Julia Y. Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Julia Y. Lu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
William H. Schroeder
Meteorological Service of Canada
3 shared publicationsXinbin Feng
Department of Chemistry, Biology and Chemical Engineering, Ryerson University, 350 Victoria Street, Toronto, ON M5B 2 K3, Canada
2 shared publicationsYingjie Hao
Ryerson University
2 shared publicationsAhmed Al Hejami
Department of Chemistry and Biology, Ryerson University, 350 Victoria Street, Toronto, Ontario M5B 2K3, Canada
1 shared publicationCatharine M. Banic
Meteorological Service of Canada
1 shared publicationCathy Banic
Meteorological Service of Canada, Environment Canada, Ontario M3H 5T4, Canada
1 shared publication
Latest Publications
- 1 February 2020
- Published by Elsevier in Science of The Total Environment
- Vol. 703, 134895
Heavy metals in indoor settled dusts in Toronto, Canada
- 1 February 2020
- Published by Elsevier in Science of The Total Environment
- Vol. 703, 134895
Heavy metals in indoor settled dusts in Toronto, Canada
- 7 January 2009
- Published by Royal Society of Chemistry (RSC) in Journal of Environmental Monitoring
- Vol. 11 (3) , 660-669
Annual atmospheric mercury species in Downtown Toronto, Canada
Real-time concentrations of atmospheric gaseous elemental mercury (GEM), reactive gaseous mercury (RGM), and mercury associated with particles having sizes −3 (99.2%), 21.5 ± 16.4 pg m−3 (0.5%) and 14.2 ± 13.2 pg m−3 (0.3%), respectively. The concentrations for all the measured Hg species were highly variable throughout the year and were lower in winter than in the other three seasons. The maximum concentrations of Hg species were observed in June and were a result of the high number of Hg spikes (using [GEM] >10 ng m−3 as an indicator) that occurred in the month. Nighttime (between 9pm–6am) concentrations of Hg species were higher than those of daytime. The results revealed: (1) an urban area is a continuous source of Hg species that have the potential to pose impacts on local, regional and global scales; (2) local/regional anthropogenic sources contributed significantly to the levels and the distributions of the Hg species in the urban atmosphere. More studies are needed to identify and quantify the anthropogenic sources of Hg and the Hg species emitted from these sources; (3) surface emission and photochemical reactions (including the reactions involving ozone) did not have significant influence on the levels of Hg species and their distribution in the urban atmosphere.
- 7 January 2009
- Published by Royal Society of Chemistry (RSC) in Journal of Environmental Monitoring
- Vol. 11 (3) , 660-669
Annual atmospheric mercury species in Downtown Toronto, Canada
Real-time concentrations of atmospheric gaseous elemental mercury (GEM), reactive gaseous mercury (RGM), and mercury associated with particles having sizes −3 (99.2%), 21.5 ± 16.4 pg m−3 (0.5%) and 14.2 ± 13.2 pg m−3 (0.3%), respectively. The concentrations for all the measured Hg species were highly variable throughout the year and were lower in winter than in the other three seasons. The maximum concentrations of Hg species were observed in June and were a result of the high number of Hg spikes (using [GEM] >10 ng m−3 as an indicator) that occurred in the month. Nighttime (between 9pm–6am) concentrations of Hg species were higher than those of daytime. The results revealed: (1) an urban area is a continuous source of Hg species that have the potential to pose impacts on local, regional and global scales; (2) local/regional anthropogenic sources contributed significantly to the levels and the distributions of the Hg species in the urban atmosphere. More studies are needed to identify and quantify the anthropogenic sources of Hg and the Hg species emitted from these sources; (3) surface emission and photochemical reactions (including the reactions involving ozone) did not have significant influence on the levels of Hg species and their distribution in the urban atmosphere.
