Rodney C. Ewing
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Rodney C. Ewing has a total of 64 co-authors. Here are the top co-authors by number of shared publications:
- Fuxiang Zhang
Songshan Lake Materials Laboratory, Dongguan 523808, China
9 shared publications J. Lian
Department of Mechanical, Aerospace, and Nuclear Engineering, Rensselaer Polytechnic Institute, Troy, New York 12180
8 shared publicationsM. Lang
Department of Earth and Environmental Sciences, University of Michigan, Ann Arbor, Michigan 48109
7 shared publicationsL. M. Wang
Department of Nuclear Engineering & Radiological Sciences, University of Michigan, Ann Arbor, Michigan 48105, USA
6 shared publications- Udo Becker
University of Michigan
6 shared publications Lumin Wang
University of Michigan, Ann Arbor, MI
5 shared publications
Latest Publications
- Open Access
- 18 June 2012
- Published by American Physical Society (APS) in Physical Review B
- Vol. 85 (21) , 214116
Phase transition and abnormal compressibility of lanthanide silicate with the apatite structure
The lanthanide silicate LaSiO, which has the hexagonal apatite structure (/), was investigated at high pressure. A subtle phase transition was observed at ∼13.3 GPa by in situ synchrotron x-ray diffraction and confirmed by infrared absorption and Raman scattering measurements. The high-pressure phase has a structure similar to that of the initial hexagonal apatite structure, but the symmetry is reduced to through the displacement of one oxygen site and tilting of the SiO tetrahedra. Interestingly, the high-pressure phase has an abnormally lower compressibility, which is caused by the change in symmetry that allows the tilting of the SiO tetrahedra, and the bulk modulus of the high-pressure phase is only half that of the apatite structure.- 18 June 2012
- Published by American Physical Society (APS) in Physical Review B
- Vol. 85 (21) , 214116
Open AccessPhase transition and abnormal compressibility of lanthanide silicate with the apatite structure
The lanthanide silicate LaSiO, which has the hexagonal apatite structure (/), was investigated at high pressure. A subtle phase transition was observed at ∼13.3 GPa by in situ synchrotron x-ray diffraction and confirmed by infrared absorption and Raman scattering measurements. The high-pressure phase has a structure similar to that of the initial hexagonal apatite structure, but the symmetry is reduced to through the displacement of one oxygen site and tilting of the SiO tetrahedra. Interestingly, the high-pressure phase has an abnormally lower compressibility, which is caused by the change in symmetry that allows the tilting of the SiO tetrahedra, and the bulk modulus of the high-pressure phase is only half that of the apatite structure. - 15 June 2012
- Published by Cambridge University Press (CUP)
- p. 178-193
Nuclear-waste management and disposal
- 15 June 2012
- Published by Cambridge University Press (CUP)
- p. 178-193
Nuclear-waste management and disposal
- 30 September 2011
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 184 (9) , 2329-2332
Structural changes of (K,Gd)2Ta2O7 pyrochlore at high pressure
- 30 September 2011
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 184 (9) , 2329-2332
Structural changes of (K,Gd)2Ta2O7 pyrochlore at high pressure
- 30 June 2010
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 105 (1) , 015503
Pressure-Induced Disordering and Anomalous Lattice Expansion inPyrochlorePressure-induced cation and anion disordering in pyrochlore is quantitatively analyzed by Rietveld refinement of in situ x-ray diffraction patterns, Raman, and infrared measurements. An anomalous lattice expansion and obvious change of the pressure dependence of the vibrational modes occur at . The pressure-induced water incorporation in the pyrochlore structure may be related to a previously noted photoelectrochemical effect.- 30 June 2010
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 105 (1) , 015503
Pressure-Induced Disordering and Anomalous Lattice Expansion inPyrochlorePressure-induced cation and anion disordering in pyrochlore is quantitatively analyzed by Rietveld refinement of in situ x-ray diffraction patterns, Raman, and infrared measurements. An anomalous lattice expansion and obvious change of the pressure dependence of the vibrational modes occur at . The pressure-induced water incorporation in the pyrochlore structure may be related to a previously noted photoelectrochemical effect.- 24 November 2009
- Published by American Physical Society (APS) in Physical Review B
- Vol. 80 (18) , 184114
High-pressure phase transitions ofandand with the tetragonal zircon-structure were studied at room temperature and pressures up to . Pressure-induced phase transitions to the sheelite structure occur at 30 GPa for and 16.3 GPa for , respectively. In addition to the scheelite-type high-pressure phase, an intermediate phase with the monoclinic monazite-type structure formed during the phase transition process of . The high-pressure phases of and are not quenchable on pressure release. The pressure dependence of the total energy of the different phases was calculated using density-functional method, and the results confirm the experimentally observed phase relations under pressure. Structural parameters and compressibility of each phase were determined by refinement of the x-ray diffraction patterns. The high-pressure phase of has a very large bulk modulus [376(8) GPa].- 24 November 2009
- Published by American Physical Society (APS) in Physical Review B
- Vol. 80 (18) , 184114
High-pressure phase transitions ofandand with the tetragonal zircon-structure were studied at room temperature and pressures up to . Pressure-induced phase transitions to the sheelite structure occur at 30 GPa for and 16.3 GPa for , respectively. In addition to the scheelite-type high-pressure phase, an intermediate phase with the monoclinic monazite-type structure formed during the phase transition process of . The high-pressure phases of and are not quenchable on pressure release. The pressure dependence of the total energy of the different phases was calculated using density-functional method, and the results confirm the experimentally observed phase relations under pressure. Structural parameters and compressibility of each phase were determined by refinement of the x-ray diffraction patterns. The high-pressure phase of has a very large bulk modulus [376(8) GPa].- 1 April 2009
- Published by Springer Nature in Journal of Materials Research
- Vol. 24 (4) , 1322-1334
Structural modifications of Gd2Zr2-xTixO7 pyrochlore induced by swift heavy ions: Disordering and amorphization
The isometric, pyrochlore structure type, A2B2O7, exhibits a wide variety of properties that find application in a large number of different technologies, from electrolytes in solid oxide fuel cells to actinide-bearing compositions that can be used as nuclear waste forms or inert matrix nuclear fuels. Swift xenon ions (1.43 GeV) have been used to systematically modify different compositions in the Gd2Zr2-xTixO7 binary at the nanoscale by radiation-induced phase transitions that include the crystalline-to-amorphous and order-disorder structural transformations. Synchrotron x-ray diffraction, Raman spectroscopy, and transmission electron microscopy provide a complete and consistent description of structural changes induced by the swift heavy ions and demonstrate that the response of pyrochlore depends strongly on chemical composition. The high and dense electronic energy deposition primarily results in amorphization of Ti-rich pyrochlore; whereas the formation of the fully disordered, defect-fluorite structure is the dominant process for Zr-rich pyrochlore.
