M. Burghard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
M. Burghard has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
S. Roth
Max-Planck-Institut für Festkörperforschung, Heisenbergstr. 1, D-70569 Stuttgart, Germany
11 shared publications- G. Philipp
Max-Planck-Institut für Festkörperforschung, Heisenbergstr. 1, D-70569 Stuttgart, Germany
3 shared publications G. Philipp
Max-Planck Institut fuer Festkoerperforschung, Heisenbergstr. 1, 70569 Stuttgart, Germany
2 shared publicationsG. T. Kim
Max-Planck-Institute für Festkörperforschung, Heisenbergstr. 1, D-70569 Stuttgart, Germany
2 shared publications- Georg Stefan Duesberg
Institute of Physics, University of the Bundeswehr Munich, 85579 Munich, Germany
2 shared publications - J. Muster
Max-Planck-Institut für Festkörperforschung, Heisenbergstr. 1, D-70569 Stuttgart, Germany
2 shared publications
Latest Publications
- 3 November 2003
- Published by American Physical Society (APS) in Physical Review B
- Vol. 68 (20) , 205402
Suppression of superconductor quasiparticle tunneling into single-walled carbon nanotubes
Electrical transport through single-walled carbon nanotubes with weak electrical coupling to superconducting leads has been studied theoretically and experimentally. A simple model is considered to describe single-particle tunneling into a Luttinger-liquid-like state from electrically weak connected superconducting electrodes. This involves the superconductor’s quasiparticle and the Luttinger liquid’s excitation density of states. Experimentally, the suppression of quasiparticle tunneling induced current peaks was observed at temperatures below 0.1 K, which we attributed to the Luttinger-liquid-like excitation spectrum of the single-walled carbon nanotube.
- 3 November 2003
- Published by American Physical Society (APS) in Physical Review B
- Vol. 68 (20) , 205402
Suppression of superconductor quasiparticle tunneling into single-walled carbon nanotubes
Electrical transport through single-walled carbon nanotubes with weak electrical coupling to superconducting leads has been studied theoretically and experimentally. A simple model is considered to describe single-particle tunneling into a Luttinger-liquid-like state from electrically weak connected superconducting electrodes. This involves the superconductor’s quasiparticle and the Luttinger liquid’s excitation density of states. Experimentally, the suppression of quasiparticle tunneling induced current peaks was observed at temperatures below 0.1 K, which we attributed to the Luttinger-liquid-like excitation spectrum of the single-walled carbon nanotube.
- 1 January 2001
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 591 (1) , 235
Fabrications of multiwalled carbon nanotubes on patterned electrodes
Multiwalled carbon nanotubes (MWCN) were grown on electrodes prepared by both e-beam lithography and photolithography with chemical vapor deposition (CVD) of at 700 °C. Carbon nanotubes were selectively grown on catalyst islands. High resolution transmission electron microscopy (HRTEM) images revealed that multiwalled carbon nanotubes were obtained. As-grown carbon nanotubes could be used for nanoelectronic devices directly.- 1 January 2001
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 591 (1) , 235
Fabrications of multiwalled carbon nanotubes on patterned electrodes
Multiwalled carbon nanotubes (MWCN) were grown on electrodes prepared by both e-beam lithography and photolithography with chemical vapor deposition (CVD) of at 700 °C. Carbon nanotubes were selectively grown on catalyst islands. High resolution transmission electron microscopy (HRTEM) images revealed that multiwalled carbon nanotubes were obtained. As-grown carbon nanotubes could be used for nanoelectronic devices directly.- 1 January 2000
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 544 (1) , 437
CdSe nanoparticle arrays contacted on electron transparent substrates
