BPB. K. Panigrahi

B. K. Panigrahi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


B. K. Panigrahi has a total of 77 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Strain effect on the photoluminescence property of gold nanoclusters

    by K. Saravanan, C. David, G. Jayalakshmi, B. K. Panigrahi, D. K. Avasthi

    Herein, we report the temperature-dependent photoluminescence (PL) properties of Au nanoclusters (NCs) embedded in a Si matrix. Gold NCs have been synthesized in Si by a multistep procedure that involves ion implantation and gold decoration by drive in annealing. Transmission electron microscopic studies reveal profuse nucleation of Au NCs, with mean sizes of ∼8 nm in the near-surface region. PL measurements in the range of 2 eV to 3.65 eV were carried out in the temperature range of 5 K to 300 K. The Au NCs exhibit PL emissions at 3 eV and 2.5 eV; these are attributed to the recombination of sp-band electrons with the holes of a deep lying d-band below the Fermi level in the vicinity of the L symmetry point of the Brillouin zone and the recombination of sp band electrons with the holes of the first d band below the Fermi level in the vicinity of the X symmetry point of the Brillouin zone, respectively. Temperature-dependent PL measurements show that the PL intensity of Au NCs initially decreases with the increase of temperature up to 50 K, and, thereafter, the intensity starts to increase and reaches a maximum at 150 K. A further increase in temperature causes the intensity to decrease. However, the PL intensity of Au NCs embedded in a sapphire matrix monotonically decreases with the increase of temperature. The present work discusses the plausible mechanism behind this unusual PL behaviour by invoking the role of strain at the NC-matrix interface.


  • Resonant Rutherford backscattering spectrometric analysis on ion beam reduced graphene oxide

    by K. Saravanan, B. Sundaravel, B. K. Panigrahi

    We study the reduction of graphene oxide (GO) sheets, synthesized by modified Hummer’s method, using medium energy ion beams (500 keVAr+ or 500 keVN+). Resonant Rutherford backscattering spectrometry technique has been employed to quantify the oxygen reduction upon irradiation. Ion irradiation process results exponential reduction with the increase of fluence. The C/O ratio of Ar+ ion irradiated samples is larger than the N+ irradiated sample, indicating that Ar+ ion beam can be effectively used to reduce GO. The grazing incident X-ray diffraction analysis also reveals that the RGO content is enhanced in Ar+ ion irradiated sample in comparison with N+ irradiated sample.


  • Strain and particle size analysis in ion beam synthesized SiC nanoparticles using Raman scattering studies

    by K. Saravanan, G. Jayalakshmi, B. K. Panigrahi, René Hübner

    We study the strain and particle size analysis of ion beam synthesized SiC nanoparticles (NPs) embedded in Si matrix using Raman and low‐frequency Raman scattering (LFRS). 300 keV C+ ions with the fluence of 2 × 1017 ions/cm2 were implanted on Si substrate at three different substrate temperatures (300, 500 and 650 °C). Raman scattering analyses confirm the formation of 3C‐SiC NPs in Si matrix. Relative strain in 3C‐SiC NPs estimated from Raman scattering was found to be decreases with increase of substrate temperature. The particle size distribution of 3C‐SiC NPs was estimated from the signature of localized acoustic phonon modes observed in the low frequency region of LFRS spectra. The estimated particle size of the SiC is found to be in good agreement with the TEM analysis.


  • Delineating the role of ripples on the thermal expansion of 2D honeycomb materials: graphene, 2D h-BN and monolayer (ML)-MoS2

    by P. Anees, M. C. Valsakumar, B. K. Panigrahi

    We delineated the role of thermally excited ripples on the thermal expansion properties of 2D honeycomb materials (free-standing graphene, 2D h-BN, and ML-MoS2), by explicitly carrying out three-dimensional (3D) and two-dimensional (2D) molecular dynamics simulations. In 3D simulations, the in-plane lattice parameter (a-lattice) of graphene and 2D h-BN shows thermal contraction over a wide range of temperatures and exhibits a strong system size dependence. The 2D simulations of the very same system show a reverse trend, where the a-lattice expands in the whole computed temperature range. In contrast to graphene and 2D h-BN, the a-lattice of ML-MoS2 shows thermal expansion in both 2D and 3D simulations and their system size dependence is marginal. By analyzing the phonon dispersion at 300 K, we found that the discrepancy between 2D and 3D simulations of graphene and 2D h-BN is due to the absence of out-of-plane bending modes (ZA) in 2D simulations, which is responsible for the thermal contraction of the a-lattice at low temperature. Meanwhile, all the phonon modes are present in the 2D phonon dispersion of ML-MoS2, which indicates that the origin of the ZA mode is not purely due to the out-of-plane movement of atoms and also its effect on thermal expansion is not significant as found in graphene and 2D h-BN.


