CPChristopher M. Powers

Christopher M. Powers

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Christopher M. Powers has a total of 92 co-authors. Here are the top co-authors by number of shared publications:

  • Rachel K. Straub

    Division of Biokinesiology and Physical Therapy, University of Southern California, Los Angeles, California, USA

    9 shared publications
  • Rachel K. Straub

    University of Southern California, Division of Biokinesiology & Physical Therapy, Los Angeles, CA, USA

    8 shared publications
  • Yu-Jen Chen

    National Taiwan University, College of Medicine, School and Graduate Institute of Physical Therapy, Taipei, Taiwan, ROC; National Taiwan University Hospital, Center of Physical Therapy, Taipei, Taiwan, ROC

    6 shared publications
  • Liang-Ching Tsai

    Department of Physical Therapy, Georgia State University, USA

    5 shared publications
  • Joyce H. Keyak

    Department of Radiological Sciences, Department of Biomedical Engineering, and Department of Mechanical and Aerospace Engineering, University of California, Irvine, CA

    4 shared publications
  • Kai-Yu Ho

    Department of Physical Therapy, University of Nevada, Las Vegas, Las Vegas, Nevada, USA

    4 shared publications

Latest Publications

  • Prediction of secondary ACL injury in female athletes using 2D video-based measurements obtained during dynamic tasks: a retrospective case–control study

    by Rachel K Straub, Christopher M Powers

    Objective To determine if two-dimensional (2D) video-based angular measurements obtained during dynamic tasks predict secondary anterior cruciate ligament (ACL) injury in female athletes post-ACL reconstruction (ACLR). Methods Female athletes post-ACLR underwent 2D video assessment during six tasks (step down, drop jump, lateral shuffle, deceleration, triple hop and side-step-cut) before returning to sport. Reinjury status was determined via survey after returning to sport (N=345). Non-contact ACL reinjuries (n=23) were matched to non-injured athletes (n=57). Five 2D video-based surrogates of known risk factors for primary ACL injury (trunk-tibia angle, thigh angle, trunk lean, pelvis tilt, frontal plane projection angle (FPPA)) were measured from 2D videos across tasks. Reinjury cut-offs for the 2D angles were determined using receiver operating characteristic curves, and composite scores were calculated for each 2D surrogate, with higher scores indicating a high-risk movement across more tasks. Logistic regression, adjusted for confounders, assessed ACL reinjury risk for each composite score. Stepwise regression identified the strongest 2D predictor. Results Four of five 2D surrogate composite scores independently predicted ACL reinjury after adjusting for confounders. For each additional task in which an athlete demonstrated a high-risk movement, the odds of reinjury increased: trunk-tibia angle composite score (representing increased knee extensor relative to hip extensor moments; OR 1.75; 95% CI 1.24 to 2.47; p=0.001), thigh angle composite score (representing increased vertical ground reaction forces; OR 1.69, 95% CI 1.14 to 2.50, p=0.01), FPPA composite score (representing increased knee valgus moments; OR 2.29, 95% CI 1.13 to 4.65, p=0.02) and pelvis tilt composite score (representing increased pelvis drop; OR 1.85, 95% CI 1.16 to 2.95, p=0.01). The trunk-tibia angle composite score was selected as the strongest predictor. Conclusions 2D surrogates of known three-dimensional risk factors for primary ACL injury can predict secondary ACL injury. These findings support developing a movement assessment using 2D video-based measurements to inform return to sport decisions and identify at-risk athletes following ACLR.


