John Abraham
Research Subjects
John Abraham has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Vinicio Magi
Dipartimento di Ingegneria, Università degli Studi della Basilicata, 85100 Potenza, Italy
3 shared publications - Anupam Tiwari
Purdue University
1 shared publication Harinath Reddy
School of Mechanical Engineering, Purdue University, West Lafayette, IN, USA
1 shared publication- Kannan N. Premnath
Department of Mechanical Engineering University of Wyoming 82071 Laramie WY
1 shared publication Mohamed Sayeed
Computing Research Institute, Purdue University , West Lafayette, Indiana, USA
1 shared publicationMuhsin M. Ameen
School of Mechanical Engineering, Purdue University, West Lafayette, IN, USA
1 shared publication
Latest Publications
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 138, 403-413
An evaluation of the assumptions of the flamelet model for diesel combustion modeling
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 138, 403-413
An evaluation of the assumptions of the flamelet model for diesel combustion modeling
- 23 September 2015
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 69 (1) , 1-13
Are “2D DNS” results of turbulent fuel/air mixing layers useful for assessing subgrid-scale models?
Direct Numerical Simulations (DNS) are frequently used to evaluate subgrid-scale models, but for practical flows full three-dimensional (3D) DNS is often computationally infeasible. It is a common practice to employ two-dimensional (2D) DNS, but since turbulence is inherently a three-dimensional phenomenon, the validity of this approach is questionable. In this study, we compare the evolution of a turbulent fuel/air mixing layer employing 3D and 2D DNS. While there are significant differences in detail, it is shown that employing either set of results leads to the same conclusion about the superiority of one subgrid-scale model over another.
- 23 September 2015
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 69 (1) , 1-13
Are “2D DNS” results of turbulent fuel/air mixing layers useful for assessing subgrid-scale models?
Direct Numerical Simulations (DNS) are frequently used to evaluate subgrid-scale models, but for practical flows full three-dimensional (3D) DNS is often computationally infeasible. It is a common practice to employ two-dimensional (2D) DNS, but since turbulence is inherently a three-dimensional phenomenon, the validity of this approach is questionable. In this study, we compare the evolution of a turbulent fuel/air mixing layer employing 3D and 2D DNS. While there are significant differences in detail, it is shown that employing either set of results leads to the same conclusion about the superiority of one subgrid-scale model over another.
- 26 January 2015
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 229 (11) , 1543-1565
Critical observations on the modeling of nonreacting and reacting diesel sprays
This paper begins by discussing the structure of nonreacting and reacting diesel sprays. After a general discussion of approaches to model nonreacting diesel sprays, results from some recent work employing the Reynolds-averaged Navier–Stokes equations to model the nonreacting spray are presented. It is shown through detailed comparison with measured results that, under conventional high-pressure, high-temperature chamber and high-pressure injection conditions, the vaporizing diesel spray behaves like a gas jet and can be modeled as such without noticeable loss of accuracy in reproducing the structure of the spray. Moving on to consider a reacting diesel spray, turbulence–chemistry interaction models for the reacting spray are reviewed. Challenges in determining the suitability of one model over another, based on information available in the literature, are highlighted. The Reynolds-averaged Navier–Stokes simulation results of reacting diesel sprays in which an unsteady-flamelet-generated manifold model is employed for turbulence–chemistry interactions are discussed in detail. It is shown that the model, like others reported in the literature, can predict the ignition delay and the flame lift-off heights with reasonable accuracy. The model has also been extended to compute the concentrations of soot and nitrogen oxides in reacting diesel sprays. Nitrogen oxides are modeled using the mechanism from GRI-Mech 3.0 and soot is modeled using a kinetic mechanism coupled with a tracer particle approach to estimate the residence times within the jet. As part of this review, other recent studies on modeling pollutants in the reacting diesel spray are also reviewed in this work. Finally, recent studies employing large-eddy simulations of diesel sprays are reviewed. Initial simulations of the reacting diesel spray using a large-eddy simulation approach coupled with an unsteady-flamelet-generated manifold model are presented. The paper closes with a summary and suggestions for further work in modeling diesel sprays.
