ANAndrey V. Nomoev

Andrey V. Nomoev

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Andrey V. Nomoev has a total of 131 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of Cu/Cu2O/CuO Nanopowder Additives on the Antiwear Performance of Industrial Mineral Oil

    by Shunqi Mei, Andrey Nomoev, Erzhena Khartaeva, Undrakh Mishigdorzhiyn, Sergei Nomoev, Sayan Badmaev, Bair Garmaev

    This study evaluates the effect of copper-containing composite nanopowders on the antiwear properties of additive-free I-20A mineral oil. The powders were produced by the same electron-beam evaporation route in argon under different current–time regimes and differed in phase composition and particle characteristics. N1 was synthesized at 1.4 MeV and 20 mA for 15 min and contained 91 wt.% Cu, 2 wt.% Cu2O, and 7 wt.% CuO (mean particle size 140 nm), whereas N2 was synthesized at 1.4 MeV and 15 mA for 25 min and contained 38 wt.% Cu, 48 wt.% Cu2O, and 14 wt.% CuO (187 nm). Six separate oil suspensions containing 0.01, 0.1, or 1 wt.% N1 or N2 were evaluated in block-on-ring tests; three independent tests were performed for each lubricant condition (21 individual measurements in total). The lowest mean mass loss was obtained with 1 wt.% N2 (0.00290 ± 0.00015 g), representing a 43.1% decrease relative to pure I-20A oil (0.00510 ± 0.00026 g; Holm-adjusted p = 0.0045). The 0.01 and 0.1 wt.% N2 formulations did not differ significantly from pure oil, whereas 0.01 and 1 wt.% N1 significantly increased mass loss. In selected SEM/EDS regions, the wear scar produced with 1 wt.% N1 showed deeper longitudinal grooves and no detectable Cu, whereas the scar produced with 1 wt.% N2 showed a smoother local morphology and 0.58 wt.% Cu. These local observations are consistent with different particle–surface interactions and greater local retention of Cu-containing material for N2, but they do not identify the copper oxidation state or prove formation of a continuous tribofilm. Overall, the powders exhibited formulation- and concentration-dependent antiwear behavior: 1 wt.% N2 was beneficial, whereas 1 wt.% N1 was strongly detrimental. Because the synthesis regime, phase composition, particle size, and morphology varied together, the observed difference cannot be attributed exclusively to the Cu/Cu2O/CuO ratio.

  • Open Access

    MICROWAVE AND RHEOLOGICAL PROPERTIES OF HIGH-LOADED SILCOTIN 25/R-10 SILICONE COMPOSITE WITH SiO2 NANOPOWDER (TARKOSIL)

    by Il'Ya A. Yuzhakov, Bair Z. Garmaev, Damdin G. Tsydypov, Andrei V. Nomoev, Илья Андреевич Южаков, Баир Заятуевич Гармаев, Дамдин Галсанович Цыдыпов, Андрей Валерьевич Номоев

    MICROWAVE AND RHEOLOGICAL PROPERTIES OF HIGH-LOADED SILCOTIN 25/R-10 SILICONE COMPOSITE WITH SiO2 NANOPOWDER (TARKOSIL) | Yuzhakov | Bulletin of the Siberian State Industrial University МИКРОВОЛНОВЫЕ И РЕОЛОГИЧЕСКИЕ СВОЙСТВА ВЫСОКОНАПОЛНЕННОГО СИЛИКОНОВОГО КОМПОЗИТА SILCOTIN 25/Р-10 С НАНОПОРОШКОМ SiO2 (ТАРКОСИЛ) | Южаков | Вестник Сибирского государственного индустриального университета

  • Open Access

    KINETIC ANALYSIS OF THE FORMATION OF BRASS NANOPARTICLES PRODUCED DURING EVAPORATION BY A CONTINUOUS HIGH-ENERGY ELECTRON BEAM

    by Ehrzhena Ch. Khartaeva, Andrei V. Nomoev, Sergei A. Nomoev, Эржена Чимитдоржиевна Хартаева, Андрей Валерьевич Номоев, Сергей Андреевич Номоев

