Thomas Weber
Research Subjects
Research Interests
Thomas Weber has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Roel Prins
Laboratory for Technical Chemistry, Swiss Federal Institute of Technology (ETH)Switzerland
3 shared publicationsValentin Alexiev
Laboratory for Technical Chemistry, Swiss Federal Institute of Technology (ETH)Switzerland
3 shared publicationsF. Wypych
Curitiba PR
1 shared publication- Roel Prins
ETH Zurich
1 shared publication Teodora Todorova
Laboratory for Technical Chemistry, Swiss Federal Institute of Technology (ETH)Switzerland
1 shared publication
Latest Publications
- 25 July 2002
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 4 (16) , 4080-4081
Reply to the ‘Comment on “Ab initio study of MoS 2 and Li adsorbed on the (101̄0) face of MoS 2 ”, and “DFT study of MoS 2 and hydrogen adsorbed on the (101̄0) face of MoS 2 ”’ by R. Grau-Crespo and R. López-Cordero, Phys. Chem. Chem. Phys., 2002, 4 , 4078
- 25 July 2002
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 4 (16) , 4080-4081
Reply to the ‘Comment on “Ab initio study of MoS 2 and Li adsorbed on the (101̄0) face of MoS 2 ”, and “DFT study of MoS 2 and hydrogen adsorbed on the (101̄0) face of MoS 2 ”’ by R. Grau-Crespo and R. López-Cordero, Phys. Chem. Chem. Phys., 2002, 4 , 4078
- 26 November 2001
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 3 (23) , 5326-5336
DFT study of MoS2 and hydrogen adsorbed on the (101̄0) face of MoS2
DFT calculations were employed to investigate the properties of the catalytically important (100) edge of MoS2 and the adsorption of hydrogen thereon. The electronic properties of the bulk and surface as well as the relaxed positions of surface atoms are calculated by two different techniques, namely all-electron and plane wave pseudo-potential DFT methods. Hydrogen adsorption is studied by means of a (2 × 1) surface cell to account for H–H interactions and the different configurations of adsorbed hydrogen atoms. Our calculations demonstrate that the electronic structure and the positions of the relaxed surface atoms obtained by the two methods are identical, with the exception of minor discrepancies which are attributed to the different relaxation procedures. The (100) surface of MoS2 contains weakly coupled S–S pairs formed by relaxation of its sulfur atoms. The results of the hydrogen adsorption show that hydrogen is adsorbed on the sulfur pairs but not on Mo atoms on the surface. Only one of the possible configurations of adsorbed H atoms on a (2 × 1) cell is energetically favoured, while the energy of the other configurations is higher with respect to the energy of H2 and MoS2 .
- 26 November 2001
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 3 (23) , 5326-5336
DFT study of MoS2 and hydrogen adsorbed on the (101̄0) face of MoS2
DFT calculations were employed to investigate the properties of the catalytically important (100) edge of MoS2 and the adsorption of hydrogen thereon. The electronic properties of the bulk and surface as well as the relaxed positions of surface atoms are calculated by two different techniques, namely all-electron and plane wave pseudo-potential DFT methods. Hydrogen adsorption is studied by means of a (2 × 1) surface cell to account for H–H interactions and the different configurations of adsorbed hydrogen atoms. Our calculations demonstrate that the electronic structure and the positions of the relaxed surface atoms obtained by the two methods are identical, with the exception of minor discrepancies which are attributed to the different relaxation procedures. The (100) surface of MoS2 contains weakly coupled S–S pairs formed by relaxation of its sulfur atoms. The results of the hydrogen adsorption show that hydrogen is adsorbed on the sulfur pairs but not on Mo atoms on the surface. Only one of the possible configurations of adsorbed H atoms on a (2 × 1) cell is energetically favoured, while the energy of the other configurations is higher with respect to the energy of H2 and MoS2 .
