Kristian Krabbenhoft
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Kristian Krabbenhoft has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Andrei V. Lyamin
University of Newcastle
5 shared publications - Scott William Sloan
Laureate Professor, ARC Centre of Excellence for Geotechnical Science and Engineering, Faculty of Engineering and Built Environment, Univ. of Newcastle, Callaghan, NSW 2308, Australia
5 shared publications - Lars Damkilde
Aalborg University
2 shared publications M. R. Karim
Centre for Geotechnical Science and Engineering University of Newcastle Newcastle NSW Australia
2 shared publicationsF. Oka
Department of Civil and Earth Resources Engineering, Graduate School of Engineering Kyoto University Katsura C Campus, Nishikyo‐ku Kyoto 615‐8540 Japan
1 shared publicationM.R. Karim
Centre for Geotechnical and Materials Modelling, Department of Civil, Surveying and Environmental Engineering The University of Newcastle Callaghan NSW 2308 Australia
1 shared publication
Latest Publications
- 28 February 2013
- Published by Wiley in International Journal for Numerical and Analytical Methods in Geomechanics
- Vol. 37 (16) , 2801-2824
Simulation of long‐term consolidation behavior of soft sensitive clay using an elasto‐viscoplastic constitutive model
SUMMARY: The phenomenon of excess pore water pressure increase or stagnation and continuing large ground deformation in soft sensitive clay following the completion of construction of embankment is simulated for a case study at Saint Alban, Quebec, Canada. The present model employs an updated Lagrangian finite element framework and is combined with an automatic time increment selection scheme. The simulation based on an elasto‐viscoplastic constitutive model considers soil‐structure degradation effect. It is shown that without consideration for the microstructural degradation effect, it is not possible to reproduce the field responses of soft sensitive clay even during the construction of the embankment. When the soil‐structure degradation effect is considered, the present model can offer reasonably accurate prediction for the consolidation behavior of soft sensitive clay, including the so‐called anomalous pore water pressure generation and continuing large deformation even after the end of construction, which has been posing numerous uncertainties on the long‐term performance of earth structures. Copyright © 2013 John Wiley & Sons, Ltd.
- 28 February 2013
- Published by Wiley in International Journal for Numerical and Analytical Methods in Geomechanics
- Vol. 37 (16) , 2801-2824
Simulation of long‐term consolidation behavior of soft sensitive clay using an elasto‐viscoplastic constitutive model
SUMMARY: The phenomenon of excess pore water pressure increase or stagnation and continuing large ground deformation in soft sensitive clay following the completion of construction of embankment is simulated for a case study at Saint Alban, Quebec, Canada. The present model employs an updated Lagrangian finite element framework and is combined with an automatic time increment selection scheme. The simulation based on an elasto‐viscoplastic constitutive model considers soil‐structure degradation effect. It is shown that without consideration for the microstructural degradation effect, it is not possible to reproduce the field responses of soft sensitive clay even during the construction of the embankment. When the soil‐structure degradation effect is considered, the present model can offer reasonably accurate prediction for the consolidation behavior of soft sensitive clay, including the so‐called anomalous pore water pressure generation and continuing large deformation even after the end of construction, which has been posing numerous uncertainties on the long‐term performance of earth structures. Copyright © 2013 John Wiley & Sons, Ltd.
- 10 April 2012
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 90 (9) , 1089-1117
Associated computational plasticity schemes for nonassociated frictional materials
SUMMARY: A new methodology for computational plasticity of nonassociated frictional materials is presented. The new approach is inspired by the micromechanical origins of friction and results in a set of governing equations similar to those of standard associated plasticity. As such, procedures previously developed for associated plasticity are applicable with minor modification. This is illustrated by adaptation of the standard implicit scheme. Moreover, the governing equations can be cast in terms of a variational principle, which after discretization is solved by means of a newly developed second‐order cone programming algorithm. The effects of nonassociativity are discussed with reference to localization of deformations and illustrated by means of a comprehensive set of examples. Copyright © 2012 John Wiley & Sons, Ltd.
- 10 April 2012
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 90 (9) , 1089-1117
Associated computational plasticity schemes for nonassociated frictional materials
SUMMARY: A new methodology for computational plasticity of nonassociated frictional materials is presented. The new approach is inspired by the micromechanical origins of friction and results in a set of governing equations similar to those of standard associated plasticity. As such, procedures previously developed for associated plasticity are applicable with minor modification. This is illustrated by adaptation of the standard implicit scheme. Moreover, the governing equations can be cast in terms of a variational principle, which after discretization is solved by means of a newly developed second‐order cone programming algorithm. The effects of nonassociativity are discussed with reference to localization of deformations and illustrated by means of a comprehensive set of examples. Copyright © 2012 John Wiley & Sons, Ltd.
