PCPeter M. Chapman

Peter M. Chapman

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Peter M. Chapman has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Critical predicted no effect concentrations (PNECs) should not be based on a single toxicity test

    by Peter M. Chapman, James R. Elphick

    Predicted no-effect concentrations (PNECs), which represent the concentration of a substance below which an unacceptable effect most likely will not occur, are widely used for risk assessment and in environmental policy and regulation. They are typically based on single-species laboratory toxicity tests; often, a single test result for the most sensitive endpoints drives the derivation of a PNEC. In the present study, the authors provide a case study emphasizing the importance of determining the reliability of those most sensitive endpoints. Five 21-d Daphnia magna toxicity tests conducted using the same procedures by 2 laboratories gave 20% inhibitory concentration responses to a specific ionic composition of total dissolved solids that varied from 684 mg/L to more than 1510 mg/L. The concentration–response curve was shallow; thus, these differences could have been attributable to chance alone. The authors strongly recommend that the most sensitive endpoints that determine PNECs not be based on a single toxicity test result but rather on the geometric mean of at least 3 test results to adequately assess and bound test variability, especially when the concentration–response curve is shallow. Environ Toxicol Chem 2015;34:1088–1090. © 2015 SETAC


  • Open Access

    Scientific papers should not be boring

    by Peter M. Chapman


  • Development of a fluoride chronic effects benchmark for aquatic life in freshwater

    by Cathy A. McPherson, Danny H.Y. Lee, Peter M. Chapman

    Canada has an interim water-quality guideline for fluoride for protection of freshwater aquatic life that dates from 2002, and 1 Canadian province has a different interim water-quality guideline for fluoride that dates to 1995. The United States does not have a national benchmark for fluoride in freshwater, and only 1 US state has such a benchmark. There are no other national or regional benchmarks for fluoride chronic toxicity in freshwater. In the present study, available data on the acute and chronic toxicity of fluoride to freshwater aquatic life were compiled and reviewed. Acute toxicity was reported to occur at concentrations ranging from 11.5 to >800 mg/L fluoride (F−). The majority of chronic effects occur at concentrations between 1.8 mg/L and 195 mg/L. A total of 10 chronic studies representing 16 species (5 fish, 7 invertebrates, and 4 algae/aquatic plants) were used to derive a chronic effects benchmark of 1.94 mg/L F−, applying the species sensitivity distribution approach. Environ Toxicol Chem 2014;33:2621–2627. © 2014 SETAC


  • Development of a strontium chronic effects benchmark for aquatic life in freshwater

    by Cathy A. McPherson, Gary S. Lawrence, James R. Elphick, Peter M. Chapman

    There are no national water-quality guidelines for strontium for the protection of freshwater aquatic life in North America or elsewhere. Available data on the acute and chronic toxicity of strontium to freshwater aquatic life were compiled and reviewed. Acute toxicity was reported to occur at concentrations ranging from 75 mg/L to 15 000 mg/L. The majority of chronic effects occurred at concentrations above 11 mg/L; however, calculation of a representative benchmark was confounded by results from 4 studies indicating that chronic effects occurred at lower concentrations than all other studies, in 2 cases below background concentrations reported for US and European streams. Two of these studies, including 1 reporting effects below background concentrations, were repeated and found not to be reproducible; chronic effects occurred at considerably higher strontium concentrations than in the original studies. Studies with narrow-mouthed toad and goldfish were not repeated; both studies reported chronic effects below background concentrations, and both studies had been conducted by the authors of 1 of the 2 studies that were repeated and shown to be nonreproducible. Studies by these authors (3 of the 4 confounding studies), conducted over 30 yr ago, lacked detail in reporting of methods and results. It is thus likely that repeating the toad and goldfish studies would also have resulted in a higher strontium effects concentration. A strontium chronic effects benchmark of 10.7 mg/L that incorporates the results of additional testing summarized in the present study is proposed for freshwater environments. Environ Toxicol Chem 2014;33:2472–2478. © 2014 SETAC


  • Open Access

    Passive sampling methods for contaminated sediments: Risk assessment and management

    by Marc S Greenberg, Peter M Chapman, Ian J Allan, Kim A Anderson, Sabine E Apitz, Chris Beegan, Todd S Bridges, Steve S Brown, John G Cargill, Megan C McCulloch, et al.

    This paper details how activity‐based passive sampling methods (PSMs), which provide information on bioavailability in terms of freely dissolved contaminant concentrations (Cfree), can be used to better inform risk management decision making at multiple points in the process of assessing and managing contaminated sediment sites. PSMs can increase certainty in site investigation and management, because Cfree is a better predictor of bioavailability than total bulk sediment concentration (Ctotal) for 4 key endpoints included in conceptual site models (benthic organism toxicity, bioaccumulation, sediment flux, and water column exposures). The use of passive sampling devices (PSDs) presents challenges with respect to representative sampling for estimating average concentrations and other metrics relevant for exposure and risk assessment. These challenges can be addressed by designing studies that account for sources of variation associated with PSMs and considering appropriate spatial scales to meet study objectives. Possible applications of PSMs include: quantifying spatial and temporal trends in bioavailable contaminants, identifying and evaluating contaminant source contributions, calibrating site‐specific models, and, improving weight‐of‐evidence based decision frameworks. PSM data can be used to assist in delineating sediment management zones based on likelihood of exposure effects, monitor remedy effectiveness, and, evaluate risk reduction after sediment treatment, disposal, or beneficial reuse after management actions. Examples are provided illustrating why PSMs and freely dissolved contaminant concentrations (Cfree) should be incorporated into contaminated sediment investigations and study designs to better focus on and understand contaminant bioavailability, more accurately estimate exposure to sediment‐associated contaminants, and better inform risk management decisions. Research and communication needs for encouraging broader use are discussed. Integr Environ Assess Manag 2014;10:224–236. © 2014 The Authors. Integrated Environmental Assessment and Management published by Wiley Periodicals, Inc. on behalf of SETAC.


  • Tissue-based environmental quality benchmarks and standards

    by James P. Meador, Michael St. J. Warne, Peter M. Chapman, King Ming Chan, Shen Yu, Kenneth M. Y. Leung

    Although the use of tissue concentrations (residues) of chemical contaminants as the dose metric to characterize chemical toxicity to aquatic organisms has been gaining acceptance over the past 20 years, tissue concentrations are less commonly used in water quality management and have yet to be formally adopted as benchmarks or environmental quality standards (EQS). This synthesis paper addresses advantages and disadvantages for the development and application of tissue-based EQS as an alternative and supplement to exposure-based EQS determined with water and sediment concentration data. Tissue-based EQS can be readily developed in parallel with conventional toxicity tests, and achieved by quantification of chemical concentrations in tissue alongside traditional concentration-response toxicity testing. Tissue-residue toxicity metrics can be used as benchmarks for screening and monitoring water and sediment quality, to derive equivalent water or sediment EQS, and for ecological risk assessments and weight of evidence approaches for assessing ecosystem impairment. Tissue-based toxicity metrics and associated EQS provide several advantages; however, there are some limitations to consider and key knowledge gaps to fill.