Thierry Belmonte
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Thierry Belmonte has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Fabienne Poncin-Epaillard
Université du Maine
4 shared publications - Gerard Henrion
Université de Lorraine, CNRS 1 , IJL, F-54000 Nancy
4 shared publications H. Michel
4 shared publications- Cedric Noel
Institut Jean Lamour, Department of Physics and Chemistry of Solids and Surfaces, Nancy-Université, CNRS, Nancy Cedex, France
3 shared publications - Thierry Czerwiec
Laboratoire de Science et Génie des Surfaces, (UMR CNRS 7570), Institut National Polytechnique de Lorraine, Ecole des Mines de Nancy, Parc de Saurupt, 54042 Nancy Cedex, France
3 shared publications A. Maliska
Laboratório de Materiais, Departamento de Engenharia Mecânica, Universidade Federal de Santa Catarina, Florianópolis, Brazil
2 shared publications
Latest Publications
- 23 December 2011
- Published by Wiley in Plasma Processes and Polymers
- Vol. 9 (2) , 207-216
Interaction Mechanisms between Ar-O2 Post-discharge and Biphenyl
- 23 December 2011
- Published by Wiley in Plasma Processes and Polymers
- Vol. 9 (2) , 207-216
Interaction Mechanisms between Ar-O2 Post-discharge and Biphenyl
- 14 April 2011
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 44 (17)
On the origin of self-organization of SiO2 nanodots deposited by CVD enhanced by atmospheric pressure remote microplasma
The origin of organization of nanostructured silica coatings deposited on stainless steel substrates by remote microplasma at atmospheric pressure is investigated. We show by resorting to thermal camera measurements coupled with modelling that deposition, limited to a few seconds in time, occurs at low temperature (∼below 420 K) although the gas temperature may reach 1400 K. Raman analyses of deposited films with thicknesses below 1 µm show the presence of oxidized silicon bonded to the metallic surface. The origin of nanodots is explained as follows. Close to the microplasma nozzle, the concentration of oxidizing species and/or the temperature being high enough, a silica thin film is obtained, leading to ceramic–metallic oxide interface that leads to a Volmer–Weber growth mode and to the synthesis of 3D structures over long treatment times. Far from the nozzle, the reactivity decreasing, thin films get a plasma–polymer like behaviour which leads to a Franck–Van der Merwe growth mode and films with a higher density. Other nanostructures, made of hexagonal cells, are observed but remain unexplained.
- 14 April 2011
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 44 (17)
On the origin of self-organization of SiO2 nanodots deposited by CVD enhanced by atmospheric pressure remote microplasma
The origin of organization of nanostructured silica coatings deposited on stainless steel substrates by remote microplasma at atmospheric pressure is investigated. We show by resorting to thermal camera measurements coupled with modelling that deposition, limited to a few seconds in time, occurs at low temperature (∼below 420 K) although the gas temperature may reach 1400 K. Raman analyses of deposited films with thicknesses below 1 µm show the presence of oxidized silicon bonded to the metallic surface. The origin of nanodots is explained as follows. Close to the microplasma nozzle, the concentration of oxidizing species and/or the temperature being high enough, a silica thin film is obtained, leading to ceramic–metallic oxide interface that leads to a Volmer–Weber growth mode and to the synthesis of 3D structures over long treatment times. Far from the nozzle, the reactivity decreasing, thin films get a plasma–polymer like behaviour which leads to a Franck–Van der Merwe growth mode and films with a higher density. Other nanostructures, made of hexagonal cells, are observed but remain unexplained.
- 24 March 2011
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 20 (4) , 744-759
Nonequilibrium Atmospheric Plasma Deposition
- 24 March 2011
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 20 (4) , 744-759
Nonequilibrium Atmospheric Plasma Deposition
- 4 November 2010
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 31 (1) , 189-203
Interaction Mechanisms Between Ar–O2 Post-Discharge and Stearic Acid I: Behaviour of Thin Films
- 4 November 2010
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 31 (1) , 189-203
Interaction Mechanisms Between Ar–O2 Post-Discharge and Stearic Acid I: Behaviour of Thin Films
- Open Access
- 15 January 2010
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 107 (2)
Analysis of mass transport in an atmospheric pressure remote plasma-enhanced chemical vapor deposition process
In remote microwave plasma enhanced chemical vapor deposition processes operated at atmospheric pressure, high deposition rates are associated with the localization of precursors on the treated surface. We show that mass transport can be advantageously ensured by convection for the heavier precursor, the lighter being driven by turbulent diffusion toward the surface. Transport by laminar diffusion is negligible. The use of high flow rates is mandatory to have a good mixing of species. The use of an injection nozzle with micrometer-sized hole enables us to define accurately the reaction area between the reactive species. The localization of the flow leads to high deposition rates by confining the reactive species over a small area, the deposition yield being therefore very high. Increasing the temperature modifies nonlinearly the deposition rates and the coating properties.
