Clayton J. Radke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Clayton J. Radke has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Andrea Hickel
Institut für Biophysik und Röntgenstrukturforschung, OEAW Schmiedlstrasse 6, 8042, Graz, Austria
2 shared publications- Anuj Chauhan
Department of Chemical and Biological Engineering, Colorado School of Mines, Golden, USA
2 shared publications - Harvey W. Blanch
Department of Chemical Engineering, University of California, Berkeley, Berkeley, California 94720
2 shared publications John Newman
Department of Chemical Engineering, University of California, Berkeley, CA 94720-1462, USA
2 shared publicationsDavid T. Kim
Department of Chemical Engineering, University of California, 201 Gilman Hall, Berkeley, CA 94720-1462, USA
1 shared publicationE.K. Yeh
Department of Chemical Engineering, University of California, Berkeley, CA 94720-1462, USA
1 shared publication
Latest Publications
- 1 October 2008
- Published by Elsevier in The Ocular Surface
- Vol. 6 (4) , 154
Response of Drs. Radke and Chauhan
- 1 October 2008
- Published by Elsevier in The Ocular Surface
- Vol. 6 (4) , 154
Response of Drs. Radke and Chauhan
- 10 April 2005
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 41 (4) , 263-276
Imaging of reconstituted purple membranes by atomic force microscopy
- 10 April 2005
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 41 (4) , 263-276
Imaging of reconstituted purple membranes by atomic force microscopy
- 1 January 2005
- Published by Taylor & Francis in Current Eye Research
- Vol. 30 (5) , 329-336
The Effect of Water Hydraulic Permeability on the Settling of a Soft Contact Lens on the Eye
Purpose: Silicone-elastomer soft contact lenses (SCLs) adhere to the cornea during wear, whereas silicone-hydrogel soft contact lenses exhibit adequate on-eye movement. One explanation for the observed immunity to binding of silicone-hydrogel lenses is that some interstitial water is expelled during blinking, therefore maintaining a more stable post-lens tear film (PoLTF). We examine quantitatively whether or not water can be squeezed by hydrodynamic flow through a silicone-hydrogel membrane driven by the applied lid force during a blink. Methods: A rigid, porous-disk model of a contact lens was devised to calculate the relative settling rates of a permeable versus a completely impermeable SCL. The settling rate depended strongly on the value of the hydraulic permeability for pressure-driven water flow through the lens. Because the hydraulic permeability of water through silicone-hydrogel materials is not well-known, we measured this value. At steady state, water was forced through flat membranes of representative lens materials under known pressure drops. The resulting volumetric flows were measured by following the transient rise height of water in a vertical, precision-bore glass capillary. Darcy's law permitted calculation of the hydrodynamic permeability. Results: The settling-rate model indicated that tear can be squeezed through a SCL only when the Darcy-law hydrodynamic permeability is greater than about 10 μ m2 (i.e., greater than 10 Darcy). Our measurements for silicone and HEMA hydrogel membranes reveal hydrodynamic permeabilities of the order 10−8 μ m2, almost 9 orders of magnitude smaller than that necessary to initiate hydrodynamic flow through a SCL. Conclusions: We conclude that the squeeze-through mechanism cannot quantitatively account for the observed on-eye movement of silicone-hydrogel lenses. Also, we find that the lid-applied pressure cannot squeeze enough water out of a SCL during a blink to stabilize the PoLTF. Neither a squeeze-through nor a squeeze-out mechanism can maintain a stable PoLTF and prevent adherence.
