Ali Bahari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ali Bahari has a total of 104 co-authors. Here are the top co-authors by number of shared publications:
Adeleh Hashemi
University of Mazandaran
5 shared publications- Siamak Hoseinzadeh
School of Energy and Sustainable Resources Engineering, College of Interdisciplinary Science and Technology University of Tehran Tehran Iran
5 shared publications Vaheed Fallah Hamidabadi
Department of Solid State Physics, University of Mazandaran, Babolsar, Iran
5 shared publications- Reza Gholipur
Department of Physics, Faculty of Science, Razi University, Kermanshah, Iran
4 shared publications Saleh Fallah Samakosh
4 shared publicationsA. H. Ramezani
Islamic Azad University
3 shared publications
Latest Publications
- 1 April 2026
- Published by Springer Nature in Journal of Central South University
- Vol. 33 (4) , 1525-1540
Leakage- and tunneling-current through the gate dielectric of organic thin film transistor using retarded Green’s function, creation and annihilation operators
- 1 April 2026
- Published by Springer Nature in Journal of Central South University
- Vol. 33 (4) , 1525-1540
Leakage- and tunneling-current through the gate dielectric of organic thin film transistor using retarded Green’s function, creation and annihilation operators
- Open Access
- 3 September 2025
- Published by Springer Nature in Research Square
Photo-responsive of small organic molecules in Nano chips
Tremendous progress and researchers to the organic materials such as PMMA, PS, PFS, Ph- BTBT-10, with regarding to their electrical characterization have shown more capability for the production of flexible electronic components. These cases have been done abundantly in different ways, however the innovation in the present work, is finding the reasons for the different response of these materials to the applied electric field and incoming UV- rays with helping the field operators and Transfer-, output- curves, frequency-dependent curves as well as modulation based on Lehmann representation and also the pseudo-particle, the relaxation time has been obtained, in where relaxation time for trapping a carrier, dipole polarization, trap density and surface plasmons are the main issues for present samples responsive.
- 3 September 2025
- Published by Springer Nature in Research Square
Open AccessPhoto-responsive of small organic molecules in Nano chips
Tremendous progress and researchers to the organic materials such as PMMA, PS, PFS, Ph- BTBT-10, with regarding to their electrical characterization have shown more capability for the production of flexible electronic components. These cases have been done abundantly in different ways, however the innovation in the present work, is finding the reasons for the different response of these materials to the applied electric field and incoming UV- rays with helping the field operators and Transfer-, output- curves, frequency-dependent curves as well as modulation based on Lehmann representation and also the pseudo-particle, the relaxation time has been obtained, in where relaxation time for trapping a carrier, dipole polarization, trap density and surface plasmons are the main issues for present samples responsive.
- 1 May 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (20) , 31442-31455
Low-temperature aerosol-assisted atmospheric plasma deposition of GO/PANI/CuO for selective room-temperature ammonia gas sensing
- 1 May 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (20) , 31442-31455
Low-temperature aerosol-assisted atmospheric plasma deposition of GO/PANI/CuO for selective room-temperature ammonia gas sensing
- 2 December 2024
- Published by Springer Nature in Emergent Materials
- Vol. 8 (3) , 1835-1847
Magnetite nanoparticles coated with glycerin for use in hyperthermia-based cancer treatment
- 2 December 2024
- Published by Springer Nature in Emergent Materials
- Vol. 8 (3) , 1835-1847
Magnetite nanoparticles coated with glycerin for use in hyperthermia-based cancer treatment
- 16 October 2024
- Published by Wiley in ChemistrySelect
- Vol. 9 (39)
Efficient Nano Composite (Cerium/Aluminum Nitrate) in the Process of Desulfurization
In the present work, a lot of efforts have been made to reduce the sulfur particles, as main pollutants, from gasoline with using cerium (Ce) and Al(NO 3 ) 3 nano composites measured with Reference method: ASTM D7039‐15. The sulfur crystallite number was around 7235 ppm for DS (Ni (NO 3 ) 2 and urea). These unwanted sulfur particles reached to 3028 ppm for y (Al (NO 3 ) 3) /x (Ce)=0.25 in weight ratio, without using centrifuge process. This result is a very good due to some points: The present experimental works have been done at the room temperature and atmosphere environment, whilst many other works, as addressed here, have needed higher temperature and pressures. To our knowledge, Ce, Aluminum nitrate and urea as nano composite materials have need been used for desulfurization processes. Moreover, some relevant techniques such as X‐ray powder diffraction (XRD), Energy dispersive X‐ray analysis (EDX), Fourier Transform Infrared (FTIR) spectroscopy, X‐ray photoelectron spectroscopy (XPS), UV‐Vis spectroscopy, transmission electron microscopy (TEM), and Dynamic light scattering (DLS) have also been used.
- 16 October 2024
- Published by Wiley in ChemistrySelect
- Vol. 9 (39)
Efficient Nano Composite (Cerium/Aluminum Nitrate) in the Process of Desulfurization
In the present work, a lot of efforts have been made to reduce the sulfur particles, as main pollutants, from gasoline with using cerium (Ce) and Al(NO 3 ) 3 nano composites measured with Reference method: ASTM D7039‐15. The sulfur crystallite number was around 7235 ppm for DS (Ni (NO 3 ) 2 and urea). These unwanted sulfur particles reached to 3028 ppm for y (Al (NO 3 ) 3) /x (Ce)=0.25 in weight ratio, without using centrifuge process. This result is a very good due to some points: The present experimental works have been done at the room temperature and atmosphere environment, whilst many other works, as addressed here, have needed higher temperature and pressures. To our knowledge, Ce, Aluminum nitrate and urea as nano composite materials have need been used for desulfurization processes. Moreover, some relevant techniques such as X‐ray powder diffraction (XRD), Energy dispersive X‐ray analysis (EDX), Fourier Transform Infrared (FTIR) spectroscopy, X‐ray photoelectron spectroscopy (XPS), UV‐Vis spectroscopy, transmission electron microscopy (TEM), and Dynamic light scattering (DLS) have also been used.