Adel Hanna
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Adel Hanna has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
Aijun Xiu
University of North Carolina, Chapel Hill, United States; and †Environmental Protection Agency, RTP, United States
2 shared publications- Kevin Talgo
Institute for the Environment, University of North Carolina at Chapel Hill, 100 Europa Drive, Suite 490, Chapel Hill, NC 27517, USA
2 shared publications - Kiran Alapaty
University of North Carolina at Chapel Hill Carolina Environmental Program Chapel Hill North Carolina USA
2 shared publications - Neil Davis
Wind Energy Department, Technical University of Denmark, Roskilde, Denmark
2 shared publications - Zhengyuan Zhu
Department of Statistics, Iowa State University
2 shared publications - Aijun Xiu
Institute for the Environment, The University of North Carolina at Chapel Hill, Chapel Hill, North Carolina, 27599, USA
1 shared publication
Latest Publications
- Open Access
- 24 May 2011
- Published by Springer Nature in Environmental Health
- Vol. 10 (1) , 49
Associations between ozone and morbidity using the Spatial Synoptic Classification system
Synoptic circulation patterns (large-scale tropospheric motion systems) affect air pollution and, potentially, air-pollution-morbidity associations. We evaluated the effect of synoptic circulation patterns (air masses) on the association between ozone and hospital admissions for asthma and myocardial infarction (MI) among adults in North Carolina.
- 24 May 2011
- Published by Springer Nature in Environmental Health
- Vol. 10 (1) , 49
Open AccessAssociations between ozone and morbidity using the Spatial Synoptic Classification system
Synoptic circulation patterns (large-scale tropospheric motion systems) affect air pollution and, potentially, air-pollution-morbidity associations. We evaluated the effect of synoptic circulation patterns (air masses) on the association between ozone and hospital admissions for asthma and myocardial infarction (MI) among adults in North Carolina.
- 1 November 2009
- Published by Wolters Kluwer Health in Epidemiology
- Vol. 20, S226
Ozone, PM10, and Synoptic Circulation Patterns Associated with Asthma/Myocardial Infarction Hospital Admissions
- 1 November 2009
- Published by Wolters Kluwer Health in Epidemiology
- Vol. 20, S226
Ozone, PM10, and Synoptic Circulation Patterns Associated with Asthma/Myocardial Infarction Hospital Admissions
- 16 October 2006
- Published by Office of Scientific and Technical Information (OSTI)
Modeling the Transport and Chemical Evolution of Onshore and Offshore Emissions and their Impact on Local and Regional Air Quality Using a Variable-Grid-Resolution Air Quality Model
This research project has two primary objectives: (1) to further develop and refine the Multiscale Air Quality Simulation Platform-Variable Grid Resolution (MAQSIP-VGR) model, an advanced variable-grid-resolution air quality model, to provide detailed, accurate representation of the dynamical and chemical processes governing the fate of anthropogenic emissions in coastal environments; and (2) to improve current understanding of the potential impact of onshore and offshore oil and gas exploration and production (E&P) emissions on O{sub 3} and particulate matter nonattainment in the Gulf of Mexico and surrounding states.
- 16 October 2006
- Published by Office of Scientific and Technical Information (OSTI)
Modeling the Transport and Chemical Evolution of Onshore and Offshore Emissions and their Impact on Local and Regional Air Quality Using a Variable-Grid-Resolution Air Quality Model
This research project has two primary objectives: (1) to further develop and refine the Multiscale Air Quality Simulation Platform-Variable Grid Resolution (MAQSIP-VGR) model, an advanced variable-grid-resolution air quality model, to provide detailed, accurate representation of the dynamical and chemical processes governing the fate of anthropogenic emissions in coastal environments; and (2) to improve current understanding of the potential impact of onshore and offshore oil and gas exploration and production (E&P) emissions on O{sub 3} and particulate matter nonattainment in the Gulf of Mexico and surrounding states.
- 1 August 2006
- Published by Elsevier in Atmospheric Environment
- Vol. 40 (26) , 4809-4810
Special issue on model evaluation: Evaluation of urban and regional Eulerian air quality models
- 1 August 2006
- Published by Elsevier in Atmospheric Environment
- Vol. 40 (26) , 4809-4810
Special issue on model evaluation: Evaluation of urban and regional Eulerian air quality models
- 15 July 2005
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 110 (D13)
Multiscale Air Quality Simulation Platform (MAQSIP): Initial applications and performance for tropospheric ozone and particulate matter
The performance of the Multiscale Air Quality Simulation Platform (MAQSIP) in simulating the regional distributions of tropospheric ozone and particulate matter (PM) is evaluated through comparisons of model results from three‐dimensional simulations against available surface and aircraft measurements. These applications indicate that the model captures the dynamic range of observations and the spatial trends represented in measurements. Some discrepancies also exist, however, and they are discussed in the context of model formulation, input data specification and assumptions, and variability and bias in measurements. The daily normalized bias (within ±20%) and normalized gross errors (3 over an entire summer season are within the suggested performance criteria for management evaluation studies and are comparable to, if not smaller than, those reported previously for other regional O3 models. Comparisons of modeled PM composition with speciated fine particle concentration measurements show that the model is able to capture the spatial variability in fine PM mass as well as in the inorganic component fractions. Both measurements and model results show that in the summertime in the eastern U.S., SO42− is a relatively large component of fine PM mass; in contrast, NO3− is a significant fraction in the western U.S. in the wintertime case studied. The ability of the model to simulate the observed visibility indices (extinction coefficient and deciview) are evaluated through comparisons of model estimates using both a detailed Mie theory‐based calculation (based on predicted aerosol size and number distributions) and an empirical mass reconstruction algorithm. Both modeled and observed data show that among the various aerosol components, in the eastern U.S. SO42− contributes the largest fraction to the aerosol extinction (35–85%), while organic mass contributes up to 20–25%. In contrast, in the western U.S., SO42− and NO3− have comparable contributions (20–50%) to the observed aerosol extinction. Comparisons with limited observational aircraft data, however, show moderate to poor correlation with measurements in the free troposphere. While these discrepancies can be attributed in part to model initialization and lateral boundary conditions specification, there is a need for further evaluation of the representation of boundary layer‐free troposphere exchange mechanisms as well as the chemical mechanisms currently used in the model for representing chemistry in the free troposphere.
