Naoaki Kumagai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Naoaki Kumagai has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Hitoshi Yashiro
Department of Frontier Materials and Functional Engineering, Graduate School of Engineering, Iwate University
7 shared publicationsShinichi Komaba
Tokyo University of Science, 1-3 Kagurazaka, Shinjuku, Tokyo 162-8601, Japan
5 shared publicationsJung-Min Kim
Department of Frontier Materials and Functional Engineering, Graduate School of Engineering, Iwate University, Morioka, Iwate 020-8551, Japan
3 shared publicationsKatsumi Mabuchi
Hitachi Research Laboratory, Hitachi Ltd
3 shared publicationsSatoru Oshitari
Department of Frontier Materials and Functional Engineering, Graduate School of Engineering, Iwate University, 4-3-5 Ueda, Morioka, Iwate 020-8551, Japan
3 shared publicationsYoshihiro Kadoma
Department of Frontier Materials and Functional Engineering, Graduate School of Engineering, Iwate University, 4-3-5 Ueda, Morioka, Iwate 020-8551, Japan
3 shared publications
Latest Publications
- 30 September 2008
- Published by Elsevier in Solid State Ionics
- Vol. 179 (27-32) , 1710-1713
Characterization and electrochemical properties of Li+ ion-exchanged products of hollandite-type Ky(Mn1−xCox)O2 for rechargeable lithium battery electrodes
- 30 September 2008
- Published by Elsevier in Solid State Ionics
- Vol. 179 (27-32) , 1710-1713
Characterization and electrochemical properties of Li+ ion-exchanged products of hollandite-type Ky(Mn1−xCox)O2 for rechargeable lithium battery electrodes
- 1 January 2008
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 155 (1) , A82-A89
Synthesis, Structure, and Electrochemical Characteristics of Overlithiated Li[sub 1+x](Ni[sub z]Co[sub 1−2z]Mn[sub z])[sub 1−x]O[sub 2] (z=0.1–0.4 and x=0.0–0.1) Positive Electrodes Prepared by Spray-Drying Method
The effects of overlithiation on the structural modifications and cell performances of materials with different ratios of were investigated. We prepared the with a series of compositions of and by a spray-drying method. We found that the effects of overlithiation on cell performances may depend on the ratio; the discharge capacity of the overlithiated was more severely degraded than the stoichiometric with cyclings, whereas showed better capacity-retention ability and C-rate capability than those of because of decreasing structural disorder (cation mixing) by overlithiation. We also found that structural modifications of the synthesized materials during first charging were changed by overlithiation but mainly depended on the ratio.
- 1 January 2008
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 155 (1) , A82-A89
Synthesis, Structure, and Electrochemical Characteristics of Overlithiated Li[sub 1+x](Ni[sub z]Co[sub 1−2z]Mn[sub z])[sub 1−x]O[sub 2] (z=0.1–0.4 and x=0.0–0.1) Positive Electrodes Prepared by Spray-Drying Method
The effects of overlithiation on the structural modifications and cell performances of materials with different ratios of were investigated. We prepared the with a series of compositions of and by a spray-drying method. We found that the effects of overlithiation on cell performances may depend on the ratio; the discharge capacity of the overlithiated was more severely degraded than the stoichiometric with cyclings, whereas showed better capacity-retention ability and C-rate capability than those of because of decreasing structural disorder (cation mixing) by overlithiation. We also found that structural modifications of the synthesized materials during first charging were changed by overlithiation but mainly depended on the ratio.
