Jianguo Long
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jianguo Long has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
D. E. Laughlin
Carnegie Mellon University Department of Material Science and Engineering Pittsburgh, Pennsylvania 15213, USA
3 shared publicationsM. E. McHenry
Carnegie Mellon University Department of Material Science and Engineering Pittsburgh, Pennsylvania 15213, USA
3 shared publicationsC. Zheng
Humboldt-Universität zu Berlin Institut für Physik D-12489 Berlin, Germany
1 shared publicationH. Kirmse
Humboldt-Universität zu Berlin Institut für Physik D-12489 Berlin, Germany
1 shared publication- Kazuhiro Hono
Research Center for Magnetic and Spintronics Materials, National Institute for Materials Science (NIMS), 1-2-1 Sengen, Tsukuba 305-0047, Japan
1 shared publication P. R. Ohodnicki
Carnegie Mellon University Materials Science and Engineering Pittsburgh, Pennsylvania 15213
1 shared publication
Latest Publications
- 24 January 2008
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 103 (7) , 07E710
Analysis of hysteretic behavior in a FeCoB-based nanocrystalline alloy by a Preisach distribution and electron holography
First order reverse curves have been used to investigate the Preisach distribution and electron holography to observe the spatial variation of the magnetization in Fe40Co40Nb4B13Ge2Cu1 nanocomposite alloys after annealing at 500, 550, 610, and 960°C for 1h. Grain sizes observed for these annealing temperatures varied from 10to200nm. The Preisach distribution reveals that the magnetization process in the sample annealed at 500°C for 1h was dominated by reversible processes, consistent with a small coercivity and mobile domain walls in an external field. At higher annealing temperatures, the irreversible magnetization processes became dominant with increasing grain size. Electron holography observations of the domains show that, for the sample annealed at 500°C, the magnetic flux distribution was uniform with few pinning barriers to domain wall motion consistent with reversible magnetization. The sample annealed at 610°C exhibited irregularity in the shape of magnetic flux lines attributed to the inhomogeneous magnetization distribution due to the α-FeCo and (FeCoNb)23B6 phases present after secondary crystallization.
- 24 January 2008
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 103 (7) , 07E710
Analysis of hysteretic behavior in a FeCoB-based nanocrystalline alloy by a Preisach distribution and electron holography
First order reverse curves have been used to investigate the Preisach distribution and electron holography to observe the spatial variation of the magnetization in Fe40Co40Nb4B13Ge2Cu1 nanocomposite alloys after annealing at 500, 550, 610, and 960°C for 1h. Grain sizes observed for these annealing temperatures varied from 10to200nm. The Preisach distribution reveals that the magnetization process in the sample annealed at 500°C for 1h was dominated by reversible processes, consistent with a small coercivity and mobile domain walls in an external field. At higher annealing temperatures, the irreversible magnetization processes became dominant with increasing grain size. Electron holography observations of the domains show that, for the sample annealed at 500°C, the magnetic flux distribution was uniform with few pinning barriers to domain wall motion consistent with reversible magnetization. The sample annealed at 610°C exhibited irregularity in the shape of magnetic flux lines attributed to the inhomogeneous magnetization distribution due to the α-FeCo and (FeCoNb)23B6 phases present after secondary crystallization.
- 23 January 2008
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 103 (7) , 07E708
Structural and soft magnetic properties of a new nanocrystalline Fe-based and B-free alloy
A new nanocrystalline Fe-based soft magnetic alloy is discussed here. Ingots of nanocrystalline alloys (FeCu)80ZrxSi20−x (x=5, 6, and 8) were prepared by arc melting. The ingots were remelted and cast into 25–30μm thick ribbons by a single roller melt spinning method. X-ray diffraction (XRD) revealed the as-spun ribbons to be amorphous. The structural evolution of these samples was studied by XRD and transmission electron microscopy (TEM) after annealing at 450, 480, and 550°C. XRD shows the primary nanocrystallization product to be the α-Fe(Si) phase. The grain size was observed by TEM to be ∼10nm after annealing at 480°C for 1h and 14nm after 550°C for 1h. ac soft magnetic properties were measured using a Walker AMH 401 ac permeameter. The core loss at an exciting frequency f=100kHz and maximum induction Bm=1kG was determined to be less than 19W∕kg.
- 23 January 2008
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 103 (7) , 07E708
Structural and soft magnetic properties of a new nanocrystalline Fe-based and B-free alloy
A new nanocrystalline Fe-based soft magnetic alloy is discussed here. Ingots of nanocrystalline alloys (FeCu)80ZrxSi20−x (x=5, 6, and 8) were prepared by arc melting. The ingots were remelted and cast into 25–30μm thick ribbons by a single roller melt spinning method. X-ray diffraction (XRD) revealed the as-spun ribbons to be amorphous. The structural evolution of these samples was studied by XRD and transmission electron microscopy (TEM) after annealing at 450, 480, and 550°C. XRD shows the primary nanocrystallization product to be the α-Fe(Si) phase. The grain size was observed by TEM to be ∼10nm after annealing at 480°C for 1h and 14nm after 550°C for 1h. ac soft magnetic properties were measured using a Walker AMH 401 ac permeameter. The core loss at an exciting frequency f=100kHz and maximum induction Bm=1kG was determined to be less than 19W∕kg.
- 1 May 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (9) , 09N114
Structural studies of secondary crystallization products of the Fe23B6-type in a nanocrystalline FeCoB-based alloy
A stable -type phase formed in a nanocomposite soft magnetic alloy after thermal treatment was investigated. The primary crystallization temperature and second crystallization temperature for this alloy were determined to be 405 and , respectively. After annealing the sample at for , a -type phase was observed. The structural information was investigated by x-ray diffraction, transmission electron microscopy, and three-dimensional atom probe. The -type phase contains about Fe, Co, Nb, and B. The Nb atoms tend to occupy the sites and atoms occupy the , , and sites of the space group for this structure.- 1 May 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 101 (9) , 09N114
Structural studies of secondary crystallization products of the Fe23B6-type in a nanocrystalline FeCoB-based alloy
A stable -type phase formed in a nanocomposite soft magnetic alloy after thermal treatment was investigated. The primary crystallization temperature and second crystallization temperature for this alloy were determined to be 405 and , respectively. After annealing the sample at for , a -type phase was observed. The structural information was investigated by x-ray diffraction, transmission electron microscopy, and three-dimensional atom probe. The -type phase contains about Fe, Co, Nb, and B. The Nb atoms tend to occupy the sites and atoms occupy the , , and sites of the space group for this structure.