Robert Artinger
Research Subjects
Robert Artinger has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Jae-Il Kim
Forschungszentrum Karlsruhe, Institut für Nukleare Entsorgung, P.O. Box 3640, 76021 Karlsruhe, Germany
2 shared publications- Wolfram Schuessler
Forschungszentrum Karlsruhe, Institut für Nukleare Entsorgung, P.O. Box 3640, 76021 Karlsruhe, Germany
2 shared publications - Dieter Schild
Institute for Nuclear Waste Disposal (INE), Karlsruhe Institute of Technology (KIT), Hermann-von-Helmholtz-Platz 1, Eggenstein-Leopoldshafen 76344, Germany
1 shared publication Franz Scherbaum
Forschungszentrum Karlsruhe, Institut für Nukleare Entsorgung, P.O. Box 3640, 76021 Karlsruhe, Germany
1 shared publicationG Bernhard
1 shared publicationH Nitsche
1 shared publication
Latest Publications
- 10 October 2002
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 36 (22) , 4818-4823
241Am Migration in a Sandy Aquifer Studied by Long-Term Column Experiments
The migration behavior of 241Am(III) in a sandy aquifer was studied under near-natural conditions by long-term column experiments of more than 1 year duration. Columns with 50 cm length and 5 cm in diameter were packed with aeolian quartz sand and equilibrated with two different groundwaters having an original dissolved organic carbon concentration (DOC) of 1.1 and 7.2 mg·dm-3, respectively, from the Gorleben site (Lower Saxony, Germany). In each experiment, 1 cm3 of Am-spiked groundwater ([Am] = 0.2 to 2 μmol·dm-3) was injected into the column. The flow rate of the groundwater was adjusted to 0.28 m·d-1. A small colloid-borne Am fraction was found to elute together with tritiated water. After 414 and 559 days, respectively, the experiments were terminated. Whereas the nonsorbing tracer of tritiated water would have covered a distance of about 350 m in that time period, the maximum of the Am activity was detected between 32 and 40 mm column length. Applying selective dissolution analysis to the sand surface, Am was found to be preferentially bound to iron hydroxide/oxide sites. From this Am distribution, a retardation factor R of about 104 was determined and compared to static batch experiments. The Am breakthrough was calculated for the conditions of the column experiment.
- 10 October 2002
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 36 (22) , 4818-4823
241Am Migration in a Sandy Aquifer Studied by Long-Term Column Experiments
The migration behavior of 241Am(III) in a sandy aquifer was studied under near-natural conditions by long-term column experiments of more than 1 year duration. Columns with 50 cm length and 5 cm in diameter were packed with aeolian quartz sand and equilibrated with two different groundwaters having an original dissolved organic carbon concentration (DOC) of 1.1 and 7.2 mg·dm-3, respectively, from the Gorleben site (Lower Saxony, Germany). In each experiment, 1 cm3 of Am-spiked groundwater ([Am] = 0.2 to 2 μmol·dm-3) was injected into the column. The flow rate of the groundwater was adjusted to 0.28 m·d-1. A small colloid-borne Am fraction was found to elute together with tritiated water. After 414 and 559 days, respectively, the experiments were terminated. Whereas the nonsorbing tracer of tritiated water would have covered a distance of about 350 m in that time period, the maximum of the Am activity was detected between 32 and 40 mm column length. Applying selective dissolution analysis to the sand surface, Am was found to be preferentially bound to iron hydroxide/oxide sites. From this Am distribution, a retardation factor R of about 104 was determined and compared to static batch experiments. The Am breakthrough was calculated for the conditions of the column experiment.
- 18 September 2002
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 36 (20) , 4358-4363
A Kinetic Study of Am(III)/Humic Colloid Interactions
The interaction kinetics of the Am(III) ion with aquatic humic colloids is investigated under near-natural conditions by column experiments with a sandy aquifer sample rich in humic substances for the appraisal of the migration behavior of Am. The association and dissociation kinetics of the Am ion onto and from humic colloids control the migration of colloid-borne Am. As the contact time between Am and humic colloids prior to introduction into a column is increased, the mobility of colloid-borne Am is enhanced and hence the recovery of Am in the effluent increases. On the other hand, an increase of the migration time and residence time in column, respectively, reduces the Am recovery. Considering these experimental results a refined version of the kinetic model KICAM (Kinetically Controlled Availability Model), which suggests different Am binding modes with humic colloids, was developed. Applying KICAM it is possible to predict static and dynamic experiments affected by the kinetically controlled Am/humic colloid interactions over the range of 1 h up to several months. However, to apply these experimental results to long-term conditions, the Am binding scheme as proposed in KICAM needs to be verified. This paper provides, therefore, a basis for a better understanding of the colloid-borne Am migration in porous aquifer systems.
- 18 September 2002
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 36 (20) , 4358-4363
A Kinetic Study of Am(III)/Humic Colloid Interactions
The interaction kinetics of the Am(III) ion with aquatic humic colloids is investigated under near-natural conditions by column experiments with a sandy aquifer sample rich in humic substances for the appraisal of the migration behavior of Am. The association and dissociation kinetics of the Am ion onto and from humic colloids control the migration of colloid-borne Am. As the contact time between Am and humic colloids prior to introduction into a column is increased, the mobility of colloid-borne Am is enhanced and hence the recovery of Am in the effluent increases. On the other hand, an increase of the migration time and residence time in column, respectively, reduces the Am recovery. Considering these experimental results a refined version of the kinetic model KICAM (Kinetically Controlled Availability Model), which suggests different Am binding modes with humic colloids, was developed. Applying KICAM it is possible to predict static and dynamic experiments affected by the kinetically controlled Am/humic colloid interactions over the range of 1 h up to several months. However, to apply these experimental results to long-term conditions, the Am binding scheme as proposed in KICAM needs to be verified. This paper provides, therefore, a basis for a better understanding of the colloid-borne Am migration in porous aquifer systems.
- 1 September 2002
- Published by Elsevier in Journal of Contaminant Hydrology
- Vol. 58 (1-2) , 1-12
Humic colloid-borne migration of uranium in sand columns
- 1 September 2002
- Published by Elsevier in Journal of Contaminant Hydrology
- Vol. 58 (1-2) , 1-12
Humic colloid-borne migration of uranium in sand columns