  • Top Cited Papers
    Open Access

    A Biomechanical Review of the Squat Exercise: Implications for Clinical Practice

    by Rachel K Straub, Christopher M Powers

    The squat is one of the most frequently prescribed exercises in the rehabilitative setting. Performance of the squat can be modified by changing parameters such as stance width, foot rotation, trunk position, tibia position, and depth. An understanding of how the various squatting techniques can influence joint loading and muscular demands is important for the proper prescription of this exercise for various clinical conditions. The purpose of this clinical commentary is to discuss how the biomechanical demands of the squat can be influenced by various modifiable parameters. General recommendations for specific clinical conditions are presented. Level of Evidence: 5


  • Open Access

    Does the 2D Frontal Plane Projection Angle Predict Frontal Plane Knee Moments during Stepping, Landing, and Change of Direction Tasks?

    by Rachel K Straub, Christopher M Powers

    Background: Although dynamic knee valgus can be visually identified using the 2D frontal plane projection angle (FPPA), the validity of the FPPA in terms of predicting frontal plane knee kinematics has been questioned. The biomechanical utility of the FPPA may lie in its ability to predict frontal plane knee moments. Hypothesis/Purpose: The purpose of the current study was to comprehensively evaluate the ability of the FPPA to predict the frontal plane knee kinetics (peak moment, average moment, and moment at peak knee flexion) across a wide range of tasks (stepping, landing, and change of direction). Design: Crossover Study Design. Methods: Three-dimensional lower-extremity kinetics and 2D video were obtained from 39 healthy athletes (15 males and 24 females) during execution of six tasks (step down, drop jump, lateral shuffle, deceleration, triple hop, side-step-cut). Linear regression analysis was performed to determine if the 2D FPPA at peak knee flexion predicted frontal plane knee moment variables during the deceleration phase of each task (peak moment, average moment, moment at peak knee flexion). Results: The FPPA was found to significantly predict the peak frontal plane knee moment for two tasks (deceleration and side-step-cut, R2 = 12% to 25%), average frontal plane knee moment for five tasks (drop jump, shuffle, deceleration, triple hop, side-step-cut, R2 = 15% to 40%), and frontal plane knee moment at peak knee flexion for five tasks (drop jump, shuffle, deceleration, triple hop, side-step-cut, R2 = 16% to 45%). Conclusion: An increased FPPA (medial knee collapse) predicted increased knee valgus moments (or decreased knee varus moments) during landing and change of direction tasks (but not stepping). However, the predictive ability of the FPPA was weak to moderate.


  • Persons with Patellar Tendinopathy Exhibit Greater Patellar Tendon Stress during a Single-Leg Landing Task

    by Kyungmi Park, Joyce H. Keyak, Kornelia Kulig, Christopher M. Powers

    Purpose: This study aimed to compare peak maximum principal stress in the patellar tendon between persons with and without patellar tendinopathy during a simulated single-leg landing task. A secondary purpose was to determine the biomechanical predictor(s) of peak maximum principal stress in the patellar tendon. Methods: Using finite element (FE) modeling, patellar tendon stress profiles of 28 individuals (14 with patellar tendinopathy and 14 pain-free controls) were created at the time of the peak knee extensor moment during single-leg landing. Input parameters to the FE model included subject-specific knee joint geometry and kinematics, and quadriceps muscle forces. Independent t-tests were used to compare the peak maximum principal stress in the patellar tendon and biomechanical variables used as input variables to the FE model (knee flexion, knee rotation in the frontal and transverse planes and the peak knee extensor moment) between groups. A stepwise regression model was used to determine the biomechanical predictor(s) of peak maximum principal stress in the patellar tendon for both groups combined. Results: Compared with the control group, persons with patellar tendinopathy exhibited greater peak maximum principal stress in the patellar tendon (77.4 ± 25.0 vs 60.6 ± 13.6 MPa, P = 0.04) and greater tibiofemoral joint internal rotation (4.6° ± 4.6° vs 1.1° ± 4.2°, P = 0.04). Transverse plane rotation of the tibiofemoral joint was the best predictor of peak maximum principal stress in the patellar tendon (r = 0.51, P = 0.01). Conclusions: Persons with patellar tendinopathy exhibit greater peak patellar tendon stress compared with pain-free individuals during single-leg landing. The magnitude of peak patellar tendon stress seems to be influenced by the amount of tibiofemoral rotation in the transverse plane.


