Electrospun poly(N-isopropyl acrylamide)/poly(caprolactone) fibers for the generation of anisotropic cell sheets
- 4 July 2017
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Biomaterials Science
- Vol. 5 (8) , 1661-1669
Abstract
Cell alignment in muscle, nervous tissue, and cartilage is requisite for proper tissue function; however, cell sheeting techniques using the thermosensitive polymer poly(N-isopropyl acrylamide) (PNIPAAm) can only produce anisotropic cell sheets with delicate and resource-intensive modifications. We hypothesized that electrospinning, a relatively simple and inexpensive technique to generate aligned polymer fibers, could be used to fabricate anisotropic PNIPAAm and poly(caprolactone) (PCL) blended surfaces that both support cell viability and permit cell sheet detachment via PNIPAAm dissolution. Aligned electrospun PNIPAAm/PCL fibers (0%, 25%, 50%, 75%, 90%, and 100% PNIPAAm) were electrospun and characterized. Fibers ranged in diameter from 1–3 μm, and all fibers had an orientation index greater than 0.65. Fourier transform infrared spectroscopy was used to confirm the relative content of PNIPAAm and PCL. For advancing water contact angle and mass loss studies, only high PNIPAAm-content fibers (75% and greater) exhibited, temperature-dependent properties like 100% PNIPAAm fibers, whereas 25% and 50% PNIPAAm fibers behaved similarly to PCL-only fibers. 3T3 fibroblasts seeded on all PNIPAAm/PCL fibers had high cell viability and spreading except for the 100% PNIPAAm fibers. Cell sheet detachment by incubation with cold medium was successful only for 90% PNIPAAm fibers, which had a sufficient amount of PCL to allow cell attachment and spreading but not enough to prevent detachment upon PNIPAAm dissolution. This study demonstrates the feasibility of using anisotropic electrospun PNIPAAm/PCL fibers to generate aligned cell sheets that can potentially better recapitulate anisotropic architecture to achieve proper tissue function.Keywords
This publication has 39 references indexed in Scilit:
- Fabrication and characterization of multiscale electrospun scaffolds for cartilage regenerationBiomedical Materials, 2013
- Promoting engraftment of transplanted neural stem cells/progenitors using biofunctionalised electrospun scaffoldsBiomaterials, 2012
- Matrix nanotopography as a regulator of cell functionJournal of Cell Biology, 2012
- Fabrication of functional three-dimensional tissues by stacking cell sheets in vitroNature Protocols, 2012
- Experimental investigation of collagen waviness and orientation in the arterial adventitia using confocal laser scanning microscopyBiomechanics and Modeling in Mechanobiology, 2011
- Design, fabrication and characterization of PCL electrospun scaffolds—a reviewJournal of Materials Chemistry, 2011
- The effect of nanofiber-guided cell alignment on the preferential differentiation of neural stem cellsBiomaterials, 2010
- The role of water in structural changes of poly(N-isopropylacrylamide) and poly(N-isopropylmethacrylamide) studied by FTIR, Raman spectroscopy and quantum chemical calculationsVibrational Spectroscopy, 2009
- Intact endothelial cell sheet harvesting from thermoresponsive surfaces coated with cell adhesion promotersJournal of The Royal Society Interface, 2007
- Cell growth and detachment from protein‐coated PNIPAAm‐based copolymersJournal of Biomedical Materials Research Part A, 2007