Toshiaki Kabe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Toshiaki Kabe has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Atsushi Ishihara
Department of Chemical Engineering, Tokyo University of Agriculture and Technology, 2-24-16 Nakacho, Koganei, Tokyo 184-8588, Japan
25 shared publications Weihua Qian
Department of Chemical Engineering, Tokyo University of Agriculture and Technology, 2-24-16, Nakacho, Koganei, Tokyo 184-8588, Japan
13 shared publicationsAtsushi Ishihara
Department of Chemical Engineering, Tokyo University of Agriculture and Technology, 2-24-16 Nakacho, Koganei, Tokyo 184-8588, Japan
6 shared publicationsQing Zhang
Dept. of Applied Chemistry, Tokyo University of Agriculture and Technology
6 shared publicationsDanhong Wang
5 shared publicationsMasazumi Godo
Dept. of Applied Chemistry, Tokyo University of Agriculture and Technology
4 shared publications
Latest Publications
- 1 November 2005
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 31 (9) , 819-832
Interpretation of the difference of optimal Mo density in MoS2-Al2O3 and MoS2-TiO2 HDS catalysts
The first part of this paper deals with the morphology of the MoS2 phase and its oxide precursor, the MoO3 phase, mainly from a geometrical point of view. After giving a brief review of the literature describing the structure of these compounds, Mo densities in both phases were calculated along various crystallographic planes. Further, using structural models recently proposed by others, Mo densities in MoS2 were also calculated in the case of an epitactic growth on γ-Al2O3 and TiO2 model surfaces. Then, the calculated Mo densities were compared with experimental results (Mo density when HDS activity is maximal) previously obtained for catalysts constituted of MoS2 supported on a low SSA TiO2, a high SSA TiO2 and a conventional γ-alumina. It was suggested that either on alumina or titania the MoS2 phase is growing as (100) MoS2 planes. However, while on the alumina the optimal MoS2 phase might be constituted of dispersed MoS2 slabs covering only a part of the alumina surface (2.9–3.9 Mo atoms/nm2), on titania the optimal MoS2 phase might be constituted of a uniform MoS2 monolayer (5.2 atoms/nm2 for the high SSA titania, which is equal to the Mo density of a perfect MoS2 (100) plane). This difference may originate in the creation of a 'TiMoS' phase enhancing the S atoms mobility over Mo/TiO2-sulfided catalysts. Indeed, while in the case of a γ-alumina carrier the active sites (labile S atoms) are located on the edge of MoS2 slabs making the ratio Moedge/Mototal a crucial parameter for the catalytic performances, in the case of a titania carrier the labile sulfur atoms might be statistically distributed all over the TiMoS active phase. Further, the higher Mo density observed over the high SSA titania (5.2 atoms/nm2) when compared to that over the low SSA titania (4.2 atoms/nm2) was supposedly due to the pH-swing method advantageously used to prepare the former carrier. Indeed, this method allows giving a solid with enhanced mechanical properties providing a good stability to the derived catalysts under experimental conditions. In addition, this TiO2 carrier exhibits a great homogeneity, with a surface structure substantially uniform, which might be adequate for a long-range growth of (100) MoS2 slabs.
- 1 November 2005
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 31 (9) , 819-832
Interpretation of the difference of optimal Mo density in MoS2-Al2O3 and MoS2-TiO2 HDS catalysts
The first part of this paper deals with the morphology of the MoS2 phase and its oxide precursor, the MoO3 phase, mainly from a geometrical point of view. After giving a brief review of the literature describing the structure of these compounds, Mo densities in both phases were calculated along various crystallographic planes. Further, using structural models recently proposed by others, Mo densities in MoS2 were also calculated in the case of an epitactic growth on γ-Al2O3 and TiO2 model surfaces. Then, the calculated Mo densities were compared with experimental results (Mo density when HDS activity is maximal) previously obtained for catalysts constituted of MoS2 supported on a low SSA TiO2, a high SSA TiO2 and a conventional γ-alumina. It was suggested that either on alumina or titania the MoS2 phase is growing as (100) MoS2 planes. However, while on the alumina the optimal MoS2 phase might be constituted of dispersed MoS2 slabs covering only a part of the alumina surface (2.9–3.9 Mo atoms/nm2), on titania the optimal MoS2 phase might be constituted of a uniform MoS2 monolayer (5.2 atoms/nm2 for the high SSA titania, which is equal to the Mo density of a perfect MoS2 (100) plane). This difference may originate in the creation of a 'TiMoS' phase enhancing the S atoms mobility over Mo/TiO2-sulfided catalysts. Indeed, while in the case of a γ-alumina carrier the active sites (labile S atoms) are located on the edge of MoS2 slabs making the ratio Moedge/Mototal a crucial parameter for the catalytic performances, in the case of a titania carrier the labile sulfur atoms might be statistically distributed all over the TiMoS active phase. Further, the higher Mo density observed over the high SSA titania (5.2 atoms/nm2) when compared to that over the low SSA titania (4.2 atoms/nm2) was supposedly due to the pH-swing method advantageously used to prepare the former carrier. Indeed, this method allows giving a solid with enhanced mechanical properties providing a good stability to the derived catalysts under experimental conditions. In addition, this TiO2 carrier exhibits a great homogeneity, with a surface structure substantially uniform, which might be adequate for a long-range growth of (100) MoS2 slabs.
