HMHiromasa Miura

Hiromasa Miura

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hiromasa Miura has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Contact Stress at the Anterior Aspect of the Tibial Post in Posterior-Stabilized Total Knee Replacement

    by Satoshi Hamai, Hiromasa Miura, Shuichi Matsuda, Takeshi Shimoto, Hidehiko Higaki, Yukihide Iwamoto

    Background: Retrieval studies have demonstrated polyethylene wear and deformation of the anterior aspect of the tibial post of posterior-stabilized total knee replacements. We are not aware of any study that has analyzed the effects of the design of the femoral notch and the anterior aspect of the tibial post of posterior-stabilized total knee replacements on contact area, stress, and location. The purpose of the present study was to determine the levels of contact stress generated in three posterior-stabilized total knee replacement designs when the femoral intercondylar notch impinges on the anterior aspect of the tibial post. Methods: The contact area, mean and peak contact stresses, and contact location at the anterior aspect of the tibial post were determined when a posterior force of 100 N was applied to a NexGen LPS Flex, Genesis II, and Scorpio NRG total knee replacement. Measurements were performed at –15°, –10°, –5°, 0°, and 5° of flexion of the femoral component both in neutral and with 5° of rotation of the tibial component. Each measurement was sequentially performed five times, and the data were compared within and between the designs with use of analysis of variance and a post-hoc Scheffé F test. Results: The NexGen LPS Flex exhibited two contact areas on the medial and lateral corners of the anterior aspect of the post, whereas both the Genesis II and Scorpio NRG exhibited a single horizontal band. The NexGen LPS Flex showed the largest total contact area of the three designs at –15°, –10°, and 5° of flexion. The NexGen LPS showed the lowest mean contact stress at –15° and 5° but showed the highest peak contact stress at –5° and 0°. The Scorpio NRG showed the highest mean contact stress under all conditions and showed the highest peak contact stress at –15°, –10°, and 5°. With 5° of rotation of the tibial component, peak contact stress increased, relative to neutral, 1.2 to twofold (depending on the flexion angle) in the Genesis II design. Conclusions: The mean and peak contact stresses were variable for all three designs and the test conditions, approaching and in some cases exceeding the compressive yield stress for polyethylene. The geometry of the metal femoral notch and polyethylene tibial post in the axial and sagittal planes significantly affected contact area, mean and peak stresses, and contact location at the anterior aspect of the tibial post. Clinical Relevance: This study helps the surgeon to be more aware that high contact stresses under some conditions could lead to deformation and damage of the anterior aspect of the post in these three common designs of cruciate-sparing total knee replacements.


  • Quantitative Assessment of Rotatory Instability after Anterior Cruciate Ligament Reconstruction

    by Yasutaka Tashiro, Ken Okazaki, Hiromasa Miura, Shuichi Matsuda, Takefumi Yasunaga, Makoto Hashizume, Yoshitaka Nakanishi, Yukihide Iwamoto

    Background: Anterior cruciate ligament reconstruction successfully reduces anterior knee instability, but its effect on rotatory stability is not fully understood. In addition, a definitive method for the quantitative evaluation of rotatory instability remains to be established. Hypothesis: Measurement of anterolateral tibial translation by open magnetic resonance imaging could positively correlate with the clinical grading of the pivot-shift test and would clarify residual rotatory abnormalities not shown by conventional methods for measurement of anterior stability. Study Design: Controlled laboratory study. Methods: An anterior cruciate ligament—reconstructed group (n = 21) and an anterior cruciate ligament—deficient group (n = 20) were examined using a Slocum anterolateral rotatory instability test in open magnetic resonance imaging. Anterior tibial translation was measured at the medial and lateral compartments by evaluating sagittal images. Clinical knee stability was evaluated before the above measurement using the pivot-shift test, KT-2000 arthrometer, and stress radiography. A cutoff value for anterolateral tibial translation relating to pivot-shift was determined using a receiver operating characteristic curve. Results: Side-to-side differences of anterolateral tibial translation correlated with clinical grade of the pivot-shift test and stress radiography but not with KT-2000 arthrometry in both groups. The cutoff value was established as 3.0 mm. Although the mean anterolateral translation showed no difference, 9 reconstructed knees revealed greater than 3 mm of anterolateral tibial translation, whereas only 3 uninjured knees did. Conclusion: Measurement using an open magnetic resonance imaging successfully quantified the remaining rotatory instability in anterior cruciate ligament—reconstructed knees. Clinical Relevance: This method is a useful means for quantifying anterior cruciate ligament function to stabilize tibial rotation.


  • Evaluation of Skills in Arthroscopic Training Based on Trajectory and Force Data

    by Yasutaka Tashiro, Hiromasa Miura, Yoshitaka Nakanishi, Ken Okazaki, Yukihide Iwamoto

    Rm better on a simulated arthroscopic procedure than novices, therefore validating the quantitative assessment. Surgical trainees (n = 12), orthopaedic residents (n = 12), and experienced arthroscopic surgeons (n = 6) were tested on a Sawbones® knee simulator. Subjects performed a joint inspection and probing task and a partial meniscectomy task. The trajectory data were measured using an electromagnetic motion tracking system and the force data were measured using a force sensor. The experienced group performed both tasks with higher scores and more quickly than the less experienced groups. The path length of the probe and the scissors was substantially shorter and the probe velocity was considerably faster in the experienced group. The trainee group applied substantially stronger forces to the joint during the joint inspection and probing task. Our data suggest a performance assessment using an electromagnetic motion tracking system and a force sensor provides an objective means of evaluating surgical skills in an arthroscopic training system....