  • Predictors of Quadriceps Strength Asymmetry after Anterior Cruciate Ligament Reconstruction: A Chi-Squared Automatic Interaction Detection Decision Tree Analysis

    by Rachel K. Straub, Bert Mandelbaum, Christopher M. Powers

    Introduction: The influence of graft type on the restoration of quadriceps strength symmetry after ACL reconstruction (ACLR) has been widely studied. However, an important consideration when evaluating quadriceps symmetry is the fact that this measure can be influenced by numerous factors beyond graft type. This study sought to determine if graft type is predictive of quadriceps strength asymmetry during the first 12 months post-ACLR taking into consideration potentially influential factors (i.e., age, sex, body mass index, time post-ACLR). Methods: We retrospectively reviewed quadriceps strength data from 434 patients (303 female patients and 131 male patients) who had previously undergone ACLR with an autograft (hamstring tendon, quadriceps tendon [QT], patellar tendon [PT]) or allograft. Chi-Squared Automatic Interaction Detection decision tree analysis was used to evaluate if graft type is predictive of quadriceps strength asymmetry during the first 12 months post-ACLR taking into consideration age, sex, body mass index, and time post-ACLR. Results: The best predictor of quadriceps strength asymmetry was graft type. Specifically, three graft categories were identified: 1) allograft and hamstring tendon autograft, 2) PT autograft, and 3) QT autograft. The average quadriceps strength asymmetry for each of the three identified categories was 0.91, 0.87, and 0.81, respectively, and differed statistically from each other (P < 0.001). The second-best predictor of quadriceps strength asymmetry was sex, albeit only in the PT and QT groups (with female patients having increased asymmetry). Female patients post-ACLR with a QT autograft were at highest risk for quadriceps strength asymmetry. Conclusions: Graft type and sex are important predictors of quadriceps strength asymmetry after ACLR. Clinicians should take these factors into consideration when designing rehabilitation protocols to restore quadriceps strength symmetry during the postoperative period.


  • Open Access

    Utility of 2D Video Analysis for Assessing Frontal Plane Trunk and Pelvis Motion during Stepping, Landing, and Change in Direction Tasks: A Validity Study

    by Rachel K Straub, Christopher M Powers

    Background: Excessive frontal plane motion of the trunk and/or pelvis has been implicated in numerous clinical conditions. To date, it is unclear whether 2D video is an appropriate surrogate for assessing frontal plane trunk and pelvis motion as a comprehensive validity study across a wide range of movements using a consistent methodology has not been performed. Hypothesis/Purpose: The purpose of the current study was to assess the concurrent validity and agreement of frontal plane pelvis and trunk motion obtained with 2D video against the respective 3D angles during stepping, landing, and change in direction tasks. Design: Crossover Study Design. Methods: 3D kinematics and 2D frontal plane video were obtained from 39 healthy participants (15 males and 24 females) during five athletic tasks (step down, lateral shuffle, deceleration, triple hop, side-step-cut). Data were extracted at peak knee flexion. Pearson’s correlation analysis was used to assess the association between the 2D and 3D frontal plane angles at the trunk and pelvis. Bland Altman plots were used to assess the level of agreement between the 2D and 3D frontal plane angles at the trunk and pelvis. Results: 2D and 3D frontal plane angles for all tasks were correlated in a positive direction at the pelvis (r = 0.54 to 0.73, all p < 0.001) and trunk (r = 0.81 to 0.92, all p < 0.001). Absolute agreement in the frontal plane for all tasks and angles was below 5°. However, the 95% limits of agreement across tasks ranged from -12.8° to 21.3° for the pelvis and -11.8° to 9.4° for the trunk. Conclusions: The use of 2D video to assess frontal plane trunk and pelvis motion is appropriate during stepping, landing, and change of direction tasks, however caution is advised when high levels of agreement or accuracy is required.