András Dombi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
András Dombi has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
István Ilisz
3 shared publications- Klara Hernadi
Institute of Physical Metallurgy, Metal forming and Nanotechnology, University of Miskolc, 3515 Miskolc, Hungary
3 shared publications - Károly Mogyorósi
Research Group of Environmental Chemistry, Institute of Chemistry, University of Szeged, Tisza L. krt. 103., H-6720 Szeged, Hungary
3 shared publications Márta Hegedűs
Department of Inorganic and Analytical Chemistry, University of Szeged, P.O. Box 440, H-6701 Szeged, Hungary
2 shared publications- Péter Pusztai
Department of Applied and Environmental Chemistry, University of Szeged, Rerrich tér 1., H-6720 Szeged, Hungary
2 shared publications - Zoltán Kónya
Department of Applied and Environmental Chemistry, University of Szeged, Rerrich Béla tér 1, H-6720 Szeged, Hungary
2 shared publications
Latest Publications
- Open Access
New Insights on the Simultaneous Removal by Adsorption on Organoclays of Humic Acid and Phenol
The exploitation of thermal water as a heat source in houses and apartments (during winter) is a widely used alternative to natural gas. However, this type of water may contain organic contaminants, which must be removed before releasing the used water into rivers and lakes. Because of the presence of a wide range of pollutants (including phenolic compounds and humates), efficient, cheap removal processes are needed. In order to demonstrate their capability in thermal water cleaning, clay minerals were applied for the removal of phenol and humic acid via adsorption. To determine the most efficient removal strategy for the aforementioned pollutants, the following parameters were investigated: the type of the clay mineral, the organophilization strategy (in situ or pre-organophilization), and the individual or simultaneous removability of the model pollutants. The current study revealed that the applied low cost, in situ prepared clay mineral adsorbents are applicable in the removal of pollutants from thermal water.
Open AccessNew Insights on the Simultaneous Removal by Adsorption on Organoclays of Humic Acid and Phenol
The exploitation of thermal water as a heat source in houses and apartments (during winter) is a widely used alternative to natural gas. However, this type of water may contain organic contaminants, which must be removed before releasing the used water into rivers and lakes. Because of the presence of a wide range of pollutants (including phenolic compounds and humates), efficient, cheap removal processes are needed. In order to demonstrate their capability in thermal water cleaning, clay minerals were applied for the removal of phenol and humic acid via adsorption. To determine the most efficient removal strategy for the aforementioned pollutants, the following parameters were investigated: the type of the clay mineral, the organophilization strategy (in situ or pre-organophilization), and the individual or simultaneous removability of the model pollutants. The current study revealed that the applied low cost, in situ prepared clay mineral adsorbents are applicable in the removal of pollutants from thermal water.
- Open Access
Photocatalytic H2 Evolution Using Different Commercial TiO2 Catalysts Deposited with Finely Size-Tailored Au Nanoparticles: Critical Dependence on Au Particle Size
One weight percent of differently sized Au nanoparticles were deposited on two commercially available TiO2 photocatalysts: Aeroxide P25 and Kronos Vlp7000. The primary objective was to investigate the influence of the noble metal particle size and the deposition method on the photocatalytic activity. The developed synthesis method involves a simple approach for the preparation of finely-tuned Au particles through variation of the concentration of the stabilizing agent. Au was deposited on the TiO2 surface by photo- or chemical reduction, using trisodium citrate as a size-tailoring agent. The Au-TiO2 composites were synthetized by in situ reduction or by mixing the titania suspension with a previously prepared gold sol. The H2 production activities of the samples were studied in aqueous TiO2 suspensions irradiated with near-UV light in the absence of dissolved O2, with oxalic acid or methanol as the sacrificial agent. The H2 evolution rates proved to be strongly dependent on Au particle size: the highest H2 production rate was achieved when the Au particles measured ~6 nm.
