V. V. Ryzhov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
V. V. Ryzhov has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
S. Ya. Belomyttsev
Russian Academy of Sciences
7 shared publicationsA. A. Grishkov
Russian Academy of Sciences
4 shared publicationsS. D. Korovin
Russian Academy of Sciences
4 shared publicationsA. V. Kirikov
Russian Academy of Sciences
3 shared publicationsA. A. Kim
Russian Academy of Sciences
2 shared publicationsA.A. Grishkov
Institute of High Current Electronics, Tomsk, Russia
1 shared publication
Latest Publications
- 1 November 2007
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 52 (11) , 1527-1530
Retrapping of current in a vacuum transmission line upon reflection of a magnetic self-insulation wave from a load
The equations derived in the framework of the Brillouin model of an electron layer in a “hot” vacuum transmission line form the basis for analysis of reflection of an electromagnetic wave from a load, leading to a redistribution of currents in the magnetically insulated transmission line (MITL). It is shown theoretically for the first time that conversion (retrapping) of a considerable fraction of the current in the electron layer to the cathode current upon the reflection of the wave from the load upon an insignificant change in the current and voltage in the line is possible even under the conditions close to the self-consistent regime. This effect can be explained by the change in the state of the electron layer under the action of the reflected wave, which is associated with a transition of the system from the right branch of the magnetic self-insulation curve to the left branch.
- 1 November 2007
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 52 (11) , 1527-1530
Retrapping of current in a vacuum transmission line upon reflection of a magnetic self-insulation wave from a load
The equations derived in the framework of the Brillouin model of an electron layer in a “hot” vacuum transmission line form the basis for analysis of reflection of an electromagnetic wave from a load, leading to a redistribution of currents in the magnetically insulated transmission line (MITL). It is shown theoretically for the first time that conversion (retrapping) of a considerable fraction of the current in the electron layer to the cathode current upon the reflection of the wave from the load upon an insignificant change in the current and voltage in the line is possible even under the conditions close to the self-consistent regime. This effect can be explained by the change in the state of the electron layer under the action of the reflected wave, which is associated with a transition of the system from the right branch of the magnetic self-insulation curve to the left branch.
- 1 November 2006
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 51 (11) , 1500-1507
Calculation of the properties of a self magnetic insulation wave in a vacuum transmission line on the basis of conservation laws
On the basis of the conservation laws for the energy and the z component of the momentum in a self magnetic insulation wave propagating in a vacuum transmission line, the relativistic factor γm corresponding to the voltage at the outer boundary of the electron sheath is found under the assumption that all electrons incident to the anode have identical energies and identical angles of incidence. The effect of energy losses in the precursor wave on basic properties of the self magnetic insulation wave is investigated.
- 1 November 2006
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 51 (11) , 1500-1507
Calculation of the properties of a self magnetic insulation wave in a vacuum transmission line on the basis of conservation laws
On the basis of the conservation laws for the energy and the z component of the momentum in a self magnetic insulation wave propagating in a vacuum transmission line, the relativistic factor γm corresponding to the voltage at the outer boundary of the electron sheath is found under the assumption that all electrons incident to the anode have identical energies and identical angles of incidence. The effect of energy losses in the precursor wave on basic properties of the self magnetic insulation wave is investigated.
- 1 May 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (5) , 394-396
Theory of self-magnetically insulated vacuum transmission lines
It is assumed that vacuum transmission lines in the self-magnetic insulation regime feature a limiting current, whereby the trajectories of electrons at the wave front arriving at the anode are tangent to the surface. Under this assumption, the law of energy conservation in the system provides an equation for the relativistic factor γm corresponding to the voltage at the outer boundary of the electron layer that can be used for determining the main characteristics of a transmission line in the self-magnetic insulation regime.
- 1 May 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (5) , 394-396
Theory of self-magnetically insulated vacuum transmission lines
It is assumed that vacuum transmission lines in the self-magnetic insulation regime feature a limiting current, whereby the trajectories of electrons at the wave front arriving at the anode are tangent to the surface. Under this assumption, the law of energy conservation in the system provides an equation for the relativistic factor γm corresponding to the voltage at the outer boundary of the electron layer that can be used for determining the main characteristics of a transmission line in the self-magnetic insulation regime.
- 1 January 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (1) , 55-57
The current of an annular electron beam behind virtual cathode
The output current I out of a magnetized annular electron beam transported in a homogeneous drift tube of a SINUS-7 setup has been studied as a function of the injected beam current I inj. The electron beam was injected via an anode inset of smaller radius and had a current above the Fedosov limit for the given drift tube (I inj ≥ I F). It is established that, to within the experimental uncertainty, a virtual cathode (VC) is formed when the injected beam current exceeds the corresponding limiting I lim. In this state, the current transmitted behind VC is approximately equal to the limiting value (I out ≈ I lim).
- 1 January 2005
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 31 (1) , 55-57
The current of an annular electron beam behind virtual cathode
The output current I out of a magnetized annular electron beam transported in a homogeneous drift tube of a SINUS-7 setup has been studied as a function of the injected beam current I inj. The electron beam was injected via an anode inset of smaller radius and had a current above the Fedosov limit for the given drift tube (I inj ≥ I F). It is established that, to within the experimental uncertainty, a virtual cathode (VC) is formed when the injected beam current exceeds the corresponding limiting I lim. In this state, the current transmitted behind VC is approximately equal to the limiting value (I out ≈ I lim).
