Amir H. Mohammadi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Amir H. Mohammadi has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Dominique Richon
Discipline of Chemical Engineering, School of Engineering, University of KwaZulu-Natal, Howard College Campus, Durban, South Africa
23 shared publications - Ali Eslamimanesh
Department of Process Engineering, Faculty of Chemical Engineering, Tarbiat Modares University, Tehran, Iran
19 shared publications - Farhad Gharagheizi
Thermodynamics Research Unit, School of Engineering, University of KwaZulu-Natal, Howard College Campus, King George V Avenue, Durban 4041, South Africa
16 shared publications - Poorandokht Ilani-Kashkouli
Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
6 shared publications Mehdi Sattari
Thermodynamics Research Unit School of Engineering University of KwaZulu‐Natal Howard College Campus, King George V Avenue Durban 4041 South Africa
5 shared publicationsMohammad Yazdizadeh
4 shared publications
Latest Publications
- 25 April 2014
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 59 (5) , 1629-1635
Experimental Measurements and Correlations of Excess Molar Enthalpies for the Binary and Ternary Mixtures of (Cyclohexane, 1,4-Dioxane and Piperidine) or (Cyclohexane, Morpholine and Piperidine) at 308.15 K and Atmospheric Pressure
- 25 April 2014
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 59 (5) , 1629-1635
Experimental Measurements and Correlations of Excess Molar Enthalpies for the Binary and Ternary Mixtures of (Cyclohexane, 1,4-Dioxane and Piperidine) or (Cyclohexane, Morpholine and Piperidine) at 308.15 K and Atmospheric Pressure
- 1 February 2014
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 363, 27-31
Are the reservoir fluid compositional grading data reliable?
- 1 February 2014
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 363, 27-31
Are the reservoir fluid compositional grading data reliable?
- 27 January 2014
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 94 (9) , 974-990
On the application of binary correction factors in lattice distortion calculations for methane clathrate hydrates
The lattice distortion theory of Zele and co-workers is an attractive method for amending calculated phase equilibria of clathrate hydrates, since only two molecular computations are required. The perturbation energy between the empty and loaded clathrate hydrate lattice is the quantity of interest. The effect of binary correction factors applied to the Lorentz and Berthelot combining rules for the intermolecular interaction between gas and water particles is investigated. There are clear trends for the perturbation energy and lattice constant in terms of the binary correction factors, although there is significant sensitivity to the force field parameterization of the gas species.
- 27 January 2014
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 94 (9) , 974-990
On the application of binary correction factors in lattice distortion calculations for methane clathrate hydrates
The lattice distortion theory of Zele and co-workers is an attractive method for amending calculated phase equilibria of clathrate hydrates, since only two molecular computations are required. The perturbation energy between the empty and loaded clathrate hydrate lattice is the quantity of interest. The effect of binary correction factors applied to the Lorentz and Berthelot combining rules for the intermolecular interaction between gas and water particles is investigated. There are clear trends for the perturbation energy and lattice constant in terms of the binary correction factors, although there is significant sensitivity to the force field parameterization of the gas species.
- 19 February 2013
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 52 (10) , 3949
Reply to “Comment on ‘Group Contribution-Based Method for Determination of Solubility Parameter of Nonelectrolyte Organic Compounds’ and ‘Solubility Parameters of Nonelectrolyte Organic Compounds: Determination Using Quantitative Structure–Property Relationship Strategy’”
- 19 February 2013
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 52 (10) , 3949
Reply to “Comment on ‘Group Contribution-Based Method for Determination of Solubility Parameter of Nonelectrolyte Organic Compounds’ and ‘Solubility Parameters of Nonelectrolyte Organic Compounds: Determination Using Quantitative Structure–Property Relationship Strategy’”
- 4 October 2012
- Published by Wiley in AIChE Journal
- Vol. 59 (5) , 1702-1708
Development of a general model for determination of thermal conductivity of liquid chemical compounds at atmospheric pressure
In this communication, a general model for representation/presentation of the liquid thermal conductivity of chemical compounds (mostly organic) at 1 atm pressure for temperatures below normal boiling point and at saturation pressure for temperatures above the normal boiling point is developed using the Gene Expression Programming algorithm. Approximately 19,000 liquid thermal conductivity data at different temperatures related to 1636 chemical compounds collected from the DIPPR 801 database are used to obtain the model as well as to assess its predictive capability. The parameters of the model comprise temperature, acentric factor, critical pressure, normal boiling temperature, and molecular weight. Nearly 80% of the data set (15,221 data) is randomly assigned to develop the model equation, 10% of the data set (1902 data) is used to validate the model, and the remaining data (1902 data) were implemented to evaluate its predictive power. The average absolute relative deviation of the model results from the DIPPR 801 data is less than 9%. In terms of simplicity and wide range of applicability, this empirical model shows acceptable accuracy. © 2012 American Institute of Chemical Engineers AIChE J, 59: 1702–1708, 2013
