Tong Bou Chang
Research Subjects
Tong Bou Chang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Fu Jen Wang
National Chin-Yi University of Technology
2 shared publicationsChih-Chang Liang
Southern Taiwan University
1 shared publicationGo-Long Tsai
National Taipei University of Technology
1 shared publicationMing‐Sheng Ko
Department of Materials & Mineral Resources Engineering , National Taipei University of Technology , Taipei, 10608, Taiwan, R.O.C.
1 shared publicationRu-Li Lin
Southern Taiwan University
1 shared publicationWen Yu Yeh
1 shared publication
Latest Publications
- 29 March 2012
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 26 (3) , 681-688
Effects of spray axis incident angle on heat transfer performance of rhombus-pitch shell-and-tube interior spray evaporator
- 29 March 2012
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 26 (3) , 681-688
Effects of spray axis incident angle on heat transfer performance of rhombus-pitch shell-and-tube interior spray evaporator
- 31 December 2009
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 48 (12) , 2323-2330
Effects of uniform suction and surface tension on laminar filmwise condensation on a horizontal elliptical tube in a porous medium
- 31 December 2009
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 48 (12) , 2323-2330
Effects of uniform suction and surface tension on laminar filmwise condensation on a horizontal elliptical tube in a porous medium
- 1 December 2009
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 23 (12) , 3399-3406
Film condensation on horizontal tube with wall suction effects
- 1 December 2009
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 23 (12) , 3399-3406
Film condensation on horizontal tube with wall suction effects
- 1 January 2009
- Published by Taylor & Francis in Journal of the Chinese Institute of Engineers
- Vol. 32 (1) , 141-147
Optimizing the power generation of a radiation driven stirling engine used in the combustion chamber of an incinerator
This study performs a theoretical investigation into the optimal design of a radiation driven Stirling engine used in the combustion chamber of waste‐to‐energy incinerator. Applying the principles of finite‐time thermodynamics and entropy generation, respectively, analytical solutions are derived for the optimal temperature ratio of the internal working fluids and the corresponding output power under the constraints of a constant combustion temperature and a given ambient temperature. The results show that the radiation driven Stirling engine has a greater thermal efficiency than a steam turbine engine and a smaller hot end surface area than the solar collector area required to generate an equivalent power output.
- 1 January 2009
- Published by Taylor & Francis in Journal of the Chinese Institute of Engineers
- Vol. 32 (1) , 141-147
Optimizing the power generation of a radiation driven stirling engine used in the combustion chamber of an incinerator
This study performs a theoretical investigation into the optimal design of a radiation driven Stirling engine used in the combustion chamber of waste‐to‐energy incinerator. Applying the principles of finite‐time thermodynamics and entropy generation, respectively, analytical solutions are derived for the optimal temperature ratio of the internal working fluids and the corresponding output power under the constraints of a constant combustion temperature and a given ambient temperature. The results show that the radiation driven Stirling engine has a greater thermal efficiency than a steam turbine engine and a smaller hot end surface area than the solar collector area required to generate an equivalent power output.
- 1 November 2008
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 22 (11) , 2134-2141
An analytical investigation into the Nusselt number and entropy generation rate of film condensation on a horizontal plate
- 1 November 2008
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 22 (11) , 2134-2141
An analytical investigation into the Nusselt number and entropy generation rate of film condensation on a horizontal plate
- 13 September 2008
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 45 (3) , 355-361
An analytical investigation into filmwise condensation on a horizontal tube in a porous medium with suction at the tube surface
- 13 September 2008
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 45 (3) , 355-361
An analytical investigation into filmwise condensation on a horizontal tube in a porous medium with suction at the tube surface
- 19 May 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (7) , 071502
Laminar Filmwise Condensation on Horizontal Disk Embedded in Porous Medium With Suction at Wall
This study performs a theoretical investigation into the problem of two-dimensional steady filmwise condensation flow on a horizontal disk embedded in a porous medium layer with suction at the disk surface. The analysis considers the case of a water-vapor system and is based on typical values of the relevant dimensional and dimensionless parameters. Due to the effects of capillary forces, a two-phase zone is formed between the liquid film and the vapor zone. The minimum mechanical energy concept is employed to establish the boundary condition at the edge of the horizontal disk and the Runge–Kutta shooting method is used to solve the second-order nonlinear ordinary differential equation of the liquid film. It is found that the capillary force and wall suction effects have a significant influence on the heat transfer performance. Specifically, the results show that the dimensionless heat transfer coefficient depend on the Darcy number Da, the Jacob number Ja, the effective Rayleigh number Rae, the effective Prandtl number Pre, the suction parameter Sw, and the capillary parameter Boc.
