Wideband Bias Tee Without Lumped Components
- 9 May 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave Magazine
- Vol. 26 (6) , 104-112
Abstract
This article describes the design that won first place in the Student Design Competition for the 1-8 GHz Component Less Bias Tee at the 2024 IEEE International Microwave Symposium. The proposed design utilizes transmission lines fabricated on a single-layer PCB, where the parameters and substrate were selected based on the tradeoff between bandwidth and fabrication feasibility. Measurements show a high bandwidth-to-size ratio – a 3-dB bandwidth of 3.05 – 8.9 GHz within a PCB area of 4.5 mm × 20.5 mm. Additionally, this article explores alternative structures and examines the power-handling limitations for future component-less bias tee designs.Keywords
Funding Information
- Institute of Information and Communications Technology (RS-2024-00395366)
This publication has 5 references indexed in Scilit:
- It’s Tee Time: An Ultrabroadband Componentless Bias Tee: A Planar Ultrabroadband Componentless Bias Tee in Microstrip Line TechnologyIEEE Microwave Magazine, 2024
- Ultra-wideband bias-tee design using distributed network synthesisIEICE Electronics Express, 2013
- RF power amplifiers for wireless communicationsIEEE Microwave Magazine, 2000
- Decade Bandwidth Bias T's for MIC Applications up to 50 GHz (Short Paper)IEEE Transactions on Microwave Theory and Techniques, 1987
- Resistor-Transmission-Line CircuitsProceedings of the IRE, 1948