Andrew C Smith
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Andrew C Smith has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
- Keith W. Waldron
The Biorefinery Centre, Quadram Institute Bioscience, Norwich Research Park, Colney, Norwich, NR4 7UA, UK
3 shared publications A. M. Donald
Cambridge University, Cavendish Laboratory, Madingley Road, Cambridge CB3 0HE, UK
1 shared publicationA.H. Karlsson
Department of Food Science, Danish Institute of Agricultural Sciences, DK-8830 Tjele, Denmark, Tel: +045 89 99 19 00, Fax: +045 89 99 15 64
1 shared publication- Anette Kistrup Thybo
Department of Food Science Faculty of Science and Technology Aarhus University Kirstinebjergvej 10 DK‐5792 Aarslev Denmark
1 shared publication B.A. Marchylo
1 shared publicationC. Boeriu
1 shared publication
Latest Publications
- 20 March 2007
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 87 (6) , 1123-1131
Effect of calcium chloride on mechanical properties and microbiological characteristics of cv. Conservolea naturally black olives fermented at different sodium chloride levels
The effect of calcium chloride (CaCl2)(5 gL−1) and sodium chloride (NaCl) concentration (40, 60 and 8 gL−1) on the microbiological and mechanical properties of naturally black olives of cv. Conservolea in brines was studied. In 40 and 60 g L−1 brines the growth of lactic acid bacteria was favoured over that of yeasts, resulting in rather complete lactic acid fermentation as indicated by high free acidity (9.8–11.5 g lactic acid L−1) and low pH (3.7–3.8). At 80 g L−1 brine, yeasts were the dominant members of the microflora, rendering a product with lower acidity (8 g lactic acid L−1) and higher pH (4.3–4.5). In the presence of CaCl2 there was a consistent increase in the depth of the peripheral region in which cell wall breakage occurred. When cells separated, perforated walls were observed at sites associated with plasmodesmata. The flesh was strongest and stiffest when CaCl2 was added to olives treated with 40 g L−1 brine, consistent with cell wall breakage being the predominant mode of failure. The only observed effect on the mechanical properties of the skin was a stiffening at 60 g L−1 brine on addition of CaCl2. Copyright © 2007 Society of Chemical Industry
- 20 March 2007
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 87 (6) , 1123-1131
Effect of calcium chloride on mechanical properties and microbiological characteristics of cv. Conservolea naturally black olives fermented at different sodium chloride levels
The effect of calcium chloride (CaCl2)(5 gL−1) and sodium chloride (NaCl) concentration (40, 60 and 8 gL−1) on the microbiological and mechanical properties of naturally black olives of cv. Conservolea in brines was studied. In 40 and 60 g L−1 brines the growth of lactic acid bacteria was favoured over that of yeasts, resulting in rather complete lactic acid fermentation as indicated by high free acidity (9.8–11.5 g lactic acid L−1) and low pH (3.7–3.8). At 80 g L−1 brine, yeasts were the dominant members of the microflora, rendering a product with lower acidity (8 g lactic acid L−1) and higher pH (4.3–4.5). In the presence of CaCl2 there was a consistent increase in the depth of the peripheral region in which cell wall breakage occurred. When cells separated, perforated walls were observed at sites associated with plasmodesmata. The flesh was strongest and stiffest when CaCl2 was added to olives treated with 40 g L−1 brine, consistent with cell wall breakage being the predominant mode of failure. The only observed effect on the mechanical properties of the skin was a stiffening at 60 g L−1 brine on addition of CaCl2. Copyright © 2007 Society of Chemical Industry
- 28 November 2005
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 86 (4) , 623-633
The use of image analysis in observing mechanically deforming notched and un‐notched onion epidermal cellular structures
- 28 November 2005
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 86 (4) , 623-633
The use of image analysis in observing mechanically deforming notched and un‐notched onion epidermal cellular structures
- 1 March 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (5) , 1101-1104
The mechanical properties of lettuce: A comparison of some agronomic and postharvest effects
- 1 March 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (5) , 1101-1104
The mechanical properties of lettuce: A comparison of some agronomic and postharvest effects
- 30 July 2004
- Published by Elsevier in Thermochimica Acta
- Vol. 417 (2) , 245-249
The role of mannitol in affecting the thermal transitions in carrot tissue
- 30 July 2004
- Published by Elsevier in Thermochimica Acta
- Vol. 417 (2) , 245-249
The role of mannitol in affecting the thermal transitions in carrot tissue
- 1 January 2004
- Published by Elsevier
Contributor contact details
- Open Access
- 9 May 2003
- Published by Oxford University Press (OUP) in Annals of Botany
- Vol. 92 (1) , 73-77
Fracture of Plant Tissues and Walls as Visualized by Environmental Scanning Electron Microscopy
The environmental scanning electron microscope (ESEM) provides a highly relevant and controllable environment in which to study hydrated systems without the artefacts of other highly prepared specimens. The instrument facilitates control of turgor through hydration using different chamber vapour pressures. Deformation of a simple plant tissue—upper epidermal layers in Allium cepa (onion)—was observed at the scale of the two principal failure mechanisms: cell breakage; and cell separation induced by treatment with a chelating agent. Cell rupture and release of contents occurred at cellular junctions ahead of an imposed growing notch, indicating that disruption of cells occurred remotely from the creation of a new surface. Cells that separated usually maintained their turgor and the separation process took place through progressive failure of middle lamellar material seen as strands between separating cells. These mechanisms were compared with the rupture of excised Chara corallina walls that occurred by formation and breakage of strands between separating wall layers. This study provides in situ visual characterization of wall rupture and cell separation at the microscopic level in hydrated plant material.