Open AccessPhotocatalytic H2 Evolution Using Different Commercial TiO2 Catalysts Deposited with Finely Size-Tailored Au Nanoparticles: Critical Dependence on Au Particle Size
One weight percent of differently sized Au nanoparticles were deposited on two commercially available TiO2 photocatalysts: Aeroxide P25 and Kronos Vlp7000. The primary objective was to investigate the influence of the noble metal particle size and the deposition method on the photocatalytic activity. The developed synthesis method involves a simple approach for the preparation of finely-tuned Au particles through variation of the concentration of the stabilizing agent. Au was deposited on the TiO2 surface by photo- or chemical reduction, using trisodium citrate as a size-tailoring agent. The Au-TiO2 composites were synthetized by in situ reduction or by mixing the titania suspension with a previously prepared gold sol. The H2 production activities of the samples were studied in aqueous TiO2 suspensions irradiated with near-UV light in the absence of dissolved O2, with oxalic acid or methanol as the sacrificial agent. The H2 evolution rates proved to be strongly dependent on Au particle size: the highest H2 production rate was achieved when the Au particles measured ~6 nm.
- Open Access
Photocatalytic H2 Production Using Pt-TiO2 in the Presence of Oxalic Acid: Influence of the Noble Metal Size and the Carrier Gas Flow Rate
The primary objective of the experiments was to investigate the differences in the photocatalytic performance when commercially available Aeroxide P25 TiO2 photocatalyst was deposited with differently sized Pt nanoparticles with identical platinum content (1 wt%). The noble metal deposition onto the TiO2 surface was achieved by in situ chemical reduction (CRIS) or by mixing chemically reduced Pt nanoparticle containing sols to the aqueous suspensions of the photocatalysts (sol-impregnated samples, CRSIM). Fine and low-scale control of the size of resulting Pt nanoparticles was obtained through variation of the trisodium citrate concentration during the syntheses. The reducing reagent was NaBH4. Photocatalytic activity of the samples and the reaction mechanism were examined during UV irradiation (λmax = 365 nm) in the presence of oxalic acid (50 mM) as a sacrificial hole scavenger component. The H2 evolution rates proved to be strongly dependent on the Pt particle size, as well as the irradiation time. A significant change of H2 formation rate during the oxalic acid transformation was observed which is unusual. It is probably regulated both by the decomposition rate of accumulated oxalic acid and the H+/H2 redox potential on the surface of the catalyst. The later potential is influenced by the concentration of the dissolved H2 gas in the reaction mixture.
Open AccessPhotocatalytic H2 Production Using Pt-TiO2 in the Presence of Oxalic Acid: Influence of the Noble Metal Size and the Carrier Gas Flow Rate
The primary objective of the experiments was to investigate the differences in the photocatalytic performance when commercially available Aeroxide P25 TiO2 photocatalyst was deposited with differently sized Pt nanoparticles with identical platinum content (1 wt%). The noble metal deposition onto the TiO2 surface was achieved by in situ chemical reduction (CRIS) or by mixing chemically reduced Pt nanoparticle containing sols to the aqueous suspensions of the photocatalysts (sol-impregnated samples, CRSIM). Fine and low-scale control of the size of resulting Pt nanoparticles was obtained through variation of the trisodium citrate concentration during the syntheses. The reducing reagent was NaBH4. Photocatalytic activity of the samples and the reaction mechanism were examined during UV irradiation (λmax = 365 nm) in the presence of oxalic acid (50 mM) as a sacrificial hole scavenger component. The H2 evolution rates proved to be strongly dependent on the Pt particle size, as well as the irradiation time. A significant change of H2 formation rate during the oxalic acid transformation was observed which is unusual. It is probably regulated both by the decomposition rate of accumulated oxalic acid and the H+/H2 redox potential on the surface of the catalyst. The later potential is influenced by the concentration of the dissolved H2 gas in the reaction mixture.
