Seyed Mohsen Peyghambarzadeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Seyed Mohsen Peyghambarzadeh has a total of 68 co-authors. Here are the top co-authors by number of shared publications:
Shima Azizi
Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran
6 shared publications- Mohammad Mohsen Sarafraz
School of Chemical Engineering and Advanced Materials, The University of Adelaide, Adelaide, Australia
4 shared publications S. H. Hashemabadi
Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran
4 shared publicationsH. Hallaji
Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran
2 shared publicationsM. R. Bohloul
Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran
2 shared publicationsM. Varnaseri
Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran
2 shared publications
Latest Publications
- 21 November 2023
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 148 (23) , 13519-13541
Mathematical modeling and experimental validation of heat transfer during upward subcooled flow boiling in a vertical annulus
- 21 November 2023
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 148 (23) , 13519-13541
Mathematical modeling and experimental validation of heat transfer during upward subcooled flow boiling in a vertical annulus
- 21 March 2023
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 148 (12) , 5805-5818
Investigation and measurement of crude oil heat transfer coefficient in forced convection and subcooled flow boiling heat transfer
- 21 March 2023
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 148 (12) , 5805-5818
Investigation and measurement of crude oil heat transfer coefficient in forced convection and subcooled flow boiling heat transfer
- 25 February 2023
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 59 (8) , 1477-1505
Particulate fouling during boiling heat transfer and crystallization of CaCO3 aqueous solutions
- 25 February 2023
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 59 (8) , 1477-1505
Particulate fouling during boiling heat transfer and crystallization of CaCO3 aqueous solutions
- 24 February 2023
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 39
Experimental study on crude oil fouling in preheat exchangers at different operating conditions
- 24 February 2023
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 39
Experimental study on crude oil fouling in preheat exchangers at different operating conditions
- 3 February 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 225
Air rumbling for online fouling mitigation of calcium carbonate aqueous solution under subcooled flow boiling heat transfer
- 3 February 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 225
Air rumbling for online fouling mitigation of calcium carbonate aqueous solution under subcooled flow boiling heat transfer
- 21 December 2022
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 101 (7) , 3856-3873
Coke deposition and run length in industrial naphtha thermal cracking furnaces via a quasi‐steady state coupled CFD model
Mathematical modelling of the thickness of the coke layer growing over months in millisecond cracking reactors is a dilemma in computational fluid dynamics (CFD) simulation. To address the time scale issue, a quasi‐steady state (QSS) approach was employed through a comprehensive coupled reactor/firebox CFD model in the current study. The model was applied to predict the time‐dependent behaviour of coke deposition and to determine the appropriate operating conditions for maximum olefin yields over an industrial furnace run length. A novel algorithm was designed to overcome the complexity of QSS simulation of the CFD model, which is a combination of reactive turbulence flow, combustion, and radiation models. The furnace parameters were studied as a function of two variables: the dilution steam‐to‐feed ratio and the liberated heat by the burners. The results indicated that the run length can be extended by up to 20% while retaining the main product yields. This study offers practical suggestions to maximize the run length in the operation.
- 21 December 2022
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 101 (7) , 3856-3873
Coke deposition and run length in industrial naphtha thermal cracking furnaces via a quasi‐steady state coupled CFD model
Mathematical modelling of the thickness of the coke layer growing over months in millisecond cracking reactors is a dilemma in computational fluid dynamics (CFD) simulation. To address the time scale issue, a quasi‐steady state (QSS) approach was employed through a comprehensive coupled reactor/firebox CFD model in the current study. The model was applied to predict the time‐dependent behaviour of coke deposition and to determine the appropriate operating conditions for maximum olefin yields over an industrial furnace run length. A novel algorithm was designed to overcome the complexity of QSS simulation of the CFD model, which is a combination of reactive turbulence flow, combustion, and radiation models. The furnace parameters were studied as a function of two variables: the dilution steam‐to‐feed ratio and the liberated heat by the burners. The results indicated that the run length can be extended by up to 20% while retaining the main product yields. This study offers practical suggestions to maximize the run length in the operation.
- 6 September 2022
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 59 (4) , 655-680
Interference effect of suspended particles on the crystallization fouling: A critical review
- 6 September 2022
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 59 (4) , 655-680
Interference effect of suspended particles on the crystallization fouling: A critical review