- 1 April 2009
- Published by Springer Nature in Journal of Materials Research
- Vol. 24 (4) , 1322-1334
Structural modifications of Gd2Zr2-xTixO7 pyrochlore induced by swift heavy ions: Disordering and amorphization
The isometric, pyrochlore structure type, A2B2O7, exhibits a wide variety of properties that find application in a large number of different technologies, from electrolytes in solid oxide fuel cells to actinide-bearing compositions that can be used as nuclear waste forms or inert matrix nuclear fuels. Swift xenon ions (1.43 GeV) have been used to systematically modify different compositions in the Gd2Zr2-xTixO7 binary at the nanoscale by radiation-induced phase transitions that include the crystalline-to-amorphous and order-disorder structural transformations. Synchrotron x-ray diffraction, Raman spectroscopy, and transmission electron microscopy provide a complete and consistent description of structural changes induced by the swift heavy ions and demonstrate that the response of pyrochlore depends strongly on chemical composition. The high and dense electronic energy deposition primarily results in amorphization of Ti-rich pyrochlore; whereas the formation of the fully disordered, defect-fluorite structure is the dominant process for Zr-rich pyrochlore.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1193
Irradiation effects of synthetic coffinite (USiO4) studied by in-situ TEM
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1193
Irradiation effects of synthetic coffinite (USiO4) studied by in-situ TEM
- 22 August 2008
- Published by American Physical Society (APS) in Physical Review B
- Vol. 78 (6) , 064114
Structural phase transitions of cubicat high pressuresAn irreversible structural transformation from the cubic phase to a hexagonal high-pressure phase was verified in between 7.0 and 15 GPa. The compressibility and bond distances of both phases were determined by the refinement of the x-ray diffraction data. The high-pressure phase of is 9.2% denser than the cubic phase at 7 GPa. After release of pressure, the high-pressure phase transformed to a monoclinic structure. The pressure-induced phase transition from the monoclinic to the hexagonal phase is reversible. Unlike the case at atmospheric pressure, the hexagonal phase was found to transform to the monoclinic phase by increase of temperature at high pressures. The lattice potential energies and electronic density of states of the cubic, monoclinic, and hexagonal high-pressure phases of were calculated from the known structural models with density-functional method. The observed phase stability, transition pressure, and volume change are well explained by theoretical calculations.- 22 August 2008
- Published by American Physical Society (APS) in Physical Review B
- Vol. 78 (6) , 064114
Structural phase transitions of cubicat high pressuresAn irreversible structural transformation from the cubic phase to a hexagonal high-pressure phase was verified in between 7.0 and 15 GPa. The compressibility and bond distances of both phases were determined by the refinement of the x-ray diffraction data. The high-pressure phase of is 9.2% denser than the cubic phase at 7 GPa. After release of pressure, the high-pressure phase transformed to a monoclinic structure. The pressure-induced phase transition from the monoclinic to the hexagonal phase is reversible. Unlike the case at atmospheric pressure, the hexagonal phase was found to transform to the monoclinic phase by increase of temperature at high pressures. The lattice potential energies and electronic density of states of the cubic, monoclinic, and hexagonal high-pressure phases of were calculated from the known structural models with density-functional method. The observed phase stability, transition pressure, and volume change are well explained by theoretical calculations.- 28 January 2008
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 100 (4) , 045503
Phase Stability and Pressure Dependence of Defect Formation inandPyrochloresWe report dramatically different behaviors between isostructural and pyrochlore at pressures up to 44 GPa, in which the substitution of Ti for Zr significantly increases structural stability. Upon release of pressure, the becomes amorphous. In contrast, the high-pressure phase of transforms to a disordered defect-fluorite structure. First-principle calculations for both compositions revealed that the response of pyrochlore to high pressure is controlled by the intrinsic energetics of defect formation.- 28 January 2008
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 100 (4) , 045503
Phase Stability and Pressure Dependence of Defect Formation inandPyrochloresWe report dramatically different behaviors between isostructural and pyrochlore at pressures up to 44 GPa, in which the substitution of Ti for Zr significantly increases structural stability. Upon release of pressure, the becomes amorphous. In contrast, the high-pressure phase of transforms to a disordered defect-fluorite structure. First-principle calculations for both compositions revealed that the response of pyrochlore to high pressure is controlled by the intrinsic energetics of defect formation.