Zheng Jiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Zheng Jiao has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
Feng Chen
Dept. of Autom., Univ. of Sci. & Technol. of China, Hefei, China
3 shared publicationsMinghong Wu
3 shared publicationsJinhuai Liu
Hefei Institute of Intelligent Machines, Chinese Academy of Science, Hefei 230031, P.R. China
2 shared publicationsZheng Qin
Shanghai Applied Radiation Institute, Shanghai University, Shanghai 201800, P.R.China
2 shared publicationsBing Zhao
Institute of Nanochemistry and Nanobiology, Shanghai University, Shanghai 201800, China
1 shared publicationGang Ye
Hefei Institute of Intelligent Machines, Chinese Academy of Science, Hefei 230031, P.R. China
1 shared publication
Latest Publications
- 1 February 2009
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 9 (2) , 1312-1315
Synthesis of CdS Nanorods in Soft Template Under γ-Irradiation
CdS nano material which has a band gap of 2.42 eV at room temperature is a typical II–VII semiconductor having many commercial or potential applications, e.g., light-emitting diodes, solar cell and optoelectronic devices. In this paper, we use a new strategy to synthesize CdS nanorods. CdS nanorods were prepared in soft template under γ-irradiation though the reaction of cadmium sulphide and thiacetamide (TAA). The formation process and characters of CdS nanorods was investigated in detail by transmission electron microscopy (TEM), electron diffraction (ED) pattern, X-ray powder diffraction (XRD), ultraviolet spectrophotometer (UV) and photoluminescence spectrophotometer (PL). In the experiment we proposed that the irradiation of γ-ray accelerated the formation of S2− under acidic condition (pH = 3) and vinyl acetate (VAc) monomer formed pre-organized nano polymer tubules which were used as both templates and nanoreacters for the growth of CdS nanorods. In this process, we have obtained the CdS polycrystal nanorods with PVAc nano tubules and CdS single-crystal nanorods. The result of X-ray powder diffraction confirms that the crystal type of CdS nanorods is cubic F-43 m (216). The results from transmission electron microscopy and electron diffraction show that the concentrations of reactants and the dose rate of γ-ray are key to produce appropriate CdS nanorods. Relatively low concentrations (Cd2+: 0.008∼0.02 mol/L, Cd2+:S2− = 1 : 2) of reactants and long time (1∼2 d) of irradiation in low dose rate (6∼14 Gy/min) are propitious to form CdS single-crystal nanorods with small diameter (less than 100 nm) and well length (2–5 μm). UV and PL characterizations show the sample have well optical properties.
- 1 February 2009
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 9 (2) , 1312-1315
Synthesis of CdS Nanorods in Soft Template Under γ-Irradiation
CdS nano material which has a band gap of 2.42 eV at room temperature is a typical II–VII semiconductor having many commercial or potential applications, e.g., light-emitting diodes, solar cell and optoelectronic devices. In this paper, we use a new strategy to synthesize CdS nanorods. CdS nanorods were prepared in soft template under γ-irradiation though the reaction of cadmium sulphide and thiacetamide (TAA). The formation process and characters of CdS nanorods was investigated in detail by transmission electron microscopy (TEM), electron diffraction (ED) pattern, X-ray powder diffraction (XRD), ultraviolet spectrophotometer (UV) and photoluminescence spectrophotometer (PL). In the experiment we proposed that the irradiation of γ-ray accelerated the formation of S2− under acidic condition (pH = 3) and vinyl acetate (VAc) monomer formed pre-organized nano polymer tubules which were used as both templates and nanoreacters for the growth of CdS nanorods. In this process, we have obtained the CdS polycrystal nanorods with PVAc nano tubules and CdS single-crystal nanorods. The result of X-ray powder diffraction confirms that the crystal type of CdS nanorods is cubic F-43 m (216). The results from transmission electron microscopy and electron diffraction show that the concentrations of reactants and the dose rate of γ-ray are key to produce appropriate CdS nanorods. Relatively low concentrations (Cd2+: 0.008∼0.02 mol/L, Cd2+:S2− = 1 : 2) of reactants and long time (1∼2 d) of irradiation in low dose rate (6∼14 Gy/min) are propitious to form CdS single-crystal nanorods with small diameter (less than 100 nm) and well length (2–5 μm). UV and PL characterizations show the sample have well optical properties.
