GPGeorge Postma

George Postma

*This is an algorithmically generated author record based on publicly available information.

George Postma has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Modelling the Preservation of Sedimentary Deposits on Passive Continental Margins during Glacial–Interglacial Cycles

    by Xander D. Meijer, George Postma, Peter A. Burrough, Poppe L. de Boer

  • Sediment transport in analogue flume models compared with real‐world sedimentary systems: a new look at scaling evolution of sedimentary systems in a flume

    by G. Postma, M. G. Kleinhans, P. Th. Meijer, J. T. Eggenhuisen

    Evolution of sedimentary systems at large temporal and spatial scales cannot be scaled down to laboratory dimensions by conventional hydraulic Froude scaling. Therefore, many researchers question the validity of experiments aiming to simulate this evolution. Yet, it has been shown that laboratory experiments yield stratigraphic responses to allocyclic forcing that are remarkably similar to those in real‐world prototypes, hinting at scale independency with strong dependence on boundary conditions but weak dependence on the actual sediment transport dynamics. This paper addresses the dilemma by contrasting sediment transport rules that apply in the laboratory with those that apply in real‐world geological systems. It is demonstrated that the generation of two‐dimensional stratigraphy in a flume can be simulated numerically by the non‐linear diffusion equation. Sediment transport theory is used to demonstrate that only suspension‐dominated meandering rivers should be simulated with linear diffusion. With increasing grain‐size (coarse sand to gravel) and shallowness of river systems, the prediction of long‐term transport must be simulated by non‐linear, slope‐dependent diffusion to allow for increasing transport rates and thus change in stratigraphic style. To point out these differences in stratigraphic style, three stages in infill of accommodation have been defined here: (i) a start‐up stage, when the system is prograding to base level (e.g. the shelf edge) with no sediment flux beyond the base‐level point; (ii) a fill‐up stage, when the system is further aggrading while progressively more sediment is bypassing base level with the progression of the infill; and (iii) a keep‐up stage, when more than 90% of the input is bypassing the base level and less than 10% is used for filling the accommodation. By plotting the rate of change in flux for various degrees of non‐linearity (varying the exponent in the diffusion equation) it was found that the error between model and real‐world prototype is largest for the suspension‐dominated prototypes, although never more than 30% and only at the beginning of the fill‐up stage. The error reduces to only 10% for the non‐linear sandy‐gravelly and gravelly systems. These results are very encouraging and open up ways to calibrate numerical models of sedimentary system evolution by such experiments.


  • Angle of repose

    by Paul D. Komar, Gerard V. Middleton, Harold G. Reading, George Postma, Wolf Uwe Reimold, Sadoon Morad, Burghard W. Flemming, Morten Pejrup, Andres Aslan, Victor R. Baker, et al.

  • Control of Syndepositional Faulting on Systems Tract Evolution Across Growth-Faulted Shelf Margins: An Analog Experimental Model of the Miocene Imo River Field, Nigeria

    by Max W. I. M. van Heijst, George Postma, Wessel P. van Kesteren, Ruud G. de Jongh

    The presence of growth faults on shelf-margin deltas complicates the sequence-stratigraphic interpretation of deltaic successions. This article describes an analog modeling study of a growth-faulted shelf-margin delta. The aim of the project was to obtain a better understanding of the depositional architecture on a systems tract scale on both sides of the growth fault and to evaluate possible hydrocarbon-trapping configurations in such successions. The analog flume experiment incorporated the combined effect of growth faulting, regional subsidence, and eustasy on hanging-wall and footwall blocks. Experimental variables were based on seismic and well data of the Imo River field in the Niger Delta, which was used as a prototype to calibrate the experimental results. The spatial scale of the model, in conjunction with the supply rate, result in a time scaling that models basin-fill processes that operated over more than 5 m.y. in 90 hr of experiment. Digital topography scans, required for the determination of the bulk sediment transport, were made of the landscape at preset time intervals. The resultant experimental sedimentary successions on both sides of the growth-faulted shelf margin were sliced and correlated across the fault. The results first were compared to the Imo River field prototype and subsequently to examples from the Gulf Coast and to extensional basin settings. These comparisons led to the formulation of a conceptual sequence model for growth-faulted margins that relates the systems tract distribution on each side of the fault to eustasy. The hanging-wall succession is composed of falling stage, lowstand, and early transgressive deposits. The footwall succession, in contrast, is characterized by late transgressive, incised valley-fill, and highstand deposits. The conceptual sequence model provides useful analogs for common and several alternative hydrocarbon-trapping configurations in growth-faulted settings.


