Libor Červený
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Libor Červený has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
- Eliška Vyskočilová
Department of Organic Technology, University of Chemistry and Technology Prague, Prague, Czech Republic
14 shared publications - Eva Vrbková
Department of Organic Technology, University of Chemistry and Technology Prague, Prague, Czech Republic
7 shared publications Eliška Leitmannová
Institute of Chemical Technology in Prague
5 shared publicationsPetr Kačer
Institute of Chemical Technology in Prague
5 shared publications- Iva Paterová
Department of Organic Technology, UCT Prague, Prague, Czech Republic
3 shared publications Ladislav Kurc
Department of Organic Technology, Institute of Chemical Technology, Technická 5, 166 28 Prague, Czech Republic
3 shared publications
Latest Publications
- 3 February 2022
- Published by Springer Nature in Catalysis Letters
- Vol. 152 (12) , 3576-3585
Efficient Catalyst Based on Pyridinium Modified MCM-41 for Carbon Dioxide Utilization
- 3 February 2022
- Published by Springer Nature in Catalysis Letters
- Vol. 152 (12) , 3576-3585
Efficient Catalyst Based on Pyridinium Modified MCM-41 for Carbon Dioxide Utilization
- Open Access
Acid Treated Montmorillonite—Eco-Friendly Clay as Catalyst in Carvone Isomerization to Carvacrol
Acid-treated montmorillonites (MMT) were used as catalysts of carvone isomerization to carvacrol. Mineral acids—sulfuric, hydrochloric, nitric acids and organic acids (acetic and chloroacetic)—were used for the acid treatment. Prepared materials were characterized by available characterization methods, namely XRD, EA, TPD, TPO, UV-Vis, laser light scattering and nitrogen physisorption. The structure of montmorillonite remained intact after treatment. However, TPD proved the increase of acidity of acid-treated materials comparing pure montmorillonite. All materials were tested in the isomerization of carvone, producing carvacrol as the desired product. The initial reaction rate increased using the materials in the row MMT-COOH < MMT-HNO3 < MMT-ClCOOH < MMT-H2SO4 < MMT-HCl, which is in accordance with the pKa of acids used for the treatment. The number of weak acid sites strongly influenced the selectivity to carvacrol. The optimal solvent for the reaction was toluene. Total conversion of carvone and the selectivity to carvacrol 95.5% was achieved within 24 h under 80 °C, with toluene as solvent and montmorillonite treated by chloroacetic acid as catalyst. The catalyst may be reused after calcination with only a low loss of activity.
Open AccessAcid Treated Montmorillonite—Eco-Friendly Clay as Catalyst in Carvone Isomerization to Carvacrol
Acid-treated montmorillonites (MMT) were used as catalysts of carvone isomerization to carvacrol. Mineral acids—sulfuric, hydrochloric, nitric acids and organic acids (acetic and chloroacetic)—were used for the acid treatment. Prepared materials were characterized by available characterization methods, namely XRD, EA, TPD, TPO, UV-Vis, laser light scattering and nitrogen physisorption. The structure of montmorillonite remained intact after treatment. However, TPD proved the increase of acidity of acid-treated materials comparing pure montmorillonite. All materials were tested in the isomerization of carvone, producing carvacrol as the desired product. The initial reaction rate increased using the materials in the row MMT-COOH < MMT-HNO3 < MMT-ClCOOH < MMT-H2SO4 < MMT-HCl, which is in accordance with the pKa of acids used for the treatment. The number of weak acid sites strongly influenced the selectivity to carvacrol. The optimal solvent for the reaction was toluene. Total conversion of carvone and the selectivity to carvacrol 95.5% was achieved within 24 h under 80 °C, with toluene as solvent and montmorillonite treated by chloroacetic acid as catalyst. The catalyst may be reused after calcination with only a low loss of activity.