- 4 October 2012
- Published by Wiley in AIChE Journal
- Vol. 59 (5) , 1702-1708
Development of a general model for determination of thermal conductivity of liquid chemical compounds at atmospheric pressure
In this communication, a general model for representation/presentation of the liquid thermal conductivity of chemical compounds (mostly organic) at 1 atm pressure for temperatures below normal boiling point and at saturation pressure for temperatures above the normal boiling point is developed using the Gene Expression Programming algorithm. Approximately 19,000 liquid thermal conductivity data at different temperatures related to 1636 chemical compounds collected from the DIPPR 801 database are used to obtain the model as well as to assess its predictive capability. The parameters of the model comprise temperature, acentric factor, critical pressure, normal boiling temperature, and molecular weight. Nearly 80% of the data set (15,221 data) is randomly assigned to develop the model equation, 10% of the data set (1902 data) is used to validate the model, and the remaining data (1902 data) were implemented to evaluate its predictive power. The average absolute relative deviation of the model results from the DIPPR 801 data is less than 9%. In terms of simplicity and wide range of applicability, this empirical model shows acceptable accuracy. © 2012 American Institute of Chemical Engineers AIChE J, 59: 1702–1708, 2013
- 10 May 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (20) , 7119-7125
Determination of Vapor Pressure of Chemical Compounds: A Group Contribution Model for an Extremely Large Database
- 10 May 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (20) , 7119-7125
Determination of Vapor Pressure of Chemical Compounds: A Group Contribution Model for an Extremely Large Database
- 24 April 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (17) , 6265-6269
Corresponding States Method for Estimation of Upper Flammability Limit Temperature of Chemical Compounds
- 24 April 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (17) , 6265-6269
Corresponding States Method for Estimation of Upper Flammability Limit Temperature of Chemical Compounds
- 23 April 2012
- Published by Wiley in AIChE Journal
- Vol. 59 (2) , 613-621
Development of corresponding states model for estimation of the surface tension of chemical compounds
The gene expression programming (GEP) strategy is applied for presenting two corresponding states models to represent/predict the surface tension of about 1,700 compounds (mostly organic) from 75 chemical families at various temperatures collected from the DIPPR 801 database. The models parameters include critical temperature or temperature/critical volume/acentric factor/critical pressure/reduced temperature/reduced normal boiling point temperature/molecular weight of the compounds. Around 1,300 surface tension data of 118 random compounds are used for developing the first model (a four‐parameter model) and about 20,000 data related to around 1,600 compounds are applied for checking its prediction capability. For the second one (a five‐parameter model), about 10,000 random data are applied for its development, and 11,000 data are used for testing its prediction ability. The statistical parameters including average absolute relative deviations of the results form dataset values (25 and 18% for the first and second models, respectively) demonstrate the accuracy of the presented models. © 2012 American Institute of Chemical Engineers AIChE J, 59: 613–621, 2013
- 23 April 2012
- Published by Wiley in AIChE Journal
- Vol. 59 (2) , 613-621
Development of corresponding states model for estimation of the surface tension of chemical compounds
The gene expression programming (GEP) strategy is applied for presenting two corresponding states models to represent/predict the surface tension of about 1,700 compounds (mostly organic) from 75 chemical families at various temperatures collected from the DIPPR 801 database. The models parameters include critical temperature or temperature/critical volume/acentric factor/critical pressure/reduced temperature/reduced normal boiling point temperature/molecular weight of the compounds. Around 1,300 surface tension data of 118 random compounds are used for developing the first model (a four‐parameter model) and about 20,000 data related to around 1,600 compounds are applied for checking its prediction capability. For the second one (a five‐parameter model), about 10,000 random data are applied for its development, and 11,000 data are used for testing its prediction ability. The statistical parameters including average absolute relative deviations of the results form dataset values (25 and 18% for the first and second models, respectively) demonstrate the accuracy of the presented models. © 2012 American Institute of Chemical Engineers AIChE J, 59: 613–621, 2013
- 15 March 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (13) , 5103-5107
Computation of Upper Flash Point of Chemical Compounds Using a Chemical Structure-Based Model
- 15 March 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (13) , 5103-5107
Computation of Upper Flash Point of Chemical Compounds Using a Chemical Structure-Based Model
- 15 March 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (12) , 4764-4767
QSPR Molecular Approach for Estimating Henry’s Law Constants of Pure Compounds in Water at Ambient Conditions
- 15 March 2012
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (12) , 4764-4767
QSPR Molecular Approach for Estimating Henry’s Law Constants of Pure Compounds in Water at Ambient Conditions