Tang Son Nguyen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Tang Son Nguyen has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Leon Lefferts
University of Twente
5 shared publications K. Seshan
4 shared publicationsG. Brem
3 shared publications- Kulathuiyer Seshan
Faculty of Science and Technology, University of Twente, P.O. Box 217, 7500 AE Enschede, The Netherlands
2 shared publications M. Zabeti
2 shared publications- Songbo He
School of Energy Science and Engineering, Nanjing Tech University, 30 Puzhu South Road, Nanjing 211816, PR China
2 shared publications
Latest Publications
- 9 May 2023
- Published by Elsevier in Biomass and Bioenergy
- Vol. 174
Mild hydrogenolysis of lignin model compound and organosolv lignin over non-noble bimetallic Ni–Fe/TiN catalyst
- 9 May 2023
- Published by Elsevier in Biomass and Bioenergy
- Vol. 174
Mild hydrogenolysis of lignin model compound and organosolv lignin over non-noble bimetallic Ni–Fe/TiN catalyst
- 1 October 2021
- Published by Elsevier in Bioresource Technology
- Vol. 337, 125445
Iron-catalyzed fast hydrothermal liquefaction of Cladophora socialis macroalgae into high quality fuel precursor
- 1 October 2021
- Published by Elsevier in Bioresource Technology
- Vol. 337, 125445
Iron-catalyzed fast hydrothermal liquefaction of Cladophora socialis macroalgae into high quality fuel precursor
- Open Access
- 19 July 2021
- Published by Wiley in Journal of Nanomaterials
- Vol. 2021, 1-14
Electrochemical Behavior and Electronucleation of Copper Nanoparticles from CuCl2·2H2O Using a Choline Chloride-Urea Eutectic Mixture
This work presents a thorough study on the early stage of copper electrodeposition from a choline chloride-urea deep eutectic solvent (DES). Determination of possible species in DES containing Cu2+ ions as the electrolytes has been performed using UV-Vis measurements. Kinetic and thermodynamic aspects of copper electrodeposition on glassy carbon electrode from DES were thoroughly investigated using cyclic voltammetry (CV) and chronoamperometry (CA). Both results from CA and CV have demonstrated that the copper electrodeposition could be performed directly from DES containing a small amount of water by the single potentiostatic step technique. Theoretical approach confirmed that the direct electronucleation of copper nanoparticles in the DES can be described by a model with two contributions, namely, (i) adsorption process and (ii) a three-dimensional (3D) nucleation and diffusion-controlled growth of copper nuclei, to the total current density transients. Kinetic parameters are important for controlling morphology and chemical composition of the obtained nanoparticles, which are verified by surface characterization techniques such as SEM and EDS.
- 19 July 2021
- Published by Wiley in Journal of Nanomaterials
- Vol. 2021, 1-14
Open AccessElectrochemical Behavior and Electronucleation of Copper Nanoparticles from CuCl2·2H2O Using a Choline Chloride-Urea Eutectic Mixture
This work presents a thorough study on the early stage of copper electrodeposition from a choline chloride-urea deep eutectic solvent (DES). Determination of possible species in DES containing Cu2+ ions as the electrolytes has been performed using UV-Vis measurements. Kinetic and thermodynamic aspects of copper electrodeposition on glassy carbon electrode from DES were thoroughly investigated using cyclic voltammetry (CV) and chronoamperometry (CA). Both results from CA and CV have demonstrated that the copper electrodeposition could be performed directly from DES containing a small amount of water by the single potentiostatic step technique. Theoretical approach confirmed that the direct electronucleation of copper nanoparticles in the DES can be described by a model with two contributions, namely, (i) adsorption process and (ii) a three-dimensional (3D) nucleation and diffusion-controlled growth of copper nuclei, to the total current density transients. Kinetic parameters are important for controlling morphology and chemical composition of the obtained nanoparticles, which are verified by surface characterization techniques such as SEM and EDS.
- 31 January 2020
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 10 (5) , 1408-1421
Correlation of the ratio of metallic to oxide species with activity of PdPt catalysts for methane oxidation
Bimetallic catalysts consisting of Pd and Pt on TiO2-zeolite (mordenite, beta, ZSM-5) supports were prepared and tested for the combustion of methane. The activity of the catalysts was found to be dependent on the zeolite topology and SiO2 : Al2O3 ratio and was linearly dependent on the proportion of Pd and Pt present in a bimetallic phase observed in XRD diffractograms of the catalysts. This linear dependence was valid for a range of zeolites used. STEM-EDS and electron tomography showed the Pd and Pt to be largely co-located and XAS and XPS indicated that the metals are mostly present in the form of oxide nanoparticles with a minor contribution from the metals at high SiO2 : Al2O3 ratios. Catalyst characterization showed there to be little difference overall in the metal loading and physical characteristics of the samples and NH3-TPD suggested that the activation of methane over acid sites is not important. Adding water to the feed, slightly reduced the conversion but did not affect the deactivation profile of the catalysts tested.
