Oliver Herbort
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Oliver Herbort has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Martin V. Butz
2 shared publicationsArno Koning
1 shared publication- Giovanni Pezzulo
Affiliation Institute of Cognitive Sciences and Technologies, National Research Council, Rome, Italy
1 shared publication Janet van Uem
1 shared publicationMartin Butz
1 shared publication- Olivier Sigaud
University Pierre et Marie Curie -Paris 6 LIP6 4 Place Jussieu 75252 Cedex 05 Paris France
1 shared publication
Latest Publications
- 1 December 2013
- Published by Elsevier in New Ideas in Psychology
- Vol. 31 (3) , 217-220
The anticipatory construction of reality as a central concern for psychology and robotics
- 1 December 2013
- Published by Elsevier in New Ideas in Psychology
- Vol. 31 (3) , 217-220
The anticipatory construction of reality as a central concern for psychology and robotics
- 1 March 2012
- Published by Elsevier in Acta Psychologica
- Vol. 139 (3) , 404-416
The end-state comfort effect facilitates joint action
- 1 March 2012
- Published by Elsevier in Acta Psychologica
- Vol. 139 (3) , 404-416
The end-state comfort effect facilitates joint action
- 1 January 2012
- Published by Hogrefe Publishing Group in Zeitschrift für Psychologie
- Vol. 220 (1) , 37-43
Where to Grasp a Tool?
Biomechanical and environmental constraints limit body movements and tool use actions. However, in the case of tool use, such constraints can often be overcome by adjusting a tool’s tool transformation to the requirements of the intended tool use action. The research presented here examined whether participants grasped a lever at different positions, thus modifying the lever’s tool transformation, to accommodate speed and accuracy requirements of different tasks. Participants were asked to quickly track a sequence of targets with the lever. If accuracy requirements were high, participants compensated for limits in the accuracy of hand movements by grasping the lever at a position that enabled precise control of the lever. If accuracy requirements were low, participants compensated for limits in hand speed by grasping the lever at a position that enabled fast lever movements with comparatively slow hand movements. This task-dependent grasp selection was only present after participants had practiced the tasks. The data show that in addition to adapting to fixed tool transformations, participants also actively controlled tool transformations to facilitate tool use actions.
- 1 January 2012
- Published by Hogrefe Publishing Group in Zeitschrift für Psychologie
- Vol. 220 (1) , 37-43
Where to Grasp a Tool?
Biomechanical and environmental constraints limit body movements and tool use actions. However, in the case of tool use, such constraints can often be overcome by adjusting a tool’s tool transformation to the requirements of the intended tool use action. The research presented here examined whether participants grasped a lever at different positions, thus modifying the lever’s tool transformation, to accommodate speed and accuracy requirements of different tasks. Participants were asked to quickly track a sequence of targets with the lever. If accuracy requirements were high, participants compensated for limits in the accuracy of hand movements by grasping the lever at a position that enabled precise control of the lever. If accuracy requirements were low, participants compensated for limits in hand speed by grasping the lever at a position that enabled fast lever movements with comparatively slow hand movements. This task-dependent grasp selection was only present after participants had practiced the tasks. The data show that in addition to adapting to fixed tool transformations, participants also actively controlled tool transformations to facilitate tool use actions.