- 24 December 2009
- Published by Springer Nature in Transport in Porous Media
- Vol. 84 (2) , 371-388
Extraction of Effective Cement Paste Diffusivities from X-ray Microtomography Scans
- 24 December 2009
- Published by Springer Nature in Transport in Porous Media
- Vol. 84 (2) , 371-388
Extraction of Effective Cement Paste Diffusivities from X-ray Microtomography Scans
- Open Access
- 30 August 2007
- Published by Wiley in Communications in Numerical Methods in Engineering
- Vol. 24 (11)
Erratum: Three-dimensional Mohr-Coulomb limit analysis using semidefinite programming. Commun. Numer. Meth. Engng (DOI: 10.1002/cnm.1018)
- 30 August 2007
- Published by Wiley in Communications in Numerical Methods in Engineering
- Vol. 24 (11)
Open AccessErratum: Three-dimensional Mohr-Coulomb limit analysis using semidefinite programming. Commun. Numer. Meth. Engng (DOI: 10.1002/cnm.1018)
- 5 June 2007
- Published by Wiley in Communications in Numerical Methods in Engineering
- Vol. 24 (11) , 1107-1119
Three‐dimensional Mohr–Coulomb limit analysis using semidefinite programming
Recently, Krabbenhøft et al. (Int. J. Solids Struct. 2007; 44:1533–1549) have presented a formulation of the three‐dimensional Mohr–Coulomb criterion in terms of positive‐definite cones. The capabilities of this formulation when applied to large‐scale three‐dimensional problems of limit analysis are investigated. Following a brief discussion on a number of theoretical and algorithmic issues, three common, but traditionally difficult, geomechanics problems are solved and the performance of a common primal–dual interior‐point algorithm (SeDuMi (Appl. Numer. Math. 1999; 29:301–315)) is documented in detail. Although generally encouraging, the results also reveal several difficulties which support the idea of constructing a conic programming algorithm specifically dedicated to plasticity problems. Copyright © 2007 John Wiley & Sons, Ltd.
- 5 June 2007
- Published by Wiley in Communications in Numerical Methods in Engineering
- Vol. 24 (11) , 1107-1119
Three‐dimensional Mohr–Coulomb limit analysis using semidefinite programming
Recently, Krabbenhøft et al. (Int. J. Solids Struct. 2007; 44:1533–1549) have presented a formulation of the three‐dimensional Mohr–Coulomb criterion in terms of positive‐definite cones. The capabilities of this formulation when applied to large‐scale three‐dimensional problems of limit analysis are investigated. Following a brief discussion on a number of theoretical and algorithmic issues, three common, but traditionally difficult, geomechanics problems are solved and the performance of a common primal–dual interior‐point algorithm (SeDuMi (Appl. Numer. Math. 1999; 29:301–315)) is documented in detail. Although generally encouraging, the results also reveal several difficulties which support the idea of constructing a conic programming algorithm specifically dedicated to plasticity problems. Copyright © 2007 John Wiley & Sons, Ltd.
- 5 June 2006
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 69 (3) , 592-626
An interior‐point algorithm for elastoplasticity
The problem of small‐deformation, rate‐independent elastoplasticity is treated using convex programming theory and algorithms. A finite‐step variational formulation is first derived after which the relevant potential is discretized in space and subsequently viewed as the Lagrangian associated with a convex mathematical program. Next, an algorithm, based on the classical primal–dual interior point method, is developed. Several key modifications to the conventional implementation of this algorithm are made to fully exploit the nature of the common elastoplastic boundary value problem. The resulting method is compared to state‐of‐the‐art elastoplastic procedures for which both similarities and differences are found. Finally, a number of examples are solved, demonstrating the capabilities of the algorithm when applied to standard perfect plasticity, hardening multisurface plasticity, and problems involving softening. Copyright © 2006 John Wiley & Sons, Ltd.
- 5 June 2006
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 69 (3) , 592-626
An interior‐point algorithm for elastoplasticity
The problem of small‐deformation, rate‐independent elastoplasticity is treated using convex programming theory and algorithms. A finite‐step variational formulation is first derived after which the relevant potential is discretized in space and subsequently viewed as the Lagrangian associated with a convex mathematical program. Next, an algorithm, based on the classical primal–dual interior point method, is developed. Several key modifications to the conventional implementation of this algorithm are made to fully exploit the nature of the common elastoplastic boundary value problem. The resulting method is compared to state‐of‐the‐art elastoplastic procedures for which both similarities and differences are found. Finally, a number of examples are solved, demonstrating the capabilities of the algorithm when applied to standard perfect plasticity, hardening multisurface plasticity, and problems involving softening. Copyright © 2006 John Wiley & Sons, Ltd.
- 25 May 2006
- Published by Springer Nature in Computational Mechanics
- Vol. 39 (6) , 879-888
Bounds to Shakedown Loads for a Class of Deviatoric Plasticity Models
- 25 May 2006
- Published by Springer Nature in Computational Mechanics
- Vol. 39 (6) , 879-888
Bounds to Shakedown Loads for a Class of Deviatoric Plasticity Models
- 11 March 2006
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 43 (3) , 233-241
An implicit mixed enthalpy–temperature method for phase-change problems
- 11 March 2006
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 43 (3) , 233-241
An implicit mixed enthalpy–temperature method for phase-change problems
- 13 November 2004
- Published by Springer Nature in Wood Science and Technology
- Vol. 38 (8) , 641-659
Double porosity models for the description of water infiltration in wood
- 13 November 2004
- Published by Springer Nature in Wood Science and Technology
- Vol. 38 (8) , 641-659
Double porosity models for the description of water infiltration in wood