- 1 December 2004
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 30 (12) , 1060-1063
The virtual cathode velocity during electron beam transport in a drift tube
A solution corresponding to a thin annular electron beam in a homogeneous drift tube featuring a uniformly moving virtual cathode (VC) has been obtained. The dependence of the VC velocity on the injected and transmitted currents is determined and it is established that this velocity has a limiting value. Theoretical results agree with the results of numerical calculations performed by means of the electromagnetic PIC code KARAT.
- 1 December 2004
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 30 (12) , 1060-1063
The virtual cathode velocity during electron beam transport in a drift tube
A solution corresponding to a thin annular electron beam in a homogeneous drift tube featuring a uniformly moving virtual cathode (VC) has been obtained. The dependence of the VC velocity on the injected and transmitted currents is determined and it is established that this velocity has a limiting value. Theoretical results agree with the results of numerical calculations performed by means of the electromagnetic PIC code KARAT.
- 1 November 2003
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 29 (11) , 944-946
The electron beam with virtual cathode in a two-section drift tube
An analysis based on the law of conservation of the z component of field and particle momentum in a thin annular magnetized monoenergetic electron beam in a two-section drift tube composed of tube segments with different radii (R 1<R 2) allowed the critical injected beam current to be determined for which a virtual cathode, formed in the wider tube at the joint section, starts traveling through the narrower tube toward the beam injection region. A region behind the traveling virtual cathode features a “squeezed” single-flux state of the beam (corresponding to the “slow” left branch of the current characteristic, high charge density, but low relativistic factor). When the injected current decreases below a critical transition level (I in<I Tr), the virtual cathode returns to the initial position and restores the double-flux electron beam. This current is smaller than (I lim1+I lim2)/2, and, depending on R 2, varies from the limiting transport current for the narrower section (I lim1) up to I F/2, where I F is the Fedosov current for this tube section.
- 1 November 2003
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 29 (11) , 944-946
The electron beam with virtual cathode in a two-section drift tube
An analysis based on the law of conservation of the z component of field and particle momentum in a thin annular magnetized monoenergetic electron beam in a two-section drift tube composed of tube segments with different radii (R 1<R 2) allowed the critical injected beam current to be determined for which a virtual cathode, formed in the wider tube at the joint section, starts traveling through the narrower tube toward the beam injection region. A region behind the traveling virtual cathode features a “squeezed” single-flux state of the beam (corresponding to the “slow” left branch of the current characteristic, high charge density, but low relativistic factor). When the injected current decreases below a critical transition level (I in<I Tr), the virtual cathode returns to the initial position and restores the double-flux electron beam. This current is smaller than (I lim1+I lim2)/2, and, depending on R 2, varies from the limiting transport current for the narrower section (I lim1) up to I F/2, where I F is the Fedosov current for this tube section.
- 1 August 2003
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 29 (8) , 666-668
The current of an annular electron beam with virtual cathode in a drift tube
An analysis based on the laws of conservation of energy and the z components of the field and particle momentum shows that a thin magnetized annular electron beam in a homogeneous drift tube behind a virtual cathode under stationary conditions occurs in a “squeezed” state corresponding to a slow left-hand branch of the current characteristic with a relativistic factor in the interval 1≤γ≤Γ1/3. The beam current I 1 behind the virtual cathode in a homogeneous drift tube can vary from zero up to a limiting value I lim, while the injection currents (I 2) and the current of electrons reflected from the virtual cathode (I 3) for every stationary state are single-valued functions of I 1 and fall within the intervals I F/2≤I 2≤I lim and 0≤I 3≤I F/2, respectively, where I F is the Fedosov current.
- 1 August 2003
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 29 (8) , 666-668
The current of an annular electron beam with virtual cathode in a drift tube
An analysis based on the laws of conservation of energy and the z components of the field and particle momentum shows that a thin magnetized annular electron beam in a homogeneous drift tube behind a virtual cathode under stationary conditions occurs in a “squeezed” state corresponding to a slow left-hand branch of the current characteristic with a relativistic factor in the interval 1≤γ≤Γ1/3. The beam current I 1 behind the virtual cathode in a homogeneous drift tube can vary from zero up to a limiting value I lim, while the injection currents (I 2) and the current of electrons reflected from the virtual cathode (I 3) for every stationary state are single-valued functions of I 1 and fall within the intervals I F/2≤I 2≤I lim and 0≤I 3≤I F/2, respectively, where I F is the Fedosov current.
- 1 April 2003
- Published by Hindawi Limited in Laser and Particle Beams
- Vol. 21 (4) , 561-565
On the current of an annular electron beam with a virtual cathode in a drift tube
It is shown that beyond a virtual cathode the current of a magnetized steady-state thin annular electron beam in a drift tube may range from zero to the limiting current of the tube.
- 1 April 2003
- Published by Hindawi Limited in Laser and Particle Beams
- Vol. 21 (4) , 561-565
On the current of an annular electron beam with a virtual cathode in a drift tube
It is shown that beyond a virtual cathode the current of a magnetized steady-state thin annular electron beam in a drift tube may range from zero to the limiting current of the tube.