Fang Cao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Fang Cao has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Yong He
Zhejiang University
3 shared publications - Di Wu
College of Agriculture & Biotechnology, Zhejiang University, Hangzhou 310058, China
2 shared publications - Da-Wen Sun
School of Food Science and Engineering South China University of Technology Guangzhou China
1 shared publication Di Wu
College of Biosystems Engineering and Food Science, Zhejiang University, Hangzhou 310029, China
1 shared publicationGuang-Ming Sun
1 shared publicationHai-Yan Song
1 shared publication
Latest Publications
- Open Access
Potential of Visible and Near Infrared Spectroscopy and Pattern Recognition for Rapid Quantification of Notoginseng Powder with Adulterants
Notoginseng is a classical traditional Chinese medical herb, which is of high economic and medical value. Notoginseng powder (NP) could be easily adulterated with Sophora flavescens powder (SFP) or corn flour (CF), because of their similar tastes and appearances and much lower cost for these adulterants. The objective of this study is to quantify the NP content in adulterated NP by using a rapid and non-destructive visible and near infrared (Vis-NIR) spectroscopy method. Three wavelength ranges of visible spectra, short-wave near infrared spectra (SNIR) and long-wave near infrared spectra (LNIR) were separately used to establish the model based on two calibration methods of partial least square regression (PLSR) and least-squares support vector machines (LS-SVM), respectively. Competitive adaptive reweighted sampling (CARS) was conducted to identify the most important wavelengths/variables that had the greatest influence on the adulterant quantification throughout the whole wavelength range. The CARS-PLSR models based on LNIR were determined as the best models for the quantification of NP adulterated with SFP, CF, and their mixtures, in which the rP values were 0.940, 0.939, and 0.867 for the three models respectively. The research demonstrated the potential of the Vis-NIR spectroscopy technique for the rapid and non-destructive quantification of NP containing adulterants.
Open AccessPotential of Visible and Near Infrared Spectroscopy and Pattern Recognition for Rapid Quantification of Notoginseng Powder with Adulterants
Notoginseng is a classical traditional Chinese medical herb, which is of high economic and medical value. Notoginseng powder (NP) could be easily adulterated with Sophora flavescens powder (SFP) or corn flour (CF), because of their similar tastes and appearances and much lower cost for these adulterants. The objective of this study is to quantify the NP content in adulterated NP by using a rapid and non-destructive visible and near infrared (Vis-NIR) spectroscopy method. Three wavelength ranges of visible spectra, short-wave near infrared spectra (SNIR) and long-wave near infrared spectra (LNIR) were separately used to establish the model based on two calibration methods of partial least square regression (PLSR) and least-squares support vector machines (LS-SVM), respectively. Competitive adaptive reweighted sampling (CARS) was conducted to identify the most important wavelengths/variables that had the greatest influence on the adulterant quantification throughout the whole wavelength range. The CARS-PLSR models based on LNIR were determined as the best models for the quantification of NP adulterated with SFP, CF, and their mixtures, in which the rP values were 0.940, 0.939, and 0.867 for the three models respectively. The research demonstrated the potential of the Vis-NIR spectroscopy technique for the rapid and non-destructive quantification of NP containing adulterants.
- 1 December 2009
- Vol. 29 (12) , 3295-9
[Study on disease level classification of rice panicle blast based on visible and near infrared spectroscopy].
Visible and near infrared (Vis-NIR) spectroscopy was used to fast and non-destructively classify the disease levels of rice panicle blast. Reflectance spectra between 325 and 1 075 nm were measured. Kennard-Stone algorithm was operated to separate samples into calibration and prediction sets. Different spectral pretreatment methods, including standard normal variate (SNV) and multiplicative scatter correction (MSC), were used for the spectral pretreatment before further spectral analysis. A hybrid wavelength variable selection method which is combined with uninformative variable elimination (UVE) and successive projections algorithm (SPA) was operated to select effective wavelength variables from original spectra, SNV pretreated spectra and MSC pretreated spectra, respectively. UVE was firstly operated to remove uninformative wavelength variables from the full-spectrum. Then SPA selected the effective wavelength variables with less colinearity after UVE. Least square-support vector machine (LS-SVM) was used as the calibration method for the spectral analysis in this study. The selected effective wavelengths were set as input variables of LS-SVM model. The LS-SVM model established based on SNV-UVE-SPA obtained the best results. Only six effective wavelengths (459, 546, 569, 590, 775 and 981 nm) were selected from the full-spectrum which has 600 wavelength variables by UVE-SPA, and their LS-SVM model's performance was further improved. For SNV-UVE-SPA-LS-SVM model, coefficient of determination for prediction set (R2(p)), root mean square error for prediction (RMSEP) and residual predictive deviation (RPD) were 0.979, 0.507 and 6.580, respectively. The overall results indicate that Vis-NIR spectroscopy is a feasible way to classify disease levels of rice panicle blast fast and non-destructively. UVE-SPA is an efficient variable selection method for the spectral analysis, and their selected effective wavelengths can represent the useful information of the full-spectrum and have higher signal/noise ratio and less colinearity.