    KINETIC ANALYSIS OF THE FORMATION OF BRASS NANOPARTICLES PRODUCED DURING EVAPORATION BY A CONTINUOUS HIGH-ENERGY ELECTRON BEAM | Khartaeva | Bulletin of the Siberian State Industrial University КИНЕТИЧЕСКИЙ АНАЛИЗ ОБРАЗОВАНИЯ НАНОЧАСТИЦ ЛАТУНИ, СОЗДАЮЩИХСЯ ПРИ ИСПАРЕНИИ НЕПРЕРЫВНЫМ ПУЧКОМ ЭЛЕКТРОНОВ ВЫСОКОЙ ЭНЕРГИИ | Хартаева | Вестник Сибирского государственного индустриального университета

  • Separation of Microparticles by Size in an Electrodynamic Field

    by S. V. Kalashnikov, A. V. Nomoev, T. A. Chimytov

    The article studies electrodeposition in an electrodynamic field used, for example, in electrostatic filters for cleaning smoke from solid particles, as a method for separating micro- and nanoparticles by size. The dependence of the particle charge acquired in the corona discharge of a special electrode system, and hence the Coulomb force on their radius, allows spatially separating particles by size in a gas flow. A theoretically calculated curve of the dependence of the deposition length on the particle size in a channel equipped with corona-forming and precipitation electrodes is shown. By spraying micro- and nanoparticles into an air flow passing through a specially created precipitation channel, the dependences of the deposition length on the particle size were obtained, which are in good agreement with the calculated ones for microparticles. Separation of nanopowders failed, apparently due to the hindrance of proportional deposition of particles of different sizes by Coulomb forces by the ion wind, which has a complex vortex structure between the electrodes.

  • Open Access

    Study of the thermodynamic characteristics of gold nanoparticles in the processes of melting and crystallization by the molecular dynamics method

    by D. G. Tsydypov, A. V. Nomoev, B. Z. Garmaev

    The article presents the results of computer modeling of melting and crystallization processes of spherical gold nanoparticles. The molecular dynamics method was used to analyze the thermodynamic characteristics (temperature, heat, entropy of melting, and crystallization) of nanoparticles for different heating and cooling rates. Such studies allow choosing the most suitable temperature ranges for the formation of nanocrystalline structures and predicting their sizes. Reducing the size of gold nanoparticles (less than 100 nm) leads to a significant increase in the ratio of the surface area to the volume of particles, as a result of which the physical and chemical characteristics of the material change significantly compared to materials of the same material in bulk form. Interest in gold nanoparticles is due to enhanced photoemission, high electrical and thermal conductivity, and increased catalytic activity of the surface. Gold nanoparticles have strong optical absorption and scattering properties in the visible region of the spectrum due to surface plasmon oscillations of free electrons. In the known studies from the literature, it was found that with an increase in the size of nanoparticles, the hysteresis between the melting and crystallization temperatures increases, while in theory the macroscopic melting and crystallization temperatures should be the same. The novelty of the study presented in this paper is to reveal a previously unobserved tendency for macroscopic temperatures, heat and entropy of melting and crystallization to converge with a decrease in the heating and cooling rates. The classical molecular dynamics method was used to study the thermodynamic properties of gold nanoparticles. The subject of modeling was gold nanoparticles of various sizes, spherical in shape with a face-centered cubic lattice. In the modeling process, the interatomic potential was used corresponding to the embedded atom method which was developed for gold, using an improved force matching methodology. Heating and cooling of nanoparticles were modeled at temperature change rates of 0.1 TK/s, 1 TK/s, 3 TK/s. By analyzing the relationship between the potential energy of gold nanoparticles and temperature, the dependences of the melting and crystallization temperatures of nanoparticles on their size were revealed. A relationship was established between the size of nanoparticles, heat, entropy of melting and crystallization at different heating and cooling rates. It was shown that with a decrease in the heating and cooling rates from 3 TK/s to 0.1 TK/s, there is a convergence of the macroscopic values of the melting and crystallization temperatures (a decrease in the difference from 467 K to 158 K), macroscopic values of the heat of melting and crystallization (from 4.24 kJ/mol to 0.67 kJ/mol), entropy of melting and crystallization (from 1.99 J/(mol·K) to 0.16 J/(mol·K)). It was assumed that this is due to a decrease in the proportion of the formed nanostructures other than face-centered cubic ones. Prediction of temperature regimes of melting and crystallization of gold nanoparticles allows controlling phase transitions in the production of nanocrystals with specified properties. This phenomenon can find application in microelectronics for the formation of thin films with a high degree of homogeneity and in catalysis for the formation of nanoparticles with the required structures and properties. The obtained data can be used to verify the results of real experiments on phase transitions and to adjust molecular dynamics models.