- 28 August 2003
- Published by Elsevier in Applied Catalysis A: General
- Vol. 249 (2) , 255-263
Study of the sulfidation process of CrO3–Al2O3 hydrodesulfurization catalysts by a 35S-labeled H2S pulse tracer method
- 28 August 2003
- Published by Elsevier in Applied Catalysis A: General
- Vol. 249 (2) , 255-263
Study of the sulfidation process of CrO3–Al2O3 hydrodesulfurization catalysts by a 35S-labeled H2S pulse tracer method
- 28 February 2003
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- No. 7,p. 842-843
Characterization of sulfur exchange reaction between polysulfides and elemental sulfur using a 35S radioisotope tracer method
A sulfur exchange reaction between di-tert-butylpolysulfides and elemental sulfur was examined using a 35S tracer method and the reaction mechanism was discussed.
- 28 February 2003
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- No. 7,p. 842-843
Characterization of sulfur exchange reaction between polysulfides and elemental sulfur using a 35S radioisotope tracer method
A sulfur exchange reaction between di-tert-butylpolysulfides and elemental sulfur was examined using a 35S tracer method and the reaction mechanism was discussed.
- 1 January 2003
- Published by Elsevier
- p. 299-302
62 Elucidation of behavior of hydrogen on solid catalysts using a tritium tracer method
- 1 January 2003
- Published by Elsevier
- p. 299-302
62 Elucidation of behavior of hydrogen on solid catalysts using a tritium tracer method
- 22 October 2002
- Published by Elsevier in Applied Catalysis A: General
- Vol. 238 (1) , 109-117
Elucidation of promotion effect of cobalt and nickel on Mo/TiO2 catalyst using a 35S tracer method
- 22 October 2002
- Published by Elsevier in Applied Catalysis A: General
- Vol. 238 (1) , 109-117
Elucidation of promotion effect of cobalt and nickel on Mo/TiO2 catalyst using a 35S tracer method
- 25 January 2002
- Published by Elsevier in Applied Catalysis A: General
- Vol. 224 (1-2) , 191-199
Elucidation of sulfidation state and hydrodesulfurization mechanism on Mo/TiO2 catalyst using 35S radioisotope tracer methods
- 25 January 2002
- Published by Elsevier in Applied Catalysis A: General
- Vol. 224 (1-2) , 191-199
Elucidation of sulfidation state and hydrodesulfurization mechanism on Mo/TiO2 catalyst using 35S radioisotope tracer methods
- 23 February 2001
- Published by Elsevier in Applied Catalysis A: General
- Vol. 209 (1-2) , 237-247
Effects of H2S on hydrodesulfurization of dibenzothiophene and 4,6-dimethyldibenzothiophene on alumina-supported NiMo and NiW catalysts
- 23 February 2001
- Published by Elsevier in Applied Catalysis A: General
- Vol. 209 (1-2) , 237-247
Effects of H2S on hydrodesulfurization of dibenzothiophene and 4,6-dimethyldibenzothiophene on alumina-supported NiMo and NiW catalysts
- 1 January 2001
- Published by Japan Petroleum Institute in Journal of The Japan Petroleum Institute
- Vol. 44 (2) , 80-91
Hydrodesulfurization of Dibenzothiophene Catalyzed by Supported Metal Carbonyl Complexes.
- 1 January 2001
- Published by Japan Petroleum Institute in Journal of The Japan Petroleum Institute
- Vol. 44 (2) , 80-91
Hydrodesulfurization of Dibenzothiophene Catalyzed by Supported Metal Carbonyl Complexes.