- 1 March 2007
- Vol. 28 (3) , 472-7
[Physicochemistry and bioreactivity characterization of fine particles (PM(2.5)) in Shanghai air].
PM(2.5) was collected at Shanghai urban and suburban sites during spring and autumn. PIXE (Proton Induced X-ray Emission) was used to investigate mass concentration of 15 elements (S, K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, As, Se, Br, Sr, Pb) in Shanghai PM(2.5). The total mass concentration of the 15 chemical elements was higher in spring (5 038.6 ng x m(-3)) than in summer (3 810.6 ng x m(-3)). In spring, mass concentrations of these elements in urban and suburban samples were in the same level. In summer, concentration of the elements in urban samples were lower than in suburban samples, however, the elements which were originated from anthropogenic resources were in higher level in urban samples. The results of FESEM showed that Shanghai PM(2.5) was consisted of soot aggregates, coal fly ashes, minerals, bio-particles and unidentified particles. The result of Plasmid DNA assay demonstrated bioreactivity of urban PM(2.5) was more reactive than that of suburban PM(2.5), this phenomenon probably was explained by higher mass level of heavy metals and more proportion of soot aggregates in urban PM(2.5).
- 1 March 2007
- Vol. 28 (3) , 472-7
[Physicochemistry and bioreactivity characterization of fine particles (PM(2.5)) in Shanghai air].
PM(2.5) was collected at Shanghai urban and suburban sites during spring and autumn. PIXE (Proton Induced X-ray Emission) was used to investigate mass concentration of 15 elements (S, K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, As, Se, Br, Sr, Pb) in Shanghai PM(2.5). The total mass concentration of the 15 chemical elements was higher in spring (5 038.6 ng x m(-3)) than in summer (3 810.6 ng x m(-3)). In spring, mass concentrations of these elements in urban and suburban samples were in the same level. In summer, concentration of the elements in urban samples were lower than in suburban samples, however, the elements which were originated from anthropogenic resources were in higher level in urban samples. The results of FESEM showed that Shanghai PM(2.5) was consisted of soot aggregates, coal fly ashes, minerals, bio-particles and unidentified particles. The result of Plasmid DNA assay demonstrated bioreactivity of urban PM(2.5) was more reactive than that of suburban PM(2.5), this phenomenon probably was explained by higher mass level of heavy metals and more proportion of soot aggregates in urban PM(2.5).
- Open Access
The NO2 sensing ITO thin films prepared by ultrasonic spray pyrolysis
In this paper ITO thin films were deposited on alumina substrates by ultrasonic spray pyrolysis. The NO2 sensing properties of ITO thin films were investigated. The results show ITO thin films have good sensitivity to nitrogen dioxide.
Open AccessThe NO2 sensing ITO thin films prepared by ultrasonic spray pyrolysis
In this paper ITO thin films were deposited on alumina substrates by ultrasonic spray pyrolysis. The NO2 sensing properties of ITO thin films were investigated. The results show ITO thin films have good sensitivity to nitrogen dioxide.
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
A novel processing for multiple gases detection
It is difficult to detect multiple gases by single chemical sensor because of nonlinear and complicated relations between multiple gas and surface of sensitive materials. In this paper, the technology of multisensor data fusion is applied to detect multiple gases. It is presented a novel detection method based on multiobjective genetic algorithm(MOGA) for analyzing and distinguishing each component's concentration in multiple gases. The multigas detection is transformed to multiobjective optimization problem. In order to avoid premature convergence, sharing function is introduced to maintain the diversity of the population. The theory of multiple gases detection is described in detail. The experimental results are given and the results demonstrate the mechanism proposed in this paper is effective.