Arrays of CdSe clusters were obtained by deposition of the clusters (diameter ) on 20 nm thin, electron transparent substrates using a self-assembly process. The obtained cluster arrangements were characterized by transmission electron microscopy. To contact the cluster arrays, metal electrodes were defined by electron beam lithography on the substrates. A metallic layer evaporated onto the rear side of the membranes served as a backgate. The investigated junctions showed a very high resistance in spite of closely packed CdSe cluster monolayers.- 1 January 2000
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 544 (1) , 437
CdSe nanoparticle arrays contacted on electron transparent substrates
Arrays of CdSe clusters were obtained by deposition of the clusters (diameter ) on 20 nm thin, electron transparent substrates using a self-assembly process. The obtained cluster arrangements were characterized by transmission electron microscopy. To contact the cluster arrays, metal electrodes were defined by electron beam lithography on the substrates. A metallic layer evaporated onto the rear side of the membranes served as a backgate. The investigated junctions showed a very high resistance in spite of closely packed CdSe cluster monolayers.- 1 January 2000
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 544 (1) , 367
Role of the metal in contacting Single-Walled Carbon Nanotubes
Electrodes have been defined by e-beam lithography on top of Carbon Nanotubes in order to reduce the contact resistance between metal and Nanotube. Individual Single-Walled Carbon Nanotubes or individual thin bundles were contacted with different metals (Au, AuPd, Al, and Co). The electrode material has been varied in order to investigate the Nanotube/metal-contact. The adhesion properties of the metals and the Carbon Nanotubes on the substrates turned out to be crucial.
- 1 January 2000
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 544 (1) , 367
Role of the metal in contacting Single-Walled Carbon Nanotubes
Electrodes have been defined by e-beam lithography on top of Carbon Nanotubes in order to reduce the contact resistance between metal and Nanotube. Individual Single-Walled Carbon Nanotubes or individual thin bundles were contacted with different metals (Au, AuPd, Al, and Co). The electrode material has been varied in order to investigate the Nanotube/metal-contact. The adhesion properties of the metals and the Carbon Nanotubes on the substrates turned out to be crucial.
- 30 June 1999
- Published by Elsevier in Synthetic Metals
- Vol. 103 (1-3) , 2540-2542
Carbon SWNTs as wires and structural templates between nanoelectrodes
- 30 June 1999
- Published by Elsevier in Synthetic Metals
- Vol. 103 (1-3) , 2540-2542
Carbon SWNTs as wires and structural templates between nanoelectrodes
- 1 January 1999
- Published by AIP Publishing
- Vol. 486 (1) , 338
Surface Enhanced Raman Spectroscopy of single wall carbon nanotubes
Raman Microscopy has been performed on single wall carbon nanotubes (SWNTs). For that purpose chromatographically purified SWNTs were adsorbed onto substrates for Surface Enhanced Raman Spectroscopy. Investigations by Scanning Electron and Atomic Force Microscopy of the substrates revealed, that there are only a few objects in the Raman active area. Spectra with a distinct sharp peak in the region of the radial breathing mode (RBM) and four C-C stretching modes centred at 1580 cm−1 were recorded. The extremely narrow line width indicates that the spectra originate from individuals SWNTs or ropes of SWNTs with a unique diameter.
- 1 January 1999
- Published by AIP Publishing
- Vol. 486 (1) , 338
Surface Enhanced Raman Spectroscopy of single wall carbon nanotubes
Raman Microscopy has been performed on single wall carbon nanotubes (SWNTs). For that purpose chromatographically purified SWNTs were adsorbed onto substrates for Surface Enhanced Raman Spectroscopy. Investigations by Scanning Electron and Atomic Force Microscopy of the substrates revealed, that there are only a few objects in the Raman active area. Spectra with a distinct sharp peak in the region of the radial breathing mode (RBM) and four C-C stretching modes centred at 1580 cm−1 were recorded. The extremely narrow line width indicates that the spectra originate from individuals SWNTs or ropes of SWNTs with a unique diameter.