- 1 January 2005
- Published by Taylor & Francis in Current Eye Research
- Vol. 30 (5) , 329-336
The Effect of Water Hydraulic Permeability on the Settling of a Soft Contact Lens on the Eye
Purpose: Silicone-elastomer soft contact lenses (SCLs) adhere to the cornea during wear, whereas silicone-hydrogel soft contact lenses exhibit adequate on-eye movement. One explanation for the observed immunity to binding of silicone-hydrogel lenses is that some interstitial water is expelled during blinking, therefore maintaining a more stable post-lens tear film (PoLTF). We examine quantitatively whether or not water can be squeezed by hydrodynamic flow through a silicone-hydrogel membrane driven by the applied lid force during a blink. Methods: A rigid, porous-disk model of a contact lens was devised to calculate the relative settling rates of a permeable versus a completely impermeable SCL. The settling rate depended strongly on the value of the hydraulic permeability for pressure-driven water flow through the lens. Because the hydraulic permeability of water through silicone-hydrogel materials is not well-known, we measured this value. At steady state, water was forced through flat membranes of representative lens materials under known pressure drops. The resulting volumetric flows were measured by following the transient rise height of water in a vertical, precision-bore glass capillary. Darcy's law permitted calculation of the hydrodynamic permeability. Results: The settling-rate model indicated that tear can be squeezed through a SCL only when the Darcy-law hydrodynamic permeability is greater than about 10 μ m2 (i.e., greater than 10 Darcy). Our measurements for silicone and HEMA hydrogel membranes reveal hydrodynamic permeabilities of the order 10−8 μ m2, almost 9 orders of magnitude smaller than that necessary to initiate hydrodynamic flow through a SCL. Conclusions: We conclude that the squeeze-through mechanism cannot quantitatively account for the observed on-eye movement of silicone-hydrogel lenses. Also, we find that the lid-applied pressure cannot squeeze enough water out of a SCL during a blink to stabilize the PoLTF. Neither a squeeze-through nor a squeeze-out mechanism can maintain a stable PoLTF and prevent adherence.
- 1 February 2004
- Published by Wiley in Protein Science
- Vol. 13 (2) , 358-369
Solvent–amino acid interaction energies in three‐dimensional‐lattice Monte Carlo simulations of a model 27‐mer protein: Folding thermodynamics and kinetics
Amino acid residue–solvent interactions are required for lattice Monte Carlo simulations of model proteins in water. In this study, we propose an interaction‐energy scale that is based on the interaction scale by Miyazawa and Jernigan. It permits systematic variation of the amino acid–solvent interactions by introducing a contrast parameter for the hydrophobicity, Cs, and a mean attraction parameter for the amino acids, ω. Changes in the interaction energies strongly affect many protein properties. We present an optimized energy parameter set for best representing realistic behavior typical for many proteins (fast folding and high cooperativity for single chains). Our optimal parameters feature a much weaker hydrophobicity contrast and mean attraction than does the original interaction scale. The proposed interaction scale is designed for calculating the behavior of proteins in bulk and at interfaces as a function of solvent characteristics, as well as protein size and sequence.
- 1 February 2004
- Published by Wiley in Protein Science
- Vol. 13 (2) , 358-369
Solvent–amino acid interaction energies in three‐dimensional‐lattice Monte Carlo simulations of a model 27‐mer protein: Folding thermodynamics and kinetics
Amino acid residue–solvent interactions are required for lattice Monte Carlo simulations of model proteins in water. In this study, we propose an interaction‐energy scale that is based on the interaction scale by Miyazawa and Jernigan. It permits systematic variation of the amino acid–solvent interactions by introducing a contrast parameter for the hydrophobicity, Cs, and a mean attraction parameter for the amino acids, ω. Changes in the interaction energies strongly affect many protein properties. We present an optimized energy parameter set for best representing realistic behavior typical for many proteins (fast folding and high cooperativity for single chains). Our optimal parameters feature a much weaker hydrophobicity contrast and mean attraction than does the original interaction scale. The proposed interaction scale is designed for calculating the behavior of proteins in bulk and at interfaces as a function of solvent characteristics, as well as protein size and sequence.
- 2 August 2003
- Published by Elsevier in Biophysical Chemistry
- Vol. 106 (1) , 81-89
3D-Lattice Monte Carlo simulations of model proteins. Size effects on folding thermodynamics and kinetics
- 2 August 2003
- Published by Elsevier in Biophysical Chemistry
- Vol. 106 (1) , 81-89
3D-Lattice Monte Carlo simulations of model proteins. Size effects on folding thermodynamics and kinetics
- 29 April 2002
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 78 (6) , 595-605
A kinetic model for enzyme interfacial activity and stability: pa‐hydroxynitrile lyase at the diisopropyl ether/water interface
A kinetic framework is developed to describe enzyme activity and stability in two‐phase liquid–liquid systems. In particular, the model is applied to the enzymatic production of benzaldehyde from mandelonitrile by Prunus amygdalus hydroxynitrile lyase (pa‐Hnl) adsorbed at the diisopropyl ether (DIPE)/aqueous buffer interface (pH = 5.5). We quantitatively describe our previously obtained experimental kinetic results (Hickel et al., 1999; 2001), and we successfully account for the aqueous‐phase enzyme concentration dependence of product formation rates and the observed reaction rates at early times. Multilayer growth explains the early time reversibility of enzyme adsorption at the DIPE/buffer interface observed by both enzyme‐activity and dynamic‐interfacial‐tension washout experiments that replace the aqueous enzyme solution with a buffer solution. The postulated explanation for the unusual stability of pa‐Hnl adsorbed at the DIPE/buffer interface is attributed to a two‐layer adsorption mechanism. In the first layer, slow conformational change from the native state leads to irreversible attachment and partial loss of catalytic activity. In the second layer, pa‐Hnl is reversibly adsorbed without loss in catalytic activity. The measured catalytic activity is the combined effect of the deactivation kinetics of the first layer and of the adsorption kinetics of each layer. For the specific case of pa‐Hnl adsorbed at the DIPE/buffer interface, this combined effect is nearly constant for several hours resulting in no apparent loss of catalytic activity. Our proposed kinetic model can be extended to other interfacially active enzymes and other organic solvents. Finally, we indicate how interfacial‐tension lag times provide a powerful tool for rational solvent selection and enzyme engineering. © 2002 Wiley Periodicals, Inc. Biotechnol Bioeng 78: 595–605, 2002.