  • Open Access

    Experiments to Improve the Efficiency of Obtaining Brass Nanoparticles by Evaporation by a Continuous Beam of High-Energy Electrons

    by Е. Ch. Khartaeva, А. V. Nomoev, S. P. Bardakhanov, К. V. Zobov, D. Yu. Trufanov, V. R. Gaponenko, D. G. Tsydypov

    Composite, copper and zinc containing nanoparticles and brass nanoparticles have been obtained by a high-performance method of evaporation of substances by a relativistic electron beam. The change in the stoichiometry of nanopowders produced by stepwise irradiation of a brass ingot placed in a single-zone graphite crucible is considered. It was found that the production of such particles depends on the concentration of saturated vapors of zinc and copper. A two-zone configuration of the crucible has been developed, which makes it possible to realize the simultaneous evaporation of the constituent components, thereby providing the conditions for the formation of uniform brass nanoparticles with a uniform distribution of elements and a high yield of nanopowder. X-ray diffraction analysis (XRD), Transmission electron microscopy (TEM), Energy dispersive X-ray analysis (EDX) were carried out, and the specific surface of the obtained nanoparticles was determined. The mechanism of formation of composite nanoparticles is discussed.

  • Determination of thermophysical properties and the radial distribution function of a silver nanoparticle using numerical methods

    by Damdin G. Tsydypov, Andrey V. Nomoev, Bair Z. Garmaev

    The performance of microelectronic devices based on silver nanostructures depends on their thermophysical properties. Therefore, it is important to study the thermophysical properties of silver nanostructures depending on their size and structure. In this work, the thermal stability of spherical silver nanoparticles was studied using computer simulation by the molecular dynamics method. In the course of this work, the temperature dependences of the potential part of the specific internal energy of silver nanoparticles were obtained with a change in the size of the nanoparticle for various potentials corresponding to the embedded atom” method. Using numerical data processing methods, the temperatures of the beginning and end of melting were determined. Also, size dependences of the melting temperature and specific heat of fusion of silver nanoparticles were plotted and analyzed for different potentials of the “embedded atom”. Potentials that provide the best agreement with the tabular values of the macroscopic melting temperature and specific heat of fusion were determined. In addition, the radial distribution function for a silver nanoparticle was constructed and analyzed at different temperatures and for different sizes of the nanoparticle.


  • Open Access

    Влияние наноразмерного порошка диоксида кремния на физико- механические, прочностные характеристики лакокрасочного покрытия из эмали ХВ-16

    by В.ц. Лыгденов, А.в. Номоев, С.п. Бардаханов, Т.в. Ларина

    В данной статье установлено влияние наноразмерного диоксида кремния марки на Таркосил на физико- механические, прочностные свойства, структуру полимерного лакокрасочного покрытия из эмали на основе перхлорвиниловой и глифталевой смол ХВ-16. Обнаружено увеличение прочности на истирание, твердости, модуля упругости лакокрасочного покрытия по сравнению с исходным. Методами атомно- силовой микроскопии, растровой электронной микроскопии, ИК спектроскопии проведен качественный и количественный анализ структуры полученных образцов лакокрасочных покрытий. Выявлено, что изменение структуры и повышение механических свойств покрытий обусловлено появлением новых структурообразующих центров в композиционном покрытии при введении наноразмерного диоксида кремния.

  • РАСЧЕТ ТЕМПЕРАТУРЫ ПЛАВЛЕНИЯ И КРИСТАЛЛИЗАЦИИ НАНОЧАСТИЦЫ МЕДИ МОЛЕКУЛЯРНО-ДИНАМИЧЕСКИМ МЕТОДОМ

    by Э. Ч. Хартаева, Институт Физического Материаловедения Со Ран, А. В. Номоев, Е. В. Батуева, Институт Физического Материаловедения Со Ран; Бурятский Государственный Университет