SCShoude Chang

Shoude Chang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shoude Chang has a total of 17 co-authors. Here are the top co-authors by number of shared publications:

  • Costel Flueraru

    National Research Council Canada (Canada)

    9 shared publications
  • Youxin Mao

    Institute for Microstructural Sciences, National Research Council Canada, 1200 Montreal Road, Ottawa, Ontario K1A 0R6, Canada

    9 shared publications
  • Chander P. Grover

    The authors are with the Optics Group, Institute for National Measurement Standards, National Research Council, Canada, Building M-36, Montreal Road Campus, Ottawa, Ontario K1A 0R6, Canada. S. Chang’s address is

    5 shared publications
  • Xianyang Cai

    National Research Council Canada

    4 shared publications
  • Costel Flueraru

    Institute for Microstructural Sciences, National Research Council Canada, 1200 Montreal Road, Ottawa, Ontario K1A 0R6, Canada

    3 shared publications
  • Erroll Murdock

    Institute for Microstructural Sciences, National Research Council Canada, 1200 Montreal Road, Ottawa, Ontario K1A 0R6, Canada

    3 shared publications

Latest Publications

  • Stationary-fiber rotary probe with unobstructed 360° view for optical coherence tomography.

    by Shoude Chang, Erroll Murdock, Youxin Mao, Costel Flueraru, John Disano

    A side-scanning fiber probe is a critical component for optical coherence tomography in medical imaging and diagnosis. We propose and fabricate an on-axis rotating probe that performs in situ, circumferential scanning that is shadow-free (not susceptible to shadow effects caused by the motor’s wires). A miniature motor that incorporates a bored-out shaft for the optical fiber is located at the distal end of the probe, which results in a more stable and uniform circumferential scan, free from wire-shadow interference effects. More importantly, this design, novel to our knowledge, compared to other probes avoids the insertion losses introduced by optical coupling components and the multitude of optical interfaces, which is very important for sensing weak signals backscattered from structures deep in the tissue.


  • Images of arterial tissues using catheter swept source optical coherence tomography

    by Youxin Mao, Costel Flueraru, Shoude Chang, Dan P. Popescu, M. G. Sowa

    Optical coherence tomography images of arterial samples harvested from asymptomatic pigs and from lipid-rich Watanabe heritable hyperlipidemic rabbits were acquired using a fiber catheter-based swept-source optical coherence tomography system (OCT). A quadrature Mach-Zehnder interferometer based on multi-port fiber couplers and a semiconductor optical amplifier (SOA) were employed in the swept-source optical coherence tomography system. The improvement of signal to noise ratio as a result of incorporating the SOA into the configuration translated in an increase of the penetration depth. A fiber probe ending in a fiber ball lens was developed for the arterial imaging. The images acquired by this system offer the possibility to investigate anatomical details located under the surface of the artery such as the intima, media, and adventitia layers (from lumen side) of the blood vessel wall , as well as morphological features specific to artherosclerotic plaques such as lipid pools, fibrous caps, macrophage accumulations and calcified. This report indicates that our improved catheter-based swept source OCT is a potential tool for in vivo intravascular imaging.

  • Detection and analysis of jade material using optical coherence tomography

    by Shoude Chang, Youxin Mao, Guangming Chang, Costel Flueraru

    Jade is a type of rare and expensive stone. The current approaches for jade exploration and processing are blindly and wasteful. Capable of performing high resolution, cross-sectional sensing of the internal structure of materials, Optical Coherence Tomography (OCT) could be used to greatly facilitate these jade procedures. By detecting the signal intensity and analysing the internal texture, OCT system can indicate if the jade exists and what the type it could be. It provides a tool to guide the artist in designing and making the jade artworks. It also can be used for discrimination of the fake antique jade wares, as well as anti-counterfeiters on the jade market. In this paper, we present how a Swept-Source OCT system to detect and analysis the internal features of jades. Algorithms for feature extraction and classification are described and experimental results with various unearthed jades are demonstrated.