- 5 March 2021
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 132 (2) , 729-749
Synthesis of new ruthenium complexes and their use as catalysts in the hydrogenation of diene compounds
- 5 March 2021
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 132 (2) , 729-749
Synthesis of new ruthenium complexes and their use as catalysts in the hydrogenation of diene compounds
- 8 January 2021
- Published by Springer Nature in Catalysis Letters
- Vol. 151 (9) , 2673-2683
Preparation of α-Terpineol from Biomass Resource Catalysed by Acid Treated Montmorillonite K10
- 8 January 2021
- Published by Springer Nature in Catalysis Letters
- Vol. 151 (9) , 2673-2683
Preparation of α-Terpineol from Biomass Resource Catalysed by Acid Treated Montmorillonite K10
- 13 November 2020
- Published by Springer Nature in Catalysis Letters
- Vol. 151 (7) , 1993-2003
Fe-Modified Zeolite BETA as an Active Catalyst for Intramolecular Prins Cyclization of Citronellal
- 13 November 2020
- Published by Springer Nature in Catalysis Letters
- Vol. 151 (7) , 1993-2003
Fe-Modified Zeolite BETA as an Active Catalyst for Intramolecular Prins Cyclization of Citronellal
- Open Access
Solvent Influence on Selectivity in α-Pinene Oxide Isomerization Using MoO3-Modified Zeolite BETA
Natural source turpentine is an available source of α-pinene oxide. This compound’s value is especially given by the possibility of producing important compounds campholenic aldehyde and trans-carveol. In this work, we would like to present the usage of MoO3-modified zeolite BETA in α-pinene oxide isomerization concerning campholenic aldehyde and trans-carveol formation using a wide range of solvents. Catalyst calcination temperature also influenced the reaction course (selectivity to desired compounds and reaction rate). MoO3-zeolite BETA was prepared by the wet impregnation method and characterized by different techniques. The use of polar aprotic solvents had the most positive effect on the reaction course. Solvent basicity and polarity considerably influenced the reaction rate and selectivity to particular products. The combination of high basicity and the high polarity was the most suitable for the studied reaction from the reaction rate point of view. Selectivity to campholenic aldehyde and trans-carveol was the most influenced by solvent basicity. Higher solvent basicity caused the preferential formation of trans–carveol, influence on selectivity to campholenic aldehyde formation was the opposite. The described catalyst may be used for α-pinene oxide rearrangement to both desired products dependently on the used solvent. Molybdenum offers an exciting alternative for previously described modifications of zeolites for this reaction.
Open AccessSolvent Influence on Selectivity in α-Pinene Oxide Isomerization Using MoO3-Modified Zeolite BETA
Natural source turpentine is an available source of α-pinene oxide. This compound’s value is especially given by the possibility of producing important compounds campholenic aldehyde and trans-carveol. In this work, we would like to present the usage of MoO3-modified zeolite BETA in α-pinene oxide isomerization concerning campholenic aldehyde and trans-carveol formation using a wide range of solvents. Catalyst calcination temperature also influenced the reaction course (selectivity to desired compounds and reaction rate). MoO3-zeolite BETA was prepared by the wet impregnation method and characterized by different techniques. The use of polar aprotic solvents had the most positive effect on the reaction course. Solvent basicity and polarity considerably influenced the reaction rate and selectivity to particular products. The combination of high basicity and the high polarity was the most suitable for the studied reaction from the reaction rate point of view. Selectivity to campholenic aldehyde and trans-carveol was the most influenced by solvent basicity. Higher solvent basicity caused the preferential formation of trans–carveol, influence on selectivity to campholenic aldehyde formation was the opposite. The described catalyst may be used for α-pinene oxide rearrangement to both desired products dependently on the used solvent. Molybdenum offers an exciting alternative for previously described modifications of zeolites for this reaction.
- 1 August 2020
- Published by Elsevier in Molecular Catalysis
- Vol. 492, 110945
Homogeneous Lewis and Brønsted acids as catalysts for β-pinene oxide rearrangement to prepare myrtenol and myrtanal
- 1 August 2020
- Published by Elsevier in Molecular Catalysis
- Vol. 492, 110945
Homogeneous Lewis and Brønsted acids as catalysts for β-pinene oxide rearrangement to prepare myrtenol and myrtanal
- 23 June 2020
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 46 (9) , 4047-4059
Tungsten oxide-based materials as effective catalysts in isopulegol formation by intramolecular Prins reaction of citronellal
- 23 June 2020
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 46 (9) , 4047-4059
Tungsten oxide-based materials as effective catalysts in isopulegol formation by intramolecular Prins reaction of citronellal
- 12 July 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 125 (2) , 619-631
Selective hydrogenation of C6 dienic compounds using homogeneous Cp*-ruthenium (II) catalyst
- 12 July 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 125 (2) , 619-631
Selective hydrogenation of C6 dienic compounds using homogeneous Cp*-ruthenium (II) catalyst
- 23 May 2018
- Published by Springer Nature in Catalysis Letters
- Vol. 148 (7) , 2042-2057
Aldol Condensation of Benzaldehyde and Heptanal Over Zinc Modified Mixed Mg/Al Oxides
- 23 May 2018
- Published by Springer Nature in Catalysis Letters
- Vol. 148 (7) , 2042-2057
Aldol Condensation of Benzaldehyde and Heptanal Over Zinc Modified Mixed Mg/Al Oxides