Zhiming M. Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhiming M. Wang has a total of 89 co-authors. Here are the top co-authors by number of shared publications:
G. J. Salamo
Arkansas Institute for Nanoscale Material Science and Engineering, University of Arkansas 1 , Fayetteville, Arkansas 72701, USA
25 shared publications- Jihoon Lee
Department of Electronic Engineering, College of Electronics and Information, Kwangwoon University, Nowon-gu, Seoul 01897, Republic of Korea
18 shared publications Gregory J. Salamo
Arkansas Institute for Nanoscale Material Science and Engineering, University of Arkansas, Fayetteville, Arkansas, United States of America
15 shared publications- Jiang Wu
Institute of Fundamental and Frontier Sciences, University of Electronic Science and Technology of China, Chengdu, China
11 shared publications Yu. I. Mazur
University of Arkansas Institute of Nanoscale Science and Engineering Arkansas 72701, USA
10 shared publications- Alvason Zhenhua Li
Vaccine and Infectious Disease Division Fred Hutchinson Cancer Research Center 98109 Seattle WA USA
7 shared publications
Latest Publications
- 12 December 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 99 (24) , 243113
Bismuth nano-droplets for group-V based molecular-beam droplet epitaxy
Self-assembly of bismuth droplets at nanoscale on GaAs(100) surface using molecular beam epitaxy was demonstrated. Fine control of density and size was achieved by varying growth temperature and total bismuth deposition. Droplet density was tuned by roughly 3 orders of magnitude, and the density-temperature dependence was found to be consistent with classical nucleation theory. These results may extend the flexibility of droplet epitaxy by serving as templates for group V based droplet epitaxy, which is in contrast to conventional group III based droplet epitaxy and may encourage nanostructure formation of bismuth-containing materials.
- 12 December 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 99 (24) , 243113
Bismuth nano-droplets for group-V based molecular-beam droplet epitaxy
Self-assembly of bismuth droplets at nanoscale on GaAs(100) surface using molecular beam epitaxy was demonstrated. Fine control of density and size was achieved by varying growth temperature and total bismuth deposition. Droplet density was tuned by roughly 3 orders of magnitude, and the density-temperature dependence was found to be consistent with classical nucleation theory. These results may extend the flexibility of droplet epitaxy by serving as templates for group V based droplet epitaxy, which is in contrast to conventional group III based droplet epitaxy and may encourage nanostructure formation of bismuth-containing materials.
- Open Access
- 6 June 2011
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 6 (6) , e20765
Nanoscale Footprints of Self-Running Gallium Droplets on GaAs Surface
In this work, the nanoscale footprints of self-driven liquid gallium droplet movement on a GaAs (001) surface will be presented and analyzed. The nanoscale footprints of a primary droplet trail and ordered secondary droplets along primary droplet trails are observed on the GaAs surface. A well ordered nanoterrace from the trail is left behind by a running droplet. In addition, collision events between two running droplets are investigated. The exposed fresh surface after a collision demonstrates a superior evaporation property. Based on the observation of droplet evolution at different stages as well as nanoscale footprints, a schematic diagram of droplet evolution is outlined in an attempt to understand the phenomenon of stick-slip droplet motion on the GaAs surface. The present study adds another piece of work to obtain the physical picture of a stick-slip self-driven mechanism in nanoscale, bridging nano and micro systems.
- 6 June 2011
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 6 (6) , e20765
Open AccessNanoscale Footprints of Self-Running Gallium Droplets on GaAs Surface
In this work, the nanoscale footprints of self-driven liquid gallium droplet movement on a GaAs (001) surface will be presented and analyzed. The nanoscale footprints of a primary droplet trail and ordered secondary droplets along primary droplet trails are observed on the GaAs surface. A well ordered nanoterrace from the trail is left behind by a running droplet. In addition, collision events between two running droplets are investigated. The exposed fresh surface after a collision demonstrates a superior evaporation property. Based on the observation of droplet evolution at different stages as well as nanoscale footprints, a schematic diagram of droplet evolution is outlined in an attempt to understand the phenomenon of stick-slip droplet motion on the GaAs surface. The present study adds another piece of work to obtain the physical picture of a stick-slip self-driven mechanism in nanoscale, bridging nano and micro systems.