  • Varus–valgus laxity correlates with pain in osteoarthritis of the knee

    by Hiromasa Miura, Shin-Ichiro Takasugi, Tsutomu Kawano, Takashi Manabe, Yukihide Iwamoto


  • Open Access

    Three‐dimensional knee joint kinematics during golf swing and stationary cycling after total knee arthroplasty

    by Satoshi Hamai, Hiromasa Miura, Hidehiko Higaki, Takeshi Shimoto, Shuichi Matsuda, Ken Okazaki, Yukihide Iwamoto

    The expectation of returning to sports activities after total knee arthroplasty (TKA) has become more important to patients than ever. To our knowledge, no studies have been published evaluating the three‐dimensional knee joint kinematics during sports activity after TKA. Continuous X‐ray images of the golf swing and stationary cycling were taken using a large flat panel detector for four and eight post‐arthroplasty knees, respectively. The implant flexion and axial rotation angles were determined using a radiographic‐based, image‐matching technique. Both the golf swing from the set‐up position to the top of the backswing, and the stationary cycling from the top position of the crank to the bottom position of the crank, produced progressive axial rotational motions (p = 0.73). However, the golf swing from the top of the backswing to the end of the follow‐through produced significantly larger magnitudes of rotational motions in comparison to stationary cycling (p < 0.01). Excessive internal–external rotations generated from the top of the backswing to the end of the follow‐through could contribute to accelerated polyethylene wear. However, gradual rotational movements were consistently demonstrated during the stationary cycling. Therefore, stationary cycling is recommended rather than playing golf for patients following a TKA who wish to remain physically active. © 2008 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res


  • Minimally Invasive versus Standard Approach in Total Knee Arthroplasty

    by Yasutaka Tashiro, Hiromasa Miura, Shuichi Matsuda, Ken Okazaki, Yukihide Iwamoto

    We compared a group of 20 patients who had 24 minimally invasive total knee arthroplasties with a similar group of 21 patients who had 25 standard medial parapatellar approach total knee arthroplasties. We wanted to clarify whether the minimally invasive group had an advantage over the standard group in muscle strength, pain level, postoperative recovery, and clinical results and whether the patients were prone to radiographically poor results, more operative time, and increased complications. The extensor and flexor torque, visual analog scale, pace of rehabilitation, Knee Society scores, radiographic findings, operative time, and complications of each group were examined. The minimally invasive group showed higher extensor torque values, higher ratios of postoperative to preoperative extensor torque, and lower average visual analog scale scores at 1 and 2 weeks. The patients in this group achieved straight leg raising, 90° knee flexion, and T-cane gait earlier. There was no component malalignment, but the tibial component shifted to a more medial position. The mean operative time was 56 minutes longer in the minimally invasive group. We encountered no major perioperative complications in either group. We believe the minimally invasive technique positively contributes to the early restoration of quadriceps strength and a speedy return to normal function. Level of Evidence: Level III, therapeutic study. See the Guidelines for Authors for a complete description of levels of evidence.


  • The Effect of Ankle Rotation on Cutting of the Tibia in Total Knee Arthroplasty

    by Hideki Mizu-Uchi, Shuichi Matsuda, Hiromasa Miura, Hidehiko Higaki, Ken Okazaki, Yukihide Iwamoto

    Ed that a rotational mismatch might cause incorrect positioning of an extramedullary alignment guide and evaluated such a mismatch on the predicted postoperative coronal alignment of the tibia....


  • Validity of an oblique posterior condylar radiographic view for revision total knee arthroplasty

    by H. Miura, S. Matsuda, K. Okazaki, T. Kawano, H. Kawamura, Y. Iwamoto

    We have previously developed a radiographic technique, the oblique posterior condylar view, for assessment of the posterior aspect of the femoral condyles after total knee arthroplasty. The purpose of this study was to confirm the validity of this radiographic view based upon intra-operative findings at revision total knee arthroplasty. Lateral and oblique posterior condylar views were performed for 11 knees prior to revision total knee arthroplasty, and radiolucent lines or osteolysis of the posterior aspect of the femoral condyles were identified. These findings were compared with the intra-operative appearance of the posterior aspects of the femoral condyles. Statistical analysis showed that sensitivity and efficacy were significantly better for the oblique posterior condylar than the lateral view. This method can, therefore, be considered as suitable for routine follow-up radiographs of the femoral component and in the pre-operative planning of revision surgery.


  • The Oblique Posterior Femoral Condylar Radiographic View Following Total Knee Arthroplasty

    by Hiromasa Miura, Shuichi Matsuda, Taro Mawatari, Tsutomu Kawano, Ryotaro Nabeyama, Yukihide Iwamoto

    It is often difficult to evaluate the posterior aspects of the femoral condyles after total knee arthroplasty. We have developed an imaging technique involving the use of the oblique posterior condylar view for the evaluation of the posterior aspects of the femoral condyles. The purpose of the present study was to compare the efficacy of this view with that of the true-lateral view. Three orthopaedic surgeons analyzed fifty-five sets of radiographs (consisting of oblique posterior condylar and true-lateral views) for patients who had undergone total knee arthroplasty. The accuracy and reproducibility of the oblique posterior condylar view for the detection of radiolucencies were compared with those of the true-lateral view. The oblique posterior condylar view was significantly better than the true-lateral view for the detection of radiolucencies of the posterior aspects of the femoral condyles (p < 0.0005). Radiographic analysis with use of the oblique posterior condylar view is technically easy and is accurate for the evaluation of radiolucencies of the posterior aspects of the femoral condyles after total knee arthroplasty.