Emilia Giorgetti
Research Subjects
Emilia Giorgetti has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
- Stefano Sottini
Istituto di ricerca sulle Onde Elettromagnetiche, Consiglio Nazionale delle Richerche, Via Panciatichi 64, 50127 Firenze, Italy
6 shared publications Francesco Giammanco
University of Pisa
4 shared publications- Eduardo Arias
Centro de Investigación en Química Aplicada, Boulevard Enrique Reyna 140, 25294 Saltillo, Coahuila, Mexico
3 shared publications F. Giammanco
Department of Physics "E. Fermi", University of Pisa, Largo Bruno Pontecorvo 3, 56127 Pisa, Italy
3 shared publications- Maurizio Muniz-Miranda
Department of Chemistry “Ugo Schiff”, University of Florence, Via Lastruccia 3, 50019 Sesto Fiorentino, Italy
3 shared publications P. Marsili
Istituto dei Sistemi Complessi, Consiglio Nazionale delle Ricerche, Via Madonna del Piano 10, 50019 Sesto Fiorentino (FI), Italy; Department of Physics "E. Fermi", University of Pisa, Largo Bruno Pontecorvo 3, 56127 Pisa, Italy
3 shared publications
Latest Publications
- Open Access
- 10 January 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (1) , 132
Spectroscopic and Microscopic Analyses of Fe3O4/Au Nanoparticles Obtained by Laser Ablation in Water
Magneto-plasmonic nanoparticles constituted of gold and iron oxide were obtained in an aqueous environment by laser ablation of iron and gold targets in two successive steps. Gold nanoparticles are embedded in a mucilaginous matrix of iron oxide, which was identified as magnetite by both microscopic and spectroscopic analyses. The plasmonic properties of the obtained colloids, as well as their adsorption capability, were tested by surface-enhanced Raman scattering (SERS) spectroscopy using 2,2′-bipyridine as a probe molecule. DFT calculations allowed for obtaining information on the adsorption of the ligand molecules that strongly interact with positively charged surface active sites of the gold nanoparticles, thus providing efficient SERS enhancement. The presence of iron oxide gives the bimetallic colloid new possibilities of adsorption in addition to those inherent to gold nanoparticles, especially regarding organic pollutants and heavy metals, allowing to remove them from the aqueous environment by applying a magnetic field. Moreover, these nanoparticles, thanks to their low toxicity, are potentially useful not only in the field of sensors, but also for biomedical applications.
- 10 January 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (1) , 132
Open AccessSpectroscopic and Microscopic Analyses of Fe3O4/Au Nanoparticles Obtained by Laser Ablation in Water
Magneto-plasmonic nanoparticles constituted of gold and iron oxide were obtained in an aqueous environment by laser ablation of iron and gold targets in two successive steps. Gold nanoparticles are embedded in a mucilaginous matrix of iron oxide, which was identified as magnetite by both microscopic and spectroscopic analyses. The plasmonic properties of the obtained colloids, as well as their adsorption capability, were tested by surface-enhanced Raman scattering (SERS) spectroscopy using 2,2′-bipyridine as a probe molecule. DFT calculations allowed for obtaining information on the adsorption of the ligand molecules that strongly interact with positively charged surface active sites of the gold nanoparticles, thus providing efficient SERS enhancement. The presence of iron oxide gives the bimetallic colloid new possibilities of adsorption in addition to those inherent to gold nanoparticles, especially regarding organic pollutants and heavy metals, allowing to remove them from the aqueous environment by applying a magnetic field. Moreover, these nanoparticles, thanks to their low toxicity, are potentially useful not only in the field of sensors, but also for biomedical applications.
- Open Access
Supramolecular Recognition of Escherichia coli Bacteria by Fluorescent Oligo(Phenyleneethynylene)s with Mannopyranoside Termini Groups
Escherichia coli is one the most common bacteria responsible of uropathogenic diseases, which motives the search for rapid and easy methods of detection. By taking advantage of the specific interactions between mannose and type 1 fimbriae, in this work two fluorescent phenyleneethynylene (PE) trimers bearing one or two 4-aminophenyl-α-D-mannopyranoside termini groups were synthesized for the detection of E. coli. Three bacterial strains: ORN 178 (fimbriae I expression), ORN 208 (mutant serotype with no fimbriae expression) and one obtained from a local hospital (SS3) were used. Laser Scanning Confocal Microscopy (LSCM) and Surface Plasmon Resonance (SPR) were applied for the interaction studies following two different approaches: (1) mixing the oligomer solutions with the bacterial suspension, which permitted the observation of stained bacteria and by (2) biosensing as thin films, where bacteria adhered on the surface-functionalized substrate. LSCM allows one to easily visualize that two mannose groups are necessary to have a specific interaction with the fimbriae 1. The sensitivity of SPR assays to E. coli was 104 colony forming unit (CFU)/mL at 50 µL/min flow rate. The combination of PE units with two mannose groups results in a novel molecule that can be used as a specific fluorescent marker as well as a transducer for the detection of E. coli.