- 19 May 2011
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 3 (6) , 1817-1820
On the Secondary Droplets of Self-Running Gallium Droplets on GaAs Surface
- 19 May 2011
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 3 (6) , 1817-1820
On the Secondary Droplets of Self-Running Gallium Droplets on GaAs Surface
- 16 May 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 98 (20) , 203109
Electronic states and light absorption in quantum dot molecule
The electronic states and direct interband absorption of light in quantum dot molecule (QDM) consisting 4 or 5 QDs are investigated. The electron energy levels and wave functions are calculated. It is shown that the energy levels are split in azimuth direction. In the case of the presence of the central QD in QDM an additional splitting in the radial direction is revealed. The suggested method can be used to calculate the electronic states and light absorption of arbitrary number QDM. The results are useful for the application of the QDM to photoelectric devices.
- 16 May 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 98 (20) , 203109
Electronic states and light absorption in quantum dot molecule
The electronic states and direct interband absorption of light in quantum dot molecule (QDM) consisting 4 or 5 QDs are investigated. The electron energy levels and wave functions are calculated. It is shown that the energy levels are split in azimuth direction. In the case of the presence of the central QD in QDM an additional splitting in the radial direction is revealed. The suggested method can be used to calculate the electronic states and light absorption of arbitrary number QDM. The results are useful for the application of the QDM to photoelectric devices.
- 8 March 2011
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 3 (4) , 1485-1488
Near infrared broadband emission of In0.35Ga0.65As quantum dots on high index GaAs surfaces
The morphology and optical properties of In0.35Ga0.65As/GaAs quantum dots (QDs) grown on (210), (311)A, (711)A, (731) and (100) substrates are investigated. QDs formed on (210) and (731) oriented substrates are grown by molecular beam epitaxy. Regular QDs are observed on (100), (311)A, and (711)A. Randomly distributed QDs and comet-shaped QDs form on (210) and (731) substrates, respectively. A high density of QDs on the order of 1011 cm−2 are obtained from (711)A. The optical measurement shows a spectrum linewidth (FWHM = 74.3 nm) of QDs on GaAs (210) three times wider than GaAs (100) substrate. Long exciton decay times, over 1 ns, are also measured by time-resolved photoluminescence technique for all samples. Our results demonstrate the potential for QDs on GaAs high index substrates for wideband applications.
- 8 March 2011
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 3 (4) , 1485-1488
Near infrared broadband emission of In0.35Ga0.65As quantum dots on high index GaAs surfaces
The morphology and optical properties of In0.35Ga0.65As/GaAs quantum dots (QDs) grown on (210), (311)A, (711)A, (731) and (100) substrates are investigated. QDs formed on (210) and (731) oriented substrates are grown by molecular beam epitaxy. Regular QDs are observed on (100), (311)A, and (711)A. Randomly distributed QDs and comet-shaped QDs form on (210) and (731) substrates, respectively. A high density of QDs on the order of 1011 cm−2 are obtained from (711)A. The optical measurement shows a spectrum linewidth (FWHM = 74.3 nm) of QDs on GaAs (210) three times wider than GaAs (100) substrate. Long exciton decay times, over 1 ns, are also measured by time-resolved photoluminescence technique for all samples. Our results demonstrate the potential for QDs on GaAs high index substrates for wideband applications.
- 25 January 2011
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 13 (3) , 947-952
Insight into optical properties of strain-free quantum dot pairs
- 25 January 2011
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 13 (3) , 947-952
Insight into optical properties of strain-free quantum dot pairs
- 25 October 2010
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 4 (12) , 371-373
Surface mediated control of droplet density and morphology on GaAs and AlAs surfaces
- 25 October 2010
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 4 (12) , 371-373
Surface mediated control of droplet density and morphology on GaAs and AlAs surfaces
- 8 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 10 (3) , 600-605
Low-Density Quantum Dot Molecules by Selective Etching Using in Droplet as a Mask
We demonstrate low-density quantum dot molecules (QDMs) by selective etching using In droplets as a mask. Selective etching is performed with InGaAs QDMs buried underneath GaAs capping layer, on which In droplets are formed by droplet epitaxy using molecular beam epitaxy. During the chemical etching, the droplets act as a mask and QDMs underneath the droplets that only survive. Photoluminescence measurement from the selectively etched QDMs in mesa structures shows a much reduced intensity, which indicates low-density QDMs. This technique provides a simple and flexible method to attain low-density QDMs. The density can be easily modified by the control of the size and density of In droplets, which is suitable for single QDM spectroscopy and for their device applications.
