Through-Silicon-Via (TSV) Filling by Electrodeposition of Cu with Pulse Current at Ultra-Short Duty Cycle
Authors:
- 18 December 2013
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 160 (12) , D3300-D3305
Abstract
Through-Si-via (TSV) filling with electrodeposited Cu was performed with a pulse current consisting of very a short duty cycle to achieve 3D interconnection in high density integrated circuit (IC) devices. Low frequency was unacceptable in this condition, because a highly acidic electrolyte attacked the seed layer and Cu deposit obtained with low current efficiency during comparably longer off time period. An increased frequency critically enhanced the filling rate of Cu, which was mainly related to the improvement of the current efficiency and lower dissolution rate. In pulse conditions, high density nanoscale twin structure and strain fields were observed, which were caused by induced stress during the on-time because of high peak current density. Application of pulse deposition reduced thermal extrusion of Cu that was related to the imperfect microstructure of the deposited Cu.Keywords
This publication has 24 references indexed in Scilit:
- Modeling the Bottom-Up Filling of Through-Silicon vias Through Suppressor Adsorption/Desorption MechanismJournal of the Electrochemical Society, 2013
- Modeling Extreme Bottom-Up Filling of Through Silicon ViasJournal of the Electrochemical Society, 2012
- Extreme Bottom-Up Superfilling of Through-Silicon-Vias by Damascene Processing: Suppressor Disruption, Positive Feedback and Turing PatternsJournal of the Electrochemical Society, 2012
- Reduction of defects in TSV filled with Cu by high-speed 3-step PPR for 3D Si chip stackingMicroelectronics Reliability, 2011
- Vertical Integration of Stacked DRAM and High-Speed Logic Device Using SMAFTI TechnologyIEEE Transactions on Advanced Packaging, 2009
- Mechanistic Analysis of the “Bottom-Up” Fill in Copper Interconnect MetallizationJournal of the Electrochemical Society, 2009
- The development of a tapered silicon micro-micromachining process for 3D microsystems packagingJournal of Micromechanics and Microengineering, 2008
- Three-dimensional wafer stacking via Cu-Cu bonding integrated with 65-nm strained-Si/low-k CMOS technologyIEEE Electron Device Letters, 2006
- Development of next-generation system-on-package (SOP) technology based on silicon carriers with fine-pitch chip interconnectionIBM Journal of Research and Development, 2005
- 3D System Integration TechnologiesMRS Proceedings, 2003