- 29 April 2002
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 78 (6) , 595-605
A kinetic model for enzyme interfacial activity and stability: pa‐hydroxynitrile lyase at the diisopropyl ether/water interface
A kinetic framework is developed to describe enzyme activity and stability in two‐phase liquid–liquid systems. In particular, the model is applied to the enzymatic production of benzaldehyde from mandelonitrile by Prunus amygdalus hydroxynitrile lyase (pa‐Hnl) adsorbed at the diisopropyl ether (DIPE)/aqueous buffer interface (pH = 5.5). We quantitatively describe our previously obtained experimental kinetic results (Hickel et al., 1999; 2001), and we successfully account for the aqueous‐phase enzyme concentration dependence of product formation rates and the observed reaction rates at early times. Multilayer growth explains the early time reversibility of enzyme adsorption at the DIPE/buffer interface observed by both enzyme‐activity and dynamic‐interfacial‐tension washout experiments that replace the aqueous enzyme solution with a buffer solution. The postulated explanation for the unusual stability of pa‐Hnl adsorbed at the DIPE/buffer interface is attributed to a two‐layer adsorption mechanism. In the first layer, slow conformational change from the native state leads to irreversible attachment and partial loss of catalytic activity. In the second layer, pa‐Hnl is reversibly adsorbed without loss in catalytic activity. The measured catalytic activity is the combined effect of the deactivation kinetics of the first layer and of the adsorption kinetics of each layer. For the specific case of pa‐Hnl adsorbed at the DIPE/buffer interface, this combined effect is nearly constant for several hours resulting in no apparent loss of catalytic activity. Our proposed kinetic model can be extended to other interfacially active enzymes and other organic solvents. Finally, we indicate how interfacial‐tension lag times provide a powerful tool for rational solvent selection and enzyme engineering. © 2002 Wiley Periodicals, Inc. Biotechnol Bioeng 78: 595–605, 2002.
- 20 November 1999
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 65 (4) , 425-436
Hydroxynitrile lyase at the diisopropyl ether/water interface: Evidence for interfacial enzyme activity
- 20 November 1999
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 65 (4) , 425-436
Hydroxynitrile lyase at the diisopropyl ether/water interface: Evidence for interfacial enzyme activity
- 1 October 1999
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 156 (1-3) , 525-546
Equilibrium configurations of liquid droplets on solid surfaces under the influence of thin-film forces
- 1 October 1999
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 156 (1-3) , 525-546
Equilibrium configurations of liquid droplets on solid surfaces under the influence of thin-film forces
- 13 May 1999
- Published by Elsevier in Journal of Electrostatics
- Vol. 46 (4) , 247-257
A nonlinear corrosion model for the entrance region in laminar flow electrification of hydrocarbon liquids
- 13 May 1999
- Published by Elsevier in Journal of Electrostatics
- Vol. 46 (4) , 247-257
A nonlinear corrosion model for the entrance region in laminar flow electrification of hydrocarbon liquids
- 1 July 1998
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 203 (1) , 69-82
Surface Conductivity and Disjoining Pressure of Common Black Films Stabilized with Sodium Dodecyl Sulfate
- 1 July 1998
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 203 (1) , 69-82
Surface Conductivity and Disjoining Pressure of Common Black Films Stabilized with Sodium Dodecyl Sulfate