Open AccessSupramolecular Recognition of Escherichia coli Bacteria by Fluorescent Oligo(Phenyleneethynylene)s with Mannopyranoside Termini Groups
Escherichia coli is one the most common bacteria responsible of uropathogenic diseases, which motives the search for rapid and easy methods of detection. By taking advantage of the specific interactions between mannose and type 1 fimbriae, in this work two fluorescent phenyleneethynylene (PE) trimers bearing one or two 4-aminophenyl-α-D-mannopyranoside termini groups were synthesized for the detection of E. coli. Three bacterial strains: ORN 178 (fimbriae I expression), ORN 208 (mutant serotype with no fimbriae expression) and one obtained from a local hospital (SS3) were used. Laser Scanning Confocal Microscopy (LSCM) and Surface Plasmon Resonance (SPR) were applied for the interaction studies following two different approaches: (1) mixing the oligomer solutions with the bacterial suspension, which permitted the observation of stained bacteria and by (2) biosensing as thin films, where bacteria adhered on the surface-functionalized substrate. LSCM allows one to easily visualize that two mannose groups are necessary to have a specific interaction with the fimbriae 1. The sensitivity of SPR assays to E. coli was 104 colony forming unit (CFU)/mL at 50 µL/min flow rate. The combination of PE units with two mannose groups results in a novel molecule that can be used as a specific fluorescent marker as well as a transducer for the detection of E. coli.
- 1 October 2015
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 456, 182-189
Synthesis of mercaptopropyl-(phenylene)s-benzoates passivated gold nanoparticles: Implications for plasmonic photovoltaic cells
- 1 October 2015
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 456, 182-189
Synthesis of mercaptopropyl-(phenylene)s-benzoates passivated gold nanoparticles: Implications for plasmonic photovoltaic cells
- 12 May 2015
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 17 (5) , 1-14
Cyto- and genotoxicity assessment of Gold nanoparticles obtained by laser ablation in A549 lung adenocarcinoma cells
- 12 May 2015
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 17 (5) , 1-14
Cyto- and genotoxicity assessment of Gold nanoparticles obtained by laser ablation in A549 lung adenocarcinoma cells
- 1 March 2015
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 442, 89-96
Preparation of small size palladium nanoparticles by picosecond laser ablation and control of metal concentration in the colloid
- 1 March 2015
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 442, 89-96
Preparation of small size palladium nanoparticles by picosecond laser ablation and control of metal concentration in the colloid
- 2 February 2014
- Published by Springer Nature in Applied Physics A
- Vol. 117 (1) , 327-331
Spectroscopic evidence of positive clusters in Ag colloids obtained by laser ablation in aqueous solutions
- 2 February 2014
- Published by Springer Nature in Applied Physics A
- Vol. 117 (1) , 327-331
Spectroscopic evidence of positive clusters in Ag colloids obtained by laser ablation in aqueous solutions
- 16 December 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 15 (1) , 1-12
Cu/Ag-based bifunctional nanoparticles obtained by one-pot laser-assisted galvanic replacement
- 16 December 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 15 (1) , 1-12
Cu/Ag-based bifunctional nanoparticles obtained by one-pot laser-assisted galvanic replacement
- 28 August 2012
- Published by Springer Nature in Applied Physics A
- Vol. 110 (4) , 829-833
Characterization of Copper nanoparticles obtained by laser ablation in liquids
- 28 August 2012
- Published by Springer Nature in Applied Physics A
- Vol. 110 (4) , 829-833
Characterization of Copper nanoparticles obtained by laser ablation in liquids
- 14 March 2012
- Published by Wiley in Physica Status Solidi (b)
- Vol. 249 (6) , 1188-1192
Tunable gold nanostars for surface enhanced Raman spectroscopy
We fabricated stable gold nanostars (AuNSs) with tunable extinction properties from the visible spectral region up to 1800 nm, depending on the average values of core size and branch length. The results of their UV–Vis and transmission electron microscopy characterization are compared with computational data from finite elements method, which makes use of an approximated model of the branched structures. The theoretical computations put in evidence the existence of hot spots located on the tips of the nanostars even up to 1800 nm wavelength, which opens the way to the improvement of diagnostics in the IR region. Preliminary Fourier transform Raman experiments performed after functionalization with a fluorescent dye bearing end thiol groups seem to confirm the field enhancing capability of the nanostructures at 1064 nm.
- 14 March 2012
- Published by Wiley in Physica Status Solidi (b)
- Vol. 249 (6) , 1188-1192
Tunable gold nanostars for surface enhanced Raman spectroscopy
We fabricated stable gold nanostars (AuNSs) with tunable extinction properties from the visible spectral region up to 1800 nm, depending on the average values of core size and branch length. The results of their UV–Vis and transmission electron microscopy characterization are compared with computational data from finite elements method, which makes use of an approximated model of the branched structures. The theoretical computations put in evidence the existence of hot spots located on the tips of the nanostars even up to 1800 nm wavelength, which opens the way to the improvement of diagnostics in the IR region. Preliminary Fourier transform Raman experiments performed after functionalization with a fluorescent dye bearing end thiol groups seem to confirm the field enhancing capability of the nanostructures at 1064 nm.
- 18 January 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 14 (1) , 1-13
Stable gold nanoparticles obtained in pure acetone by laser ablation with different wavelengths
- 18 January 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 14 (1) , 1-13
Stable gold nanoparticles obtained in pure acetone by laser ablation with different wavelengths