Masami Mori
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Masami Mori has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Yoshihiko Sadaoka
Department of Materials Science and Biotechnology, Graduate School of Science and Engineering, Ehime University, Matsuyama 790-8577, Japan
2 shared publications - Ayumu Noguchi
Graduate School of Science and Engineering, Ehime University, Matsuyama 790-8577, Japan
1 shared publication Hajime Kusaba
Department of Energy and Material Sciences, Faculty of Engineering Sciences, Kyushu University, 6-1 Kasuga-koen, Kasuga-shi, Fukuoka 816-8580, Japan
1 shared publication- Hideaki Sasaki
Materials Science and Engineering, Graduate School of Science and Engineering, Ehime University
1 shared publication - Hidenori Yahiro
Department of Materials Science and Biotechnology, Graduate School of Science and Engineering, Ehime University, Matsuyama 790-8577, Japan
1 shared publication Hiroyuki Nishimura
1 shared publication
Latest Publications
- Open Access
VOC Detections by p-Type Semiconducting Sensors Using Nano-Sized SmFeO3 Particles
Nano-sized SmFeO3 particles are prepared by the pyrolysis of heteronuclear cyano-complex, Sm[Fe(CN)6]·4H2O at a temperature of 600 °C in ozone. The low temperature decomposition followed in ozone successfully yielded fine particles with a high specific surface area of 20.0 m3/g (sample A). The fine particles were classified into further smaller particles with a unimodal size distribution and this process yielded a high specific surface area of 26.0 m3/g (sample B). These semiconducting powders were deposited on a sensor electrode by electrophoretic deposition (EPD) and tested on their sensing properties to VOCs. The sensors consisting of samples A and B both showed good responses to ethanol at 285 and 320 °C. The sensor with sample B showed extraordinarily good selectivity of ethanol for toluene at 320 °C. This could be because the detection film of sample B with moderately grown particles selectively reduced the reaction activity of toluene. The sensor with sample B also exhibited good selectivity of ethanol for hexane and dichloromethane.
Open AccessVOC Detections by p-Type Semiconducting Sensors Using Nano-Sized SmFeO3 Particles
Nano-sized SmFeO3 particles are prepared by the pyrolysis of heteronuclear cyano-complex, Sm[Fe(CN)6]·4H2O at a temperature of 600 °C in ozone. The low temperature decomposition followed in ozone successfully yielded fine particles with a high specific surface area of 20.0 m3/g (sample A). The fine particles were classified into further smaller particles with a unimodal size distribution and this process yielded a high specific surface area of 26.0 m3/g (sample B). These semiconducting powders were deposited on a sensor electrode by electrophoretic deposition (EPD) and tested on their sensing properties to VOCs. The sensors consisting of samples A and B both showed good responses to ethanol at 285 and 320 °C. The sensor with sample B showed extraordinarily good selectivity of ethanol for toluene at 320 °C. This could be because the detection film of sample B with moderately grown particles selectively reduced the reaction activity of toluene. The sensor with sample B also exhibited good selectivity of ethanol for hexane and dichloromethane.
- Open Access
Synthesis of Ce1−xPdxO2−δ Solid Solution in Molten Nitrate
CeO2-based solid solutions in which Pd partially substitutes for Ce attract considerable attention, owing to their high catalytic performances. In this study, the solid solution (Ce1−xPdxO2−δ) with a high Pd content (x ~ 0.2) was synthesized through co-precipitation under oxidative conditions using molten nitrate, and its structure and thermal decomposition were examined. The characteristics of the solid solution, such as the change in a lattice constant, inhibition of sintering, and ionic states, were examined using X-ray diffraction (XRD), scanning electron microscopy–energy-dispersive X-ray spectroscopy (SEM−EDS), transmission electron microscopy (TEM)−EDS, and X-ray photoelectron spectroscopy (XPS). The synthesis method proposed in this study appears suitable for the easy preparation of CeO2 solid solutions with a high Pd content.
Open AccessSynthesis of Ce1−xPdxO2−δ Solid Solution in Molten Nitrate
CeO2-based solid solutions in which Pd partially substitutes for Ce attract considerable attention, owing to their high catalytic performances. In this study, the solid solution (Ce1−xPdxO2−δ) with a high Pd content (x ~ 0.2) was synthesized through co-precipitation under oxidative conditions using molten nitrate, and its structure and thermal decomposition were examined. The characteristics of the solid solution, such as the change in a lattice constant, inhibition of sintering, and ionic states, were examined using X-ray diffraction (XRD), scanning electron microscopy–energy-dispersive X-ray spectroscopy (SEM−EDS), transmission electron microscopy (TEM)−EDS, and X-ray photoelectron spectroscopy (XPS). The synthesis method proposed in this study appears suitable for the easy preparation of CeO2 solid solutions with a high Pd content.
- 1 October 2013
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 187, 509-513
Development of ethanol and toluene sensing devices with a planar-type structure based on YSZ and modified Pt electrodes
- 1 October 2013
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 187, 509-513
Development of ethanol and toluene sensing devices with a planar-type structure based on YSZ and modified Pt electrodes
- 15 December 2008
- Published by Elsevier in Catalysis Today
- Vol. 139 (1-2) , 125-129
Effect of preparation routes on the catalytic activity over SmFeO3 oxide
- 15 December 2008
- Published by Elsevier in Catalysis Today
- Vol. 139 (1-2) , 125-129
Effect of preparation routes on the catalytic activity over SmFeO3 oxide
- 1 December 2008
- Published by American Scientific Publishers in Sensor Letters
- Vol. 6 (6) , 987-991
Sensor Performance of Oxygen Sensor with Pt/8YSZ/Pt Structures and Its Application to VOCs Detection
In the temperature below 500 °C, EMF of the O2 sensor with Pt/8YSZ/Pt structure exposed in un-contaminated air with VOCs was influenced by the surface morphology of 8YSZ(Zirconia) and electrode materials (Pt, Au). Also, the EMF was responded to the contaminated ppm-level's VOCs. At a constant oxygen concentration, 21%, the EMF was linearly increased to logarithm of VOCs concentration. The changes for VOCs contaminations of the EMF were enhanced by the over coating with Au layer on one side electrode with Pt. The ppm-level's VOCs resulted to decrease in the adsorbed oxygen density in electrode layer and also in the oxygen ion density on the triple point sites.
- 1 December 2008
- Published by American Scientific Publishers in Sensor Letters
- Vol. 6 (6) , 987-991
Sensor Performance of Oxygen Sensor with Pt/8YSZ/Pt Structures and Its Application to VOCs Detection
In the temperature below 500 °C, EMF of the O2 sensor with Pt/8YSZ/Pt structure exposed in un-contaminated air with VOCs was influenced by the surface morphology of 8YSZ(Zirconia) and electrode materials (Pt, Au). Also, the EMF was responded to the contaminated ppm-level's VOCs. At a constant oxygen concentration, 21%, the EMF was linearly increased to logarithm of VOCs concentration. The changes for VOCs contaminations of the EMF were enhanced by the over coating with Au layer on one side electrode with Pt. The ppm-level's VOCs resulted to decrease in the adsorbed oxygen density in electrode layer and also in the oxygen ion density on the triple point sites.