KVKrish Vijayaraghavan

Krish Vijayaraghavan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Krish Vijayaraghavan has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Source apportionment of emissions from light-duty gasoline vehicles and other sources in the United States for ozone and particulate matter

    by Krish Vijayaraghavan, Chris Lindhjem, Bonyoung Koo, Allison DenBleyker, Edward Tai, Tejas Shah, Yesica Alvarez, Greg Yarwood

    Federal Tier 3 motor vehicle emission and fuel sulfur standards have been promulgated in the United States to help attain air quality standards for ozone and PM2.5 (particulate matter with an aerodynamic diameter 2.5 in 2030. Strengthening Tier 2 to a Tier 3-like (LEV III) standard reduces the summertime monthly mean of daily maximum 8-hr average (MDA8) ozone in the eastern U.S. by up to 1.5 ppb (or 2%) and the maximum MDA8 ozone by up to 3.4 ppb (or 3%). Reducing gasoline sulfur content from 30 to 10 ppm is responsible for up to 0.3 ppb of the improvement in the monthly mean ozone and up to 0.8 ppb of the improvement in maximum ozone. Across four major urban areas—Atlanta, Detroit, Philadelphia, and St. Louis—gLDV contributions range from 5% to 9% and 3% to 6% of the summertime mean MDA8 ozone under Tier 2 and Tier 3, respectively, and from 7% to 11% and 3% to 7% of the maximum MDA8 ozone under Tier 2 and Tier 3, respectively. Monthly mean 24-hr PM2.5 decreases by up to 0.5 μg/m3 (or 3%) in the eastern U.S. from Tier 2 to Tier 3, with about 0.1 μg/m3 of the reduction due to the lower gasoline sulfur content. At the four urban areas under the Tier 3 program, gLDV emissions contribute 3.4–5.0% and 1.7–2.4% of the winter and summer mean 24-hr PM2.5, respectively, and 3.8–4.6% and 1.5–2.0% of the mean 24-hr PM2.5 on days with elevated PM2.5 in winter and summer, respectively. Implications: Following U.S. Tier 3 emissions and fuel sulfur standards for gasoline-fueled passenger cars and light trucks, these vehicles are expected to contribute less than 6% of the summertime mean daily maximum 8-hr ozone and less than 7% and 4% of the winter and summer mean 24-hr PM2.5 in the eastern U.S. in 2030. On days with elevated ozone or PM2.5 at four major urban areas, these vehicles contribute less than 7% of ozone and less than 5% of PM2.5, with sources outside North America and U.S. area source emissions constituting some of the main contributors to ozone and PM2.5, respectively.


  • Open Access

    Trends in on-road vehicle emissions and ambient air quality in Atlanta, Georgia, USA, from the late 1990s through 2009

    by Krish Vijayaraghavan, Allison DenBleyker, Lan Ma, Chris Lindhjem, Greg Yarwood

    On-road vehicle emissions of carbon monoxide (CO), nitrogen oxides (NOx), and volatile organic compounds (VOCs) during 1995–2009 in the Atlanta Metropolitan Statistical Area were estimated using the Motor Vehicle Emission Simulator (MOVES) model and data from the National Emissions Inventories and the State of Georgia. Statistically significant downward trends (computed using the nonparametric Theil-Sen method) in annual on-road CO, NOx, and VOC emissions of 6.1%, 3.3%, and 6.0% per year, respectively, are noted during the 1995–2009 period despite an increase in total vehicle distance traveled. The CO and NOx emission trends are correlated with statistically significant downward trends in ambient air concentrations of CO and NOx in Atlanta ranging from 8.0% to 11.8% per year and from 5.8% to 8.7% per year, respectively, during similar time periods. Weather-adjusted summertime ozone concentrations in Atlanta exhibited a statistically significant declining trend of 2.3% per year during 2001–2009. Although this trend coexists with the declining trends in on-road NOx, VOC, and CO emissions, identifying the cause of the downward trend in ozone is complicated by reductions in multiple precursors from different source sectors.


  • Response of fish tissue mercury in a freshwater lake to local, regional, and global changes in mercury emissions

    by Krish Vijayaraghavan, Leonard Levin, Lynsey Parker, Greg Yarwood, David Streets

    A suite of mechanistic atmospheric and mercury (Hg) cycling and bioaccumulation models is applied to simulate atmospheric Hg deposition and Hg concentrations in the water column and in fish in a Hg-impaired freshwater lake located in the northeastern United States that receives its Hg loading primarily through deposition. Two future-year scenarios evaluate the long-term response of fish tissue Hg concentrations to reductions in local and nationwide coal-fired electric-generating utility and other Hg emissions and an increase or decrease in global (non-US) Hg emissions. Results indicate that fish tissue Hg concentrations in this ecosystem could require approximately 3 yr to 8 yr to begin to respond to declines in US emissions and deposition with a fish Hg reduction proportional to deposition reduction requiring over 50 yr. Furthermore, recovery could potentially be partially or completely offset by growth in non-US Hg emissions. Environ Toxicol Chem 2014;33:1238–1247. © 2014 SETAC


  • Open Access

    Response of Freshwater Systems to Local and Global Changes in Mercury Emissions

    by Leonard Levin, Krish Vijayaraghavan, Kristen Lohman

    Lakes and other waterways, and the biota in those waterways, receiving their mercury burden primarily via atmospheric deposition can be expected to exhibit responses to changes in deposition over an extended time period. A projected control strategy for power plant emissions of mercury was imposed on modeled U.S. plants, while international emissions were modeled for two Chinese emission scenarios: a "business-as-usual" scenario and an "expedited controls" scenario. Levels of mercury in fish were simulated in a New England lake located close to a large U.S. power plant. Results indicated that fish responses to mercury emissions changes were spread over several years, and that even severe reductions in U.S. emissions were masked by non-U.S. emissions growth.

  • Open Access

    Effects of light duty gasoline vehicle emission standards in the United States on ozone and particulate matter

    by Krish Vijayaraghavan, Chris Lindhjem, Allison DenBleyker, Uarporn Nopmongcol, John Grant, Edward Tai, Greg Yarwood


  • Open Access

    Sub-Grid Scale Plume Modeling

    by Prakash Karamchandani, Krish Vijayaraghavan, Greg Yarwood

    Multi-pollutant chemical transport models (CTMs) are being routinely used to predict the impacts of emission controls on the concentrations and deposition of primary and secondary pollutants. While these models have a fairly comprehensive treatment of the governing atmospheric processes, they are unable to correctly represent processes that occur at very fine scales, such as the near-source transport and chemistry of emissions from elevated point sources, because of their relatively coarse horizontal resolution. Several different approaches have been used to address this limitation, such as using fine grids, adaptive grids, hybrid modeling, or an embedded sub-grid scale plume model, i.e., plume-in-grid (PinG) modeling. In this paper, we first discuss the relative merits of these various approaches used to resolve sub-grid scale effects in grid models, and then focus on PinG modeling which has been very effective in addressing the problems listed above. We start with a history and review of PinG modeling from its initial applications for ozone modeling in the Urban Airshed Model (UAM) in the early 1980s using a relatively simple plume model, to more sophisticated and state-of-the-science plume models, that include a full treatment of gas-phase, aerosol, and cloud chemistry, embedded in contemporary models such as CMAQ, CAMx, and WRF-Chem. We present examples of some typical results from PinG modeling for a variety of applications, discuss the implications of PinG on model predictions of source attribution, and discuss possible future developments and applications for PinG modeling.