BGBrent Grocholski

Brent Grocholski

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Brent Grocholski has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Stability, metastability, and elastic properties of a dense silica polymorph, seifertite

    by B. Grocholski, S.‐H. Shim, V. B. Prakapenka

    Dense silica polymorphs with sixfold coordinated Si have been found in SNC and lunar meteorites and may be important minerals for silica‐rich components in the lower mantle. However, the stable crystal structure in the lower mantle and properties of dense silica remain controversial. Under stable heating and quasi‐hydrostatic stress conditions, we found that the CaCl2 type undergoes a phase transition to the α‐PbO2type (seifertite) at 130–140 GPa and 2500 K. Our data suggest that this phase transition occurs at a greater depth than the perovskite → postperovskite transition in the lowermost mantle. The molar volume measured at 1 bar is the smallest among the reported silica polymorphs, therefore having the highest calculated density and in excellent agreement with recent first‐principles calculations. The greater molar volume of seifertite found in the shergottite meteorite and previous experiments supports a metastable synthesis of the phase outside its stability field. Our data combined with the Hugoniots of silica polymorphs also rule out the possibility of the formation of seifertite in the meteorite within its stability field. We found very little change in bulk sound speed across the CaCl2‐type → seifertite transition. If shear wave velocity decreases at the transition to seifertite as suggested by some computational studies, this silica transition may provide an alternative explanation for the discontinuities with a shear wave velocity decrease found at depths greater than the D″discontinuity.


  • Mineralogical effects on the detectability of the postperovskite boundary

    by Brent Grocholski, Krystle Catalli, Sang-Heon Shim, Vitali Prakapenka

    The discovery of a phase transition in Mg-silicate perovskite (Pv) to postperovskite (pPv) at lowermost mantle pressure-temperature ( P - T ) conditions may provide an explanation for the discontinuous increase in shear wave velocity found in some regions at a depth range of 200 to 400 km above the core-mantle boundary, hereafter the D ′′ discontinuity. However, recent studies on binary and ternary systems showed that reasonable contents of Fe 2+ and Al for pyrolite increase the thickness (width of the mixed phase region) of the Pv - pPv boundary (400–600 km) to much larger than the D ′′ discontinuity (≤ 70 km). These results challenge the assignment of the D ′′ discontinuity to the Pv - pPv boundary in pyrolite (homogenized mantle composition). Furthermore, the mineralogy and composition of rocks that can host a detectable Pv → pPv boundary are still unknown. Here we report in situ measurements of the depths and thicknesses of the Pv → pPv transition in multiphase systems (San Carlos olivine, pyrolitic, and midocean ridge basaltic compositions) at the P - T conditions of the lowermost mantle, searching for candidate rocks with a sharp Pv - pPv discontinuity. Whereas the pyrolitic mantle may not have a seismologically detectable Pv → pPv transition due to the effect of Al, harzburgitic compositions have detectable transitions due to low Al content. In contrast, Al-rich basaltic compositions may have a detectable Pv - pPv boundary due to their distinct mineralogy. Therefore, the observation of the D ′′ discontinuity may be related to the Pv → pPv transition in the differentiated oceanic lithosphere materials transported to the lowermost mantle by subducting slabs.


  • Stability of the MgSiO3 analog NaMgF3 and its implication for mantle structure in super‐Earths

    by B. Grocholski, S.‐H. Shim, V. B. Prakapenka

    First‐principles calculations on MgSiO3 suggested a breakdown into MgO + SiO2 at pressure above 1000 GPa with an extremely large negative Clapeyron slope, isolating the lowermost mantles of larger super‐Earths (∼10M⊕) from convection. Similar calculations predicted the same type of breakdown in NaMgF3 to NaF + MgF2 at 40 GPa, allowing for experimental examination. We found that NaMgF3 is stable to at least 70 GPa and 2500 K. In our measurements on MgF2 (an SiO2 analog), we found a previously unidentified phase (“phase X”) between the stability fields of pyrite‐type and cotunnite‐type (49–53 GPa and 1500–2500 K). A very small density increase (1%) at the pyrite‐type → phase X transition would extend the stability of NaMgF3 relative to the breakdown products. Furthermore, because phase X appears to have a cation coordination number intermediate between pyrite‐type (6) and cotunnite‐type (9), entropy change (ΔS) would be smaller at the breakdown boundary, making the Clapeyron slope (dP/dT = ΔS/ΔV) much smaller than the prediction. If similar trend occurs in MgSiO3 and SiO2, the breakdown of MgSiO3 may occur at higher pressure and have much smaller negative Clapeyron slope than the prediction, allowing for large‐scale convection in the mantles of super‐Earth exoplanets.


  • Equation of state, phase stability, and amorphization ofSnI4at high pressure and temperature

    by Brent Grocholski, Sergio Speziale, Raymond Jeanloz

    We have measured the pressure-induced amorphization of tin iodide (SnI4) as a function of temperature and found a small (<1$\hskip0.3em${}GPa) increase in the initiation pressure of the transition from 293 to 523 K. We have also determined the P-V equation of state while the material undergoes the amorphization, including multiple compressions of a single sample, using a diamond-anvil cell and x-ray diffraction. Apparent stiffening upon multiple compression of the sample can be explained by either an increase in nonhydrostaticity during loading or, possibly, changes in the initial crystal structure upon decompression recrystallization. Contrary to previous interpretations of the amorphization being a two-stage process, with SnI4 converting to a second (unidentified) crystalline phase before the loss of Bragg intensities, the present experiments show that it is also possible to amorphize SnI4 without the appearance of the second crystalline phase. While the new diffraction peaks appear upon the first compression of a sample, subsequent compressions of the same sample do not show these new peaks; instead, long-range ordering of the original cubic crystal structure is lost.


  • Open Access

    Spin and valence states of iron in (Mg0.8Fe0.2)SiO3 perovskite

    by B. Grocholski, S.‐H. Shim, W. Sturhahn, J. Zhao, Y. Xiao, P. C. Chow

    The spin and valence states of iron in (Mg0.8Fe0.2)SiO3 perovskite were measured between 0 and 65 GPa using synchrotron Mössbauer spectroscopy. Samples were synthesized in situ in the laser‐heated diamond cell under reducing conditions. The dominant spin state of iron in perovskite is high spin at pressures below 50 GPa. Above 50 GPa, the spectra shows severe changes which can be explained by appearance of two distinct iron sites with similar site weightings. One site has Mössbauer parameters consistent with high spin Fe2+, while the other has the parameters previously interpreted as intermediate spin. The latter intermediate‐spin assignment is not unique, as similar Mössbauer parameters have been reported for high spin Fe2+ in almandine at ambient pressure. However, our data do not rule out the existence of low‐spin iron, which may exist with a smaller fraction and explain the observation of lower spin moments in the X‐ray emission spectroscopy of perovskite at high pressure. From these considerations, our preferred interpretation is that iron in perovskite is mixed or high spin to at least 2000 km depths in the mantle, consistent with computational results. Our study also reveals that reducing conditions do not inhibit the formation of Fe3+ in perovskite at deep‐mantle pressures.