  • Wavelength probing optical coherence tomography

    by Shoude Chang, Youxin Mao, Costel Flueraru

  • Attenuation compensation for optical coherence tomography imaging

    by Shoude Chang, Costel Flueraru, Youxin Mao, Sherif Sherif


  • New optical instruments for coherence tomography

    by Youxin Mao, Shoude Chang, Costel Flueraru

    We present the following novel technologies for optical coherence tomography developed in Institute for Microstructural Sciences, National Research Council Canada. We first demonstrate a high power mode-lock wavelength swept laser using a polygon-based narrowband optical scanning filter first. Peak and average output powers of 98 mW and 71 mW have been achieved, respectively, without an external amplifier, while the wavelength was swept continuously from 1247 nm to 1360 nm. Then, we present a design, construction and characterization of ultra-small OCT probes using fiber lenses. Those fiber lens modules are made of a single mode fiber and a GRIN or ball fiber lens with or without a fiber spacer between them. The lens diameters are smaller than 0.3 mm. We discuss theoretical models, design methods, fabrication techniques, and measured performance compared with modeling results. Finally, we demonstrate an instantaneous complex conjugate resolved swept-source OCT using a 3x3 Mach-Zehnder interferometer. The interferometer provides simultaneous access to complementary phase components of the complex interferometric signals; therefore, the effective imaging depth was doubled. The complex conjugate artifact suppression of 27 dB was obtained. OCT Images of human nail and animal tissue are presented.

  • Quantitative analysis of arterial tissue with optical coherence tomography

    by Costel Flueraru, Dan P. Popescu, Youxin Mao, Shoude Chang, Michael G. Sowa

    Tissue morphology, light attenuation and texture are analyzed from images acquired by swept-source Fourier-domain optical coherence tomography from arterial samples. The data were corrected for the effect of the confocal point spread function and were analyzed using the single scattering model.

  • Fiber probes used in optical coherence tomography

    by Youxin Mao, Shoude Chang, Sherif Sherif, Costel Flueraru

    Quality and parameters of probing optical beams are extremely important in optical coherence tomography (OCT) systems both for image quality and light coupling efficiency considerations. For example, the shape, size, focal position, and focal range of such beams could have a great impact on the lateral resolution, penetration depth, and signal-to-noise ratio of the image. We present a design, construction and characterization of different variations of GRIN and ball fiber lenses, for ultra-small OCT probes. Those fiber probes are made of a single mode fiber and a GRIN or ball fiber lens with or without a fiber spacer between them. The probe diameters are smaller than 0.3 mm. We discuss design methods, fabrication techniques, and measured performance compared with modeling results. We demonstrate swept-source OCT images with different fiber probes.

  • Full-field optical coherence tomography used for security and document identity

    by Shoude Chang, Youxin Mao, Sherif Sherif, Costel Flueraru

    The optical coherence tomography (OCT) is an emerging technology for high-resolution cross-sectional imaging of 3D structures. In the past years, OCT systems have been used mainly for medical, especially ophthalmological diagnostics. Concerning the nature of OCT system being capable to explore the internal features of an object, we apply the OCT technology to directly retrieve the 2D information pre-stored in a multiple-layer information carrier. The standard depth-resolution of an OCT system is at micrometer level. If a 20mm by 20mm sampling area with a 1024 x 1024 CCD array is used in the OCT system having 10 μm, an information carrier having a volume of 20mm x 20mm x 2mm could contain 200 Mega-pixel images. Because of its tiny size and large information volume, the information carrier, with its OCT retrieving system, will have potential applications in documents security and object identification. In addition, as the information carrier can be made by low-scattering transparent material, the signal/noise ratio will be improved dramatically. As a consequence, the specific hardware and complicated software can also be greatly simplified. Owing to non-scanning along X-Y axis, the full-field OCT could be the simplest and most economic imaging system for extracting information from such a multilayer information carrier. In this paper, deign and implementation of a full-field OCT system is described and the related algorithms are introduced. In our experiments, a four layers information carrier is used, which contains 4 layers of image pattern, two text images and two fingerprint images. The extracted tomography images of each layer are also provided.