Jaideep Chatterjee
Jaideep Chatterjee has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Darsh T. Wasan
4 shared publicationsP.K.S. Khan
Dept. of Electr. & Electron. Eng., Inst. of Technol., Chittagong, Bangladesh
2 shared publicationsSantosh Kumar Gupta
2 shared publicationsShailendra Pratap
2 shared publicationsA. Anand
Department of Electrical Engineering, Indian Institute of Technology, New Delhi, India
1 shared publicationAdapa.K. Rao
Department of Electrical Engineering, Indian Institute of Technology Delhi, New Delhi 110016, India
1 shared publication
Latest Publications
- 25 August 2023
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 198, 129-137
A model for the observed secondary-maximum in backwash-effluent-TDS-data obtained during backwash of spiral-wound RO membranes
- 25 August 2023
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 198, 129-137
A model for the observed secondary-maximum in backwash-effluent-TDS-data obtained during backwash of spiral-wound RO membranes
- Open Access
- 1 May 2023
- Published by IWA Publishing in Water Practice & Technology
- Vol. 18 (5) , 1172-1183
An improved technique for reducing water wastage from micro-RO-membrane-based water purification systems: An experimental study
While reverse osmosis (RO) has emerged as the leading technology for home-use and point-of-use (POU) water purification, this technology leads to water wastage as the reject. This wastage needs to be reduced, especially in water-stressed regions of the world. In this paper, we report an experimental study, which demonstrates that it is possible to operate a home-use RO-based water purification system, at ∼75% recovery, without significantly compromising the life of the membrane. The membrane element is ‘cleaned’ using a hydrostatic and osmotically driven backwash using the permeate produced in the system. This study examines the effect of the permeate volume used for the backwash, on the extent of salt removal from the membrane module. During this study, which involved the measurement of the total dissolved solids (TDS) of the backwash-effluent, it was observed that the backwash-effluent showed dual-minima in the effluent TDS. This paper further examines this dual-minima observed under different experimental conditions. Data generated suggest the causes for the dual-minima.
- 1 May 2023
- Published by IWA Publishing in Water Practice & Technology
- Vol. 18 (5) , 1172-1183
Open AccessAn improved technique for reducing water wastage from micro-RO-membrane-based water purification systems: An experimental study
While reverse osmosis (RO) has emerged as the leading technology for home-use and point-of-use (POU) water purification, this technology leads to water wastage as the reject. This wastage needs to be reduced, especially in water-stressed regions of the world. In this paper, we report an experimental study, which demonstrates that it is possible to operate a home-use RO-based water purification system, at ∼75% recovery, without significantly compromising the life of the membrane. The membrane element is ‘cleaned’ using a hydrostatic and osmotically driven backwash using the permeate produced in the system. This study examines the effect of the permeate volume used for the backwash, on the extent of salt removal from the membrane module. During this study, which involved the measurement of the total dissolved solids (TDS) of the backwash-effluent, it was observed that the backwash-effluent showed dual-minima in the effluent TDS. This paper further examines this dual-minima observed under different experimental conditions. Data generated suggest the causes for the dual-minima.
- 1 April 2017
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 5 (2) , 1586-1598
Separation of anionic surfactant in paste form from its aqueous solutions using foam fractionation
- 1 April 2017
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 5 (2) , 1586-1598
Separation of anionic surfactant in paste form from its aqueous solutions using foam fractionation
- 25 March 2017
- Published by Techno-Press in Advances in environmental research
- Vol. 6 (1) , 35-51
A comparative study of granular activated carbon and sand as water filtration media with estimation of model parameters
- 25 March 2017
- Published by Techno-Press in Advances in environmental research
- Vol. 6 (1) , 35-51
A comparative study of granular activated carbon and sand as water filtration media with estimation of model parameters
- 1 April 2011
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 356 (1) , 362-368
Dual-deposition rates in colloid filtration caused by coupled heterogeneities in a colloidal population
- 1 April 2011
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 356 (1) , 362-368
Dual-deposition rates in colloid filtration caused by coupled heterogeneities in a colloidal population
- 1 December 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Improved operation of a three phase matrix converter using simple modulation strategy
Present work relates to improved operation of a 3-phase matrix converter using simple modulation strategy. A simple approach for input displacement power factor control is described, which can make the matrix converter as a source or sink of controlled reactive power. Novel feature of this investigation is the study relating to parallel operation of two matrix converters, from the point of view of reduction of input current harmonic, using a simple and reliable control strategy for matrix converter operation. These aspects enhance the possibility of application of matrix converters in grid connected wind energy conversion systems (wind farms).