  • Open Access

    Delineating the role of ripples on thermal expansion of honeycomb materials:graphene, 2D-h-BN and monolayer(ML)-MoS2

    by P. Anees, M. C. Valsakumar, B. K. Panigrahi

    We delineated the role of thermally excited ripples on thermal expansion properties of 2D honeycomb materials (free-standing graphene, 2D h-BN, and ML-MoS2), by explicitly carrying out three-dimensional (3D) and two-dimensional (2D) molecular dynamics simulations. In 3D simulations, the in-plane lattice parameter (a-lattice) of graphene and 2D h-BN shows thermal contraction over a wide range of temperatures and exhibits a strong system size dependence. The 2D simulations of the very same system show a reverse trend, where the a-lattice is expanding in the whole computed temperature range. Contrary to graphene and 2D h-BN, the a-lattice of ML-MoS2 shows thermal expansion in both 2D and 3D simulations and their system size dependence is marginal. By analyzing the phonon dispersion at 300 K, we found that the discrepancy between 2D and 3D simulations of graphene and 2D h-BN is due to the absence of out-of-plane bending mode (ZA) in 2D simulations, which is responsible for thermal contraction of a-lattice at low temperature. Meanwhile, all the phonon modes are present in 2D phonon dispersion of ML-MoS2, which indicates that the origin of ZA mode is not purely due to out-of-plane movement of atoms and also its effect on thermal expansion is not significant as found in graphene and 2D h-BN

  • Ion irradiation studies on the void swelling behavior of a titanium modified D9 alloy

    by S. Balaji, Sruthi Mohan, S. Amirthapandian, S. Chinnathambi, C. David, B.K. Panigrahi


  • Effect of strong phonon–phonon coupling on the temperature dependent structural stability and frequency shift of 2D hexagonal boron nitride

    by P. Anees, M. C. Valsakumar, B. K. Panigrahi

    The temperature dependent structural stability, frequency shift and linewidth of 2D hexagonal boron nitride (h-BN) are studied using a combination of lattice dynamics (LD) and molecular dynamics (MD) simulations. The in-plane lattice parameter shows a negative thermal expansion in the whole computed temperature range (0–2000 K). When the in-plane lattice parameter falls below the equilibrium value, the quasi-harmonic bending (ZA) mode frequency becomes imaginary along the Γ–M direction in the Brillouin zone, leading to a structural instability of the 2D sheet. The ZA mode is seen to be stabilized in the dispersion obtained from MD simulations, due to the automatic incorporation of higher order phonon scattering processes in MD, which are absent in a quasi-harmonic dispersion. The mode resolved phonon spectra computed with a quasi-harmonic method predict a blueshift of the longitudinal and transverse (LO/TO) optic mode frequencies with an increase in temperature. On the other hand, both canonical (NVT) and isobaric–isothermal (NPT) ensembles predict a redshift with an increase in temperature, which is more prominent in the NVT ensemble. The strong phonon–phonon coupling dominates over the thermal contraction effect and leads to a redshift in LO/TO mode frequency in the NPT ensemble simulations. The out-of-plane (ZO) optic mode quasi-harmonic frequencies are redshifted due to a membrane effect. The phonon–phonon coupling effects in the NVT and NPT ensemble simulations lead to a further reduction in the ZO mode frequencies. The linewidth of the LO/TO and ZO mode frequencies increases in a monotonic fashion. The temperature dependence of acoustic modes is also analyzed. The quasi-harmonic calculations predict a redshift of ZA mode, and at the same time the TA (transverse acoustic) and LA (longitudinal acoustic) mode frequencies are blueshifted. The strong phonon–phonon coupling in MD simulations causes a redshift of the LA and TA mode frequencies, while the ZA mode frequencies are blueshifted with an increase in temperature.


  • Microstructure and friction behaviour in nanocrystalline diamond films

    by Kalpataru Panda, N. Kumar, S.R. Polaki, B.K. Panigrahi, S. Dash, A.K. Tyagi, I-Nan Lin