- 26 January 2015
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 229 (11) , 1543-1565
Critical observations on the modeling of nonreacting and reacting diesel sprays
This paper begins by discussing the structure of nonreacting and reacting diesel sprays. After a general discussion of approaches to model nonreacting diesel sprays, results from some recent work employing the Reynolds-averaged Navier–Stokes equations to model the nonreacting spray are presented. It is shown through detailed comparison with measured results that, under conventional high-pressure, high-temperature chamber and high-pressure injection conditions, the vaporizing diesel spray behaves like a gas jet and can be modeled as such without noticeable loss of accuracy in reproducing the structure of the spray. Moving on to consider a reacting diesel spray, turbulence–chemistry interaction models for the reacting spray are reviewed. Challenges in determining the suitability of one model over another, based on information available in the literature, are highlighted. The Reynolds-averaged Navier–Stokes simulation results of reacting diesel sprays in which an unsteady-flamelet-generated manifold model is employed for turbulence–chemistry interactions are discussed in detail. It is shown that the model, like others reported in the literature, can predict the ignition delay and the flame lift-off heights with reasonable accuracy. The model has also been extended to compute the concentrations of soot and nitrogen oxides in reacting diesel sprays. Nitrogen oxides are modeled using the mechanism from GRI-Mech 3.0 and soot is modeled using a kinetic mechanism coupled with a tracer particle approach to estimate the residence times within the jet. As part of this review, other recent studies on modeling pollutants in the reacting diesel spray are also reviewed in this work. Finally, recent studies employing large-eddy simulations of diesel sprays are reviewed. Initial simulations of the reacting diesel spray using a large-eddy simulation approach coupled with an unsteady-flamelet-generated manifold model are presented. The paper closes with a summary and suggestions for further work in modeling diesel sprays.
- Open Access
- 1 December 2012
- Published by SAGE Publications in International Journal of Spray and Combustion Dynamics
- Vol. 4 (4) , 323-339
Transient Evolution of Strain and Curvature in Flames Developing from Kernels
Achieving reliable ignition in lean-burn natural gas engines is a challenge. To provide insight into the processes involved, direct simulations are carried out to study the influence of varying flow fluctuation scales on flames developing from kernels. This study is conducted at elevated temperature and pressure conditions relevant to lean-burn natural gas engines. The transient evolution of strain and curvature during kernel development is studied. It is observed that both strain and curvature reach statistically steady values in distinct characteristic times. The time period is about four flow time scales for strain rate and about two and a half flow time scales for curvature, respectively, and these scales are found to be independent of flow fluctuation scales and laminar flame speed of the mixture when the initial kernel diameter is larger than the integral length scale of the flow field.
- 1 December 2012
- Published by SAGE Publications in International Journal of Spray and Combustion Dynamics
- Vol. 4 (4) , 323-339
Open AccessTransient Evolution of Strain and Curvature in Flames Developing from Kernels
Achieving reliable ignition in lean-burn natural gas engines is a challenge. To provide insight into the processes involved, direct simulations are carried out to study the influence of varying flow fluctuation scales on flames developing from kernels. This study is conducted at elevated temperature and pressure conditions relevant to lean-burn natural gas engines. The transient evolution of strain and curvature during kernel development is studied. It is observed that both strain and curvature reach statistically steady values in distinct characteristic times. The time period is about four flow time scales for strain rate and about two and a half flow time scales for curvature, respectively, and these scales are found to be independent of flow fluctuation scales and laminar flame speed of the mixture when the initial kernel diameter is larger than the integral length scale of the flow field.
- 17 October 2012
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 227 (5) , 748-760
Influence of turbulence on autoignition in stratified mixtures under compression ignition engine conditions
The influence of turbulence on the autoignition characteristics of initially stratified mixing layers is studied using numerical simulations and multi-step kinetic mechanisms. The computations are carried out at a high initial pressure and a high initial temperature representative of conditions in compression ignition engines. n-Heptane is used as the surrogate fuel. It is shown that the influence of turbulence is to reduce the time for the first occurrence of ignition in the mixing layer in all cases. The initial gradient is modified by the turbulence, resulting in higher and lower gradients than the initial value. The lower gradients favor ignition, as pointed out in the literature. During a two-stage ignition process, the influence is primarily reflected in the second stage of ignition. The separate influences of the velocity scale and the length scale on autoignition are explored. An increase in the velocity and/or a decrease in the length scale increase(s) the spread of gradients in the domain and accelerate(s) ignition.
- 17 October 2012
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 227 (5) , 748-760
Influence of turbulence on autoignition in stratified mixtures under compression ignition engine conditions
The influence of turbulence on the autoignition characteristics of initially stratified mixing layers is studied using numerical simulations and multi-step kinetic mechanisms. The computations are carried out at a high initial pressure and a high initial temperature representative of conditions in compression ignition engines. n-Heptane is used as the surrogate fuel. It is shown that the influence of turbulence is to reduce the time for the first occurrence of ignition in the mixing layer in all cases. The initial gradient is modified by the turbulence, resulting in higher and lower gradients than the initial value. The lower gradients favor ignition, as pointed out in the literature. During a two-stage ignition process, the influence is primarily reflected in the second stage of ignition. The separate influences of the velocity scale and the length scale on autoignition are explored. An increase in the velocity and/or a decrease in the length scale increase(s) the spread of gradients in the domain and accelerate(s) ignition.