- 31 January 2020
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 10 (5) , 1408-1421
Correlation of the ratio of metallic to oxide species with activity of PdPt catalysts for methane oxidation
Bimetallic catalysts consisting of Pd and Pt on TiO2-zeolite (mordenite, beta, ZSM-5) supports were prepared and tested for the combustion of methane. The activity of the catalysts was found to be dependent on the zeolite topology and SiO2 : Al2O3 ratio and was linearly dependent on the proportion of Pd and Pt present in a bimetallic phase observed in XRD diffractograms of the catalysts. This linear dependence was valid for a range of zeolites used. STEM-EDS and electron tomography showed the Pd and Pt to be largely co-located and XAS and XPS indicated that the metals are mostly present in the form of oxide nanoparticles with a minor contribution from the metals at high SiO2 : Al2O3 ratios. Catalyst characterization showed there to be little difference overall in the metal loading and physical characteristics of the samples and NH3-TPD suggested that the activation of methane over acid sites is not important. Adding water to the feed, slightly reduced the conversion but did not affect the deactivation profile of the catalysts tested.
- 1 September 2019
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 296, 110-120
Facile post-synthesis and gas sensing properties of highly porous NiO microspheres
- 1 September 2019
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 296, 110-120
Facile post-synthesis and gas sensing properties of highly porous NiO microspheres
- 1 September 2017
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 127, 436-443
Online catalytic deoxygenation of vapour from fast pyrolysis of Vietnamese sugarcane bagasse over sodium-based catalysts
- 1 September 2017
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 127, 436-443
Online catalytic deoxygenation of vapour from fast pyrolysis of Vietnamese sugarcane bagasse over sodium-based catalysts
- 1 September 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 299, 415-419
Catalytic hydro-pyrolysis of lignocellulosic biomass over dual Na2CO3/Al2O3 and Pt/Al2O3 catalysts using n-butane at ambient pressure
- 1 September 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 299, 415-419
Catalytic hydro-pyrolysis of lignocellulosic biomass over dual Na2CO3/Al2O3 and Pt/Al2O3 catalysts using n-butane at ambient pressure
- 1 January 2016
- Published by Elsevier in Catalysis Today
- Vol. 259, 381-387
Study on the catalytic conversion of lignin-derived components in pyrolysis vapour using model component
- 1 January 2016
- Published by Elsevier in Catalysis Today
- Vol. 259, 381-387
Study on the catalytic conversion of lignin-derived components in pyrolysis vapour using model component
- 5 June 2015
- Published by Wiley in ChemCatChem
- Vol. 7 (12) , 1833-1840
Catalytic Conversion of Biomass Pyrolysis Vapours over Sodium‐Based Catalyst: A Study on the State of Sodium on the Catalyst
In situ upgrading of biomass pyrolysis vapours over Na2CO3/γ‐Al2O3 catalysts was studied in a laboratory‐scale fixed‐bed reactor at 500 °C. Catalytic oil exhibits a significant improvement over its non‐catalytic counterpart, such as lower oxygen content (12.3 wt % compared to 42.1 wt %), higher energy density (37.0 compared to 19.0 MJ kg−1) and lower acidity. A study using thermogravimetry–mass spectrometry analysis and 23Na and 1H magic‐angle spinning NMR techniques has revealed the formation of a new sodium species in the catalyst, which is responsible for the high catalytic activity. This species is proposed to be formed by the coordination of Na+ ions and the hydroxyl groups on the surface of γ‐Al2O3. Regeneration of the catalyst was performed in air at 600 °C and the regenerated material displays lower activity towards deoxygenation than the fresh catalyst. This deactivation is likely attributed to the change in the active sodium species during regeneration.
- 5 June 2015
- Published by Wiley in ChemCatChem
- Vol. 7 (12) , 1833-1840
Catalytic Conversion of Biomass Pyrolysis Vapours over Sodium‐Based Catalyst: A Study on the State of Sodium on the Catalyst
In situ upgrading of biomass pyrolysis vapours over Na2CO3/γ‐Al2O3 catalysts was studied in a laboratory‐scale fixed‐bed reactor at 500 °C. Catalytic oil exhibits a significant improvement over its non‐catalytic counterpart, such as lower oxygen content (12.3 wt % compared to 42.1 wt %), higher energy density (37.0 compared to 19.0 MJ kg−1) and lower acidity. A study using thermogravimetry–mass spectrometry analysis and 23Na and 1H magic‐angle spinning NMR techniques has revealed the formation of a new sodium species in the catalyst, which is responsible for the high catalytic activity. This species is proposed to be formed by the coordination of Na+ ions and the hydroxyl groups on the surface of γ‐Al2O3. Regeneration of the catalyst was performed in air at 600 °C and the regenerated material displays lower activity towards deoxygenation than the fresh catalyst. This deactivation is likely attributed to the change in the active sodium species during regeneration.