Paul M. Natishan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Paul M. Natishan has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
H. Kahn
Department of Materials Science and Engineering, Case Western Reserve University, Cleveland, Ohio 44105, USA
3 shared publicationsA. H. Heuer
Department of Materials Science and Engineering, Case Western Reserve University, Cleveland, Ohio 44105, USA
2 shared publicationsF. J. Martin
Naval Research Laboratory, Washington, DC 20375, USA
2 shared publications- Frank Ernst
Department of Materials Science and Engineering, Case Western Reserve University, Cleveland, USA
2 shared publications R. J. Rayne
Naval Research Laboratory, Washington, DC 20375, USA
2 shared publicationsA.H. Heuer
Department of Materials Science and Engineering, Case Western Reserve University, Cleveland, USA
1 shared publication
Latest Publications
- 11 October 2017
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 74 (3) , 263-275
2017 W.R. Whitney Award: Perspectives on Chloride Interactions with Passive Oxides and Oxide Film Breakdown
The nature of passivity and its breakdown have garnered great interest before and since Schonbein used the term “passivity” in 1836 to describe the “altered state” of iron. There has been a large body of experimental work, and a number of theories describing passivity and its breakdown leading to pitting corrosion have been proposed. However, there continues to be debate on this topic, which includes the discussion as to whether pit initiation is controlled by oxide film breakdown or by the pit growth kinetics. This communication will focus on oxide film breakdown without drawing any conclusions on the rate controlling step. As all currently proposed mechanisms require Cl− interactions for oxide film breakdown in Cl-containing environments, the question becomes what is the nature of the interaction of Cl− with the passive film, adsorption and/or incorporation, or neither? The interaction of Cl− with the passive film on pure aluminum and Type 316 stainless steel will be reviewed and summarized using available experimental data concerning Cl− interactions both from prior work at the Naval Research Laboratory and work reported in the literature. A point will be made that choosing the appropriate experimental procedure and data analysis is of great importance for getting high-fidelity data.
- 11 October 2017
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 74 (3) , 263-275
2017 W.R. Whitney Award: Perspectives on Chloride Interactions with Passive Oxides and Oxide Film Breakdown
The nature of passivity and its breakdown have garnered great interest before and since Schonbein used the term “passivity” in 1836 to describe the “altered state” of iron. There has been a large body of experimental work, and a number of theories describing passivity and its breakdown leading to pitting corrosion have been proposed. However, there continues to be debate on this topic, which includes the discussion as to whether pit initiation is controlled by oxide film breakdown or by the pit growth kinetics. This communication will focus on oxide film breakdown without drawing any conclusions on the rate controlling step. As all currently proposed mechanisms require Cl− interactions for oxide film breakdown in Cl-containing environments, the question becomes what is the nature of the interaction of Cl− with the passive film, adsorption and/or incorporation, or neither? The interaction of Cl− with the passive film on pure aluminum and Type 316 stainless steel will be reviewed and summarized using available experimental data concerning Cl− interactions both from prior work at the Naval Research Laboratory and work reported in the literature. A point will be made that choosing the appropriate experimental procedure and data analysis is of great importance for getting high-fidelity data.
- 13 January 2016
- Published by Taylor & Francis
- p. 947-962
Corrosion-Resistant Alloys: Case Hardening
Low-temperature gas-phase carburization (≈625 to 775K) can generate very high surface interstitial carbon contents, up to 15 at.%, in austenitic stainless steel and up to 20 at.% in superaustenitic steels. The high interstitial carbon content leads to substantial surface hardening (Vickers hardness of up to 1200 HV) with high residual compressive stress, enhanced fatigue and wear resistance, and increased corrosion resistance, with no apparent embrittlement. These remarkable improvements arise because the carburizing is carried out at temperatures where “paraequilibrium”, rather than conventional thermodynamic equilibrium, determines the phase composition. Paraequilibrium refers to conditions where substitutional solutes, such as Cr or Ni, are immobile whereas interstitial solutes, such as carbon, are not. The low temperatures enable kinetic suppression of carbide formation and a “colossal” interstitial supersaturation. Low-temperature carburization of other alloys and surface hardening by low-temperature nitriding are also discussed.
- 13 January 2016
- Published by Taylor & Francis
- p. 947-962
Corrosion-Resistant Alloys: Case Hardening
Low-temperature gas-phase carburization (≈625 to 775K) can generate very high surface interstitial carbon contents, up to 15 at.%, in austenitic stainless steel and up to 20 at.% in superaustenitic steels. The high interstitial carbon content leads to substantial surface hardening (Vickers hardness of up to 1200 HV) with high residual compressive stress, enhanced fatigue and wear resistance, and increased corrosion resistance, with no apparent embrittlement. These remarkable improvements arise because the carburizing is carried out at temperatures where “paraequilibrium”, rather than conventional thermodynamic equilibrium, determines the phase composition. Paraequilibrium refers to conditions where substitutional solutes, such as Cr or Ni, are immobile whereas interstitial solutes, such as carbon, are not. The low temperatures enable kinetic suppression of carbide formation and a “colossal” interstitial supersaturation. Low-temperature carburization of other alloys and surface hardening by low-temperature nitriding are also discussed.
