Tim Kemmitt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tim Kemmitt has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Najeh I. Al-Salim
Industrial Research Ltd., P.O. Box 31-310, Lower Hutt, New Zealand, and Institute of Fundamental Sciences, Massey University, Private Bag 11-222, Palmerston North, New Zealand
4 shared publicationsGraeme J. Gainsford
Industrial Research Ltd., P.O. Box 31-310, Lower Hutt, New Zealand, and Institute of Fundamental Sciences, Massey University, Private Bag 11-222, Palmerston North, New Zealand
3 shared publications- Mark E. Bowden
Industrial Research Ltd, PO Box 31-310, Lower Hutt, New Zealand
2 shared publications A. James McQuillan
Department of Chemistry, University of Otago, PO Box 56, Dunedin, New Zealand
1 shared publication- Alexander Kirchner
Industrial Research Ldt., MacDiarmid Institute, Gracefield Road, PO Box 31-310, Lower Hutt, N/A, New Zealand, ++ 64 4 931 3155
1 shared publication Andrea Bubendorfer
Industrial Research Ltd., P.O. Box 31-310, Lower Hutt, New Zealand, and Institute of Fundamental Sciences, Massey University, Private Bag 11-222, Palmerston North, New Zealand
1 shared publication
Latest Publications
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1023
Hydrogen Purification using Ultra-Thin Palladium Films Supported on Porous Anodic Alumina Membranes
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1023
Hydrogen Purification using Ultra-Thin Palladium Films Supported on Porous Anodic Alumina Membranes
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 927
Mechanistic Studies of Hydrogen Release from Solid Amine Borane Materials
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 927
Mechanistic Studies of Hydrogen Release from Solid Amine Borane Materials
- 1 September 2004
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 43 (20) , 6300-6306
Unprecedented Oxo-Titanium Citrate Complex Precipitated from Aqueous Citrate Solutions, Exhibiting a Novel Bilayered Ti8O10 Structural Core
Aqueous titanium citrate solutions were prepared from the reaction of citric acid with titanium 2-propoxide in a range of molar ratios. Solutions containing two or fewer citrates per titanium resulted in the slow crystallization of an insoluble titanium oxo-citrate complex. Single-crystal X-ray analysis identified the species as Ti8O10(citrate)4(H2O)12·14H2O·3HOPri, crystallized in the tetragonal space group I41/a, with a = 30.775(7) Å, c = 14.528(7) Å, V = 13 759(8) Å3, and Z = 8. The trianionic citrate ligands supply both carboxylate and alkoxide coordination and stabilize the structure using simultaneous chelating and bridging modes of attachment. The compound is a neutral species, exhibiting titanium in three contrasting environments. Laser Raman microscopy and 13C CPMAS solid-state NMR data were consistent with those of the X-ray crystal structure. When exposed to air, the crystals rapidly lost water and became a powder. The dehydrated powder was noncrystalline to X-rays and insoluble, but 13C NMR results demonstrated retention of the carboxylate linkages.
- 1 September 2004
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 43 (20) , 6300-6306
Unprecedented Oxo-Titanium Citrate Complex Precipitated from Aqueous Citrate Solutions, Exhibiting a Novel Bilayered Ti8O10 Structural Core
Aqueous titanium citrate solutions were prepared from the reaction of citric acid with titanium 2-propoxide in a range of molar ratios. Solutions containing two or fewer citrates per titanium resulted in the slow crystallization of an insoluble titanium oxo-citrate complex. Single-crystal X-ray analysis identified the species as Ti8O10(citrate)4(H2O)12·14H2O·3HOPri, crystallized in the tetragonal space group I41/a, with a = 30.775(7) Å, c = 14.528(7) Å, V = 13 759(8) Å3, and Z = 8. The trianionic citrate ligands supply both carboxylate and alkoxide coordination and stabilize the structure using simultaneous chelating and bridging modes of attachment. The compound is a neutral species, exhibiting titanium in three contrasting environments. Laser Raman microscopy and 13C CPMAS solid-state NMR data were consistent with those of the X-ray crystal structure. When exposed to air, the crystals rapidly lost water and became a powder. The dehydrated powder was noncrystalline to X-rays and insoluble, but 13C NMR results demonstrated retention of the carboxylate linkages.
- 29 October 2003
- Published by CSIRO Publishing in Australian Journal of Chemistry
- Vol. 56 (11) , 1147-1152
Influence of Ligand Architecture on Bridging Bond Strength in Dimeric Titanium Aminoalkoxy-Diolates
A series of mixed-ligand–titanium complexes is reported which incorporate a tridentate N -methyldiethoxoamine (mdea) ligand in conjunction with chelating diolate ligand. X-ray crystal structures of the complexes [Ti(mdea) (O-O)]2 (where O-O = OC(CH3)2C(CH3)2O (1), OC(C2H5)2C(C2H5)2O (2), OC(CH3)2CH2CH(CH3)O (3), and OC(CH3)2CH2C(CH3)2O (4)) show them to exist as dimers in the solid state, with one arm of the aminodialkoxy ligand µ-bridging two titanium centres. Solution-state 1H and 13C NMR studies concur with the solid-state structures of (1)–(4) at low temperature. The room-temperature spectra of (3) and (4) suggest that bridging bond scission and reformation occurs increasing the apparent symmetry of the complexes. Complexes (3) and (4) dissociate into monomers in the vapour phase. The influence of the diolate ligand on the bridging bond strengths is discussed.
