Ignacio Galiana
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ignacio Galiana has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Manuel Ferre
Universidad Politécnica de Madrid
2 shared publications- Manuel Ferre
Universidad Politécnica de Madrid
2 shared publications - Antonio Gimenez
CIESOL ARM University of Almería Spain
1 shared publication - Javier López-Martínez
CIAIMBITAL Research Centre, University of Almería, Ctra. de Sacramento s/n, 04120 Almería, Spain
1 shared publication Jorge Barrio
Universidad Politécnica de Madrid
1 shared publication- Jorge Barrio
Universidad Politecnica de Madrid, Madrid, Spain
1 shared publication
Latest Publications
- 1 January 2013
- Published by Springer Nature
- p. 55-83
Modular Multi-finger Haptic Device: Mechanical Design, Controller and Applications
- 1 January 2013
- Published by Springer Nature
- p. 55-83
Modular Multi-finger Haptic Device: Mechanical Design, Controller and Applications
- 1 January 2013
- Published by Springer Nature
- p. 1-3
Introduction
- 15 July 2012
- Published by Faculty of Mechanical Engineering in Strojniški vestnik - Journal of Mechanical Engineering
- Vol. 58 (7) , 431-443
Mechanical Design Optimization for Multi-Finger Haptic Devices Applied to Virtual Grasping Manipulation
- 15 July 2012
- Published by Faculty of Mechanical Engineering in Strojniški vestnik - Journal of Mechanical Engineering
- Vol. 58 (7) , 431-443
Mechanical Design Optimization for Multi-Finger Haptic Devices Applied to Virtual Grasping Manipulation
- Open Access
Design of a Lightweight, Cost Effective Thimble-Like Sensor for Haptic Applications Based on Contact Force Sensors
This paper describes the design and calibration of a thimble that measures the forces applied by a user during manipulation of virtual and real objects. Haptic devices benefit from force measurement capabilities at their end-point. However, the heavy weight and cost of force sensors prevent their widespread incorporation in these applications. The design of a lightweight, user-adaptable, and cost-effective thimble with four contact force sensors is described in this paper. The sensors are calibrated before being placed in the thimble to provide normal and tangential forces. Normal forces are exerted directly by the fingertip and thus can be properly measured. Tangential forces are estimated by sensors strategically placed in the thimble sides. Two applications are provided in order to facilitate an evaluation of sensorized thimble performance. These applications focus on: (i) force signal edge detection, which determines task segmentation of virtual object manipulation, and (ii) the development of complex object manipulation models, wherein the mechanical features of a real object are obtained and these features are then reproduced for training by means of virtual object manipulation.
Open AccessDesign of a Lightweight, Cost Effective Thimble-Like Sensor for Haptic Applications Based on Contact Force Sensors
This paper describes the design and calibration of a thimble that measures the forces applied by a user during manipulation of virtual and real objects. Haptic devices benefit from force measurement capabilities at their end-point. However, the heavy weight and cost of force sensors prevent their widespread incorporation in these applications. The design of a lightweight, user-adaptable, and cost-effective thimble with four contact force sensors is described in this paper. The sensors are calibrated before being placed in the thimble to provide normal and tangential forces. Normal forces are exerted directly by the fingertip and thus can be properly measured. Tangential forces are estimated by sensors strategically placed in the thimble sides. Two applications are provided in order to facilitate an evaluation of sensorized thimble performance. These applications focus on: (i) force signal edge detection, which determines task segmentation of virtual object manipulation, and (ii) the development of complex object manipulation models, wherein the mechanical features of a real object are obtained and these features are then reproduced for training by means of virtual object manipulation.