- 29 March 2000
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 2 (8) , 1815-1827
Ab initio study of MoS2 and Li adsorbed on the (101̄0) face of MoS2
Periodic Hartree–Fock methods were used to calculate the geometric and electronic properties of 2H-MoS2 , 1T-MoS2, the (100) surface of MoS2 and Li adsorbed thereon. For the calculations, the structures were generated by an extension of unit cells to the respective bulk structures (1T- and 2H-MoS2) or by cutting sections, each consisting of six or eight layers of sulfur and molybdenum, from a crystal ((100) surface of MoS2 with and without adsorbed Li). Structural optimization was performed with a post Hartree–Fock DFT correlation correction. The calculated structures of 2H-MoS2 and 1T-MoS2 are in good agreement with experimental data and the metastable and metallic properties of 1T-MoS2 are also described correctly. The relaxation of the (100) surface of 2H-MoS2 leads to a minor reconstruction of the surface accompanied by the formation of S2 species and an inward relaxation of Mo atoms. Adsorption of Li on this surface is favoured in the high symmetry positions above the van der Waals gap. Relaxation of the Li-covered (100) surface of 2H-MoS2 shifts the Li atoms towards the S2 pairs and closer to the surface. Upon adsorption, the system becomes metallic and delocalized surface states form at the Fermi level due to electron transfer processes from the Li atoms to the surface layers of MoS2.
- 29 March 2000
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 2 (8) , 1815-1827
Ab initio study of MoS2 and Li adsorbed on the (101̄0) face of MoS2
Periodic Hartree–Fock methods were used to calculate the geometric and electronic properties of 2H-MoS2 , 1T-MoS2, the (100) surface of MoS2 and Li adsorbed thereon. For the calculations, the structures were generated by an extension of unit cells to the respective bulk structures (1T- and 2H-MoS2) or by cutting sections, each consisting of six or eight layers of sulfur and molybdenum, from a crystal ((100) surface of MoS2 with and without adsorbed Li). Structural optimization was performed with a post Hartree–Fock DFT correlation correction. The calculated structures of 2H-MoS2 and 1T-MoS2 are in good agreement with experimental data and the metastable and metallic properties of 1T-MoS2 are also described correctly. The relaxation of the (100) surface of 2H-MoS2 leads to a minor reconstruction of the surface accompanied by the formation of S2 species and an inward relaxation of Mo atoms. Adsorption of Li on this surface is favoured in the high symmetry positions above the van der Waals gap. Relaxation of the Li-covered (100) surface of 2H-MoS2 shifts the Li atoms towards the S2 pairs and closer to the surface. Upon adsorption, the system becomes metallic and delocalized surface states form at the Fermi level due to electron transfer processes from the Li atoms to the surface layers of MoS2.
- Open Access
- 1 February 1998
- Published by FapUNIFESP (SciELO) in Química Nova
- Vol. 21 (1) , 5-10
Defeitos superficiais em 2H-WS2 observados por microscopia de tunelamento
Scanning tunnelling microscopy (STM) was used to characterise the basal surface of fresh cleaved crystals of 2H-WS2. Although no impurity or stacking faults could be detected by X-ray diffraction, STM images obtained with negative bias voltage showed two kinds of defects. These defects were attributed to an iodine derivative used as transport agent. In a flat surface free of defects, an image with atomic resolution was achieved with sulphur distances and angles as expected for hexagonal symmetry of 2H-WS2
- 1 February 1998
- Published by FapUNIFESP (SciELO) in Química Nova
- Vol. 21 (1) , 5-10
Open AccessDefeitos superficiais em 2H-WS2 observados por microscopia de tunelamento
Scanning tunnelling microscopy (STM) was used to characterise the basal surface of fresh cleaved crystals of 2H-WS2. Although no impurity or stacking faults could be detected by X-ray diffraction, STM images obtained with negative bias voltage showed two kinds of defects. These defects were attributed to an iodine derivative used as transport agent. In a flat surface free of defects, an image with atomic resolution was achieved with sulphur distances and angles as expected for hexagonal symmetry of 2H-WS2