Roch Espiau de Lamaestre
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Roch Espiau de Lamaestre has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Salim Boutami
CEA, LETI, Minatec Campus, 17 Rue des Martyrs, Grenoble 38054, France
2 shared publicationsAdel Najar
CEA, LETI, Minatec Campus, 17 rue des martyrs, F-38042 Grenoble, France
1 shared publicationAlexandros Emboras
CEA, LETI, Minatec Campus, 17 rue des martyrs, F-38042 Grenoble, France
1 shared publicationBarbara de Salvo
CEA, LETI, Minatec Campus, 17 rue des martyrs, F-38042 Grenoble, France
1 shared publicationCharles Leroux
CEA, LETI, Minatec Campus, 17 rue des martyrs, F-38042 Grenoble, France
1 shared publication- Chawki Awada
Department of Physics, College of Science, King Faisal University, Al-Ahsa, Saudi Arabia
1 shared publication
Latest Publications
- 16 January 2013
- Published by Optica Publishing Group in Optics Letters
- Vol. 38 (3) , 254-256
Partially localized hybrid surface plasmon mode for thin-film semiconductor infrared photodetection
We use numerical simulations to show that a suitably dimensioned periodic arrangement of vertical metallic metal–dielectric–metal nanocavities supports a hybrid plasmonic mode whose spatial electric field distribution is suitable for use in infrared photodetectors based on an unpatterned semiconductor thin-film absorbing layer. The partially localized nature of the hybrid mode offers reduced sensitivity to the angle of incoming light and smaller pixel sizes compared with surface plasmonic modes coupled by diffraction.
- 16 January 2013
- Published by Optica Publishing Group in Optics Letters
- Vol. 38 (3) , 254-256
Partially localized hybrid surface plasmon mode for thin-film semiconductor infrared photodetection
We use numerical simulations to show that a suitably dimensioned periodic arrangement of vertical metallic metal–dielectric–metal nanocavities supports a hybrid plasmonic mode whose spatial electric field distribution is suitable for use in infrared photodetectors based on an unpatterned semiconductor thin-film absorbing layer. The partially localized nature of the hybrid mode offers reduced sensitivity to the angle of incoming light and smaller pixel sizes compared with surface plasmonic modes coupled by diffraction.
- 4 June 2012
- Published by Optica Publishing Group in Optics Express
- Vol. 20 (13) , 13612-13621
MNOS stack for reliable, low optical loss, Cu based CMOS plasmonic devices
We study the electro optical properties of a Metal-Nitride-Oxide-Silicon (MNOS) stack for a use in CMOS compatible plasmonic active devices. We show that the insertion of an ultrathin stoichiometric Si3N4 layer in a MOS stack lead to an increase in the electrical reliability of a copper gate MNOS capacitance from 50 to 95% thanks to a diffusion barrier effect, while preserving the low optical losses brought by the use of copper as the plasmon supporting metal. An experimental investigation is undertaken at a wafer scale using some CMOS standard processes of the LETI foundry. Optical transmission measurments conducted in a MNOS channel waveguide configuration coupled to standard silicon photonics circuitry confirms the very low optical losses (0.39 dB.μm−1), in good agreement with predictions using ellipsometric optical constants of Cu.
- 4 June 2012
- Published by Optica Publishing Group in Optics Express
- Vol. 20 (13) , 13612-13621
MNOS stack for reliable, low optical loss, Cu based CMOS plasmonic devices
We study the electro optical properties of a Metal-Nitride-Oxide-Silicon (MNOS) stack for a use in CMOS compatible plasmonic active devices. We show that the insertion of an ultrathin stoichiometric Si3N4 layer in a MOS stack lead to an increase in the electrical reliability of a copper gate MNOS capacitance from 50 to 95% thanks to a diffusion barrier effect, while preserving the low optical losses brought by the use of copper as the plasmon supporting metal. An experimental investigation is undertaken at a wafer scale using some CMOS standard processes of the LETI foundry. Optical transmission measurments conducted in a MNOS channel waveguide configuration coupled to standard silicon photonics circuitry confirms the very low optical losses (0.39 dB.μm−1), in good agreement with predictions using ellipsometric optical constants of Cu.