- 31 May 2008
- Published by Elsevier in Environmental Pollution
- Vol. 153 (2) , 342-350
Effects of modern and ancient human activities on mercury in the environment in Xi'an area, Shannxi Province, P.R. China
- 31 May 2008
- Published by Elsevier in Environmental Pollution
- Vol. 153 (2) , 342-350
Effects of modern and ancient human activities on mercury in the environment in Xi'an area, Shannxi Province, P.R. China
- 25 September 2004
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 380 (4) , 683-689
Analysis of inorganic mercury species associated with airborne particulate matter/aerosols: method development
This paper describes a method for speciation of Hg associated with airborne particulate matter. This method uses a mini-sampler for sample collection and analysis, thermal desorption for separating Hg species, and inductively coupled plasma mass spectrometry (ICP–MS) for identification and quantification of Hg. Coal fly ash spiked with different Hg compounds (e.g. Hg0, HgCl2, HgO, and HgS) was used for qualitative calibration. A standard reference material with a certified value for Hg concentration was used to evaluate the method. When the temperature of the furnace was programmed at a linear rate of increase of 50° min−1, different Hg compounds could clearly be separated. Three airborne particulate matter samples were collected in parallel in Toronto, ON, Canada and analyzed using this method. Reproducible results were obtained and Hg0, HgCl2, HgO, and HgS species from these samples were detected.
- 25 September 2004
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 380 (4) , 683-689
Analysis of inorganic mercury species associated with airborne particulate matter/aerosols: method development
This paper describes a method for speciation of Hg associated with airborne particulate matter. This method uses a mini-sampler for sample collection and analysis, thermal desorption for separating Hg species, and inductively coupled plasma mass spectrometry (ICP–MS) for identification and quantification of Hg. Coal fly ash spiked with different Hg compounds (e.g. Hg0, HgCl2, HgO, and HgS) was used for qualitative calibration. A standard reference material with a certified value for Hg concentration was used to evaluate the method. When the temperature of the furnace was programmed at a linear rate of increase of 50° min−1, different Hg compounds could clearly be separated. Three airborne particulate matter samples were collected in parallel in Toronto, ON, Canada and analyzed using this method. Reproducible results were obtained and Hg0, HgCl2, HgO, and HgS species from these samples were detected.
- Open Access
- 1 July 2004
- Published by Stockholm University Press in Tellus B: Chemical and Physical Meteorology
- Vol. 56 (3) , 213-222
Annual time-series of total filterable atmospheric mercury concentrations in the Arctic
Total atmospheric mercury (TAM) is operationally defined as the sum of gaseous elemental mercury (GEM), gaseous oxidized inorganic mercury (GOIM), which is also called reactive gaseous mercury (RGM...
- 1 July 2004
- Published by Stockholm University Press in Tellus B: Chemical and Physical Meteorology
- Vol. 56 (3) , 213-222
Open AccessAnnual time-series of total filterable atmospheric mercury concentrations in the Arctic
Total atmospheric mercury (TAM) is operationally defined as the sum of gaseous elemental mercury (GEM), gaseous oxidized inorganic mercury (GOIM), which is also called reactive gaseous mercury (RGM...
- 1 August 2003
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 376 (7) , 1137-1140
Evaluation and applications of a gaseous mercuric chloride source
In this study, a diffusion-type device for generating gaseous mercuric chloride (HgCl2) was systematically evaluated and applied to validate the annular denuder method for sampling gaseous HgCl2 species in a synthetic gas stream. The results show that it takes at least 48 h for the system to reach a steady-state condition after the diffusion cell reaches the temperature set-point and the carrier gas is activated. The primary Hg species from the source was proven to be HgCl2. In the temperature range from −5.00 to 11.80 °C, the Hg emission rates from the source vary from 1.8 to 14.2 pg min−1. It is shown that, under the experimental conditions examined, KCl-coated annular quartz denuders designed for ambient reactive gaseous mercury (RGM) collection could quantitatively collect HgCl2. It is also demonstrated that the impactors used to remove coarse airborne particulate matter could lead to a loss of up to one third of the HgCl2 in the gas stream.
- 1 August 2003
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 376 (7) , 1137-1140
Evaluation and applications of a gaseous mercuric chloride source
In this study, a diffusion-type device for generating gaseous mercuric chloride (HgCl2) was systematically evaluated and applied to validate the annular denuder method for sampling gaseous HgCl2 species in a synthetic gas stream. The results show that it takes at least 48 h for the system to reach a steady-state condition after the diffusion cell reaches the temperature set-point and the carrier gas is activated. The primary Hg species from the source was proven to be HgCl2. In the temperature range from −5.00 to 11.80 °C, the Hg emission rates from the source vary from 1.8 to 14.2 pg min−1. It is shown that, under the experimental conditions examined, KCl-coated annular quartz denuders designed for ambient reactive gaseous mercury (RGM) collection could quantitatively collect HgCl2. It is also demonstrated that the impactors used to remove coarse airborne particulate matter could lead to a loss of up to one third of the HgCl2 in the gas stream.