- 29 October 2003
- Published by CSIRO Publishing in Australian Journal of Chemistry
- Vol. 56 (11) , 1147-1152
Influence of Ligand Architecture on Bridging Bond Strength in Dimeric Titanium Aminoalkoxy-Diolates
A series of mixed-ligand–titanium complexes is reported which incorporate a tridentate N -methyldiethoxoamine (mdea) ligand in conjunction with chelating diolate ligand. X-ray crystal structures of the complexes [Ti(mdea) (O-O)]2 (where O-O = OC(CH3)2C(CH3)2O (1), OC(C2H5)2C(C2H5)2O (2), OC(CH3)2CH2CH(CH3)O (3), and OC(CH3)2CH2C(CH3)2O (4)) show them to exist as dimers in the solid state, with one arm of the aminodialkoxy ligand µ-bridging two titanium centres. Solution-state 1H and 13C NMR studies concur with the solid-state structures of (1)–(4) at low temperature. The room-temperature spectra of (3) and (4) suggest that bridging bond scission and reformation occurs increasing the apparent symmetry of the complexes. Complexes (3) and (4) dissociate into monomers in the vapour phase. The influence of the diolate ligand on the bridging bond strengths is discussed.
- 25 August 2000
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 10 (10) , 2358-2363
Characterisation and activity of sol–gel-prepared TiO2 photocatalysts modified with Ca, Sr or Ba ion additives
TiO2 (anatase)-based photocatalyst powders containing up to 20 mol% calcium, strontium or barium ions were prepared from α-titanic acid by calcining gels prepared from triethanolamine-based sols at 600 °C. The powders were characterised using X-ray diffraction (XRD), scanning electron microscopy (SEM), diffuse reflectance ultraviolet spectrophotometry, nitrogen sorption porosimetry and in situ infrared spectroscopy to examine surface adsorbed species. Compositions containing greater than 15 mol% alkaline earth ions resulted in largely amorphous materials. The residual anatase showed decreased crystallite sizes and increased crystallographic cell volumes with increasing concentration of alkaline earth ions, while the BET surface areas of the materials increased from around 80 m2 g−1 (no additive) to 160 m2 g−1 at higher levels of additive. Electronic spectroscopy showed that the band gaps of the materials increased with increasing Ca2+ content, due to the decreasing particle sizes. Under the synthesis conditions used, no other crystalline phase was observed, except rutile (< 1% w.r.t. anatase). The photocatalytic decomposition of oxalic acid was used as a model system to determine the relative influences of the additives on the photocatalytic activities. Titania containing 20 mol% alkaline earth ions showed approximately double the photocatalytic activity of similarly prepared anatase without additive. Half of the enhancement occurred for titania samples containing only 2 mol% alkaline earth ions. Comparisons of the physico-chemical properties of the photocatalysts with oxalic acid decomposition rates were carried out to determine the factors influencing the photocatalytic activity.
- 25 August 2000
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 10 (10) , 2358-2363
Characterisation and activity of sol–gel-prepared TiO2 photocatalysts modified with Ca, Sr or Ba ion additives
TiO2 (anatase)-based photocatalyst powders containing up to 20 mol% calcium, strontium or barium ions were prepared from α-titanic acid by calcining gels prepared from triethanolamine-based sols at 600 °C. The powders were characterised using X-ray diffraction (XRD), scanning electron microscopy (SEM), diffuse reflectance ultraviolet spectrophotometry, nitrogen sorption porosimetry and in situ infrared spectroscopy to examine surface adsorbed species. Compositions containing greater than 15 mol% alkaline earth ions resulted in largely amorphous materials. The residual anatase showed decreased crystallite sizes and increased crystallographic cell volumes with increasing concentration of alkaline earth ions, while the BET surface areas of the materials increased from around 80 m2 g−1 (no additive) to 160 m2 g−1 at higher levels of additive. Electronic spectroscopy showed that the band gaps of the materials increased with increasing Ca2+ content, due to the decreasing particle sizes. Under the synthesis conditions used, no other crystalline phase was observed, except rutile (< 1% w.r.t. anatase). The photocatalytic decomposition of oxalic acid was used as a model system to determine the relative influences of the additives on the photocatalytic activities. Titania containing 20 mol% alkaline earth ions showed approximately double the photocatalytic activity of similarly prepared anatase without additive. Half of the enhancement occurred for titania samples containing only 2 mol% alkaline earth ions. Comparisons of the physico-chemical properties of the photocatalysts with oxalic acid decomposition rates were carried out to determine the factors influencing the photocatalytic activity.
- 20 October 1999
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 1999 (11) , 1847-1849
Formation and Structural Characterisation of an Unusual Cyclic HexamericOxotitanium Complex
- 20 October 1999
- Published by Wiley in European Journal of Inorganic Chemistry
- Vol. 1999 (11) , 1847-1849
Formation and Structural Characterisation of an Unusual Cyclic HexamericOxotitanium Complex