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
A novel processing for multiple gases detection
It is difficult to detect multiple gases by single chemical sensor because of nonlinear and complicated relations between multiple gas and surface of sensitive materials. In this paper, the technology of multisensor data fusion is applied to detect multiple gases. It is presented a novel detection method based on multiobjective genetic algorithm(MOGA) for analyzing and distinguishing each component's concentration in multiple gases. The multigas detection is transformed to multiobjective optimization problem. In order to avoid premature convergence, sharing function is introduced to maintain the diversity of the population. The theory of multiple gases detection is described in detail. The experimental results are given and the results demonstrate the mechanism proposed in this paper is effective.
- 20 March 2003
- Published by IOP Publishing in Nanotechnology
- Vol. 14 (4) , 458-461
The electrochromic characteristics of sol gel-prepared NiO thin film
- 20 March 2003
- Published by IOP Publishing in Nanotechnology
- Vol. 14 (4) , 458-461
The electrochromic characteristics of sol gel-prepared NiO thin film
- Open Access
Study on the Characteristics of Ag Doped CuO-BaTiO3 CO2 Sensors
In this paper the characteristics of a CuO-BaTiO3 based CO2 gas sensor was investigated. The sensitivity of the CuO-BaTiO3 based CO2 sensor was influenced by doping various metal elements such as Au, Ag, Pt, Pd, Ce, Mg, Sr, La, Zn, Fe and Bi, which were added as a pure metal or in the form of metal oxides. It was found that Ag is the most suitable additive among all substances tested. The Ag-doped CO2 gas sensor has better sensitivity and lower operating temperature, with a detection concentration range of from 100 ppm to 10%. The sensor also shows good stability.
Open AccessStudy on the Characteristics of Ag Doped CuO-BaTiO3 CO2 Sensors
In this paper the characteristics of a CuO-BaTiO3 based CO2 gas sensor was investigated. The sensitivity of the CuO-BaTiO3 based CO2 sensor was influenced by doping various metal elements such as Au, Ag, Pt, Pd, Ce, Mg, Sr, La, Zn, Fe and Bi, which were added as a pure metal or in the form of metal oxides. It was found that Ag is the most suitable additive among all substances tested. The Ag-doped CO2 gas sensor has better sensitivity and lower operating temperature, with a detection concentration range of from 100 ppm to 10%. The sensor also shows good stability.
- Open Access
The Preparation of ZnGa2O4 Nano Crystals by Spray Coprecipitation and Its Gas Sensitive Characteristics
ZnGa2O4 nano crystals were prepared by an improved coprecipitation method, which we call ‘spray coprecipitation’. XRD results shows the resulting crystal size using the new method is under 10nm, whereas the powder prepared by ordinary coprecipitation is about 30nm. XRD results also shows ZnO peaks exists in ZnGa2O4 powder prepared by traditional coprecipitation, but disappears in ZnGa2O4 nano crystal prepared by spraying coprecipitation. SEM and TEM were used to analysis the structural characteristics of ZnGa2O4 nano crystals. The gas sensitive characteristics of ZnGa2O4 nano crystals are reported.
Open AccessThe Preparation of ZnGa2O4 Nano Crystals by Spray Coprecipitation and Its Gas Sensitive Characteristics
ZnGa2O4 nano crystals were prepared by an improved coprecipitation method, which we call ‘spray coprecipitation’. XRD results shows the resulting crystal size using the new method is under 10nm, whereas the powder prepared by ordinary coprecipitation is about 30nm. XRD results also shows ZnO peaks exists in ZnGa2O4 powder prepared by traditional coprecipitation, but disappears in ZnGa2O4 nano crystal prepared by spraying coprecipitation. SEM and TEM were used to analysis the structural characteristics of ZnGa2O4 nano crystals. The gas sensitive characteristics of ZnGa2O4 nano crystals are reported.