- 1 December 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Improved operation of a three phase matrix converter using simple modulation strategy
Present work relates to improved operation of a 3-phase matrix converter using simple modulation strategy. A simple approach for input displacement power factor control is described, which can make the matrix converter as a source or sink of controlled reactive power. Novel feature of this investigation is the study relating to parallel operation of two matrix converters, from the point of view of reduction of input current harmonic, using a simple and reliable control strategy for matrix converter operation. These aspects enhance the possibility of application of matrix converters in grid connected wind energy conversion systems (wind farms).
- 1 June 2010
- Published by Elsevier in Water Research
- Vol. 44 (11) , 3365-3374
Estimation of colloidal deposition from heterogeneous populations
- 1 June 2010
- Published by Elsevier in Water Research
- Vol. 44 (11) , 3365-3374
Estimation of colloidal deposition from heterogeneous populations
- 17 April 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 43 (10) , 3694-3699
An Agglomeration-Based Model for Colloid Filtration
This paper develops a model for colloid filtration which accounts for the possibility of aggregation of the colloidal particles in the aqueous phase. Depth-wise variation of liquid-phase colloid concentration, C(x), is measured experimentally in the presence of monovalent cations at different concentrations and divalent cations, which confirm that log of C(x) deviates significantly from linearity for all of the above cases. It is also observed that in all systems showing significant removal, preaggregation of the colloids is observed, which confirms the correlation between aggregation of colloids with their retention in saturated porous media, which has been reported earlier. A new model for depth filtration which is based on material balances of the different sized aggregates, which could be present in the colloidal dispersion, is developed. This resulting model, based on differential deposition rates for different sized aggregates, shows good match with the experimentally observed variation of C(x) with depth, for all of the above conditions. A method for estimating model parameters from data is developed. This model remains independent of the actual deposition mechanism, which could be secondary minima attachment of these colloidal aggregates or the entrapment of these colloidal aggregates in regions of confined geometry. This model can be extended to predict the transport of colloids in groundwater.
- 17 April 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 43 (10) , 3694-3699
An Agglomeration-Based Model for Colloid Filtration
This paper develops a model for colloid filtration which accounts for the possibility of aggregation of the colloidal particles in the aqueous phase. Depth-wise variation of liquid-phase colloid concentration, C(x), is measured experimentally in the presence of monovalent cations at different concentrations and divalent cations, which confirm that log of C(x) deviates significantly from linearity for all of the above cases. It is also observed that in all systems showing significant removal, preaggregation of the colloids is observed, which confirms the correlation between aggregation of colloids with their retention in saturated porous media, which has been reported earlier. A new model for depth filtration which is based on material balances of the different sized aggregates, which could be present in the colloidal dispersion, is developed. This resulting model, based on differential deposition rates for different sized aggregates, shows good match with the experimentally observed variation of C(x) with depth, for all of the above conditions. A method for estimating model parameters from data is developed. This model remains independent of the actual deposition mechanism, which could be secondary minima attachment of these colloidal aggregates or the entrapment of these colloidal aggregates in regions of confined geometry. This model can be extended to predict the transport of colloids in groundwater.
- 1 March 2008
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 317 (1-3) , 421-430
Estimation of size from capillary pressure—A correction factor for a two menisci capillary
- 1 March 2008
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 317 (1-3) , 421-430
Estimation of size from capillary pressure—A correction factor for a two menisci capillary
- 1 October 2007
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 314 (1) , 199-206
Prediction of coupled menisci shapes by Young–Laplace equation and the resultant variability in capillary retention
- 1 October 2007
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 314 (1) , 199-206
Prediction of coupled menisci shapes by Young–Laplace equation and the resultant variability in capillary retention