  • Quantitative analogue flume‐model study of river–shelf systems: principles and verification exemplified by the Late Quaternary Colorado river–delta evolution

    by Van Heijst, M. W. I. M., G. Postma, X. D. Meijer, J. N. Snow, J. B. Anderson

    Physical modelling of clastic sedimentary systems over geological time spans has to resort to analogue modelling since full scaling cannot be achieved within the spatial and temporal restrictions that are imposed by a laboratory set‐up. Such analogue models are suitable for systematic investigation of a sedimentary system's sensitivity to allocyclic changes by isolating governing parameters. Until now, analogue models of landscape evolution were mainly qualitative in nature. In this paper, we present a quantitative approach. The quantitative experimental results are verified and discussed by comparison with high‐resolution data from the Colorado river–shelf system of the Texas shelf that we used as a prototype.The model's dimensions are proportionally scaled to the prototype, except for a vertical exaggeration. Time is scaled using a Basin Response factor to maintain a similar ratio between the period of change and the system's equilibrium time for model and prototype. A Basin Fill factor was used to compare the ratio between the time‐averaged sedimentation rate and the rate of change in accommodation space of model and prototype. The flume‐model results are in the form of sediment budgets that are related to shelf cannibalism and fluvial supply, which are compared with the ancestral Colorado river–delta evolution of the last 40 kyr.Model and prototype have similarities in delta evolution in response to one cycle of sea‐level change. With sea‐level change as the isolated variable, the flume model generates a significant supply pulse caused by headward erosion of the shelf in response to the sea‐level fall. This pulse adds to the yield of the hinterland. The supply induced by sea‐level change persists during the early rise, although its rate declines. A similar trend is observed on the east Texas shelf. We argue that shelfal and fluvial degradation cycles induced by sea‐level changes can significantly influence the timing and amount of sediment supply to basins and must therefore be taken into consideration.


  • Fluvial response to sea‐level changes: a quantitative analogue, experimental approach

    by Van Heijst, M. W. I. M., G. Postma

    Quantitative evaluation of fluvial response to allogenic controls is crucial for further progress in understanding the stratigraphic record in terms of processes that control landscape evolution. For instance, without quantitative insight into time lags that are known to exist between sea‐level change and fluvial response, there is no way to relate fluvial stratigraphy to the sea‐level curve. It is difficult to put firm constraints on these time‐lag relationships on the basis of empirical studies. Therefore, we have started to quantify time‐averaged erosion and deposition in the fluvial and offshore realms in response to sea‐level change by means of analogue modelling in a 4 × 8‐m flume tank. The rate of sea‐level change was chosen as an independent variable, with other factors such as sediment supply, discharge and initial geometry kept constant over the course of 18 experiments. Our experimental results support the common view that neither fall nor rise in sea level affects the upstream fluvial system instantaneously. An important cause for the delayed fluvial response is that a certain amount of time is required to connect initial incisions on the newly emergent shelf (canyons) with the fluvial valley. Lowering of the fluvial longitudinal profile starts only after the connection of an active shelf canyon with the fluvial valley; until that moment the profile remains steady. We quantified the process of connection and introduced the quantity ‘connection rate’. It controlled, in conjunction with the rate of sea‐level fall: (1) the amount of fluvial degradation during sea‐level fall; (2) the total sediment volume that bypasses the shelf edge; (3) the percentage of fluvial relative to shelf sediment in the lowstand delta; (4) the volume of the transgressive systems tract and (5) the amount of diachroneity along the sequence boundary. Our experiments demonstrate also that the sequence‐stratigraphic concept is difficult to apply to continental successions, even when these successions have been deposited within the influence of sea level.