- 19 August 2011
- Published by Springer Nature in International Journal of Automotive Technology
- Vol. 12 (5) , 721-732
Computational study of charge stratification in early-injection SCCI engines under light-load conditions
- 19 August 2011
- Published by Springer Nature in International Journal of Automotive Technology
- Vol. 12 (5) , 721-732
Computational study of charge stratification in early-injection SCCI engines under light-load conditions
- 3 March 2011
- Published by Taylor & Francis in Numerical Heat Transfer, Part B: Fundamentals
- Vol. 59 (3) , 169-189
Enhancing the Performance of a Parallel Solver for Turbulent Reacting Flow Simulations
This article describes results of an effort to improve the parallel efficiency of a solver for turbulent reacting flows on two computer architectures. The compact finite-difference scheme employed for the solution of the differential equations involves the inversion of multiple tridiagonal matrices at each time step. Detailed performance evaluation of the standard LU, parallel partition LU, and parallel diagonal dominant algorithms are presented. The speed-up and efficiencies of these parallel strategies are critically compared and evaluated based on both computation and communication complexities, on the CRAY XT4 and IBM Blue Gene/P architectures.
- 3 March 2011
- Published by Taylor & Francis in Numerical Heat Transfer, Part B: Fundamentals
- Vol. 59 (3) , 169-189
Enhancing the Performance of a Parallel Solver for Turbulent Reacting Flow Simulations
This article describes results of an effort to improve the parallel efficiency of a solver for turbulent reacting flows on two computer architectures. The compact finite-difference scheme employed for the solution of the differential equations involves the inversion of multiple tridiagonal matrices at each time step. Detailed performance evaluation of the standard LU, parallel partition LU, and parallel diagonal dominant algorithms are presented. The speed-up and efficiencies of these parallel strategies are critically compared and evaluated based on both computation and communication complexities, on the CRAY XT4 and IBM Blue Gene/P architectures.
- 31 December 2010
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 35 (23) , 12936-12944
Some numerical considerations in the simulation of low-Ma number hydrogen/air mixing layers
- 31 December 2010
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 35 (23) , 12936-12944
Some numerical considerations in the simulation of low-Ma number hydrogen/air mixing layers
- 30 June 2010
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 182 (7) , 717-738
Numerical Studies of the Response of Flamelets to Unsteadiness in the Near-Field of Jets Under Diesel Conditions
Turbulent time records of scalar dissipation rates are numerically generated in the near-field of a high Reynolds number turbulent jet. The response of one-dimensional unsteady diffusion flamelets to these records were studied under pressure and temperature conditions representative of those in diesel engines. n-Heptane was chosen as the diesel fuel surrogate, its oxidation chemistry modeled by a 1,540-step mechanism comprising 159 species. Unsteadiness in the scalar dissipation rates was observed to impact autoignition, extinction, and reignition in the near-field. Possible linkages between these observations and flame liftoff, as well as its prediction, in diesel engines are discussed. Steady flamelet models were shown to not capture unsteady extinction–reignition events and associated chemical phase-lag effects. Unsteady flamelet–progress variable (UFPV) models in which the progress variable uniquely identifies all the flame states corresponding to a given value of χ are more suitable for representing the physics.
- 30 June 2010
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 182 (7) , 717-738
Numerical Studies of the Response of Flamelets to Unsteadiness in the Near-Field of Jets Under Diesel Conditions
Turbulent time records of scalar dissipation rates are numerically generated in the near-field of a high Reynolds number turbulent jet. The response of one-dimensional unsteady diffusion flamelets to these records were studied under pressure and temperature conditions representative of those in diesel engines. n-Heptane was chosen as the diesel fuel surrogate, its oxidation chemistry modeled by a 1,540-step mechanism comprising 159 species. Unsteadiness in the scalar dissipation rates was observed to impact autoignition, extinction, and reignition in the near-field. Possible linkages between these observations and flame liftoff, as well as its prediction, in diesel engines are discussed. Steady flamelet models were shown to not capture unsteady extinction–reignition events and associated chemical phase-lag effects. Unsteady flamelet–progress variable (UFPV) models in which the progress variable uniquely identifies all the flame states corresponding to a given value of χ are more suitable for representing the physics.