Ralph Skomski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ralph Skomski has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- David J. Sellmyer
Nebraska Center for Materials and Nanoscience, University of Nebraska, Lincoln, Nebraska 68588, USA
13 shared publications D. J. Sellmyer
University of Nebraska 1 Department of Physics and Astronomy and Nebraska Center for Materials and Nanoscience Lincoln, Nebraska 68588, USA
4 shared publicationsA. Enders
University of Nebraska 1 Department of Physics and Astronomy and Nebraska Center for Materials and Nanoscience Lincoln, Nebraska 68588, USA
3 shared publications- Arti Kashyap
School of Basic Sciences, Indian Institute of Technology Mandi - Mandi, Himachal Pradesh 175001, India
3 shared publications Priyanka Manchanda
Howard University
3 shared publicationsR. D. Kirby
Department of Physics and Astronomy and Center for Materials Research and Analysis, University of Nebraska, Lincoln, Nebraska 68588
3 shared publications
Latest Publications
- 19 May 2022
- Published by International Union of Crystallography (IUCr) in Acta crystallographica Section B, Structural science, crystal engineering and materials
- Vol. 78 (3) , 485-489
A modulated structure derived from the XA-type Mn2RuSn Heusler compound
A modulated structure derived from the inverse Heusler phase (the XA-type and the disordered variant L21B-type) has been observed in rapidly quenched Mn2RuSn ribbons. The powder X-ray diffraction pattern of the quenched ribbons can be indexed as an L21B-type structure. Electron diffraction patterns of the new structure mostly resemble those of the XA-type (and the disordered variant L21B-type) structure and additional reflections with denser spacing indicate a long periodicity. Orthogonal domains of the modulated structure were revealed by a selected-area electron diffraction pattern and the corresponding dark-field transmission electron microscopy images. The structure was further studied by the crystallographic analysis of high-resolution transmission electron microscopy images. A model for the modulated structure has been proposed to interpret the experimental results.
- 19 May 2022
- Published by International Union of Crystallography (IUCr) in Acta crystallographica Section B, Structural science, crystal engineering and materials
- Vol. 78 (3) , 485-489
A modulated structure derived from the XA-type Mn2RuSn Heusler compound
A modulated structure derived from the inverse Heusler phase (the XA-type and the disordered variant L21B-type) has been observed in rapidly quenched Mn2RuSn ribbons. The powder X-ray diffraction pattern of the quenched ribbons can be indexed as an L21B-type structure. Electron diffraction patterns of the new structure mostly resemble those of the XA-type (and the disordered variant L21B-type) structure and additional reflections with denser spacing indicate a long periodicity. Orthogonal domains of the modulated structure were revealed by a selected-area electron diffraction pattern and the corresponding dark-field transmission electron microscopy images. The structure was further studied by the crystallographic analysis of high-resolution transmission electron microscopy images. A model for the modulated structure has been proposed to interpret the experimental results.
- Open Access
- 25 September 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (10) , 1371
Structure and Magnetism of Co2Ge Nanoparticles
The structural and magnetic properties of Co2Ge nanoparticles (NPs) prepared by the cluster-beam deposition (CBD) technique have been investigated. As-made particles with an average size of 5.5 nm exhibit a mixture of hexagonal and orthorhombic crystal structures. Thermomagnetic measurements showed that the as-made particles are superparamagnetic at room temperature with a blocking temperature (TB) of 20 K. When the particles are annealed at 823 K for 12 h, their size is increased to 13 nm and they develop a new orthorhombic crystal structure, with a Curie temperature (TC) of 815 K. This is drastically different from bulk, which are ferromagnetic at cryogenic temperatures only. X-ray diffraction (XRD) measurements suggest the formation of a new Co-rich orthorhombic phase (OP) with slightly increased c/a ratio in the annealed particles and this is believed to be the reason for the drastic change in their magnetic properties.