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (2) , C7-C10
Chloride Interactions with the Passive Films on Stainless Steel
The uptake of chloride (Cl−)(Cl−) by the passive oxide film on 316L austenitic stainless steel polarized at potentials below (less positive than) the pitting potential in 0.6M0.6M NaCl solutions was studied using X-ray photoelectron spectroscopy (XPS) and compared to our previous work on aluminum. The XPS spectra for the stainless steel showed that chloride was not adsorbed or present in the passive oxide film. This is quite different from the case of aluminum, where XPS data for the presence of chloride on the surface and incorporated into the oxide film are unambiguous. These differences in the adsorption and incorporation of chloride for these two metals will be discussed in the context of the mechanisms of passive film breakdown.
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (2) , C7-C10
Chloride Interactions with the Passive Films on Stainless Steel
The uptake of chloride (Cl−)(Cl−) by the passive oxide film on 316L austenitic stainless steel polarized at potentials below (less positive than) the pitting potential in 0.6M0.6M NaCl solutions was studied using X-ray photoelectron spectroscopy (XPS) and compared to our previous work on aluminum. The XPS spectra for the stainless steel showed that chloride was not adsorbed or present in the passive oxide film. This is quite different from the case of aluminum, where XPS data for the presence of chloride on the surface and incorporated into the oxide film are unambiguous. These differences in the adsorption and incorporation of chloride for these two metals will be discussed in the context of the mechanisms of passive film breakdown.
- 1 January 2010
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 13 (12) , C37-C39
Carburization-Enhanced Passivity of PH13-8 Mo: A Precipitation-Hardened Martensitic Stainless Steel
Interstitial hardening of the martensitic stainless steel PH13-8 Mo has been achieved by low temperature gas-phase carburization. After treatment, hardness is increased to a depth of , with a surface hardness that is twice the core hardness and a corresponding improvement in pin-on-disk wear resistance. Pitting potential is increased by in 0.6 M NaCl. Elemental analysis and X-ray diffraction suggest the formation of a thin carbidic surface layer that is both wear and corrosion resistant.
- 1 January 2010
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 13 (12) , C37-C39
Carburization-Enhanced Passivity of PH13-8 Mo: A Precipitation-Hardened Martensitic Stainless Steel
Interstitial hardening of the martensitic stainless steel PH13-8 Mo has been achieved by low temperature gas-phase carburization. After treatment, hardness is increased to a depth of , with a surface hardness that is twice the core hardness and a corresponding improvement in pin-on-disk wear resistance. Pitting potential is increased by in 0.6 M NaCl. Elemental analysis and X-ray diffraction suggest the formation of a thin carbidic surface layer that is both wear and corrosion resistant.
- 1 December 2009
- Published by The Electrochemical Society in The Electrochemical Society Interface
- Vol. 18 (4) , 7
From the President: Winds of Change
After our meeting in Vienna, I stayed for a few days to enjoy the city. I was sitting at a streetside café enjoying a cup of coffee and a wonderful torte; the winds were picking up, ushering in a change in the weather. As I sat, I thought about the meeting and how much has changed in the Society since I became a member 28 years ago.
- 1 December 2009
- Published by The Electrochemical Society in The Electrochemical Society Interface
- Vol. 18 (4) , 7
From the President: Winds of Change
After our meeting in Vienna, I stayed for a few days to enjoy the city. I was sitting at a streetside café enjoying a cup of coffee and a wonderful torte; the winds were picking up, ushering in a change in the weather. As I sat, I thought about the meeting and how much has changed in the Society since I became a member 28 years ago.
- 24 June 2009
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 40 (8) , 1805-1810
Enhanced Corrosion Resistance of Stainless Steel Carburized at Low Temperature
- 24 June 2009
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 40 (8) , 1805-1810
Enhanced Corrosion Resistance of Stainless Steel Carburized at Low Temperature
- 27 July 2002
- Published by Elsevier in Electrochimica Acta
- Vol. 47 (19) , 3131-3136
X-ray absorption near edge structure and X-ray photoelectron spectroscopy studies of chloride in passive oxide films
- 27 July 2002
- Published by Elsevier in Electrochimica Acta
- Vol. 47 (19) , 3131-3136
X-ray absorption near edge structure and X-ray photoelectron spectroscopy studies of chloride in passive oxide films