- 8 July 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 10 (3) , 600-605
Low-Density Quantum Dot Molecules by Selective Etching Using in Droplet as a Mask
We demonstrate low-density quantum dot molecules (QDMs) by selective etching using In droplets as a mask. Selective etching is performed with InGaAs QDMs buried underneath GaAs capping layer, on which In droplets are formed by droplet epitaxy using molecular beam epitaxy. During the chemical etching, the droplets act as a mask and QDMs underneath the droplets that only survive. Photoluminescence measurement from the selectively etched QDMs in mesa structures shows a much reduced intensity, which indicates low-density QDMs. This technique provides a simple and flexible method to attain low-density QDMs. The density can be easily modified by the control of the size and density of In droplets, which is suitable for single QDM spectroscopy and for their device applications.
- Open Access
- 16 June 2010
- Published by Tsinghua University Press in Nano Research
- Vol. 3 (7) , 490-495
Holed nanostructures formed by aluminum droplets on a GaAs substrate
We have studied the morphology evolution of holed nanostructures formed by aluminum droplet epitaxy on a GaAs surface. Unique outer rings with concentric inner holed rings were observed. Further, an empirical equation to describe the size distribution of the outer rings in the holed nanostructures has been established. The contour line generated by the equation provides physical insights into quantum ring formation by droplets of group III materials on III–V substrates. Open image in new window
- 16 June 2010
- Published by Tsinghua University Press in Nano Research
- Vol. 3 (7) , 490-495
Open AccessHoled nanostructures formed by aluminum droplets on a GaAs substrate
We have studied the morphology evolution of holed nanostructures formed by aluminum droplet epitaxy on a GaAs surface. Unique outer rings with concentric inner holed rings were observed. Further, an empirical equation to describe the size distribution of the outer rings in the holed nanostructures has been established. The contour line generated by the equation provides physical insights into quantum ring formation by droplets of group III materials on III–V substrates. Open image in new window
- Open Access
- 19 May 2010
- Published by Springer Nature in Discover Nano
- Vol. 5 (8) , 1272-1278
Superlattice Growth via MBE and Green’s Function Techniques
A model has been developed to simulate the growth of arrays consisting of a substrate on which alternating layers of quantum dots (QDs) and spacer layers are epitaxially grown. The substrate and spacer layers are modeled as an anisotropic elastic half-space, and the QDs are modeled as point inclusions buried within the half-space. In this model, the strain at the free surface of this half-space due to the buried point QDs is calculated, and a scalar measure of the strain at the surface is subsequently determined. New point QDs are placed on the surface where the previously calculated scalar strain measure is a minimum. Following available DFT results, this scalar strain measure is a weighted average of the in-plane strains. This model is constructed under the assumption that diffusional anisotropy can be neglected, and thus, the results are more in agreement with results from experiments of growth of SiGe QDs than experiments involving QDs of (In,Ga)As.
- 19 May 2010
- Published by Springer Nature in Discover Nano
- Vol. 5 (8) , 1272-1278
Open AccessSuperlattice Growth via MBE and Green’s Function Techniques
A model has been developed to simulate the growth of arrays consisting of a substrate on which alternating layers of quantum dots (QDs) and spacer layers are epitaxially grown. The substrate and spacer layers are modeled as an anisotropic elastic half-space, and the QDs are modeled as point inclusions buried within the half-space. In this model, the strain at the free surface of this half-space due to the buried point QDs is calculated, and a scalar measure of the strain at the surface is subsequently determined. New point QDs are placed on the surface where the previously calculated scalar strain measure is a minimum. Following available DFT results, this scalar strain measure is a weighted average of the in-plane strains. This model is constructed under the assumption that diffusional anisotropy can be neglected, and thus, the results are more in agreement with results from experiments of growth of SiGe QDs than experiments involving QDs of (In,Ga)As.