- 31 August 2007
- Published by Elsevier in Electrochimica Acta
- Vol. 53 (4) , 1697-1702
Synthesis of hollandite-type LixMnO2 by Li+ ion-exchange in molten salt and lithium insertion characteristics
- 31 August 2007
- Published by Elsevier in Electrochimica Acta
- Vol. 53 (4) , 1697-1702
Synthesis of hollandite-type LixMnO2 by Li+ ion-exchange in molten salt and lithium insertion characteristics
- 3 July 2007
- Published by Elsevier in Journal of Power Sources
- Vol. 174 (2) , 932-937
Synthesis of hollandite-type LiyMn1−xCoxO2 (x=0–0.15) by Li+ ion-exchange in molten salt and the electrochemical property for rechargeable lithium battery electrodes
- 3 July 2007
- Published by Elsevier in Journal of Power Sources
- Vol. 174 (2) , 932-937
Synthesis of hollandite-type LiyMn1−xCoxO2 (x=0–0.15) by Li+ ion-exchange in molten salt and the electrochemical property for rechargeable lithium battery electrodes
- 28 September 2006
- Published by Elsevier in Electrochemistry Communications
- Vol. 9 (1) , 103-108
Electrochemical properties of Li(Li(1−x)/3CoxMn(2−2x)/3)O2 (0⩽x⩽1) solid solutions prepared by poly-vinyl alcohol (PVA) method
- 28 September 2006
- Published by Elsevier in Electrochemistry Communications
- Vol. 9 (1) , 103-108
Electrochemical properties of Li(Li(1−x)/3CoxMn(2−2x)/3)O2 (0⩽x⩽1) solid solutions prepared by poly-vinyl alcohol (PVA) method
- 2 June 2006
- Published by Elsevier in Electrochimica Acta
- Vol. 52 (4) , 1483-1490
Improved electrochemical properties of Li1+x(Ni0.3Co0.4Mn0.3)O2−δ (x=0, 0.03 and 0.06) with lithium excess composition prepared by a spray drying method
- 2 June 2006
- Published by Elsevier in Electrochimica Acta
- Vol. 52 (4) , 1483-1490
Improved electrochemical properties of Li1+x(Ni0.3Co0.4Mn0.3)O2−δ (x=0, 0.03 and 0.06) with lithium excess composition prepared by a spray drying method
- 15 March 2006
- Published by Elsevier in Solid State Ionics
- Vol. 177 (7) , 733-739
Hydrothermal phase formation of orthorhombic LiMnO2 and its derivatives as lithium intercalation compounds
- 15 March 2006
- Published by Elsevier in Solid State Ionics
- Vol. 177 (7) , 733-739
Hydrothermal phase formation of orthorhombic LiMnO2 and its derivatives as lithium intercalation compounds
- 1 January 2006
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 9 (11) , A494-A498
Improved Electrochemical Properties and Structural Stability of Overlithiated Li[sub 1+x](Ni[sub 1∕3]Co[sub 1∕3]Mn[sub 1∕3])[sub 1−x]O[sub 2] Prepared by Spray-Drying Method
The electrochemical properties and structural stability of the materials have been investigated. The materials were prepared using a spray-drying method with the adjusted molar ratios of 0.95 to 1.5. The prepared materials exhibited a hexagonal structure in all the region of 0 and the lattice parameters of the materials gradually decreased as the value of increased. The discharge capacities of overlithiated material was at the which is 86% of the initial capacity, whereas the stoichiometric one preserved 77% . From the X-ray diffraction results, it was found that the structural stability of charged material was improved by overlithiation, which could contribute to good electrochemical properties of overlithiated materials.
- 1 January 2006
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 9 (11) , A494-A498
Improved Electrochemical Properties and Structural Stability of Overlithiated Li[sub 1+x](Ni[sub 1∕3]Co[sub 1∕3]Mn[sub 1∕3])[sub 1−x]O[sub 2] Prepared by Spray-Drying Method
The electrochemical properties and structural stability of the materials have been investigated. The materials were prepared using a spray-drying method with the adjusted molar ratios of 0.95 to 1.5. The prepared materials exhibited a hexagonal structure in all the region of 0 and the lattice parameters of the materials gradually decreased as the value of increased. The discharge capacities of overlithiated material was at the which is 86% of the initial capacity, whereas the stoichiometric one preserved 77% . From the X-ray diffraction results, it was found that the structural stability of charged material was improved by overlithiation, which could contribute to good electrochemical properties of overlithiated materials.