- 1 January 2008
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 11 (3)
Comparison of UV- and UV/VUV-Induced Photolytic and Heterogeneous Photocatalytic Degradation of Phenol, with Particular Emphasis on the Intermediates
The application of UV photolysis (254 nm), UV/VUV photolysis (254/185 nm) and heterogeneous photocatalysis (TiO
- 1 January 2008
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 11 (3)
Comparison of UV- and UV/VUV-Induced Photolytic and Heterogeneous Photocatalytic Degradation of Phenol, with Particular Emphasis on the Intermediates
The application of UV photolysis (254 nm), UV/VUV photolysis (254/185 nm) and heterogeneous photocatalysis (TiO
- 8 November 2004
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 53 (3) , 141-151
Gas-phase heterogeneous photocatalytic oxidation of chlorinated ethenes over titanium dioxide: perchloroethene
- 8 November 2004
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 53 (3) , 141-151
Gas-phase heterogeneous photocatalytic oxidation of chlorinated ethenes over titanium dioxide: perchloroethene
- 10 September 2004
- Published by Elsevier in Applied Catalysis A: General
- Vol. 271 (1-2) , 177-184
Comparative study of heterogeneous photocatalytic decomposition of tetrachloroethene and trichloroethene in the gas phase
- 10 September 2004
- Published by Elsevier in Applied Catalysis A: General
- Vol. 271 (1-2) , 177-184
Comparative study of heterogeneous photocatalytic decomposition of tetrachloroethene and trichloroethene in the gas phase
- 30 October 2002
- Published by Elsevier in Chemosphere
- Vol. 50 (1) , 9-13
Decomposition of halogenated methanes in oxygen-free gas mixtures by the use of a silent electric discharge
- 30 October 2002
- Published by Elsevier in Chemosphere
- Vol. 50 (1) , 9-13
Decomposition of halogenated methanes in oxygen-free gas mixtures by the use of a silent electric discharge
- 1 January 2002
- Published by Taylor & Francis in Ozone: Science & Engineering
- Vol. 24 (1) , 49-54
Comparison of Ozone-based and other (VUV and TiO2/UV) Radical Generation Methods in Phenol Decomposition
The degradation reaction kinetics and chemical mechanism of phenol decomposition by ozonation, TiO2-photocatalysis and vacuum ultraviolet (VUV) photolysis were investigated. The concentration dependences of the aromatic and aliphatic intermediates and the TOC content were compared as a function of the phenol conversion. The concentration profiles and the TOC curves obtained with each method were very similar. The results suggest a similar chemical mechanism for the transformation of phenol irrespective of the starting active component (a positive hole on the surface of the catalysts, a VUV photon, ozone or the hydroxyl radical).
- 1 January 2002
- Published by Taylor & Francis in Ozone: Science & Engineering
- Vol. 24 (1) , 49-54
Comparison of Ozone-based and other (VUV and TiO2/UV) Radical Generation Methods in Phenol Decomposition
The degradation reaction kinetics and chemical mechanism of phenol decomposition by ozonation, TiO2-photocatalysis and vacuum ultraviolet (VUV) photolysis were investigated. The concentration dependences of the aromatic and aliphatic intermediates and the TOC content were compared as a function of the phenol conversion. The concentration profiles and the TOC curves obtained with each method were very similar. The results suggest a similar chemical mechanism for the transformation of phenol irrespective of the starting active component (a positive hole on the surface of the catalysts, a VUV photon, ozone or the hydroxyl radical).
- 1 November 2001
- Published by Springer Nature in Reaction Kinetics and Catalysis Letters
- Vol. 74 (2) , 209-215
Photocatalytic decomposition of tetrachloroethylene in the gas phase with titanium dioxide as catalyst
- 1 November 2001
- Published by Springer Nature in Reaction Kinetics and Catalysis Letters
- Vol. 74 (2) , 209-215
Photocatalytic decomposition of tetrachloroethylene in the gas phase with titanium dioxide as catalyst
- 19 April 1999
- Published by Elsevier in Applied Catalysis A: General
- Vol. 180 (1-2) , 35-45
Investigation of the photodecomposition of phenol in near-UV-irradiated aqueous TiO2 suspensions. II. Effect of charge-trapping species on product distribution
- 19 April 1999
- Published by Elsevier in Applied Catalysis A: General
- Vol. 180 (1-2) , 35-45
Investigation of the photodecomposition of phenol in near-UV-irradiated aqueous TiO2 suspensions. II. Effect of charge-trapping species on product distribution