Seiichi Irie
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Seiichi Irie has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Keijiro Nishi
Kumamoto University, Kumamoto, Kumamoto, Japan
1 shared publicationMakoto Ide
Kumamoto University, Kumamoto, Kumamoto, Japan
1 shared publication- Matej Borovinsek
Faculty of Mechanical Engineering, University of Maribor, Maribor 2000, Slovenia
1 shared publication - Matej Vesenjak
Univerza v Mariboru, Fakulteta za strojništvo
1 shared publication Nozomi Terasawa
Kumamoto University, Kumamoto, Kumamoto, Japan
1 shared publicationShigeru Itoh
Kumamoto University, Kumamoto, Kumamoto, Japan
1 shared publication
Latest Publications
- Open Access
Behavior of Metallic Foam under Shock Wave Loading
In this manuscript, the behavior of metallic foam under impact loading and shock wave propagation has been observed. The goal of this research was to investigate the material and structural properties of submerged open-cell aluminum foam under impact loading conditions with particular interest in shock wave propagation and its effects on cellular material deformation. For this purpose experimental tests and dynamic computational simulations of aluminum foam specimens inside a water tank subjected to explosive charge have been performed. Comparison of the results shows a good correlation between the experimental and simulation results.
Open AccessBehavior of Metallic Foam under Shock Wave Loading
In this manuscript, the behavior of metallic foam under impact loading and shock wave propagation has been observed. The goal of this research was to investigate the material and structural properties of submerged open-cell aluminum foam under impact loading conditions with particular interest in shock wave propagation and its effects on cellular material deformation. For this purpose experimental tests and dynamic computational simulations of aluminum foam specimens inside a water tank subjected to explosive charge have been performed. Comparison of the results shows a good correlation between the experimental and simulation results.
- 1 January 2010
- Published by ASME International
- p. 241-245
Research on the Powder Consolidation by Using Shock Compaction Method
Shock compaction of powder by using an underwater shock wave is studied and the technical advantages are reported. In this research, we propose a technique for shock compaction of copper/diamond powders by using an underwater shock wave generated by the detonation of explosive. This process produces a composite material in which the particles are strongly bonded due to melting caused by strong deformation and rapid solidification at the particle surface. The improvement of the thermal conductivity of the composite material collected is expected, because the diamond has a high thermal conductivity. Good compacts of composite materials in which diamond particles were dispersed in the copper matrix were obtained in this experiment, and their microstructures and thermal properties were examined. Moreover, pressure measurements and numerical calculations were performed to assess the effect of the pressuring condition in the explosive container.
- 1 January 2010
- Published by ASME International
- p. 241-245
Research on the Powder Consolidation by Using Shock Compaction Method
Shock compaction of powder by using an underwater shock wave is studied and the technical advantages are reported. In this research, we propose a technique for shock compaction of copper/diamond powders by using an underwater shock wave generated by the detonation of explosive. This process produces a composite material in which the particles are strongly bonded due to melting caused by strong deformation and rapid solidification at the particle surface. The improvement of the thermal conductivity of the composite material collected is expected, because the diamond has a high thermal conductivity. Good compacts of composite materials in which diamond particles were dispersed in the copper matrix were obtained in this experiment, and their microstructures and thermal properties were examined. Moreover, pressure measurements and numerical calculations were performed to assess the effect of the pressuring condition in the explosive container.