- 1 December 2009
- Vol. 29 (12) , 3295-9
[Study on disease level classification of rice panicle blast based on visible and near infrared spectroscopy].
Visible and near infrared (Vis-NIR) spectroscopy was used to fast and non-destructively classify the disease levels of rice panicle blast. Reflectance spectra between 325 and 1 075 nm were measured. Kennard-Stone algorithm was operated to separate samples into calibration and prediction sets. Different spectral pretreatment methods, including standard normal variate (SNV) and multiplicative scatter correction (MSC), were used for the spectral pretreatment before further spectral analysis. A hybrid wavelength variable selection method which is combined with uninformative variable elimination (UVE) and successive projections algorithm (SPA) was operated to select effective wavelength variables from original spectra, SNV pretreated spectra and MSC pretreated spectra, respectively. UVE was firstly operated to remove uninformative wavelength variables from the full-spectrum. Then SPA selected the effective wavelength variables with less colinearity after UVE. Least square-support vector machine (LS-SVM) was used as the calibration method for the spectral analysis in this study. The selected effective wavelengths were set as input variables of LS-SVM model. The LS-SVM model established based on SNV-UVE-SPA obtained the best results. Only six effective wavelengths (459, 546, 569, 590, 775 and 981 nm) were selected from the full-spectrum which has 600 wavelength variables by UVE-SPA, and their LS-SVM model's performance was further improved. For SNV-UVE-SPA-LS-SVM model, coefficient of determination for prediction set (R2(p)), root mean square error for prediction (RMSEP) and residual predictive deviation (RPD) were 0.979, 0.507 and 6.580, respectively. The overall results indicate that Vis-NIR spectroscopy is a feasible way to classify disease levels of rice panicle blast fast and non-destructively. UVE-SPA is an efficient variable selection method for the spectral analysis, and their selected effective wavelengths can represent the useful information of the full-spectrum and have higher signal/noise ratio and less colinearity.
- 1 May 2008
- Vol. 28 (5) , 1071-5
[Application of infrared spectroscopy technique to protein content fast measurement in milk powder based on support vector machines].
In the present study, the JASCO Model FTIR-4 000 fourier transform infrared spectrometer (Japan) was used, with a valid range of 7 800-350 cm(-1). Seven brands of milk powder were bought in a local supermarket. Milk powder was compressed into a uniform tablet with a diameter of 5 mm and a thickness of 2 mm, and then scanned by the spectrometer. Each sample was scanned 40 times and the data were averaged. About 60 samples were measured for each brand, and data for 409 samples were obtained. NIRS analysis was based on the range of 4 000 to 6 666 cm(-1), while MIRS analysis was between 400 and 4 000 cm(-1). The protein content was determined by kjeldahl method and the factor 6.38 was used to convert the nitrogen values to protein. The protein content value is the weight of protein per 100 g of milk powder. The NIR data of the milk powder exhibited slight differences. Univariate analysis was not really appropriate for analyzing the data sets. From NIRS region, it could be observed that the trend of different curves is similar. The one around 4 312 cm(-1) embodies the vibration of protein. From MIRS region, it could be determined that there are many differences between transmission value curves. Two troughs around 1 545 and 1 656 cm(-1) stand for the vibration of amide I and II bands of protein. The smoothing way of Savitzky-Golay with 3 segments and zero polynomials and multiplicative scatter correction (MSC) were applied for denoising. First 8 important principle components (PCs), which were obtained from principle component analysis (PCA), were the optimal input feature subset. Least-squares support vector machines was applied to build the protein prediction model based on infrared spectral transmission value. The prediction result was better than that of traditional PLS regression model as the determination coefficient for prediction (R(p)2) is 0.951 7 and root mean square error for prediction (RMSEP) is 0.520 201. These indicate that LS-SVM is a powerful tool for spectral analysis. Moreover, the study compared the prediction results based on near infrared spectral data and mid-infrared spectral data. The results showed that the performance of the model with mid-infrared spectral data was better than the one with near infrared spectra data. It was concluded that infrared spectroscopy technique can do the quantification of protein content in milk powder fast and non-destructively and the process was simple and easy to operate. The results of this study can be used for the design of a simple and non-destructive spectra sensor for the quantitative of protein content in milk powder.