- 1 January 2005
- Published by Japan Society of Corrosion Engineering in Corrosion Engineering
- Vol. 54 (7) , 323-328
A Mo/MoO2 Electrode for Use of Corrosion Control in Absorption Refrigeration Systems
A new electrode, Mo/Mo/MoO2 has been proposed for the purpose of better control of corrosion inhibition of constructive materials in adsorption refrigeration systems. The electrode is prepared by heating a molybdenum rod in air at 873K followed by reduction in hydrogen at 723K. The potential of the electrode was stable in LiBr solutions of wide range of temperature (298-428K), concentrations of LiBr (2, 17.3mol kg-1), LiOH (10-3-10-1mol kg-1), Li2MoO4 (10-4-10-2mol kg-1) and LiNO3 (0-10-2mol kg-1). The potential of the electrode responded to the concentration of LiOH while not to those of Li2MoO4 and LiNO3. The electrode potential was changed sharply by introducing oxygen into the solution at 353K in 2mol kg-1 LiBr solution. But it became less clear at 428K in 17.3mol kg-1 LiBr solution. The electrode can be used as a sensor for the concentration of LiOH. Another application of the electrode would be a quasi internal reference electrode in a commercial machine for the monitoring of corrosion potential of steels.
- 1 January 2005
- Published by Japan Society of Corrosion Engineering in Corrosion Engineering
- Vol. 54 (7) , 323-328
A Mo/MoO2 Electrode for Use of Corrosion Control in Absorption Refrigeration Systems
A new electrode, Mo/Mo/MoO2 has been proposed for the purpose of better control of corrosion inhibition of constructive materials in adsorption refrigeration systems. The electrode is prepared by heating a molybdenum rod in air at 873K followed by reduction in hydrogen at 723K. The potential of the electrode was stable in LiBr solutions of wide range of temperature (298-428K), concentrations of LiBr (2, 17.3mol kg-1), LiOH (10-3-10-1mol kg-1), Li2MoO4 (10-4-10-2mol kg-1) and LiNO3 (0-10-2mol kg-1). The potential of the electrode responded to the concentration of LiOH while not to those of Li2MoO4 and LiNO3. The electrode potential was changed sharply by introducing oxygen into the solution at 353K in 2mol kg-1 LiBr solution. But it became less clear at 428K in 17.3mol kg-1 LiBr solution. The electrode can be used as a sensor for the concentration of LiOH. Another application of the electrode would be a quasi internal reference electrode in a commercial machine for the monitoring of corrosion potential of steels.
- 1 January 2005
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 8 (9) , A471-A475
Synthesis of Hollandite-Type K[sub y](Mn[sub 1−x]M[sub x])O[sub 2] (M=Co, Fe) by Oxidation of Mn(II) Precursor and Preliminary Results on Electrode Characteristics in Rechargeable Lithium Batteries
Hollandite-type doped with several transition metals were synthesized by the oxidation of and ( or Fe) aqueous solutions with the oxidizing agent . The chemical analysis and X-ray diffraction measurements indicated that the metal-doped are shown as ( or Fe) with the hollandite-type structure and the -value varies in the range from 0 to 0.12. Extended X-ray absorption fine structure study revealed that ions are partly substituted for the ions in resulting in . Transmission electron microscopic measurement showed that the high-crystalline or particle was rod shaped with the width of 30-50 nm. The electrochemical measurements indicated that electrode provides excellent performance of 296 and -active material at the first and twentieth cycles, respectively, superior to undoped electrode ( at the 1st cycle and at the 20th cycle) and ) electrodes ( at the 1st to 20th cycles). Moreover, the discharge performance of electrodes was enhanced with an increase in the Co content or -value.
- 1 January 2005
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 8 (9) , A471-A475
Synthesis of Hollandite-Type K[sub y](Mn[sub 1−x]M[sub x])O[sub 2] (M=Co, Fe) by Oxidation of Mn(II) Precursor and Preliminary Results on Electrode Characteristics in Rechargeable Lithium Batteries
Hollandite-type doped with several transition metals were synthesized by the oxidation of and ( or Fe) aqueous solutions with the oxidizing agent . The chemical analysis and X-ray diffraction measurements indicated that the metal-doped are shown as ( or Fe) with the hollandite-type structure and the -value varies in the range from 0 to 0.12. Extended X-ray absorption fine structure study revealed that ions are partly substituted for the ions in resulting in . Transmission electron microscopic measurement showed that the high-crystalline or particle was rod shaped with the width of 30-50 nm. The electrochemical measurements indicated that electrode provides excellent performance of 296 and -active material at the first and twentieth cycles, respectively, superior to undoped electrode ( at the 1st cycle and at the 20th cycle) and ) electrodes ( at the 1st to 20th cycles). Moreover, the discharge performance of electrodes was enhanced with an increase in the Co content or -value.