- 19 May 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (7) , 071502
Laminar Filmwise Condensation on Horizontal Disk Embedded in Porous Medium With Suction at Wall
This study performs a theoretical investigation into the problem of two-dimensional steady filmwise condensation flow on a horizontal disk embedded in a porous medium layer with suction at the disk surface. The analysis considers the case of a water-vapor system and is based on typical values of the relevant dimensional and dimensionless parameters. Due to the effects of capillary forces, a two-phase zone is formed between the liquid film and the vapor zone. The minimum mechanical energy concept is employed to establish the boundary condition at the edge of the horizontal disk and the Runge–Kutta shooting method is used to solve the second-order nonlinear ordinary differential equation of the liquid film. It is found that the capillary force and wall suction effects have a significant influence on the heat transfer performance. Specifically, the results show that the dimensionless heat transfer coefficient depend on the Darcy number Da, the Jacob number Ja, the effective Rayleigh number Rae, the effective Prandtl number Pre, the suction parameter Sw, and the capillary parameter Boc.
- 17 March 2008
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 195 (7) , 721-737
EFFECTS OF SURFACE TENSION ON LAMINAR FILMWISE CONDENSATION ON A HORIZONTAL PLATE IN A POROUS MEDIUM WITH SUCTION AT THE WALL
The problem of two-dimensional, steady-state film condensation on an isothermal finite-size horizontal plate embedded in a porous medium is studied for the case in which the plate faces upward into a region of dry saturated vapor. Due to surface tension effects, a two-phase zone is formed between the liquid film on the horizontal plate and the vapor zone. The effects of surface tension are shown to reduce the thickness of the liquid film and hence to increase the heat transfer performance of the horizontal plate. Furthermore, the results show that the dimensionless heat transfer coefficient depends on the Darcy number Da, the Jacob number Ja, the effective Rayleigh number Rae, the effective Prandtl number Pre, the wall suction parameter Sw, and the surface tension parameter Boc. When the surface tension effects are neglected and there is no suction at the wall, a closed-form correlation for the Nusselt number can be established.
- 17 March 2008
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 195 (7) , 721-737
EFFECTS OF SURFACE TENSION ON LAMINAR FILMWISE CONDENSATION ON A HORIZONTAL PLATE IN A POROUS MEDIUM WITH SUCTION AT THE WALL
The problem of two-dimensional, steady-state film condensation on an isothermal finite-size horizontal plate embedded in a porous medium is studied for the case in which the plate faces upward into a region of dry saturated vapor. Due to surface tension effects, a two-phase zone is formed between the liquid film on the horizontal plate and the vapor zone. The effects of surface tension are shown to reduce the thickness of the liquid film and hence to increase the heat transfer performance of the horizontal plate. Furthermore, the results show that the dimensionless heat transfer coefficient depends on the Darcy number Da, the Jacob number Ja, the effective Rayleigh number Rae, the effective Prandtl number Pre, the wall suction parameter Sw, and the surface tension parameter Boc. When the surface tension effects are neglected and there is no suction at the wall, a closed-form correlation for the Nusselt number can be established.
- 1 June 2007
- Published by Canadian Science Publishing in Transactions of the Canadian Society for Mechanical Engineering
- Vol. 31 (2) , 243-253
OPTIMIZATION OF REALISTIC REFRIGERATION PLANT UNDER FIXED TOTAL THERMAL CONDUCTANCE CONSTRAINT
This study analyzes the internal irreversibility of a realistic refrigeration plant under the design constraint of a fixed total thermal conductance. The internal heat losses are determined using a heat by-pass model. The optimal thermal conductance allocation and optimal coefficient of performance are derived from a series of detailed analyses and formulations. The numerical results indicate that the optimal thermal conductance ratio of the hot end of a realistic refrigeration plant is slightly higher than 0.5.
- 1 June 2007
- Published by Canadian Science Publishing in Transactions of the Canadian Society for Mechanical Engineering
- Vol. 31 (2) , 243-253
OPTIMIZATION OF REALISTIC REFRIGERATION PLANT UNDER FIXED TOTAL THERMAL CONDUCTANCE CONSTRAINT
This study analyzes the internal irreversibility of a realistic refrigeration plant under the design constraint of a fixed total thermal conductance. The internal heat losses are determined using a heat by-pass model. The optimal thermal conductance allocation and optimal coefficient of performance are derived from a series of detailed analyses and formulations. The numerical results indicate that the optimal thermal conductance ratio of the hot end of a realistic refrigeration plant is slightly higher than 0.5.