- 25 September 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (10) , 1371
Open AccessStructure and Magnetism of Co2Ge Nanoparticles
The structural and magnetic properties of Co2Ge nanoparticles (NPs) prepared by the cluster-beam deposition (CBD) technique have been investigated. As-made particles with an average size of 5.5 nm exhibit a mixture of hexagonal and orthorhombic crystal structures. Thermomagnetic measurements showed that the as-made particles are superparamagnetic at room temperature with a blocking temperature (TB) of 20 K. When the particles are annealed at 823 K for 12 h, their size is increased to 13 nm and they develop a new orthorhombic crystal structure, with a Curie temperature (TC) of 815 K. This is drastically different from bulk, which are ferromagnetic at cryogenic temperatures only. X-ray diffraction (XRD) measurements suggest the formation of a new Co-rich orthorhombic phase (OP) with slightly increased c/a ratio in the annealed particles and this is believed to be the reason for the drastic change in their magnetic properties.
- Open Access
- 15 April 2018
- Published by MDPI AG in Nanomaterials
- Vol. 8 (4) , 241
Structure and Magnetism of Mn5Ge3 Nanoparticles
In this work, we investigated the magnetic and structural properties of isolated Mn5Ge3 nanoparticles prepared by the cluster-beam deposition technique. Particles with sizes between 7.2 and 12.6 nm were produced by varying the argon pressure and power in the cluster gun. X-ray diffraction (XRD)and selected area diffraction (SAD) measurements show that the nanoparticles crystallize in the hexagonal Mn5Si3-type crystal structure, which is also the structure of bulk Mn5Ge3. The temperature dependence of the magnetization shows that the as-made particles are ferromagnetic at room temperature and have slightly different Curie temperatures. Hysteresis-loop measurements show that the saturation magnetization of the nanoparticles increases significantly with particle size, varying from 31 kA/m to 172 kA/m when the particle size increases from 7.2 to 12.6 nm. The magnetocrystalline anisotropy constant K at 50 K, determined by fitting the high-field magnetization data to the law of approach to saturation, also increases with particle size, from 0.4 × 105 J/m3 to 2.9 × 105 J/m3 for the respective sizes. This trend is mirrored by the coercivity at 50 K, which increases from 0.04 T to 0.13 T. A possible explanation for the magnetization trend is a radial Ge concentration gradient.
- 15 April 2018
- Published by MDPI AG in Nanomaterials
- Vol. 8 (4) , 241
Open AccessStructure and Magnetism of Mn5Ge3 Nanoparticles
In this work, we investigated the magnetic and structural properties of isolated Mn5Ge3 nanoparticles prepared by the cluster-beam deposition technique. Particles with sizes between 7.2 and 12.6 nm were produced by varying the argon pressure and power in the cluster gun. X-ray diffraction (XRD)and selected area diffraction (SAD) measurements show that the nanoparticles crystallize in the hexagonal Mn5Si3-type crystal structure, which is also the structure of bulk Mn5Ge3. The temperature dependence of the magnetization shows that the as-made particles are ferromagnetic at room temperature and have slightly different Curie temperatures. Hysteresis-loop measurements show that the saturation magnetization of the nanoparticles increases significantly with particle size, varying from 31 kA/m to 172 kA/m when the particle size increases from 7.2 to 12.6 nm. The magnetocrystalline anisotropy constant K at 50 K, determined by fitting the high-field magnetization data to the law of approach to saturation, also increases with particle size, from 0.4 × 105 J/m3 to 2.9 × 105 J/m3 for the respective sizes. This trend is mirrored by the coercivity at 50 K, which increases from 0.04 T to 0.13 T. A possible explanation for the magnetization trend is a radial Ge concentration gradient.
- 31 May 2014
- Published by Springer Nature in JOM
- Vol. 66 (7) , 1144-1150
Geometry Dependence of Magnetization Reversal in Nanocomposite Alloys
- 31 May 2014
- Published by Springer Nature in JOM
- Vol. 66 (7) , 1144-1150
Geometry Dependence of Magnetization Reversal in Nanocomposite Alloys
- 27 January 2014
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 26 (6) , 064209
Permanent magnetism of intermetallic compounds between light and heavy transition-metal elements
First-principle calculations are used to investigate the intrinsic magnetic properties of intermetallic alloys of the type XMn, where X is a 4d or 5d element and M is Fe or Co. Emphasis is on the hexagonal C14 Laves-phase 1:2 and 1:5 alloys, the latter crystallizing in the CaCu5 structure. These series are of interest in permanent magnetism from fundamental and practical viewpoints, respectively. In the former, the unit cells form a prototypical motif where a heavy atom with high spin–orbit coupling and magnetocrystalline anisotropy is surrounded by many somewhat smaller M atoms with high magnetization, and the latter are Laves-phase derivatives of renewed interest in permanent magnetism. Our DFT calculations predict magnetic moments, magnetizations and anisotropies, as well as formation energies. The results are analyzed across the 4d and 5d series, especially with respect to hybridization effects between 3d and 4d/5d bands.