- 3 April 2012
- Published by Optica Publishing Group in Optics Express
- Vol. 20 (8) , 8974-8981
Loss mechanisms of surface plasmon polaritons propagating on a smooth polycrystalline Cu surface
We study the propagation properties of surface plasmon polaritons on a Cu surface by means of photoemission electron microscopy. Use of a CMOS process to fabricate the Cu thin film is shown to enable very high propagation distances (up to 65 μm at 750 nm wavelength), provided that the copper native oxide is removed. A critical review of the optical loss mechanisms is undertaken and shed light on the effect of single grain boundaries in increasing the propagation losses of the plasmon. A microscopic interpretation is provided, relying on groove induced electromagnetic hot spots.
- 3 April 2012
- Published by Optica Publishing Group in Optics Express
- Vol. 20 (8) , 8974-8981
Loss mechanisms of surface plasmon polaritons propagating on a smooth polycrystalline Cu surface
We study the propagation properties of surface plasmon polaritons on a Cu surface by means of photoemission electron microscopy. Use of a CMOS process to fabricate the Cu thin film is shown to enable very high propagation distances (up to 65 μm at 750 nm wavelength), provided that the copper native oxide is removed. A critical review of the optical loss mechanisms is undertaken and shed light on the effect of single grain boundaries in increasing the propagation losses of the plasmon. A microscopic interpretation is provided, relying on groove induced electromagnetic hot spots.
- 2 August 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (17) , 15720-15731
High rejection bandpass optical filters based on sub-wavelength metal patch arrays
We report the study of a resonant bandpass filter made of a very thin subwavelength metal patch array coupled to a high index dielectric waveguide. The spectral properties of those filters can easily be tuned by playing on the lateral dimensions of the grating. They exhibit high and narrow transmission peaks together with very good rejection of light out of the pass-band and low angular dependance. An experimental demonstration using standard large scale silicon microelectronics processes is presented in the mid infrared spectral range. This concept of filters can easily be scaled throughout the optical spectrum, and can be integrated within focal plane arrays of various imaging technologies, down to visible wavelengths.
- 2 August 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (17) , 15720-15731
High rejection bandpass optical filters based on sub-wavelength metal patch arrays
We report the study of a resonant bandpass filter made of a very thin subwavelength metal patch array coupled to a high index dielectric waveguide. The spectral properties of those filters can easily be tuned by playing on the lateral dimensions of the grating. They exhibit high and narrow transmission peaks together with very good rejection of light out of the pass-band and low angular dependance. An experimental demonstration using standard large scale silicon microelectronics processes is presented in the mid infrared spectral range. This concept of filters can easily be scaled throughout the optical spectrum, and can be integrated within focal plane arrays of various imaging technologies, down to visible wavelengths.
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1020
Ion Beam-induced Quantum Dot Synthesis in Glass
Irradiation-induced processes are often considered only in their nonequilibrium aspects. The purpose of this brief review is to show that chemistry, and particularly redox properties, play a major role in the thermal evolution of such systems and generally cannot, therefore, be neglected. This is exemplified by the synthesis of Ag nanoclusters in glasses and silica, under both low (gamma-ray) and high (MeV ion) deposited energy density irradiation conditions. The nanocluster formation mechanism is shown to be similar to the latent image formation process in photography. The corresponding information was used to control nucleation and growth of PbS clusters in glasses, leading to promising optical properties. In the course of these studies, we also showed that lognormal size distributions characterize the absence of information on the nanocluster formation process.
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1020
Ion Beam-induced Quantum Dot Synthesis in Glass
Irradiation-induced processes are often considered only in their nonequilibrium aspects. The purpose of this brief review is to show that chemistry, and particularly redox properties, play a major role in the thermal evolution of such systems and generally cannot, therefore, be neglected. This is exemplified by the synthesis of Ag nanoclusters in glasses and silica, under both low (gamma-ray) and high (MeV ion) deposited energy density irradiation conditions. The nanocluster formation mechanism is shown to be similar to the latent image formation process in photography. The corresponding information was used to control nucleation and growth of PbS clusters in glasses, leading to promising optical properties. In the course of these studies, we also showed that lognormal size distributions characterize the absence of information on the nanocluster formation process.