- 1 January 1999
- Published by AIP Publishing
- Vol. 486 (1) , 221
Vandium pentoxide nanowires
Colloidal vanadium pentoxide sols consist of individual fibres which are uniformly 1.5 nm high and 10 nm wide. Their length depends on the age of the sol and can reach up to several μm. Fibers were deposited on chemically modified electrode structures with electrode separations of 3 μm and about 150 nm, respectively. Position and shape of the nanowires on the electrodes were determined by Scanning Force Microscopy. Electrical transport measurements revealed non-linear characteristics at room temperature and 4.2 K. In addition, the transport behavior of networks of fibers is interpreted in terms of one-dimensional variable range hopping.- 1 January 1999
- Published by AIP Publishing
- Vol. 486 (1) , 221
Vandium pentoxide nanowires
Colloidal vanadium pentoxide sols consist of individual fibres which are uniformly 1.5 nm high and 10 nm wide. Their length depends on the age of the sol and can reach up to several μm. Fibers were deposited on chemically modified electrode structures with electrode separations of 3 μm and about 150 nm, respectively. Position and shape of the nanowires on the electrodes were determined by Scanning Force Microscopy. Electrical transport measurements revealed non-linear characteristics at room temperature and 4.2 K. In addition, the transport behavior of networks of fibers is interpreted in terms of one-dimensional variable range hopping.- 31 January 1998
- Published by Elsevier in Optical Materials
- Vol. 9 (1-4) , 401-405
Chemical functionalisation and arrangement of ultrasmall gold clusters in Langmuir-Blodgett films
- 31 January 1998
- Published by Elsevier in Optical Materials
- Vol. 9 (1-4) , 401-405
Chemical functionalisation and arrangement of ultrasmall gold clusters in Langmuir-Blodgett films
- 1 January 1998
- Published by AIP Publishing
- Vol. 442 (1) , 74-78
Transmission electron microscopy and electrical transport investigations performed on the same single-walled carbon nanotube
Electrical transport measurements and high resolution transmission electron microscopy performed on the same (rope of) single-walled carbon nanotube(s) (SWCNTs) allow to establish links between structural and electronic properties of the tubes. The tubes are deposited on electron transparent ultrathin -membranes bearing Cr/AuPd-electrodes defined by electron beam lithography. TEM-micrographs of the setup reveal mostly ropes consisting of 2-3 tubes which also appear on a scanning force microscope image of the same area. A current-voltage trace of the ropes at 4.2 K is also presented.- 1 January 1998
- Published by AIP Publishing
- Vol. 442 (1) , 74-78
Transmission electron microscopy and electrical transport investigations performed on the same single-walled carbon nanotube
Electrical transport measurements and high resolution transmission electron microscopy performed on the same (rope of) single-walled carbon nanotube(s) (SWCNTs) allow to establish links between structural and electronic properties of the tubes. The tubes are deposited on electron transparent ultrathin -membranes bearing Cr/AuPd-electrodes defined by electron beam lithography. TEM-micrographs of the setup reveal mostly ropes consisting of 2-3 tubes which also appear on a scanning force microscope image of the same area. A current-voltage trace of the ropes at 4.2 K is also presented.- 1 January 1998
- Published by AIP Publishing
- Vol. 442 (1) , 460-463
Self-assembly of ropes of cyanine dye molecules
Cyanine molecules self-assemble into molecular ropes. Through the aid of a polyelectrolyte, which is oppositely charged compared to the dye, this ability is even enhanced and leads to formation of individual ropes with lengths up to a few hundred nanometers, widths on the order of ten nanometers, and a few nanometers in height. These ropes were attached to chemically modified surfaces of atomically flat gold and substrates bearing a gold/palladium electrodepattern.
- 1 January 1998
- Published by AIP Publishing
- Vol. 442 (1) , 460-463
Self-assembly of ropes of cyanine dye molecules
Cyanine molecules self-assemble into molecular ropes. Through the aid of a polyelectrolyte, which is oppositely charged compared to the dye, this ability is even enhanced and leads to formation of individual ropes with lengths up to a few hundred nanometers, widths on the order of ten nanometers, and a few nanometers in height. These ropes were attached to chemically modified surfaces of atomically flat gold and substrates bearing a gold/palladium electrodepattern.