Justin K. Valley
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Justin K. Valley has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ming-Chiang Wu
University of California
4 shared publications - Aaron Takami Ohta
Department of Electrical and Computer Engineering University of Hawai'i at Mānoa Honolulu HI 96822 USA
3 shared publications Arash Jamshidi
Berkeley Sensor and Actuator Center, Department of Electrical Engineering and Computer Science, University of California Berkeley, 497 Cory Hall, Berkeley, CA, USA
2 shared publications- Arash Jamshidi
Electrical Engineering and Computer Science Department, Berkeley Sensor and Actuator Center, University of California, Berkeley, CA, USA
2 shared publications Hsan-Yin Hsu
Berkeley Sensor and Actuator Center, Department of Electrical Engineering and Computer Science, University of California Berkeley, 497 Cory Hall, Berkeley, CA, USA
2 shared publications- Hsan-Yin Hsu
Electrical Engineering and Computer Science Department, Berkeley Sensor and Actuator Center, University of California, Berkeley, CA, USA
2 shared publications
Latest Publications
- 11 February 2011
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 11 (7) , 1292-1297
A unified platform for optoelectrowetting and optoelectronic tweezers
A platform capable of seamlessly unifying both optoelectrowetting and optoelectronic tweezers is presented. This enables the user to manipulate aqueous droplets (with electrowetting) as well as individual particles within those droplets (with dielectrophoresis). The device requires no photolithography and droplet/particle manipulation can occur continuously over the entire surface of the device. Droplet and 10 µm polystyrene particle speeds of up to 8 mm s−1 and 60 µm s−1, respectively, are demonstrated. Particle concentration within, and subsequent splitting of, a droplet is performed resulting in average concentration efficiencies of 93%. Serial concentration is also demonstrated resulting in exponentially increasing particle concentrations and a 10× concentration increase. Finally, the platform is used to select a single cell out of a cohort and subsequently encapsulate it in its own aqueous droplet.
- 11 February 2011
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 11 (7) , 1292-1297
A unified platform for optoelectrowetting and optoelectronic tweezers
A platform capable of seamlessly unifying both optoelectrowetting and optoelectronic tweezers is presented. This enables the user to manipulate aqueous droplets (with electrowetting) as well as individual particles within those droplets (with dielectrophoresis). The device requires no photolithography and droplet/particle manipulation can occur continuously over the entire surface of the device. Droplet and 10 µm polystyrene particle speeds of up to 8 mm s−1 and 60 µm s−1, respectively, are demonstrated. Particle concentration within, and subsequent splitting of, a droplet is performed resulting in average concentration efficiencies of 93%. Serial concentration is also demonstrated resulting in exponentially increasing particle concentrations and a 10× concentration increase. Finally, the platform is used to select a single cell out of a cohort and subsequently encapsulate it in its own aqueous droplet.
- 30 October 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 3 (6) , 424-431
Optoelectronic Tweezers as a Tool for Parallel Single-Cell Manipulation and Stimulation
Optoelectronic tweezers (OET) is a promising approach for the parallel manipulation of single cells for a variety of biological applications. By combining the manipulation capabilities of OET with other relevant biological techniques (such as cell lysis and electroporation), one can realize a true parallel, single-cell diagnostic and stimulation tool. Here, we demonstrate the utility of the OET device by integrating it onto single-chip systems capable of performing in-situ , electrode-based electroporation/lysis, individual cell, light-induced lysis, and light-induced electroporation.
- 30 October 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 3 (6) , 424-431
Optoelectronic Tweezers as a Tool for Parallel Single-Cell Manipulation and Stimulation
Optoelectronic tweezers (OET) is a promising approach for the parallel manipulation of single cells for a variety of biological applications. By combining the manipulation capabilities of OET with other relevant biological techniques (such as cell lysis and electroporation), one can realize a true parallel, single-cell diagnostic and stimulation tool. Here, we demonstrate the utility of the OET device by integrating it onto single-chip systems capable of performing in-situ , electrode-based electroporation/lysis, individual cell, light-induced lysis, and light-induced electroporation.
- 13 March 2009
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 9 (12) , 1714-1720
Parallel single-cell light-induced electroporation and dielectrophoretic manipulation
Electroporation is a common technique for the introduction of exogenous molecules across the, otherwise, impermeant cell membrane. Conventional techniques are limited by either low throughput or limited selectivity. Here we present a novel technique whereby we use patterned light to create virtual electrodes which can induce the parallel electroporation of single cells. This technique seamlessly integrates with optoelectronic tweezers to provide a single cell manipulation platform as well. We present evidence of parallel, single cell electroporation using this method through use of fluorescent dyes and dielectrophoretic responses. Additionally, through the use of integrated microfluidic channels, we show that cells remain viable following treatment in the device. Finally, we determine the optimal field dosage to inject propidium iodide into a HeLa cell and maintain cellular viability.
- 13 March 2009
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 9 (12) , 1714-1720
Parallel single-cell light-induced electroporation and dielectrophoretic manipulation
Electroporation is a common technique for the introduction of exogenous molecules across the, otherwise, impermeant cell membrane. Conventional techniques are limited by either low throughput or limited selectivity. Here we present a novel technique whereby we use patterned light to create virtual electrodes which can induce the parallel electroporation of single cells. This technique seamlessly integrates with optoelectronic tweezers to provide a single cell manipulation platform as well. We present evidence of parallel, single cell electroporation using this method through use of fluorescent dyes and dielectrophoretic responses. Additionally, through the use of integrated microfluidic channels, we show that cells remain viable following treatment in the device. Finally, we determine the optimal field dosage to inject propidium iodide into a HeLa cell and maintain cellular viability.
- 4 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 17 (2) , 342-350
Operational Regimes and Physics Present in Optoelectronic Tweezers
Optoelectronic tweezers (OET) are a powerful light-based technique for the manipulation of micro- and nanoscopic particles. In addition to an optically patterned dielectrophoresis (DEP) force, other light-induced electrokinetic and thermal effects occur in the OET device. In this paper, we present a comprehensive theoretical and experimental investigation of various fluidic, optical, and electrical effects present during OET operation. These effects include DEP, light-induced ac electroosmosis, electrothermal flow, and buoyancy-driven flow. We present finite-element modeling of these effects to establish the dominant mode for a given set of device parameters and bias conditions. These results are confirmed experimentally and present a comprehensive outline of the operational regimes of the OET device.
- 4 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 17 (2) , 342-350
Operational Regimes and Physics Present in Optoelectronic Tweezers
Optoelectronic tweezers (OET) are a powerful light-based technique for the manipulation of micro- and nanoscopic particles. In addition to an optically patterned dielectrophoresis (DEP) force, other light-induced electrokinetic and thermal effects occur in the OET device. In this paper, we present a comprehensive theoretical and experimental investigation of various fluidic, optical, and electrical effects present during OET operation. These effects include DEP, light-induced ac electroosmosis, electrothermal flow, and buoyancy-driven flow. We present finite-element modeling of these effects to establish the dominant mode for a given set of device parameters and bias conditions. These results are confirmed experimentally and present a comprehensive outline of the operational regimes of the OET device.