- 15 July 2005
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 110 (D13)
Multiscale Air Quality Simulation Platform (MAQSIP): Initial applications and performance for tropospheric ozone and particulate matter
The performance of the Multiscale Air Quality Simulation Platform (MAQSIP) in simulating the regional distributions of tropospheric ozone and particulate matter (PM) is evaluated through comparisons of model results from three‐dimensional simulations against available surface and aircraft measurements. These applications indicate that the model captures the dynamic range of observations and the spatial trends represented in measurements. Some discrepancies also exist, however, and they are discussed in the context of model formulation, input data specification and assumptions, and variability and bias in measurements. The daily normalized bias (within ±20%) and normalized gross errors (3 over an entire summer season are within the suggested performance criteria for management evaluation studies and are comparable to, if not smaller than, those reported previously for other regional O3 models. Comparisons of modeled PM composition with speciated fine particle concentration measurements show that the model is able to capture the spatial variability in fine PM mass as well as in the inorganic component fractions. Both measurements and model results show that in the summertime in the eastern U.S., SO42− is a relatively large component of fine PM mass; in contrast, NO3− is a significant fraction in the western U.S. in the wintertime case studied. The ability of the model to simulate the observed visibility indices (extinction coefficient and deciview) are evaluated through comparisons of model estimates using both a detailed Mie theory‐based calculation (based on predicted aerosol size and number distributions) and an empirical mass reconstruction algorithm. Both modeled and observed data show that among the various aerosol components, in the eastern U.S. SO42− contributes the largest fraction to the aerosol extinction (35–85%), while organic mass contributes up to 20–25%. In contrast, in the western U.S., SO42− and NO3− have comparable contributions (20–50%) to the observed aerosol extinction. Comparisons with limited observational aircraft data, however, show moderate to poor correlation with measurements in the free troposphere. While these discrepancies can be attributed in part to model initialization and lateral boundary conditions specification, there is a need for further evaluation of the representation of boundary layer‐free troposphere exchange mechanisms as well as the chemical mechanisms currently used in the model for representing chemistry in the free troposphere.
- 1 November 2001
- Published by American Meteorological Society in Journal of Applied Meteorology and Climatology
- Vol. 40 (11) , 2068-2082
Assimilating Surface Data to Improve the Accuracy of Atmospheric Boundary Layer Simulations
Large errors in atmospheric boundary layer (ABL) simulations can be caused by inaccuracies in the specification of surface characteristics in addition to assumptions and simplifications made in boundary layer formulations or other model deficiencies. For certain applications, such as air quality studies, these errors can have significant effects. To reduce such errors, a continuous surface data assimilation technique is developed. In this technique, surface-layer temperature and water vapor mixing ratio are directly assimilated by using the analyzed surface data. Then, the difference between the observations and model results is used to calculate adjustments to the surface fluxes of sensible and latent heat. These adjustments are then used to calculate a new estimate of the ground temperature, thereby affecting the simulated surface fluxes on the subsequent time step. This indirect data assimilation is applied simultaneously with the direct assimilation of surface data in the model's lowest layer, thereby maintaining greater consistency between the ground temperature and the surface-layer mass-field variables. A one-dimensional model was used to study the improvements that result from applying this technique for ABL simulations in two cases. It was found that application of the new technique led to significant reductions in ABL modeling errors.
- 1 November 2001
- Published by American Meteorological Society in Journal of Applied Meteorology and Climatology
- Vol. 40 (11) , 2068-2082
Assimilating Surface Data to Improve the Accuracy of Atmospheric Boundary Layer Simulations
Large errors in atmospheric boundary layer (ABL) simulations can be caused by inaccuracies in the specification of surface characteristics in addition to assumptions and simplifications made in boundary layer formulations or other model deficiencies. For certain applications, such as air quality studies, these errors can have significant effects. To reduce such errors, a continuous surface data assimilation technique is developed. In this technique, surface-layer temperature and water vapor mixing ratio are directly assimilated by using the analyzed surface data. Then, the difference between the observations and model results is used to calculate adjustments to the surface fluxes of sensible and latent heat. These adjustments are then used to calculate a new estimate of the ground temperature, thereby affecting the simulated surface fluxes on the subsequent time step. This indirect data assimilation is applied simultaneously with the direct assimilation of surface data in the model's lowest layer, thereby maintaining greater consistency between the ground temperature and the surface-layer mass-field variables. A one-dimensional model was used to study the improvements that result from applying this technique for ABL simulations in two cases. It was found that application of the new technique led to significant reductions in ABL modeling errors.