Thomas John Balk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Thomas John Balk has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Ye Sun
University of Kentucky
4 shared publicationsWen-Chung Li
Department of Chemical and Materials Engineering, University of Kentucky, Lexington, 40506-0046 KY, USA
3 shared publicationsAndrew M. Minor
National Center for Electron Microscopy, Lawrence Berkeley National Laboratory, Berkeley, California 94720
2 shared publicationsJia Ye
National Center for Electron Microscopy, Lawrence Berkeley National Laboratory, Berkeley, California 94720
2 shared publications- C. Eberl
Institute for Micro Systems Technology Albert-Ludwigs University, Fahnenbergplatz 79110 Freiburg Germany
1 shared publication Chris Eberl
Karlsruhe Institute of Technology, izbs
1 shared publication
Latest Publications
- 9 December 2010
- Published by Elsevier in Thin Solid Films
- Vol. 519 (8) , 2393-2397
Transition from single- to multi-layered structures in nanoporous gold–palladium ultrathin films
- 9 December 2010
- Published by Elsevier in Thin Solid Films
- Vol. 519 (8) , 2393-2397
Transition from single- to multi-layered structures in nanoporous gold–palladium ultrathin films
- 31 December 2009
- Published by Elsevier in Scripta Materialia
- Vol. 61 (12) , 1125-1128
Effects of substrate curvature on dealloying of nanoporous thin films
- 31 December 2009
- Published by Elsevier in Scripta Materialia
- Vol. 61 (12) , 1125-1128
Effects of substrate curvature on dealloying of nanoporous thin films
- Open Access
Preparation and Hydrogen Absorption/Desorption of Nanoporous Palladium Thin Films
Nanoporous Pd (np-Pd) was prepared by co-sputtering Pd-Ni alloy films onto Si substrates, followed by chemical dealloying with sulfuric acid. X-ray diffractometry and chemical analysis were used to track the extent of dealloying. The np-Pd structure was changed from particle-like to sponge-like by diluting the sulfuric acid etchant. Using suitable precursor alloy composition and dealloying conditions, np-Pd films were prepared with uniform and open sponge-like structures, with interconnected ligaments and no cracks, yielding a large amount of surface area for reactions with hydrogen. Np-Pd films exhibited shorter response time for hydrogen absorption/desorption than dense Pd films, showing promise for hydrogen sensing.
Open AccessPreparation and Hydrogen Absorption/Desorption of Nanoporous Palladium Thin Films
Nanoporous Pd (np-Pd) was prepared by co-sputtering Pd-Ni alloy films onto Si substrates, followed by chemical dealloying with sulfuric acid. X-ray diffractometry and chemical analysis were used to track the extent of dealloying. The np-Pd structure was changed from particle-like to sponge-like by diluting the sulfuric acid etchant. Using suitable precursor alloy composition and dealloying conditions, np-Pd films were prepared with uniform and open sponge-like structures, with interconnected ligaments and no cracks, yielding a large amount of surface area for reactions with hydrogen. Np-Pd films exhibited shorter response time for hydrogen absorption/desorption than dense Pd films, showing promise for hydrogen sensing.
- 12 December 2009
- Published by Springer Nature in JOM
- Vol. 61 (12) , 26-31
Tensile and compressive microspecimen testing of bulk nanoporous gold
- 12 December 2009
- Published by Springer Nature in JOM
- Vol. 61 (12) , 26-31
Tensile and compressive microspecimen testing of bulk nanoporous gold
- 22 January 2009
- Published by Wiley in Microscopy Research and Technique
- Vol. 72 (3) , 232-241
In situ indentation of nanoporous gold thin films in the transmission electron microscope
The mechanical behavior of nanoporous gold was investigated during in situ nanoindentation in the transmission electron microscope. Thin films of nanoporous gold, with ligaments and pores of the order of 10‐nm diameter, offer a highly constrained geometry for deformation and thus provide an opportunity to study the role of defects such as dislocations in the plasticity of nanomaterials. Films ranging in thickness from 75 to 300 nm were indented, while the motion of dislocations and deformation of ligaments were observed in situ. Dislocations were generated and moved along ligament axes, after which they interacted with other dislocations in the nodes of the porous network. For thicker films, the load‐displacement curves exhibited load drops at regular intervals. The question of whether the spacing of these load drops was related to the collapse of pores in the nanoporous films or due to bursts of plasticity within the ligaments was investigated. Additionally, the effect of the indenter displacement rate on the mechanical response of these gold films with nanoscale porosity was investigated. Indentation rates were varied from 1.5 to 30 nm/s. There appears to be a kinetic factor related to dislocation nucleation, where slower displacement rates cause load drops to occur at shorter distance intervals and over longer time intervals. Microsc. Res. Tech., 2009.
- 22 January 2009
- Published by Wiley in Microscopy Research and Technique
- Vol. 72 (3) , 232-241
In situ indentation of nanoporous gold thin films in the transmission electron microscope
The mechanical behavior of nanoporous gold was investigated during in situ nanoindentation in the transmission electron microscope. Thin films of nanoporous gold, with ligaments and pores of the order of 10‐nm diameter, offer a highly constrained geometry for deformation and thus provide an opportunity to study the role of defects such as dislocations in the plasticity of nanomaterials. Films ranging in thickness from 75 to 300 nm were indented, while the motion of dislocations and deformation of ligaments were observed in situ. Dislocations were generated and moved along ligament axes, after which they interacted with other dislocations in the nodes of the porous network. For thicker films, the load‐displacement curves exhibited load drops at regular intervals. The question of whether the spacing of these load drops was related to the collapse of pores in the nanoporous films or due to bursts of plasticity within the ligaments was investigated. Additionally, the effect of the indenter displacement rate on the mechanical response of these gold films with nanoscale porosity was investigated. Indentation rates were varied from 1.5 to 30 nm/s. There appears to be a kinetic factor related to dislocation nucleation, where slower displacement rates cause load drops to occur at shorter distance intervals and over longer time intervals. Microsc. Res. Tech., 2009.
- 16 September 2008
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 39 (11) , 2656-2665
Evolution of Structure, Composition, and Stress in Nanoporous Gold Thin Films with Grain-Boundary Cracks
- 16 September 2008
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 39 (11) , 2656-2665
Evolution of Structure, Composition, and Stress in Nanoporous Gold Thin Films with Grain-Boundary Cracks
- 31 August 2008
- Published by Elsevier in Scripta Materialia
- Vol. 59 (4) , 467-470
Mechanical spectroscopy of nanocrystalline nickel near room temperature
- 31 August 2008
- Published by Elsevier in Scripta Materialia
- Vol. 59 (4) , 467-470
Mechanical spectroscopy of nanocrystalline nickel near room temperature
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1098
Microstructure and Hydrogen Absorption/Desorption Behavior of Nanoporous Pd Thin Films
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1098
Microstructure and Hydrogen Absorption/Desorption Behavior of Nanoporous Pd Thin Films
- 6 September 2007
- Published by Springer Nature in JOM
- Vol. 59 (9) , 54-58
The mechanical behavior of nanoporous gold thin films
- 6 September 2007
- Published by Springer Nature in JOM
- Vol. 59 (9) , 54-58
The mechanical behavior of nanoporous gold thin films
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 924
Mechanical Behavior and Microstructure of Nanoporous Gold Films
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 924
Mechanical Behavior and Microstructure of Nanoporous Gold Films