- 27 January 2014
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 26 (6) , 064209
Permanent magnetism of intermetallic compounds between light and heavy transition-metal elements
First-principle calculations are used to investigate the intrinsic magnetic properties of intermetallic alloys of the type XMn, where X is a 4d or 5d element and M is Fe or Co. Emphasis is on the hexagonal C14 Laves-phase 1:2 and 1:5 alloys, the latter crystallizing in the CaCu5 structure. These series are of interest in permanent magnetism from fundamental and practical viewpoints, respectively. In the former, the unit cells form a prototypical motif where a heavy atom with high spin–orbit coupling and magnetocrystalline anisotropy is surrounded by many somewhat smaller M atoms with high magnetization, and the latter are Laves-phase derivatives of renewed interest in permanent magnetism. Our DFT calculations predict magnetic moments, magnetizations and anisotropies, as well as formation energies. The results are analyzed across the 4d and 5d series, especially with respect to hybridization effects between 3d and 4d/5d bands.
- 15 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 49 (7) , 3353-3355
Magnetism of Rapidly Quenched Sm$_{1 - {\rm x}}$Zr$_{{\rm x}}$Co$_{5}$ Nanocrystalline Materials
The effect of Zr addition on nanostructure and magnetic properties in nanocrystalline Sm1-xZrxCo5 (x = 0-0.6) has been investigated. (Sm, Zr)Co5 with the CaCu5 structure was synthesized by melt spinning. The lattice parameters a and b decrease with x, whereas c increases. Thus, the unit cell volume of (Sm, Zr)Co5 shrinks because the smaller Zr atoms occupy the sites of the larger Sm atoms. Zr addition decreases the grain size and induces the formation of planar defects. The coercivity decreases with x, due to weakening of magnetocrystalline anisotropy energy and effective intergrain exchange coupling. A very high coercivity of 39 kOe and energy product of 13.9 MGOe are obtained for x = 0. The remanence of (Sm, Zr)Co5 increases with x. For x ≤ 0.4, the energy product slightly decreases with x. The results show that 40% of the Sm can be replaced by the less expensive Zr, with an energy-product reduction of only 10%. In addition, the planar defects are responsible for the change of coercivity mechanism from the nucleation-type of reverse domain for the x = 0 to the pinning-type of domain wall for the x = 0.4.
- 15 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 49 (7) , 3353-3355
Magnetism of Rapidly Quenched Sm$_{1 - {\rm x}}$Zr$_{{\rm x}}$Co$_{5}$ Nanocrystalline Materials
The effect of Zr addition on nanostructure and magnetic properties in nanocrystalline Sm1-xZrxCo5 (x = 0-0.6) has been investigated. (Sm, Zr)Co5 with the CaCu5 structure was synthesized by melt spinning. The lattice parameters a and b decrease with x, whereas c increases. Thus, the unit cell volume of (Sm, Zr)Co5 shrinks because the smaller Zr atoms occupy the sites of the larger Sm atoms. Zr addition decreases the grain size and induces the formation of planar defects. The coercivity decreases with x, due to weakening of magnetocrystalline anisotropy energy and effective intergrain exchange coupling. A very high coercivity of 39 kOe and energy product of 13.9 MGOe are obtained for x = 0. The remanence of (Sm, Zr)Co5 increases with x. For x ≤ 0.4, the energy product slightly decreases with x. The results show that 40% of the Sm can be replaced by the less expensive Zr, with an energy-product reduction of only 10%. In addition, the planar defects are responsible for the change of coercivity mechanism from the nucleation-type of reverse domain for the x = 0 to the pinning-type of domain wall for the x = 0.4.