- 9 May 2003
- Published by Oxford University Press (OUP) in Annals of Botany
- Vol. 92 (1) , 73-77
Open AccessFracture of Plant Tissues and Walls as Visualized by Environmental Scanning Electron Microscopy
The environmental scanning electron microscope (ESEM) provides a highly relevant and controllable environment in which to study hydrated systems without the artefacts of other highly prepared specimens. The instrument facilitates control of turgor through hydration using different chamber vapour pressures. Deformation of a simple plant tissue—upper epidermal layers in Allium cepa (onion)—was observed at the scale of the two principal failure mechanisms: cell breakage; and cell separation induced by treatment with a chelating agent. Cell rupture and release of contents occurred at cellular junctions ahead of an imposed growing notch, indicating that disruption of cells occurred remotely from the creation of a new surface. Cells that separated usually maintained their turgor and the separation process took place through progressive failure of middle lamellar material seen as strands between separating cells. These mechanisms were compared with the rupture of excised Chara corallina walls that occurred by formation and breakage of strands between separating wall layers. This study provides in situ visual characterization of wall rupture and cell separation at the microscopic level in hydrated plant material.
- 30 January 2001
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 81 (4) , 448-454
Effect of ripening on the mechanical properties of Portuguese and Spanish varieties of olive (Olea europaeaL)
- 30 January 2001
- Published by Wiley in Journal of the Science of Food and Agriculture
- Vol. 81 (4) , 448-454
Effect of ripening on the mechanical properties of Portuguese and Spanish varieties of olive (Olea europaeaL)
- 1 April 1999
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 74 (4) , 376
The use of onion waste as a raw material for functional foods
- 1 April 1999
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 74 (4) , 376
The use of onion waste as a raw material for functional foods
- 15 May 1998
- Published by Wiley in Cereal Chemistry
- Vol. 75 (3) , 325-330
Physical Properties of Extruded Wheat Starch‐Additive Mixtures
The effects of the addition of fatty acids, monoglycerides (MG), and wheat germ oil (WGO) on the level of crystallinity and the crystalline structure of extrusion‐cooked wheat starch have been studied using twin‐screw extruders. Measurements of water solubility and water absorption indices were made on the extrudates, together with specific mechanical energy (SME) consumption and die pressure for the extruder. MG and the fatty acids added to a level of 4% caused an increase in Vhydrate type crystallinity. WGO addition to a level of 8% caused no change in crystallinity, although the Ehydrate type was favored at lower moisture contents. All additives caused a decrease in SME and an increase or maximum in die pressure. WGO behaved differently than MG and fatty acids in that its addition caused the water solubility index and expansion to increase, as previously observed for other oils added to flours.
- 15 May 1998
- Published by Wiley in Cereal Chemistry
- Vol. 75 (3) , 325-330
Physical Properties of Extruded Wheat Starch‐Additive Mixtures
The effects of the addition of fatty acids, monoglycerides (MG), and wheat germ oil (WGO) on the level of crystallinity and the crystalline structure of extrusion‐cooked wheat starch have been studied using twin‐screw extruders. Measurements of water solubility and water absorption indices were made on the extrudates, together with specific mechanical energy (SME) consumption and die pressure for the extruder. MG and the fatty acids added to a level of 4% caused an increase in Vhydrate type crystallinity. WGO addition to a level of 8% caused no change in crystallinity, although the Ehydrate type was favored at lower moisture contents. All additives caused a decrease in SME and an increase or maximum in die pressure. WGO behaved differently than MG and fatty acids in that its addition caused the water solubility index and expansion to increase, as previously observed for other oils added to flours.