- 15 January 2010
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 107 (2)
Open AccessAnalysis of mass transport in an atmospheric pressure remote plasma-enhanced chemical vapor deposition process
In remote microwave plasma enhanced chemical vapor deposition processes operated at atmospheric pressure, high deposition rates are associated with the localization of precursors on the treated surface. We show that mass transport can be advantageously ensured by convection for the heavier precursor, the lighter being driven by turbulent diffusion toward the surface. Transport by laminar diffusion is negligible. The use of high flow rates is mandatory to have a good mixing of species. The use of an injection nozzle with micrometer-sized hole enables us to define accurately the reaction area between the reactive species. The localization of the flow leads to high deposition rates by confining the reactive species over a small area, the deposition yield being therefore very high. Increasing the temperature modifies nonlinearly the deposition rates and the coating properties.
- Open Access
- 1 June 2009
- Published by Wiley in Plasma Processes and Polymers
- Vol. 6 (S1) , S198-S203
Treatment of Hexatriacontane by Ar–O2 Remote Plasma: Formation of the Active Species
To follow the interaction with a heavy alkane, the hexatriacontane, and a remote argon–oxygen plasma, the O2 (b1Σ, v = 0 − X3Σ, v′ = 0) transition at 762 nm can be used. A strong correlation with the material transformation is observed and attributed to atomic oxygen whose recombination releases a quantity of heat that affects the treatment temperature.
- 1 June 2009
- Published by Wiley in Plasma Processes and Polymers
- Vol. 6 (S1) , S198-S203
Open AccessTreatment of Hexatriacontane by Ar–O2 Remote Plasma: Formation of the Active Species
To follow the interaction with a heavy alkane, the hexatriacontane, and a remote argon–oxygen plasma, the O2 (b1Σ, v = 0 − X3Σ, v′ = 0) transition at 762 nm can be used. A strong correlation with the material transformation is observed and attributed to atomic oxygen whose recombination releases a quantity of heat that affects the treatment temperature.
- 26 June 2008
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 28 (4) , 495-509
Role of the Temperature on the Interaction Mechanisms Between Argon–Oxygen Post-Discharge and Hexatriacontane
- 26 June 2008
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 28 (4) , 495-509
Role of the Temperature on the Interaction Mechanisms Between Argon–Oxygen Post-Discharge and Hexatriacontane
- 19 March 2008
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 42 (1) , 41-46
Microwave plasmas at atmospheric pressure: theoretical insight and applications in surface treatment
This work is an assessment of recent developments on microwave plasmas at atmospheric pressure and their applications in the field of surface treatment. A special attention is paid to the question of the accuracy of data at high temperature (above 2000 K) and to the non-locality of the energy dissipation in argon and helium plasmas.
- 19 March 2008
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 42 (1) , 41-46
Microwave plasmas at atmospheric pressure: theoretical insight and applications in surface treatment
This work is an assessment of recent developments on microwave plasmas at atmospheric pressure and their applications in the field of surface treatment. A special attention is paid to the question of the accuracy of data at high temperature (above 2000 K) and to the non-locality of the energy dissipation in argon and helium plasmas.
- 1 April 2007
- Published by Wiley in Plasma Processes and Polymers
- Vol. 4 (S1) , S664-S667
Synthesis of Si-Zn-O Composite Thin Films by a Hybrid PECVD-PVD Radiofrequency Process
- 1 April 2007
- Published by Wiley in Plasma Processes and Polymers
- Vol. 4 (S1) , S664-S667
Synthesis of Si-Zn-O Composite Thin Films by a Hybrid PECVD-PVD Radiofrequency Process
- 21 April 2006
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 26 (3) , 251-266
Modification of Hexatriacontane by O2–N2 Microwave Post-Discharges
- 21 April 2006
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 26 (3) , 251-266
Modification of Hexatriacontane by O2–N2 Microwave Post-Discharges