Evaluacion termica, mecanica y electrica de materiales compuestos cordierita-mullita
Open Access
- 1 October 2000
- journal article
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 3 (4) , 124-130
Abstract
Commercially available cordierite and mullite powders were used to obtain cordierite and cordierite-30wt% mullite materials by attrition milling, uniaxial pressing and sintering. Cordierite powders were the coarse (D50 = 1.82 mum), medium (D50 = 0.9 mum) and fine (D50 = 0.45 mum) single granulometric fractions and binary mixtures of them. Mullite powder employed in composites was the 7 h-attrition milled one (D50 = 1.3 mum). Hardness (H V) and fracture toughness (K IC) were measured by Vickers indentation techniques. Composites showed higher H V and K IC than cordierite matrices. In both materials, H V and K IC diminish with the increasing porosity. Dielectric constant (epsilon) and losses (tan delta) were determined at 1 MHz. An increase in epsilon and tan delta values was registered when mullite was present in composites with respect to cordierite material. Higher the porosity, epsilon was lower and tan delta increased. The thermal expansion coefficients (alpha) were determined up to 1000 °C resulting the alpha of the composite close to that of the siliconKeywords
This publication has 15 references indexed in Scilit:
- Better ceramic substrates through zeolitesBulletin of Materials Science, 1993
- Ceramic and Glass‐Ceramic Packaging in the 1990sJournal of the American Ceramic Society, 1991
- Evaluation by indentation of fracture toughness of ceramic materialsJournal of Materials Science, 1990
- Indentation Fracture Toughness of Sintered Silicon Carbide in the Palmqvist Crack RegimeJournal of the American Ceramic Society, 1989
- Mechanical properties of alkoxy-derived cordierite ceramicsJournal of Materials Science, 1988
- Elastic/plastic indentation in ceramics: a fracture toughness determination methodCeramics International, 1984
- Elastic/Plastic Indentation Damage in Ceramics: The Median/Radial Crack SystemJournal of the American Ceramic Society, 1980
- Hardness, Toughness, and Brittleness: An Indentation AnalysisJournal of the American Ceramic Society, 1979
- Indentation fracture: principles and applicationsJournal of Materials Science, 1975
- Dependence of Mechanical Strength of Brittle Polycrystalline Specimens on Porosity and Grain SizeJournal of the American Ceramic Society, 1959