- 1 May 2008
- Vol. 28 (5) , 1071-5
[Application of infrared spectroscopy technique to protein content fast measurement in milk powder based on support vector machines].
In the present study, the JASCO Model FTIR-4 000 fourier transform infrared spectrometer (Japan) was used, with a valid range of 7 800-350 cm(-1). Seven brands of milk powder were bought in a local supermarket. Milk powder was compressed into a uniform tablet with a diameter of 5 mm and a thickness of 2 mm, and then scanned by the spectrometer. Each sample was scanned 40 times and the data were averaged. About 60 samples were measured for each brand, and data for 409 samples were obtained. NIRS analysis was based on the range of 4 000 to 6 666 cm(-1), while MIRS analysis was between 400 and 4 000 cm(-1). The protein content was determined by kjeldahl method and the factor 6.38 was used to convert the nitrogen values to protein. The protein content value is the weight of protein per 100 g of milk powder. The NIR data of the milk powder exhibited slight differences. Univariate analysis was not really appropriate for analyzing the data sets. From NIRS region, it could be observed that the trend of different curves is similar. The one around 4 312 cm(-1) embodies the vibration of protein. From MIRS region, it could be determined that there are many differences between transmission value curves. Two troughs around 1 545 and 1 656 cm(-1) stand for the vibration of amide I and II bands of protein. The smoothing way of Savitzky-Golay with 3 segments and zero polynomials and multiplicative scatter correction (MSC) were applied for denoising. First 8 important principle components (PCs), which were obtained from principle component analysis (PCA), were the optimal input feature subset. Least-squares support vector machines was applied to build the protein prediction model based on infrared spectral transmission value. The prediction result was better than that of traditional PLS regression model as the determination coefficient for prediction (R(p)2) is 0.951 7 and root mean square error for prediction (RMSEP) is 0.520 201. These indicate that LS-SVM is a powerful tool for spectral analysis. Moreover, the study compared the prediction results based on near infrared spectral data and mid-infrared spectral data. The results showed that the performance of the model with mid-infrared spectral data was better than the one with near infrared spectra data. It was concluded that infrared spectroscopy technique can do the quantification of protein content in milk powder fast and non-destructively and the process was simple and easy to operate. The results of this study can be used for the design of a simple and non-destructive spectra sensor for the quantitative of protein content in milk powder.
- 1 September 2007
- Vol. 27 (9) , 1731-4
[Study on the relationship between spectral properties of oilseed rape leaves and their chlorophyll content].
Chlorophyll is the important factors of the crop in its growth stage, and it is the favorable indicator of nutrition stress and photosynthesis. Site-specific crop nutrition diagnosis is the basics of the scientific fertilizer management, and it is essential for the practice of precision agriculture. Spectral properties of the oilseed rape leaves in different nitrogenous fertilizer levels were measured using visible-near infrared reflectance spectroscopy (Vis-NIRS) with natural illumination in the present study. According to the unique spectral properties of the crop, multiple stepwise regression technique was used to find the relationships between chlorophyll content and red edge, green edge. The result shows that the model with two independent variables (red edge, green edge) was better than with the one independeot variable (red edge). The correlation coefficient was 0.863, 0.848, and SEC was 5.273, 5.459, respectively. It can be seen the combination of the red edge and green edge can accurately predict chlorophyll content.
- 1 September 2007
- Vol. 27 (9) , 1731-4
[Study on the relationship between spectral properties of oilseed rape leaves and their chlorophyll content].
Chlorophyll is the important factors of the crop in its growth stage, and it is the favorable indicator of nutrition stress and photosynthesis. Site-specific crop nutrition diagnosis is the basics of the scientific fertilizer management, and it is essential for the practice of precision agriculture. Spectral properties of the oilseed rape leaves in different nitrogenous fertilizer levels were measured using visible-near infrared reflectance spectroscopy (Vis-NIRS) with natural illumination in the present study. According to the unique spectral properties of the crop, multiple stepwise regression technique was used to find the relationships between chlorophyll content and red edge, green edge. The result shows that the model with two independent variables (red edge, green edge) was better than with the one independeot variable (red edge). The correlation coefficient was 0.863, 0.848, and SEC was 5.273, 5.459, respectively. It can be seen the combination of the red edge and green edge can accurately predict chlorophyll content.